PQN44210RX49RC Airplane

FCC ID: PQN44210RX49 Ophoto1 Ophoto2 FCC ID: PQN44210RX49 Ophoto3 Ophoto4 FCC ID: PQN44210RX49 Ophoto5

• The test results reported in this report shall refer only to the sample actually tested and shall not refer or be deemed to refer to bulk from which such a sample may be said to have been obtained. • This report shall not be reproduced except in full without prior authorization from Intertek Testing Services Hong Kong Limited • The evaluation data of the report will be kept for 3 years from the date of issuance. FCC ID : PQN44210RX49 Spin Master Toys Far East Ltd. Application For Certification (FCC ID: PQN44210RX49) Superregenerative Receiver Sample Description : Air Hogs R/C Room Raider Model : 44210 0609552 TL/at June 2, 2006 INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 i LIST OF EXHIBITS INTRODUCTION EXHIBIT 1: General Description EXHIBIT 2: System Test Configuration EXHIBIT 3: Emission Results EXHIBIT 4: Equipment Photographs EXHIBIT 5: Product Labelling EXHIBIT 6: Technical Specifications EXHIBIT 7: Instruction Manual EXHIBIT 8: Miscellaneous Information INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 ii MEASUREMENT/TECHNICAL REPORT Spin Master Toys Far East Ltd. - MODEL: 44210 FCC ID: PQN44210RX49 June 2, 2006 This report concerns (check one:) Original Grant X Class II Change Equipment Type: Superregenerative Receiver (example: computer, printer, modem, etc.) Deferred grant requested per 47 CFR 0.457(d)(1)(ii)? Yes No X If yes, defer until: date Company Name agrees to notify the Commission by: date of the intended date of announcement of the product so that the grant can be issued on that date. Transition Rules Request per 15.37? Yes No X If no, assumed Part 15, Subpart B for intentional radiator Report prepared by: Leung Wai Leung, Tommy Intertek Testing Services 2/F., Garment Center, 576, Castle Peak Road, HONG KONG Phone: 852-2173-8502 Fax: 852-2742-9149 INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 iii Table of Contents 1.0 General Description................................................................................................. 2 1.1 Product Description............................................................................................... 2 1.2 Related Submittal(s) Grants .................................................................................. 2 1.3 Test Methodology................................................................................................. 3 1.4 Test Facility .......................................................................................................... 3 2.0 System Test Configuration ...................................................................................... 5 2.1 Justification ........................................................................................................... 5 2.2 EUT Exercising Software ...................................................................................... 5 2.3 Support Equipment List and Description................................................................ 5 2.4 Equipment Modification......................................................................................... 6 2.5 Special Accessories.............................................................................................. 6 3.0 Emission Results ..................................................................................................... 8 3.1 Field Strength Calculation ..................................................................................... 9 3.2 Radiated Emission Configuration Photograph ..................................................... 10 3.3 Radiated Emission Data...................................................................................... 11 4.0 Equipment Photographs ........................................................................................ 15 5.0 Product Labelling................................................................................................... 17 6.0 Technical Specifications........................................................................................ 19 7.0 Instruction Manual ................................................................................................. 21 8.0 Miscellaneous Information.................................................................................... 23 8.1 Stabilization Waveform........................................................................................ 24 8.2 Emissions Test Procedures................................................................................. 25 8.2 Emissions Test Procedures (cont'd) .................................................................... 26 INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 iv List of attached file Exhibit type File Description filename Test Report Test Report report.pdf Operation Description Technical Description descri.pdf Test Setup Photo Radiated Emission radiated photos.doc Test Report Stabilization Waveform superreg.pdf External Photo External Photo external photos.doc Internal Photo Internal Photo internal photos.doc Block Diagram Block Diagram block.pdf Schematics Circuit Diagram circuit.pdf ID Label/Location Label Artwork and Location label.pdf User Manual User Manual manual.pdf INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 1 EXHIBIT 1 GENERAL DESCRIPTION INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 2 1.0 General Description 1.1 Product Description The equipment under test (EUT) is a receiver for a RC airplane operating at 49.860 MHz which is controlled by a crystal. The EUT is powered by a 3.7V rechargeable Ni-MH battery. The EUT has an ON/OFF switch and a charge port. After switched ON the EUT, it can be controlled to flying forward with the different speed. To charge the internal battery in the RC airplane, plug the charge cable on the corresponding controller into the charge port. The brief circuit description is saved with filename: descri.pdf 1.2 Related Submittal(s) Grants This is a single application for certification of a receiver. The transmitter for this receiver is authorized by Cer…

Text truncated - open the document above for the full version.

