PRDOPWIRWMU20Wireless Blue Trace Mouse

2.4G Multimedia Keyboard & Mouse USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installation 1 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2 Functional Introduction Battery and Power Management: Step 1: Pull the battery cover backward. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. For Extra usage hours, use two AA batteries instead of two AAA Batteries. **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse. Left button Right button Battery Cover Connect Button ON/OFF Switch Scrolling Wheel & LED Indicator Pull out Insert Nano Receiver 3 Keyboard Buttons AAA battery X2 Media Player Hot Keys 4 Media Player Hot Keys 1. Outlook(E-mail)
Default Start the default e-mail program 2. Homepage(www/e) Start the default Web browser and loads the home Web page 3. Web Stop Stop loading the current page 4. Search Open the Internet Explorer Search panel 5. My Favorites Start my favorites 6. Mute Mute (turns off) the computer's sound 7. Volume down (Voice-) Decrease the computer's sound volume. 8. Volume up (Voice+) Increase the computer's sound volume. 9. Play/Pause Switch between playing and pausing media 10. Calculator Start Microsoft Calculator 11. My Computer My Computer 12. LED Indicator Low Battery & Pairing Indicator 13. 104 standard-Keys 14. Connect Button 15 Battery Cover Setup the Connection between the Receiver and the Mouse, Keyboard. 1. Plug the RF receiver into the USB port of your computer. 2. Insert the batteries into the mouse and keyboard, then follow the steps below. 3. If the mouse or the keyboard is not working, please put them into pair mode. 5 4. Pairing: Re-plug the receiver into the USB port of your computer, then press connect button of the moue and keyboard. If the mouse or keyboard does not work after 10 seconds, pair them again. (The receiver has auto pairing function). 5. When the batteries’ power of the keyboard is low, the Low Power indicator will start to blink. LED indicator Power ON *Keyboard Indicator Red LED is on for 10 sec. Red LED Blinking Pairing (LED OFF when paired or failed after 10 sec.) Red LED Blinks for 10 sec. Low Battery Warning LED Indicator *Mouse Indicator LED Blinks 3 times During Pairing LED is on 3 sec. Power ON Low Battery Warning will blink 10 times when turn on.

Page 1 CONSTRUCTION PHOTOS OF EUT

size:20X10mm MODLE NAME: KBF (KEYBOARD) FCC ID:PRDCOWIFIKB08 size:20X10mm MODEL NAME: GKA (MOUSE) FCC ID:PRDOPWIRWMU20

Label Location

Page 1 CONSTRUCTION PHOTOS OF EUT Page 2 Page 3

FCC ID: PRDOPWIRWMU20 Report No.: RF990729C07 Operational Description This device is a Wireless Mouse. The transmitter of the EUT is powered by 3Vdc from batteries (1.5V AAA x 2). The antenna is printed antenna. The other instruction, please have a look at the users manual.

Report No.: RF990729C07 1 Report Format Version 3.0.1 FCC TEST REPORT REPORT NO. :RF990729C07 MODEL NO. :GKA FCC ID:PRDOPWIRWMU20 RECEIVED :Jul. 29, 2010 TESTED :Aug. 02, 2010 ISSUED :Aug. 05, 2010 APPLICANT : Acrox Technologies Co., Ltd ADDRESS : 4F., No. 89, Minshan St., Neihu Dist., Taipei City 114, Taiwan, R.O.C. ISSUED BY : Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS : No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang, Taipei Hsien 244, Taiwan, R.O.C. TEST LOCATION : No. 19, Hwa Ya 2nd Rd, Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. This test report consists of 24 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product certification, approval, or endorsement by TAF or any government agency. The test results in the report only apply to the tested sample. Report No.: RF990729C07 2 Report Format Version 3.0.1 Table of Contents 1. CERTIFICATION ...........................................................................................................3 2. SUMMARY OF TEST RESULTS ...................................................................................4 2.1 MEASUREMENT UNCERTAINTY ................................................................................4 3. GENERAL INFORMATION............................................................................................5 3.1 GENERAL DESCRIPTION OF EUT..............................................................................5 3.2 DESCRIPTION OF TEST MODES................................................................................6 3.2.1 CONFIGURATION OF SYSTEM UNDER TEST ...........................................................6 3.2.2 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL ................................7 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS ...............................................8 3.4 DESCRIPTION OF SUPPORT UNITS ..........................................................................8 4. TEST TYPES AND RESULTS .......................................................................................9 4.1 RADIATED EMISSION MEASUREMENT .....................................................................9 4.1.1 LIMITS OF RADIATED EMISSION MEASUREMENT...................................................9 4.1.2 TEST INSTRUMENTS ................................................................................................10 4.1.3 TEST PROCEDURES ................................................................................................. 11 4.1.4 DEVIATION FROM TEST STANDARD ....................................................................... 11 4.1.5 TEST SETUP ..............................................................................................................12 4.1.6 EUT OPERATING CONDITIONS ................................................................................12 4.1.7 TEST RESULTS ..........................................................................................................13 4.2 BAND EDGES MEASUREMENT ................................................................................19 4.2.1 LIMITS OF BAND EDGES MEASUREMENT .............................................................19 4.2.2 TEST INSTRUMENTS ................................................................................................19 4.2.3 TEST PROCEDURE ...................................................................................................19 4.2.4 DEVIATION FROM TEST STANDARD .......................................................................19 4.2.5 EUT OPERATING CONDITION ..................................................................................19 4.2.6 TEST RESULTS ..........................................................................................................20 5. PHOTOGRAPHS OF THE TEST CONFIGURATION..................................................22 6. INFORMATION ON THE TESTING LABORATORIES ................................................23 7. APPENDIX A - MODIFICATIONS RECORDERS FOR ENGINEERING CHANGES TO THE EUT BY THE LAB.........................................................................................24 Report No.: RF990729C07 3 Report Format Version 3.0.1 1. CERTIFICATION PRODUCT: Wireless Blue Trace Mouse MODEL NO.: GKA BRAND: ACROX APPLICANT: Acrox Technologies Co., Ltd TESTED: Aug. 02, 2010 TEST SAMPLE: ENGINEERING SAMPLE STANDARDS: FCC Part 15, Subpart C (Section 15.249) ANSI C63.4-2003 The above equipment (model: GKA) have been tested by Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the sample’s EMC characteristics under the conditions specified in this report. PREPARED BY : , DATE :Aug. 05, 2010 Joanna Wang / Senior Specialist TECHNICAL ACCEPTANCE : , DATE :Aug. 05, 2010 Responsible for RF Long Chen / Senior Engineer APPROVED BY : , DATE :Aug. 05, 2010 Gary Chang / Assistant Manager Report No.: RF990729C07 4 Report Format Version 3.0.1 2. SUMMARY OF TEST RESULTS The EUT has been tested according to the following specifications: APPLIED STANDARD: FCC Part 15, Subpart C (Section 15.249) STANDARD PARAGRAPH TEST TYPE RESULTREMARK 15.207 Conducted Emission Test NA Power supply is 3Vdc from batteries. 15.209 15.249 15.249 (d) Radiated Emission Test Band Edge Measurement Limit: 50dB less than the peak value of fundamental frequency or meet radiated emission limit in section 15.209 PASS Meet the requirement of limit. Minimum passing margin is -7.7dB at 4880.00MHz. 2.1 MEASUREMENT UNCERTAINTY Where relevant, the following measurement uncertainty levels have…

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION RADIATED EMISSION TEST