PQTDORM46315 MHz Keyfob Transmitter

PROGRAMMING ADDITIONAL REMOTES REQUIRE AT LEAST ALREADY PROGRAMMED REMOTE Programming Instructions: Disclaimer: All currently programmed and new remotes must be reprogrammed to vehicle. Please have all remotes in hand at time of programming. Once plugging in the programmer you will have 2 minutes to program all new and existing remotes to vehicle. After 2 minutes your session will time out and your vehicle will no longer be in programming mode. Programmer will work for no more than 3 sessions. 1. Close and lock doors. 2. Insert Key into ignition and turn to IGN ON (Do not crank). 3. Insert Programmer into your vehicle’s OBD2 Port. This port is typically located underneath the dashboard below the steering wheel. It may be covered by a faceplate that will easily pop off. 4. Once the Programmer is inserted, wait for a chime or orange light on the Programmer to come on. This will indicate that the unit is ready to program the first remote. 5. Press and hold the lock and unlock button on the remote simultaneously until you hear a chime, buzzer, or the door locks cycle (approximately 10- 15 seconds). 6. To program additional remotes, repeat step 4. 7. When all remotes are programmed wait 60 seconds for buzzer to sound continuously, then remove programmer from OBD2 Port. FCC WARNING Statement 15.19(a)(3): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Dorman Products Inc. could void the user’s authority to operate the equipment. IC WARNING FVIN 6399105IC PROGRAMMING ADDITIONAL REMOTES REQUIRE AT LEAST ALREADY PROGRAMMED REMOTE This device contains licence-except transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: 1) This device may not cause interference. 2) This device must accept any interference, inclduing interference that may cause undesired operation of the device. Cet appareil contient des émetteurs / récepteurs sans licence qui sont conformes aux RSS exempts de licence d'Innovation, Sciences et Développement économique Canada. Son fonctionnement est soumis aux deux conditions suivantes: 1) Cet appareil ne doit pas provoquer d'interférences. 2) Cet appareil doit accepter toute interférence, y compris les interférences pouvant entraîner un fonctionnement indésirable de l'appareil.

External Photos PQTDORM46 Front Rear Top Bottom External Photos PQTDORM46 Side 1 Side 2

Note: Label location is identical on all models listed for PQTDORM46. Label text will be laser etched on to key fob.

