Q6WBT431201Remote (Transmitter)

1-WAY REMOTE START SYSTEM OPERATING INSTRUCTIONS CONGRATULATIONS on your choice of a Cool Start™ Remote Engine Starter and Keyless Entry with DP Technology by Crimestopper Security Products Inc. This booklet contains the information necessary for operating your system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. *IMPORTANT INFORMATION: Primary and Optional Features -PRIMARY: These are features that must be connected in order for the system to operate properly i.e. Remote Start connections, Flashing lights, and Brake Reset. For programming, the hood pin and program button are required. -OPTIONAL: These features are to be connected only if desired or agreed upon by the customer and the installing dealer i.e. Door Locks, Trunk Pop, Dome Light Illumination, Horn-Honk, Anti-Grind, etc. These features may also require additional parts and/or labor fees. Consult with your installer beforehand to be sure of what is going to be installed with your particular system. CRIMESTOPPER SECURITY PRODUCTS, INC. 1770 S. TAPO STREET, SIMI VALLEY, CA. 93063 REV 08.2012 This device complies with FCC Rules part 15. Operation is subject to the following two conditions: 1) This device may not cause interference, and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this equipment. Such modification could void the user's authority to operate the equipment. 2 TABLE OF CONTENTS Operation Cautions & Warnings.......................................................................................................2 Using the Remote Transmitter.........................................................................................................3 Status LED.................................................................................................................................4 Remote Engine Control...............................................................................................................4-7 Turbo Timer Mode........................................................................................................................8 Manual Transmission Mode............................................................................................................9 Convenience and Safety Features................................................................................................9-11 Transmitter Programming..............................................................................................................12 2 Vehicle Operation (BLUE or RED LED)..........................................................................................13 No Factory Keyless Entry after Remote Start....................................................................................14 Remote Start Diagnostics.............................................................................................................14 Battery Replacement....................................................................................................................15 2-Way Data Port........................................................................................................................16 OPERATION CAUTIONS & WARNINGS CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDORS shall not be liable for any accident resulting from the use of this equipment. This system is designed to be professionally installed into a car or vehicle in which all items, such as parking brake and all associated components, door switches, transmission shift linkage, throttle linkage, and all engine safety features, are in perfect working condition. IT IS ABSOLUTELY THE OWNER’S SOLE RESPONSIBILITY TO: A) Understand the operation of this system and its safety features. B) Check for proper operation of the system prior to accepting delivery of the vehicle from the installation facility. C) Check and maintain the condition of the vehicle and all items relative to the proper operation of this system and its safety features. D) Always leave the doors and windows closed and locked to protect against accidents and theft. DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is adequate ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes. 3 USING THE REMOTE TRANSMITTER VEH VEH NOTE: The VEH button can be used to keep remote control from accidentally operating your vehicle. See Page 13 for additional information on how to use your remote to operate a second vehicle For The transmitter supplied with this system has 4 vertical buttons – Lock, Unlock, Start and Vehicle Select. For The transmitter supplied with this system has 5 vertical buttons – Lock, Unlock, Trunk Release, Vehicle Select and Start. This remote can control up to 4 AUX functions thru data depending on the vehicle and data module. This is typically used for operating left and right sliding doors and Gas Cap release. Consult your installer. VEH 1 = Blue LED VEH 2 = Red LED AUX Outputs thru Data ( only) AUX 1 = Trunk + Lock AUX 2 = Trunk + Unlock AUX 3 = Trunk + Start AUX 4 = Lock + Start (Requires Canbus Data Module) 1# 2# 1# 2# 2# 4 STATUS LED STATUS LED: Used for Remote Start Diagnostics – page 14 (Optional, requires Installation of LED) LED will flash when locking your doors with remote. LED will remain solid in Valet Service Mode. REMOTE ENGINE CONTROL REMOTE START & TRUNK POP – Button Press Selection (Option # 6): To eliminate the possibility of accidentally opening the trunk or starting the vehicle, there are (3) options for button press selection. This option will allow you to change whether the Remote starter and Trunk release activate by a: 1. Double button - Two presses. 2. *Single ½ second press (Default). 3. Press and Hold 2 seconds.…

Text truncated - open the document above for the full version.