FCC ID: PQN44210RX49 Iphoto1 Iphoto2 FCC ID: PQN44210RX49 Iphoto3 Iphoto4 FCC ID: PQN44210RX49 Iphoto5 Iphoto6

FCC ID: PQN44210RX49 Technical Description : The brief circuit description is listed as follows : - Q1 and associated circuit act as 49.860 MHz Super-regenerative Receiver. - U2 RX2 acts as Decoder. - U1 acts as MCU. - Z1 and associated circuit act as Voltage Regulator. - Q2, Q4 and associated circuit act as Low Battery Detection Circuit. - Q3 and associated circuit act as Motor Driver. - R13 and associated circuit act as Over Load Detection Circuit. Antenna Used : An integral antenna has been used.

• The test results reported in this report shall refer only to the sample actually tested and shall not refer or be deemed to refer to bulk from which such a sample may be said to have been obtained. • This report shall not be reproduced except in full without prior authorization from Intertek Testing Services Hong Kong Limited • The evaluation data of the report will be kept for 3 years from the date of issuance. FCC ID : PQN44210RX49 Spin Master Toys Far East Ltd. Application For Certification (FCC ID: PQN44210RX49) Superregenerative Receiver Sample Description : Air Hogs R/C Room Raider Model : 44210 0609552 TL/at June 2, 2006 INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 i LIST OF EXHIBITS INTRODUCTION EXHIBIT 1: General Description EXHIBIT 2: System Test Configuration EXHIBIT 3: Emission Results EXHIBIT 4: Equipment Photographs EXHIBIT 5: Product Labelling EXHIBIT 6: Technical Specifications EXHIBIT 7: Instruction Manual EXHIBIT 8: Miscellaneous Information INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 ii MEASUREMENT/TECHNICAL REPORT Spin Master Toys Far East Ltd. - MODEL: 44210 FCC ID: PQN44210RX49 June 2, 2006 This report concerns (check one:) Original Grant X Class II Change Equipment Type: Superregenerative Receiver (example: computer, printer, modem, etc.) Deferred grant requested per 47 CFR 0.457(d)(1)(ii)? Yes No X If yes, defer until: date Company Name agrees to notify the Commission by: date of the intended date of announcement of the product so that the grant can be issued on that date. Transition Rules Request per 15.37? Yes No X If no, assumed Part 15, Subpart B for intentional radiator Report prepared by: Leung Wai Leung, Tommy Intertek Testing Services 2/F., Garment Center, 576, Castle Peak Road, HONG KONG Phone: 852-2173-8502 Fax: 852-2742-9149 INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 iii Table of Contents 1.0 General Description................................................................................................. 2 1.1 Product Description............................................................................................... 2 1.2 Related Submittal(s) Grants .................................................................................. 2 1.3 Test Methodology................................................................................................. 3 1.4 Test Facility .......................................................................................................... 3 2.0 System Test Configuration ...................................................................................... 5 2.1 Justification ........................................................................................................... 5 2.2 EUT Exercising Software ...................................................................................... 5 2.3 Support Equipment List and Description................................................................ 5 2.4 Equipment Modification......................................................................................... 6 2.5 Special Accessories.............................................................................................. 6 3.0 Emission Results ..................................................................................................... 8 3.1 Field Strength Calculation ..................................................................................... 9 3.2 Radiated Emission Configuration Photograph ..................................................... 10 3.3 Radiated Emission Data...................................................................................... 11 4.0 Equipment Photographs ........................................................................................ 15 5.0 Product Labelling................................................................................................... 17 6.0 Technical Specifications........................................................................................ 19 7.0 Instruction Manual ................................................................................................. 21 8.0 Miscellaneous Information.................................................................................... 23 8.1 Stabilization Waveform........................................................................................ 24 8.2 Emissions Test Procedures................................................................................. 25 8.2 Emissions Test Procedures (cont'd) .................................................................... 26 INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 iv List of attached file Exhibit type File Description filename Test Report Test Report report.pdf Operation Description Technical Description descri.pdf Test Setup Photo Radiated Emission radiated photos.doc Test Report Stabilization Waveform superreg.pdf External Photo External Photo external photos.doc Internal Photo Internal Photo internal photos.doc Block Diagram Block Diagram block.pdf Schematics Circuit Diagram circuit.pdf ID Label/Location Label Artwork and Location label.pdf User Manual User Manual manual.pdf INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 1 EXHIBIT 1 GENERAL DESCRIPTION INTERTEK TESTING SERVICES FCC ID: PQN44210RX49 2 1.0 General Description 1.1 Product Description The equipment under test (EUT) is a receiver for a RC airplane operating at 49.860 MHz which is controlled by a crystal. The EUT is powered by a 3.7V rechargeable Ni-MH battery. The EUT has an ON/OFF switch and a charge port. After switched ON the EUT, it can be controlled to flying forward with the different speed. To charge the internal battery in the RC airplane, plug the charge cable on the corresponding controller into the charge port. The brief circuit description is saved with filename: descri.pdf 1.2 Related Submittal(s) Grants This is a single application for certification of a receiver. The transmitter for this receiver is authorized by Cer…

Text truncated - open the document above for the full version.

INTERTEK TESTING SERVICES Worst case radiated emission configuration Front View Back View INTERTEK TESTING SERVICES Other radiated emission configuration Front View Back View