PRDMUWIRTRE02Mini dongle

Safety Notice 1 This product complies with IEC 60825-1, class 1 laser product. 2 Your product complies with FCC and CE rules. 3 This product has no serviceable parts. Use of controls or adjustments of procedures other than the user guide may result in danger. 2.4GHz Wireless Optical Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installation Please DO NOT direct the laser beam at anyone’s eye. 1 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2 Functional Introduction Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. Nano Receiver Scrolling Wheel & Low Battery / Pairing indicator Left button Connect Button Right button Battery Cover Pull AAA Battery 1’st 2’nd 3 Nano Receiver Setup the Connection between the Receiver and the Mouse 1. Plug the Nano receiver into the USB port of your computer. 2. Insert the batteries into the mouse, then follow the steps below. 3. If the mouse is not working, please put it into pair mode. 4. Pairing: Re-plug the receiver into the USB port of your computer, then press the connect buttons on the mouse. If the mouse does not work after 30 seconds, pair them again. (The receiver has auto pairing function). Take out Push 4 5.The LED indicator on mouse flashes steadily when it is in pairing mode and stops blinking when it is successfully paired with the receiver. The mouse remains off afterwards. 6. When the battery of the mouse is low, the Low Power indicator blinking. During pairing Scrolling Wheel & Low Battery / Pairing indicator Red LED Blinking 10 sec. Low Battery Warning Blinking Red LED ON 10 Sec. Power ON *Mouse Indicator Green LED Blinking Pairing (LED OFF when paired or after 10 sec.)

Page 1 CONSTRUCTION PHOTOS OF EUT Page 2

FCC ID: PRDMUWIRTRE02 Label Location

Page 3 Page 4

FCC ID: PRDMUWIRTRE02 Report No.: RF981110L09 Operational Description This device is a Mini dongle. The transmitter of the EUT is powered by 5Vdc from host equipment. The antenna is printed antenna. The other instruction, please have a look at the users manual.

Report No.: RF981110L09 1 Report Format Version 3.0.1 FCC TEST REPORT REPORT NO. :RF981110L09 MODEL NO. :MRT RECEIVED :Nov. 10, 2009 TESTED :Feb. 25 ~ Feb. 26, 2010 ISSUED :Mar. 03, 2010 APPLICANT : Acrox Technologies Co., Ltd ADDRESS : 8F, No. 437, Rui Guang RD., Nei Hu Dist., Taipei 114, Taiwan, R.O.C. ISSUED BY : Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS : No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang, Taipei Hsien 244, Taiwan, R.O.C. TEST LOCATION : No. 19, Hwa Ya 2nd Rd, Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. This test report consists of 28 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by TAF or any government agencies. The test results in the report only apply to the tested sample. Report No.: RF981110L09 2 Report Format Version 3.0.1 Table of Contents 1. CERTIFICATION ...........................................................................................................3 2. SUMMARY OF TEST RESULTS ...................................................................................4 2.1 MEASUREMENT UNCERTAINTY ................................................................................4 3. GENERAL INFORMATION............................................................................................5 3.1 GENERAL DESCRIPTION OF EUT..............................................................................5 3.2 DESCRIPTION OF TEST MODES................................................................................6 3.2.1 CONFIGURATION OF SYSTEM UNDER TEST ...........................................................6 3.2.2 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL ................................7 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS ...............................................8 3.4 DESCRIPTION OF SUPPORT UNITS ..........................................................................8 4. TEST TYPES AND RESULTS .......................................................................................9 4.1 RADIATED EMISSION MEASUREMENT .....................................................................9 4.1.1 LIMITS OF RADIATED EMISSION MEASUREMENT...................................................9 4.1.2 TEST INSTRUMENTS ................................................................................................10 4.1.3 TEST PROCEDURES ................................................................................................. 11 4.1.4 DEVIATION FROM TEST STANDARD ....................................................................... 11 4.1.5 TEST SETUP ..............................................................................................................12 4.1.6 EUT OPERATING CONDITIONS ................................................................................12 4.1.7 TEST RESULTS ..........................................................................................................13 4.2 CONDUCTED EMISSION MEASUREMENT ..............................................................18 4.2.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT............................................18 4.2.2 TEST INSTRUMENTS ................................................................................................18 4.2.3 TEST PROCEDURES .................................................................................................19 4.2.4 DEVIATION FROM TEST STANDARD .......................................................................19 4.2.5 TEST SETUP ..............................................................................................................20 4.2.6 EUT OPERATING CONDITIONS ................................................................................20 4.2.7 TEST RESULTS ..........................................................................................................21 4.3 BAND EDGES MEASUREMENT ................................................................................23 4.3.1 LIMITS OF BAND EDGES MEASUREMENT .............................................................23 4.3.2 TEST INSTRUMENTS ................................................................................................23 4.3.3 TEST PROCEDURE ...................................................................................................23 4.3.4 DEVIATION FROM TEST STANDARD .......................................................................23 4.3.5 EUT OPERATING CONDITION ..................................................................................23 4.3.6 TEST RESULTS ..........................................................................................................24 5. PHOTOGRAPHS OF THE TEST CONFIGURATION..................................................26 6. INFORMATION ON THE TESTING LABORATORIES ................................................27 7. APPENDIX A - MODIFICATIONS RECORDERS FOR ENGINEERING CHANGES TO THE EUT BY THE LAB.........................................................................................28 Report No.: RF981110L09 3 Report Format Version 3.0.1 1. CERTIFICATION PRODUCT: Mini dongle MODEL NO.: MRT BRAND: ACROX APPLICANT: Acrox Technologies Co., Ltd TESTED: Feb. 25 ~ Feb. 26, 2010 TEST SAMPLE: ENGINEERING SAMPLE STANDARDS: FCC Part 15, Subpart C (Section 15.249) ANSI C63.4-2003 The above equipment (model: MRT) have been tested by Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the sample’s EMC characteristics under the conditions specified in this report. PREPARED BY : , DATE :Mar. 03,…

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST 2 3 RADIATED EMISSION TEST 4