PQ4IPROA29Mobile Phone

m of 5mm from the bod A29 5. 3D stereo sound FCC Warning Specific Absorption Rate (SAR) information SAR tes ts are conducted using standard operating positions accepted by the FCC with the phone transmitting at its highest certified power level in all tested frequenc y bands, although the SAR is determined at the high est certified power level, the actual SAR level of the phone while operating can be well below the maxim um value, in general, the closer you are to a wireles s base station antenna, the lower the power output. Before a new model phone is a available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit establishe d by the FCC, Tests for each phone are performed i n positions and locations (e.g. at the ear and worn o n the body)as required by the FCC. For body worn operation, this mobile phone has bee n tested and meets the FCC RF exposure guideline s when used with an accessory designated for this p roduct or when used with an accessory that contain s no metal and that positions the handset a minimu y. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference rec eived, including interference that may cause undesir ed operation. Any Changes or modifications not exp ressly approved by the party responsible for complia nce could void the user’s authority to operate the eq uipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pu rsuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against h armful interference in a residential installation. This equipment generates uses and can radiate radio fre quency energy and, if not installed and used in acco rdance with the instructions, may cause harmful inte rference to radio communications. However, there is no guarantee that interference will not occur in a par ticular installation. If this equipment does cause har mful interference to radio or television reception, wh ich can be determined by turning the equipment off and on, the user is encouraged to try to correct the i nterference by one or more of the following measur es: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment an d receiver. --Connect the equipment into an outlet on a circuit di fferent from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV tec hnician for help. 6.the cell broadcast Enter Message menu to view Broadcast list The purpose of cell broadcasting is to inform mobile phone users of the danger, such as serious threats, child abduction and so on, through some alerts issued by operators,the function is activated by default

QA-FR-170-B HONG KONG IPRO TECHNOLOGY CO.,LIMITED ADD: 12/F 3 LOCKHART ROAD WANCHAI HK TEL: 0755-83829199 FAX: 0755-83828199 E-mail: [email protected] FCC Authorization Date: 2020-10-13 FEDERAL COMMUNICATIONS COMMISSION Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Agent Authorization To whom it may concern: We , HONG KONG IPRO TECHNOLOGY CO.,LIMITED, Hereby authorizes Bay Area Compliance Laboratories Corporation to act on its behalf in all matters relating to application for Equipment authorization, including the signing of all documents relating to these matters. All acts carried out by Bay Area Compliance Laboratory Corporation on our behalf shall have the same effect as our own action. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. Sincerely Yours, Client’s signature SAM HUANG Project VP

QA-FR-171-A HONG KONG IPRO TECHNOLOGY CO.,LIMITED ADD: 12/F 3 LOCKHART ROAD WANCHAI HK TEL: 0755-83829199 FAX: 0755-83828199 E-mail: [email protected] FCC Confidential Authorization Date: 2020-10-13 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Confidentiality Request regarding application for certification of FCC ID: PQ4IPROA29 In accordance with Sections 0.457 and 0.459 of the Commission’s Rules, (HONG KONG IPRO TECHNOLOGY CO.,LIMITED) hereby requests long-term confidential treatment of information accompanying this application as outlined below:  Block Diagram  Schematics  Operation Description  Parts List/Tune up procedure (for licensed devices) The above materials contain proprietary and confidential information not customarily released to the public. The public disclosure of these materials provides unjustified benefits to its competitors in the market. Sincerely, Signature: SAM HUANG Project VP

EXHIBIT B - EUT EXTERNAL PHOTOGRAPHS Port

EXHIBIT C - EUT INTERNAL PHOTOGRAPHS BT Antenna Chip GSM Antenna

FCC PART 15.247 TEST REPORT For HONG KONG IPRO TECHNOLOGY CO.,LIMITED 12/F 3 LOCKHART ROAD WANCHAI HK FCC ID: PQ4IPROA29 Report Type: Original Report Product Name: Mobile Phone Re port Number: RDG200910003-00A Re port Date: 2020-10-13 Reviewed By: Ivan Cao Assistant Manager Test Laboratory: Bay Area Compliance Laboratories Corp. (Dongguan) No.69 Pulongcun, Puxinhu Industry Area, Tangxia, Dongguan, Guangdong, China Tel: +86-769-86858888 Fax: +86-769-86858891 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp. (Dongguan) Report No.: RDG200910003-00A Page 2 of 53 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 4 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 4 OBJECTIVE ................................................................................................................................................................... 4 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 4 TEST METHODOLOGY .................................................................................................................................................. 4 MEASUREMENT UNCERTAINTY .................................................................................................................................... 5 TEST FACILITY ............................................................................................................................................................. 5 DECLARATIONS ............................................................................................................................................................ 5 SYSTEM TEST CONFIGURATION .......................................................................................................................... 6 DESCRIPTION OF TEST CONFIGURATION ...................................................................................................................... 6 EUT EXERCISE SOFTWARE .......................................................................................................................................... 6 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 6 SUPPORT CABLE LIST AND DETAILS ............................................................................................................................ 6 BLOCK DIAGRAM OF TEST SETUP ................................................................................................................................ 7 SUMMARY OF TEST RESULTS ............................................................................................................................... 8 FCC §15.247 (i) & §1.1310 & §2.1093- RF EXPOSURE ............................................................................................ 9 APPLICABLE STANDARD .............................................................................................................................................. 9 FCC §15.203 - ANTENNA REQUIREMENT ........................................................................................................... 10 APPLICABLE STANDARD ............................................................................................................................................ 10 ANTENNA CONNECTOR CONSTRUCTION .................................................................................................................... 10 FCC §15.207 (a) – AC LINE CONDUCTED EMISSIONS ..................................................................................... 11 APPLICABLE STANDARD ............................................................................................................................................ 11 EUT SETUP ................................................................................................................................................................ 11 EMI TEST RECEIVER SETUP ....................................................................................................................................... 11 TEST PROCEDURE ...................................................................................................................................................... 12 CORRECTED AMPLITUDE & MARGIN CALCULATION ................................................................................................. 12 TEST EQUIPMENT LIST AND DETAILS ......................................................................................................................... 12 TEST DATA ................................................................................................................................................................ 13 FCC §15.209, §15.205 & §15.247(d) - SPURIOUS EMISSIONS ............................................................................. 15 APPLICABLE STANDARD ............................................................................................................................................ 15 EUT SETUP ................................................................................................................................................................ 15 EMI TEST RECEIVER & SPECTRUM ANALYZER SETUP .............................................................................................. 16 TEST PROCEDURE ...................................................................................................................................................... 16 CORRECTED AMPLITUDE & MARGIN CALCULATION ................................................................................................. 16 TEST EQUIPMENT LIST AND DETAIL…

Text truncated - open the document above for the full version.

EXHIBIT D - TEST SETUP PHOTOGRAPHS Conducted Emissions Front View Conducted Emissions Side View Radiated Emission Below 1GHz View Radiated Emission 1GHz View