DORMAN PRODUCTS Model:99105 100126 YYDDD FCC ID: PQTDORM46 IC: 10735A-DORM46 BATT CR2032

Internal Photos PQTDORM46 Antenna

FCC Part 15, Subpart C, Section 15.231 Industry Canada, RSS-210 and RSS-GEN Test Report On 315 MHz Keyfob Transmitter FCC ID: PQTDORM46 IC: 10735A-DORM46 Customer Name: Dorman Products, Inc. Customer P.O: 4200009184 Date of Report: March 4, 2020 Test Report No: R-3017P Test Start Date: February 27, 2019 Test Finish Date: March 11, 2019 Test Technicians: M. Nowak Test Engineer: A. Warwick Approved By: D. Rybicki Report Prepared By: P. Harris Our letters, procedures and reports are for the exclusive use of the customer to whom they are addressed and their communication or the use of the name of Retlif Testing Laboratories must receive our prior written approval. Our letters, procedures and reports apply only to the sample tested and are not necessarily indicative of the qualities of apparently identical or similar products. The letters, procedures and reports and the name of Retlif Testing Laboratories or insignia are not to be used under any circumstances in advertising to the general public. This test report shall not be reproduced, except in full, without the written approval of Retlif Testing Laboratories. Report No. R-3017P Page 2 of 35 Retlif Testing Laboratories R Table of Contents Certification and Signatures .................................................................................................. 3 Revision History .................................................................................................................... 4 Requirements and Test Results ............................................................................................ 8 FCC Section 15.231(a) - Periodic operation in the band 40.66 - 40.7 MHz and above 70 MHz .......................................................................... 8 IC RSS-210, A1.1 - Momentarily Operated Devices ......................................................... 8 FCC Sections 15.231(a)(1)-(5) - Periodic operation in the band 40.66 - 40.7 MHz and above 70 MHz .......................................................................... 8 IC RSS-210, A1.1.1(a)-(d) - Types of Momentary Signals ................................................ 8 FCC Section 15.231(b) - Field Strength of Emissions ..................................................... 10 IC RSS-210, A1.1.2(1) - Field Strengths and Frequency Bands ..................................... 10 FCC Section 15.231(b)(2) - Duty Cycle Determination-Pulsed Operation ....................... 11 IC RSS-GEN, Paragraph 4.5, Pulsed Operation ............................................................. 11 FCC Section 15.231(b)(3) - Field Strength of Spurious Emissions ................................. 12 IC RSS-210, A1.1.2(3) - Field Strength of Unwanted Emissions ..................................... 12 FCC Section 15.231(c) - Bandwidth of Emissions ........................................................... 12 IC RSS-210, A1.1.3 - Bandwidth of Momentary Signals ................................................. 12 FCC Section 15.109(a) - Receiver Radiated Emissions .................................................. 13 IC RSS-GEN, 7.2.3 - Receiver Spurious Emission Limits ............................................... 13 General Requirements FCC and IC .................................................................................... 14 Open Area Test Site ........................................................................................................... 15 Equipment Lists .................................................................................................................. 16 Test Data, Field Strength of Emissions ............................................................................... 18 Test Data, Duty Cycle Determination .................................................................................. 23 Test Data, Field Strength of Spurious Emissions ................................................................ 29 Test Data, Timing Requirements ........................................................................................ 31 Test Data, Bandwidth of Emission ...................................................................................... 33 Table of Tables Table 1 - Test Limits, Field Strength of Emissions .............................................................. 10 Table 2 - Fundamental and Harmonic Limits ...................................................................... 10 Table 3 - Fundamental and Harmonics Test Results .......................................................... 10 Table 4 - Radiated Emission Limits .................................................................................... 13 Report No. R-3017P Page 3 of 35 Retlif Testing Laboratories R Certification and Signatures We certify that this report is a true representation of the results obtained from the tests of the equipment stated. We further certify that the measurements shown in this report were made in accordance with the procedures indicated and vouch for the qualifications of all Retlif Testing Laboratories personnel taking them. Arik L. Warwick EMC Test Engineer David M. Rybicki Laboratory Supervisor Non-Warranty Provision The testing services have been performed, findings obtained and reports prepared in accordance with generally accepted laboratory principles and practices. This warranty is in lieu of all others, either expressed or implied. Non-Endorsement This test report contains only findings and results arrived at after employing the specific test procedures and standards listed herein. It is not intended to constitute a recommendation, endorsement or certification of the product or material tested. This report must not be used by the client to claim product endorsement by ANSI National Accreditation Board (ANAB). Report No. R-3017P Page 4 of 35 Retlif Testing Laboratories R Revision History Revisions to this document are listed below; the latest revised document supersedes all previous issues of this document. Revision …

Text truncated - open the document above for the full version.

Page 1 of 13 Dorman Products, Inc. Test Setup Photographs FCC ID: PQTDORM46 IC: 10735A-DORM46 Page 2 of 13 Field Strength of Emissions Test Setup Photographs Test Setup, X Axis, Below 1 GHz Test Setup, X Axis, Above 1 GHz Page 3 of 13 Field Strength of Emissions Test Setup Photographs Test Setup, Y Axis, Below 1 GHz Test Setup, Y Axis, Above 1 GHz Page 4 of 13 Field Strength of Emissions Test Setup Photographs Test Setup, Z Axis, Below 1 GHz Test Setup, Z Axis, Above 1 GHz Page 5 of 13 Field Strength of Emissions Test Setup Photographs Horizontal Antenna Polarization, Below 1 GHz Vertical Antenna Polarization, Below 1 GHz Page 6 of 13 Field Strength of Emissions Test Setup Photographs Horizontal Antenna Polarization, Above 1 GHz Vertical Antenna Polarization, Above 1 GHz Page 7 of 13 Field Strength of Spurious Emissions Test Setup Photographs EUT Configuration Page 8 of 13 Field Strength of Spurious Emissions Test Setup Photographs Parallel, 9 kHz to 30 MHz Perpendicular, 9 kHz to 30 MHz Page 9 of 13 Field Strength of Spurious Emissions Test Setup Photographs Horizontal Antenna Polarization, 30 to 200 MHz Vertical Antenna Polarization, 30 to 200 MHz Page 10 of 13 Field Strength of Spurious Emissions Test Setup Photographs Horizontal Antenna Polarization, 200 MHz to 1 GHz Vertical Antenna Polarization, 200 MHz to 1 GHz Page 11 of 13 Duty Cycle Determination Test Setup Photograph Test Setup Page 12 of 13 Occupied Bandwidth of Emissions Test Setup Photograph Test Setup Page 13 of 13 99% Occupied Bandwidth Test Setup Photograph Test Setup