Q55VIVOPAY4500Wireless Payment Reader

Part number: 630-0032-00Rev A A ViVOpay 4500™ User Guide May 2006 ViVOtech, Inc. 451 El Camino Real Santa Clara, CA 95050 Ph: (408) 248-7001 Email: [email protected] www.vivotech.com Copyright© 2006, ViVOtech,® Inc. All rights reserved. ViVOtech, Inc. 451 El Camino Real Santa Clara, CA 95050 Written and designed at ViVOtech, Inc. This paper, as well as the software and hardware described in it, is furnished under license and may be used or copied online in accordance with the terms of such license. The content of this paper is furnished for information use only, is subject to change without notice, and should not be construed as a commitment by ViVOtech, Inc. ViVOtech, Inc. assumes no responsibility or liability for any errors or inaccuracies that may appear in this document. Except as permitted by such license, no part of this publication may be reproduced or transmitted by electronic, mechanical, recording, or otherwise, or translated into any language form without the express written consent of ViVOtech, Inc. ViVOtech, ViVOwallet, ViVOcard, ViVOpay, and ViVOgiftcard are trademarks or registered trademarks of ViVOtech®, Inc. MasterCard Paypass is a trademark or registered trademark of MasterCard, Inc. American Express ExpressPay is a trademark or registered trademark of American Express, Inc. Warranty Disclaimer: The services and hardware are provided "as is" and "as-available," and the use of the services and hardware is at its own risk. ViVOtech does not make, and hereby disclaims, any and all other express or implied warranties, including, but not limited to, warranties of merchantability, fitness for a particular purpose, title, and any warranties arising from a course of dealing, usage, or trade practice. ViVOtech does not warrant that the services or hardware will be uninterrupted, error-free, or completely secure. May 2006 FCC/IC Regulatory Compliance Notices Class B Equipment FCC Warning: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. IC Compliance Warning: This Class B digital apparatus complies with Canadian ICES-003. Cautions and Warnings CAUTION: The unit should be mounted 1-2 feet away from other units. Can be adjusted based on lane setup. CAUTION: The unit should not be placed directly on or within 4 inches of any large metal surfaces. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer’s instructions. CAUTION: Changes or modifications not expressly approved by Vivotech could void your authority to operate the equipment. WARNING: Avoid close proximity to radio transmitters which may reduce the ability of the reader. ViVOtech Draft iv ViVOpay 4500 User Guide Table of Contents ViVOpay 4500™ Overview ......................................................................................... 1 Overview ................................................................................................................ 1 Features ................................................................................................................. 1 Additional Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 ViVOpay 4500 Specifications ................................................................................. 2 Installing ViVOpay 4500 ......................................................................................... 3 ViVOpay 4500 Counter Top Stand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Bracket and Saddle Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Ingenico enTouche 1000 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Bracket and Saddle Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Omni 3750 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Bracket and Saddle Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 ViVOpay 4500 Window Mount. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Testing with Cards and Fobs ............................................................................... 12 Troubleshooting ....................................................................................................... 13 Glossary ................................................................................................................... 14 Customer Support ................................................................................................... 16 Customer Support ................................................................................................ 16 About ViVOtech . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 ViVOtech Draft …

Text truncated - open the document above for the full version.

Page 1 of 1 Elliott TCB May 23, 2006 RE: Vivotech. FCC ID QA55VIVOPAY4500/ IC 5141A-VP4500 Attention: Chris Byleckie Please find our responses to your comments on this Application below: 1. Is the adhesive used to secure the label a permanent adhesive? Yes. 2. The Theory of Operation references an RFID radio and Antenna Driving in the block diagram. I do not see those items in the actual block diagram. Please explain. The product is an RFID reader and has antenna driving circuitry. The radio chip drives the antenna. The radio chip is located in the bold rectangle (the antenna) of the block diagram. A product overview has been uploaded to explain the operation of the EUT. A revised block diagram has also been uploaded with the word antenna added to the upper bold rectangle. 3. FYI - The height of the antenna for magnetic measurements made below 30MHz is 1m per ANSI C63.4. It appears the antenna height was varied to maximize the signal level. Noted: The field strength complied with the limits at 1m as shown in the test data. Regards, David W. Bare Chief Technical Officer

Material: Vinyl Adhesive: Standard FCC ID: Q55VIVOPAY4500 IC: 5141A-VP4500 This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interface that may cause undesired operation. 3 LISTED ITE E248414 4500 This is the rough draf t copy of the label for UL for Viv opay 4500. The final label will be shaped to fit the enclosure.