Report No: CCIS12080014201 China Certification & Inspection Services Co., Ltd. Project No.:CCIS120800142RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 23118282 Fax: +86 (0) 755 23116366 Page 20 of 25 8 Photographs - EUT Constructional Details Report No: CCIS12080014201 China Certification & Inspection Services Co., Ltd. Project No.:CCIS120800142RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 23118282 Fax: +86 (0) 755 23116366 Page 21 of 25 Report No: CCIS12080014201 China Certification & Inspection Services Co., Ltd. Project No.:CCIS120800142RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 23118282 Fax: +86 (0) 755 23116366 Page 22 of 25

Label : Specifications: Text is Black in color and justified. Labels are printed in indelible ink on permanent adhesive silk-screened onto the EUT or shall be affixed at a conspicuous location on the EUT. Label Location on EUT: FCC ID: Q6WBT431201 Label Location

Report No: CCIS12080014201 China Certification & Inspection Services Co., Ltd. Project No.:CCIS120800142RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 23118282 Fax: +86 (0) 755 23116366 Page 23 of 25 Report No: CCIS12080014201 China Certification & Inspection Services Co., Ltd. Project No.:CCIS120800142RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 23118282 Fax: +86 (0) 755 23116366 Page 24 of 25 Report No: CCIS12080014201 China Certification & Inspection Services Co., Ltd. Project No.:CCIS120800142RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 23118282 Fax: +86 (0) 755 23116366 Page 25 of 25 ------End------

China Certification & Inspection Services Co., Ltd. Report No: CCIS12080014201 Authorized Signature: Bruce Zhang Laboratory Manager This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the CCIS product certification mark. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” 1 Cover Page FCC REPORT Applicant: GUANGDONG STEELMATE SECURITY CO., LTD Address of Applicant: Renan Street, Dong fu Road, Dongfeng Town, Zhongshan, 528425 China. Equipment Under Test (EUT) Product Name: Remote（Transmitter） Model No.: 4312 Trade mark: Steelmate FCC ID: Q6WBT431201 Applicable standards: FCC CFR Title 47 Part 15 Subpart C Section 15.231:2011 Date of sample receipt: 27 Aug., 2012 Date of Test: 29 Aug., to 11 Sep., 2012 Date of report issue: 18 Sep., 2012 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. Report No: CCIS12080014201 China Certification & Inspection Services Co., Ltd. Project No.:CCIS120800142RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 23118282 Fax: +86 (0) 755 23116366 Page 2 of 25 2 Version Version No. Date Description 00 18 Sep., 2012 Original Prepared By: Date: 18 Sep., 2012 Project Engineer Check By: Date: 18 Sep., 2012 Reviewer Report No: CCIS12080014201 China Certification & Inspection Services Co., Ltd. Project No.:CCIS120800142RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 23118282 Fax: +86 (0) 755 23116366 Page 3 of 25 3 Contents Page 1 COVER PAGE......................................................................................................................................................... 1 2 VERSION.................................................................................................................................................................. 2 3 CONTENTS.............................................................................................................................................................. 3 4 TEST SUMMARY.................................................................................................................................................... 4 5 GENERAL INFORMATION................................................................................................................................... 5 5.1 CLIENT INFORMATION....................................................................................................................................... 5 5.2 GENERAL DESCRIPTION OF E.U.T................................................................................................................... 5 5.3 TEST MODE....................................................................................................................................................... 5 5.4 TEST FACILITY................................................................................................................................................... 6 5.5 TEST LOCATION................................................................................................................................................ 6 5.6 OTHER INFORMATION REQUESTED BY THE CUSTOMER.................................................................................. 6 5.7 TEST INSTRUMENTS LIST.................................................................................................................................. 7 6 TEST RESULTS AND MEASUREMENT DATA................................................................................................ 8 6.1 ANTENNA REQUIREMENT:................................................................................................................................. 8 6.2 RADIATED EMISSION......................................................................................................................................... 9 6.2.1 Field Strength Of The Fundamental Signal......................................................................................... 11 6.2.2 Spurious Emissions................................................................................................................................. 13 6.3 20DB BANDWIDTH........................................................................................................................................... 15 6.4 DWELL TIME:................................................................................................................................................... 17 7 PHOTOGRAPHS-TEST SETUP PHOTO.......................................................................................................... 19 8 PHOTOGRAPHS - EUT CONSTRUCTIONAL DETAILS............................................................................... 20 Report No: CCIS12080014201 China Certification & Inspection Services Co., Ltd. Project No.:CCIS120800142RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 23118282 Fax: +86 (0) 755 23116366 Page 4 of 25 4 Test Summary Test Item Section in CFR 47 Result Antenna requirement 15.203 Pass Field strength of the fundamental signal 15.231 (a) Pass Spurious emissions 15.231 (b)/15.209 Pass 20dB Bandwidth 15.231 (c) Pass Dwell ti…

Text truncated - open the document above for the full version.

Report No: CCIS12080014201 China Certification & Inspection Services Co., Ltd. Project No.:CCIS120800142RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 23118282 Fax: +86 (0) 755 23116366 Page 19 of 25 7 Photographs-test setup photo Radiated Emission(below 1G) Radiated Emission(above 1G)