PXPAP10682.4GHz 802.11b/g Outdoor AP-Repeater-Bridge

User Manual 2.4GHz 802.11b/g Outdoor Access Point – Repeater - Bridge Professional Turbo speed - 108Mbps AP-1068 Revision : 1-07 Updated : 04 Nov 2007 Federal Communication Commission Interference Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operatio ification not authorizthe manufacturer may void users authorit is device. The equipment compliance with FCC radiation exposure limit set forth fo ncontrolled environment. n. Mod y to operate th ed by r u Important Note 1) The transmitter module may not be co-located with any other transmitter or antenna. 2) Antenna installation should be done by experienced antenna installer. Contents 1 INTRODUCTION .................................................................................... 1 THE PRODUCT........................................................................................... 1 KEY FEATURES.......................................................................................... 1 2 PACKAGE CONTENTS............................................................................. 2 CONTENT OF PACKAGE................................................................................. 2 SYSTEM REQUIREMENTS FOR CONFIGURATION...................................................... 2 3 CONNECTION ........................................................................................ 3 4 BASIC IP NETWORKING........................................................................ 3 WIRELESS LAN BASICS................................................................................ 4 5 GETTING STARTED................................................................................ 5 6 CONFIGURATION MENU ........................................................................ 6 ADMINISTRATION....................................................................................... 6 SITE SURVEY............................................................................................ 7 IP CONFIGURATION..................................................................................... 7 OPERATION MODE...................................................................................... 8 RADIO SETTING......................................................................................... 9 SECURITY SETTING....................................................................................10 WPA-PSK SECURITY.................................................................................12 WPA SECURITY........................................................................................12 MAC ADDR CONTROL.................................................................................13 PROTOCOL FILTER.....................................................................................13 SNMP CONFIGURATION...............................................................................14 MISCELLANEOUS.......................................................................................15 ASSOCIATION STATUS................................................................................16 SUPER USER............................................................................................17 FIRMWARE UPGRADE..................................................................................17 FIRMWARE VERSION...................................................................................18 7 VIPER QUICKSTART INSTALLATION ................................................... 19 8 VIPER QUICKSTART USER GUIDE........................................................ 23 9 TECHNICAL SUPPORT ......................................................................... 25 10 DISCLAIMER ....................................................................................... 26 Pg 1 of 26 1 INTRODUCTION The Product The product is based on the IEEE 802.11b/g standard, which is the latest 54Mbps Wireless LAN (WLAN) standard. Having this wireless protocols in one product ensure that your investments are protected, while enabling you to enjoy the fastest Wireless LAN speed. This product model – AP-1068 could operate as either one of the following modes : a. Wireless LAN Access Point (AP) mode. b. Wireless Ethernet Bridge mode. c. Repeater mode. Key Features Fully compatibility with IEEE 802.11b/g WLAN standard Utilize OFDM (Orthogonal Frequency Division Multiplexing) Wireless data rate of up to 108Mbps. Operates in the 2.4GHz license-free frequency band Industrial grade IP67 Casing Power over UTP cable DC supply WEP (Wired Equivalent Privacy). A simple WLAN encryption standard to protect wireless data from sniffers. WPA (WiFi Protected Access), for AP mode only. An improved WLAN encryption standard where the secret key renew automatically at regular intervals. TKIP (Temporal Key Integrity Protocol). A new encryption key will be generated by corporate RADIUS server when a authorized wireless adaptor/user associate with the Access Point. This encryption key renew automatically at regular intervals. This is normally used in high security enterprise networks. Pre Shared Key (WPA-PSK). A new key is generated each time a wireless adaptor connects to the Access Point. This normally used for home user without a RADIUS server. Remote AP list provides added security for AP mode. Protocol Filters provides security to the network IPX Filter Wireless Isolation. Each wireless user would not be able to see each other even though they are in the same subnet. This is to protect the privacy of each user. Broadcast Filter Multicast Filter Pg 2 of 26 User-friendly web-based interface for managing and configuring the Access Point. QoS features for multimedia support - voice, video and audio. 2 PACKAGE CONTENTS Content of Package AP-1068 48V DC Combiner adaptor (power over i…

Text truncated - open the document above for the full version.