File: R53792 Page 1 of 18 2016-01 Electromagnetic Emissions Test Report and Application for Grant of Equipment Authorization pursuant to Industry Canada RSS-Gen Issue 1 / RSS 210 Issue 6 FCC Part 15 Subpart C on the Vivotech Transmitter Model: Vivopay 4500 UPN: 5141A-VP4500 FCC ID: Q55VIVOPAY4500 GRANTEE: Vivotech 451 El Camino Real Santa Clara, CA 95050 TEST SITE: Elliott Laboratories, Inc. 684 W. Maude Ave Sunnyvale, CA 94086 REPORT DATE: May 1, 2006 FINAL TEST DATES: April 5, April 21 and April 25, 2006 AUTHORIZED SIGNATORY: ______________________________ David W. Bare Chief Technical Officer Elliott Laboratories, Inc. is accredited by the A2LA, certificate number 2016-01, to perform the test(s) listed in this report. This report shall not be reproduced, except in its entirety, without the written approval of Elliott Laboratories, Inc. Elliott Laboratories, Inc. -- EMC Department Test Report Report Date: May 1, 2006 File: R53792 Page 2 of 18 pages Equipment Name and Model: Transceiver Vivopay 4500 Manufacturer: Vivotech 451 El Camino Real Santa Clara, CA 95050 Tested to applicable standard: Industry Canada RSS-Gen Issue 1 RSS 210 Issue 6 “Low-power Licence-exempt Radiocommunication Devices (All Frequency Bands): Category I Equipment” Test Report Prepared For: Dan Anchondo Vivotech 451 El Camino Real Santa Clara, CA 95050 Measurement Facility Description Filed With Department of Industry: Departmental Acknowledgement Number: IC2845 SV1 Dated August 16, 2007 Departmental Acknowledgement Number: IC2845 SV2 Dated August 16, 2007 Departmental Acknowledgement Number: IC2845 SV3 Dated August 16, 2007 Declaration of Compliance I declare that the testing was performed or supervised by me; that the test measurements were made in accordance with the above mentioned departmental standards (through the use of ANSI C63.4: 2003 as referenced by FCC Part 15 and by section 1.0 of RSS-212, Issue 1, “Test Facilities and Test Methods for Radio Equipment” / RSS-Gen Issue 1); and that the equipment performed in accordance with the data submitted in this report. Signature ______________________________ Name David W. Bare Title Chief Technical Officer Elliott Laboratories Inc. Address 684 W. Maude Ave Sunnyvale, CA 94086 USA Date: May 1, 2006 Elliott Laboratories, Inc. -- EMC Department Test Report Report Date: May 1, 2006 File: R53792 Page 3 of 18 pages TABLE OF CONTENTS COVER PAGE............................................................................................................................................................. 1 TABLE OF CONTENTS ..........................................................................................................................................3 SCOPE........................................................................................................................................................................5 OBJECTIVE ..............................................................................................................................................................6 STATEMENT OF COMPLIANCE .........................................................................................................................7 TEST RESULTS SUMMARY..................................................................................................................................7 DEVICES OPERATING IN THE 13.56 MHZ BAND (RSS 210 AND FCC 15 C) ...............................................7 MEASUREMENT UNCERTAINTIES ...................................................................................................................8 EQUIPMENT UNDER TEST (EUT) DETAILS ....................................................................................................9 GENERAL..............................................................................................................................................................9 ENCLOSURE .........................................................................................................................................................9 ANTENNA .............................................................................................................................................................9 MODIFICATIONS .................................................................................................................................................9 SUPPORT EQUIPMENT.....................................................................................................................................10 EUT INTERFACE PORTS ..................................................................................................................................10 EUT OPERATION ...............................................................................................................................................10 TEST SITE ...............................................................................................................................................................11 GENERAL INFORMATION ...............................................................................................................................11 CONDUCTED EMISSIONS CONSIDERATIONS.............................................................................................11 RADIATED EMISSIONS CONSIDERATIONS.................................................................................................11 MEASUREMENT INSTRUMENTATION ..........................................................................................................12 RECEIVER SYSTEM ..........................................................................................................................................12 INSTRUMENT CONTROL COMPUTER ..........................................................................................................12 LINE IMPEDANCE STABILIZATION NETWORK (LISN) ........................................................…

Text truncated - open the document above for the full version.