PRDMUWIRWRE01Dongle

2.4G Standard Keyboard & Mouse USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installation 1 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2 Functional Introduction Battery and Power Management: Installing the batteries Step 1: Pull the battery cover backward. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. For Extra usage hours, use two AA batteries instead of two AAA Batteries. Scrolling Wheel & LED Indicator Left button Right button Battery Cover LED Indicator RF Receiver Connect Button ON/OFF Switch Push 3 Keyboard Buttons 1. LED Indicator Low Battery & Pairing Indicator 2. 103 standard-Keys 3. Connect Button 4 Battery Cover AAA battery X2 4 Setup the Connection between the Receiver and the Mouse, Keyboard. 1. Plug the RF receiver into the USB port of your computer. 2. Insert the batteries into the mouse and keyboard, then follow the steps below. 3. If the mouse or the keyboard is not working, please put them into pair mode. 4. Pairing: Re-plug the receiver into the USB port of your computer, then press connect button of the moue and keyboard. If the mouse or keyboard does not work after 10 seconds, pair them again. (The receiver has auto pairing function). 5.The LED indicators on receiver flashes when the mouse is moving or when the keyboard is in use. 6. When the battery of the keyboard is low, the Low Power indicator would blink. Scrolling Wheel & LED Indicator *Mouse Indicator Red LED is on for 10 sec. Power ON Red LED Blinking Pairing (LED OFF when paired or failed after 10 sec.) 5 LED Indicator LED Indicator Power ON *Receiver Indicator Green LED is on for 3 sec. Green LED Blinking (If any action) Power ON *Keyboard Indicator Red LED is on for 10 sec. Red LED Blinking Pairing (LED OFF when paired or failed after 10 sec.) Red LED Blinks for 10 sec. Low Battery Warning

Page 1 CONSTRUCTION PHOTOS OF EUT Page 2

FCC ID .: PRDMUWIRWRE01 Label Location

MODEL NAME: MRW FCC ID: PRDMUWIRWRE01 MRW Size: 20 x10mm

Page 3 Page 4

FCC ID: PRDMUWIRWRE01 Report No.: RF981214L15 Operational Description The transmitter of the EUT (Dongle) is powered by host equipment. The antenna is printed antenna without antenna connector. For more detailed instruction, please take a look at the user’s manual.

Report No.: RF981214L15 1 Report Format Version 3.0.1 FCC TEST REPORT REPORT NO. :RF981214L15 MODEL NO. :MRW (refer to item 3.1 for more details) RECEIVED :Dec. 14, 2009 TESTED :Dec. 18 ~ Dec. 24, 2009 ISSUED :Dec. 28, 2009 APPLICANT : Acrox Technologies Co., Ltd ADDRESS : 8F, No. 437, Rui Guang RD., Nei Hu Dist., Taipei 114, Taiwan, R.O.C. ISSUED BY : Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS : No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang, Taipei Hsien 244, Taiwan, R.O.C. TEST LOCATION : No. 19, Hwa Ya 2nd Rd, Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. This test report consists of 28 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by TAF or any government agencies. The test results in the report only apply to the tested sample. Report No.: RF981214L15 2 Report Format Version 3.0.1 Table of Contents 1. CERTIFICATION ...........................................................................................................3 2. SUMMARY OF TEST RESULTS ...................................................................................4 2.1 MEASUREMENT UNCERTAINTY ................................................................................4 3. GENERAL INFORMATION............................................................................................5 3.1 GENERAL DESCRIPTION OF EUT..............................................................................5 3.2 DESCRIPTION OF TEST MODES................................................................................6 3.2.1 CONFIGURATION OF SYSTEM UNDER TEST ...........................................................6 3.2.2 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL ................................7 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS ...............................................8 3.4 DESCRIPTION OF SUPPORT UNITS ..........................................................................8 4. TEST TYPES AND RESULTS .......................................................................................9 4.1 RADIATED EMISSION MEASUREMENT .....................................................................9 4.1.1 LIMITS OF RADIATED EMISSION MEASUREMENT...................................................9 4.1.2 TEST INSTRUMENTS ................................................................................................10 4.1.3 TEST PROCEDURES ................................................................................................. 11 4.1.4 DEVIATION FROM TEST STANDARD ....................................................................... 11 4.1.5 TEST SETUP ..............................................................................................................12 4.1.6 EUT OPERATING CONDITIONS ................................................................................12 4.1.7 TEST RESULTS ..........................................................................................................13 4.2 CONDUCTED EMISSION MEASUREMENT ..............................................................18 4.2.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT............................................18 4.2.2 TEST INSTRUMENTS ................................................................................................18 4.2.3 TEST PROCEDURES .................................................................................................19 4.2.4 DEVIATION FROM TEST STANDARD .......................................................................19 4.2.5 TEST SETUP ..............................................................................................................20 4.2.6 EUT OPERATING CONDITIONS ................................................................................20 4.2.7 TEST RESULTS ..........................................................................................................21 4.3 BAND EDGES MEASUREMENT ................................................................................23 4.3.1 LIMITS OF BAND EDGES MEASUREMENT .............................................................23 4.3.2 TEST INSTRUMENTS ................................................................................................23 4.3.3 TEST PROCEDURE ...................................................................................................23 4.3.4 DEVIATION FROM TEST STANDARD .......................................................................23 4.3.5 EUT OPERATING CONDITION ..................................................................................23 4.3.6 TEST RESULTS ..........................................................................................................24 5. PHOTOGRAPHS OF THE TEST CONFIGURATION..................................................26 6. INFORMATION ON THE TESTING LABORATORIES ................................................27 7. APPENDIX A - MODIFICATIONS RECORDERS FOR ENGINEERING CHANGES TO THE EUT BY THE LAB.........................................................................................28 Report No.: RF981214L15 3 Report Format Version 3.0.1 1. CERTIFICATION PRODUCT: Dongle MODEL NO.: MRW (refer to item 3.1 for more details) BRAND: ACROX (refer to item 3.1 for more details) APPLICANT: Acrox Technologies Co., Ltd TESTED: Dec. 18 ~ Dec. 24, 2009 TEST SAMPLE: ENGINEERING SAMPLE STANDARDS: FCC Part 15, Subpart C (Section 15.249) ANSI C63.4-2003 The above equipment (model: MRW) have been tested by Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the …

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST 2 RADIATED EMISSION TEST 3