Q78-ZTED90CDMA 1X-EVDO Digital Mobile Phone with Bluetooth

1 ZTE CORPORATION D90 CDMA 1X-EVDO Mobile Phone User Manual Edition: 1 st edition, Oct., 2006 Software version ZTED90V1.0.0B01 Copyright © 2006 by ZTE Corporation All rights reserved. No part of this publication may be excerpted, reproduced, trans lated or utilized in any form or by any means, electronic or mec hanical, including photocopying and microfilm, without the 2 prior written permission of ZTE Corporation. ZTE Corporation operates a policy of conti nuous development. ZTE Corporation reserves the right to make changes and improvement s to any of the products described in this document without prior notice. For this product's Recycling Manual based on WEEE directive, please send email to inquiry or visit the website below to downloa d: WWW: http://ensupport.zte.com.cn E-mail: [email protected] LIMITED WARRANTY ZTE warrants to the original purchaser that the cellular produc t and its enclosed accessories will be free from defects in mate rial and workmanship, according to the following terms and conditions: WHAT THIS WARRANTY COVERS: The limited warranty extends only to the original purchaser (end user) and is not assignable or transferable to any subsequent purchaser/end user. During the warranty period ZTE or offici ally appointed service agent will repair or r eplace any defective product or parts ther eof at its discretion. This limited warranty is applicable to the customer/end user that purchased the product from an official dealer in the United K ingdom. The purchaser (end user) must retain the original purchase in voice/till slip in order to enforce this limited warranty. WHAT THIS WARRANTY DOES NOT COVER: Defects or damages resulting from the misuse of this product ： Defects or damages from abnormal use, abno rmal conditions, improper storage, exposure to moisture or dampness, unauthorized mod ifications, unauthorized repair, neglect, abuse, accident, alteration, improper installation, blown fuses, food or liquid spillage, acts of God and shipping damage. Breakage or damage to antennas unless caused directly by defects in material or workmanship. 3 The cost of delivery or transportation of the product to the deal er of officially appointed service center will be borne by the purchaser(end user). Products received for repair by the dealer or authorized service center afte r the product warranty has expired. Products that have had the serial number removed or defaced. This limited warranty is in lieu of all other warranties, expre ssed or implied in terms of ma rketability or fitness for a parti cular use. specifically the company will accept no damage caused by or due to failure of operation or malfunction of the produc t, or arising from the use or inability to use the product. Damage resulting from the use of non-ZTE approved accessories. Scratches and damage caused by normal use. Products used outside pub lished maximum rations. Consumables such as fuses. (12) Products that have been subject to an unauthorized removal or deactivation of the network operator-lock function. Thank you for purchasing this D90 handset. In the unlikely event that your handset needs to be repaired please contact the Cust omer Services for information on how to return your handset for repair. Contents FOR YOUR SA FETY............................................................................................................. 8 G ENERAL C ARE .................................................................................................................. 8 A IRCRAFT S AFETY .............................................................................................................. 9 H OSPITAL S AFETY ............................................................................................................... 9 G ENERAL S AFETY ............................................................................................................... 9 R OAD S AFETY .................................................................................................................. 10 V EHICLES EQUIPPED WITH AN AIR BAG ................................................................................ 12 E FFICIENT USE .................................................................................................................. 12 R ADIO FREQUENCY ENERGY .............................................................................................. 12 E MERGENCY S ERVICES ..................................................................................................... 12 C OPYRIGHT N OTICE .......................................................................................................... 13 4 GETTING STARTED ........................................................................................................... 14 O VERVIEW ........................................................................................................................ 14 P HONE AT A GLANCE .......................................................................................................... 14 K EY DEFINITION ................................................................................................................ 15 D ISPLAY S YMBOLS ............................................................................................................ 16 T ECHNICAL INFORMATION .................................................................................................. 17 T HE UIM C ARD ................................................................................................................ 17 M EMORY CARD ................................................................................................................. 18 Using your phone’s Micro SD memory card............................................................... 18 B ATTERY .......................................................................................................................... 18 P OWER ON / OFF Y OUR P HONE ........................…

Text truncated - open the document above for the full version.