External Photos EUT – Top View EUT – Bottom View EUT – Left View EUT – Right View

ID Label Label FCC ID: PXPAP1068 ID Label/Location Label Location Information Specifications: Text is Black or white in color and is left justified. Labels are printed in indelible ink on permanent adhesive backing or silk-screened onto the EUT or shall be affixed at a conspicuous location on the EUT. Refer to the below arrow.

Internal Photos EUT – Uncovered View EUT – Inside View EUT – Digital Board Top View EUT – Digital Board Bottom View EUT – Power Board Top View EUT – Power Board Bottom View EUT – RF Board Top View EUT – RF Board Bottom View

Note: This test report is for the customer shown above and their specific product only. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratory Corp. (Shenzhen). This report must not be used by the customer to claim product certification, approval, or endorsement by NVLAP, NIST or any agency of the Federal Government. FCC PART 15.247 MEASUREMENT AND TEST REPORT For RFNET Technologies Pte Ltd 801, Lorong 7 Toa Payoh, #05-02 Wearnes Technology Building, Singapore 319319. FCC ID: PXPAP1068 This Report Concerns: Original Report Equipment Type: 2.4GHz 802.11b/g Outdoor Access Point-Repeater-Bridge Test Engineer: Merry Zhao Report Number: RSZ07092502 Test Date: 2007-10-12 to 2007-10-26 Report Date: 2007-11-05 Reviewed By: EMC Manager: Boni Baniqued Prepared By: Bay Area Compliance Laboratory Corp. (Shenzhen) 6/F, the 3rd Phase of WanLi Industrial Building, ShiHua Road, FuTian Free Trade Zone Shenzhen, Guangdong, China Tel: +86-755-33320018 Fax: +86-755-33320008 RFNET Technologies Pte Ltd FCC ID: PXPAP1068 Report # RSZ07092502.doc Page 2 of 70 FCC Part 15.247 Test Report TABLE OF CONTENTS GENERAL INFORMATION.......................................................................................................................................4 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ....................................................................................4 OBJECTIVE...................................................................................................................................................................4 RELATED SUBMITTAL(S)/GRANT(S).............................................................................................................................4 TEST METHODOLOGY..................................................................................................................................................4 TEST FACILITY.............................................................................................................................................................4 HOST SYSTEM CONFIGURATION LIST AND DETAILS....................................................................................................6 LOCAL SUPPORT EQUIPMENT LIST AND DETAILS........................................................................................................6 EXTERNAL I/O CABLE..................................................................................................................................................7 SYSTEM TEST CONFIGURATION ..........................................................................................................................6 DESCRIPTION OF TEST CONFIGURATION......................................................................................................................6 EUT EXERCISE SOFTWARE..........................................................................................................................................6 SPECIAL ACCESSORIES.................................................................................................................................................6 EQUIPMENT MODIFICATIONS.......................................................................................................................................6 CONFIGURATION OF TEST SETUP.................................................................................................................................7 BLOCK DIAGRAM OF TEST SETUP................................................................................................................................8 SUMMARY OF TEST RESULTS ...............................................................................................................................9 §15.107 (a) - CONDUCTED EMISSIONS.................................................................................................................11 MEASUREMENT UNCERTAINTY..................................................................................................................................11 EUT SETUP................................................................................................................................................................11 EMI TEST RECEIVER SETUP.......................................................................................................................................12 TEST EQUIPMENT LIST AND DETAILS.........................................................................................................................12 TEST PROCEDURE......................................................................................................................................................12 TEST RESULTS SUMMARY..........................................................................................................................................12 TEST DATA................................................................................................................................................................13 PLOT(S) OF TEST DATA..............................................................................................................................................14 §15.109 - RADIATED EMISSIONS...........................................................................................................................19 APPLICABLE STANDARD............................................................................................................................................19 MEASUREMENT UNCERTAINTY..................................................................................................................................19 EUT SETUP................................................................................................................................................................19 EMI TEST RECEIVER & SPECTRUM ANALYZER SETUP................................…

Text truncated - open the document above for the full version.

Te s t S e t u p P h o t o s Conducted Emissions - Front View Conducted Emissions - Side View Radiated Emissions - Front View (Below 1 GHz) Radiated Emissions - Rear View (Below 1 GHz) Radiated Emissions - Front View (Above 1 GHz) Radiated Emissions - Rear View (Above 1 GHz)