Dec. 06, 2006 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Confidentiality Request Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, we, ZTE CORPORATION, hereby request confidential treatment of information accompanying this Application ( FCC ID: Q78-ZTED90) as outlined below: Exhibit Type File Name Block Diagram, ZTE D90 Block Diagram.pdf Schematics ZTE D90 SCH.pdf Operational Description ZTE D90 operational description.pdf Parts List ZTE D90 PART_LIST.pdf Tune Up Info ZTE D90 Tune-up.pdf The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to us, ZTE CORPORATION, and provide unjustified benefits to its competitors. We, ZTE CORPORATION, understand that pursuant to Rule 0.457, disclosure of this Application (FCC ID: Q78-ZTED90) and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely Yours, Li dezi Dec. 14 2006 ZTE CORPORATION

EXTERNAL PHOTOS

ZTE中兴 MODEL: ZTE D90 CDMA 1X-EVDO Digital Mobile Phone FCC ID:Q78-ZTED90 ESN NO:6980EB03 ZTE CORPORATION

29 December 2006 Equipment Authorization Division Office of Engineering and Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 Ref: FCC ID: Q78-ZTED90 Dear Sirs: ZTE CORPORATION requests acceptance of the labeling proposal described below for cell phone bearing FCC identifier Q78-ZTED90. The subject cell phone are compact handheld models as shown in figure 1, authorized under 47CFR Part 22/ Part 24 for CDMA mobile services. \ Figure 1. Because the majority of the cell phone housing is composed of display, speaker, operating controls,and a removable battery pack, there is extremely limited space available to attach the required label carrying the FCC identifier. Attaching the label to the battery pack is not acceptable because the battery pack is a removable item. For this reason, ZTE CORPORATION proposes placing the label carrying the FCC identifier inside the battery compartment as shown in figure 2. Figure 2. The consumer packaging for these models includes the battery pack as a separate item, NOT installed on the radio. As such, the FCC identifier will be readily visible to the user before the battery pack is installed and whenever the battery pack is removed or replaced. In this location, the label will also be protected from physical abuse and remain readable for the anticipated life of the device. The consumer packaging for these models is a "gift box" which does not allow the transceiver to be seen at time of purchase. In order to meet the requirements of 47CFR Part 2.925 (d), ZTE CORPORATION will add the FCC identifier " Q78-ZTED90" to the outside of the consumer "gift box" packaging. Thank you for your attention to this matter. Sincerely, Li dezi 8 January 2007

INTERNAL PHOTOS

Report No. FCC06-8098 Page 2 of 47 Table of Contents 1 Test Report Certification ...............................................................................................................3 2 General Information ......................................................................................................................3 2.1 Description of EUT ...............................................................................................................3 2.3 Test Standards and Results ....................................................................................................3 2.4 List of Test Equipments Used ...............................................................................................3 2.5 Test Facility ...........................................................................................................................3 2.6 Environmental conditions .....................................................................................................3 3 Conducted Emission Test ..............................................................................................................3 3.1 Limits of Conducted Emission..............................................................................................3 3.2 Test Procedure .......................................................................................................................3 3.3 Test Setup ..............................................................................................................................3 3.4 EUT Setup and Operating Conditions...................................................................................3 3.5 Test Results ...........................................................................................................................3 4 Radiated Emission Test .................................................................................................................3 4.1 Limits of Radiated Emission .................................................................................................3 4.2 Test Procedure .......................................................................................................................3 4.3 Test Setup ..............................................................................................................................3 4.4 EUT Setup and Operating Conditions...................................................................................3 4.5 Test Results ...........................................................................................................................3 5 Bandwidth and Carried Frequency Separation .............................................................................3 5.1 Definition ..............................................................................................................................3 5.2 Test Procedure .......................................................................................................................3 5.3 Test Setup ..............................................................................................................................3 5.4 EUT Setup and Operating Conditions...................................................................................3 5.5 Test Results ...........................................................................................................................3 6 Hopping Sequence ........................................................................................................................3 6.1 Requirement of the standard .................................................................................................3 6.2 Test Results ...........................................................................................................................3 7 Equal Hopping Frequency Use .....................................................................................................3 7.1 Requirement of the standard .................................................................................................3 7.2 Test Results ...........................................................................................................................3 8 Receiver Input Bandwidth and Hopping Capability .....................................................................3 Report No. FCC06-8098 Page 3 of 47 8.1 Requirement of the standard .................................................................................................3 8.2 Test Results ...........................................................................................................................3 9 Time of Occupancy (Dwell Time) ................................................................................................3 9.1 Requirement of the Standard.................................................................................................3 9.2 Test Procedure .......................................................................................................................3 9.3 Test Setup ..............................................................................................................................3 9.4 EUT Setup and Operating Conditions...................................................................................3 9.5 Test Results ...........................................................................................................................3 10 Peak Output Power......................................................................................................................3 10.1 Requirement of the standard ...............................................................................................3 10.2 Test Procedure .....................................................................................................................3 10.3 Test Setup ...........................................................…

Text truncated - open the document above for the full version.

Report No. FCC06-8093 Page 26 of 27 Appendix IIPhotographs of the Test Configuration 1. Conducted Emission Test, Mobile Mode 2. Conducted Emission Test, USB Mode Report No. FCC06-8093 Page 27 of 27 3. Radiated Emission Test, Mobile Mode 4. Radiated Emission Test, USB Mode