QQGCP-2020Bluetooth VOIP Phone

Enter "0000" and press OK. v1.0 2007.8 1 2 3 3 links VoIP phone with Bluetooth laptop or dvice V1.0 2007.8 Xpress VoIP Phone Quick Startup Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: . Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. . Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 54 of 64 External Photos Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 55 of 64 Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 56 of 64

22.8 mm Bluetooth VOIP Phone Model no.: CP-2020 FCC ID: QQGCP-2020 BD: Made in Taiwan 11.8mm

Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 57 of 64 Internal Photos Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 58 of 64 Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 59 of 64 Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 60 of 64 Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 61 of 64

of Applicant: J-THREE INTERNATIONAL HOLDING CO., LTD. Address: No. 23-7, Dungshyh 12 Lirn, Dungshyh Lii, Pingchien City Taoyuan Hsien 324, Taiwan Tested and Prepared by ETS Product Service (Taiwan) Co., Ltd. FCC Registration No.: 930600 Industry Canada filed test laboratory Reg. No. IC 5679 A2LA Accredited No.: 2300.01 PTCRB Accredited Type Certification Test House FCC ID: QQGCP-2020 Report No.: W6M20709-8516-P-15 6F, NO. 58, LANE 188, RUEY-KUANG RD., NEIHU TAIPEI 114, TAIWAN, R.O.C. TEL: 886-2-66068877 FAX: 886-2-66068879 E-mail: [email protected] FCC TEST REPORT for Bluetooth VOIP Phone Model No.: CP-2020 Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd. Page 1 of 30 TABLE OF CONTENTS 1 GENERAL INFORMATION ...................................................................................................... 2 1.1 Notes .................................................................................................................................... 2 1.2 Testing laboratory ................................................................................................................ 3 1.2.1 Location ....................................................................................................................... 3 1.2.2 Details of accreditation status ...................................................................................... 3 1.3 Details of approval holder.................................................................................................... 3 1.4 Application details ............................................................................................................... 4 1.5 General information of Test item......................................................................................... 4 1.6 Test standards ...................................................................................................................... 5 2 TECHNICAL TEST .................................................................................................................... 6 2.1 Summary of test results........................................................................................................ 6 2.2 Test environment ................................................................................................................. 6 2.3 Test Equipment List ............................................................................................................. 7 2.4 General Test Procedure........................................................................................................ 9 3 TEST RESULTS (ENCLOSURE) ............................................................................................ 11 3.1 Peak Output Power (transmitter) ....................................................................................... 12 3.2 Equivalent isotropic radiated power .................................................................................. 14 3.3 RF Exposure Compliance Requirements ........................................................................... 14 3.4 Out of Band Radiated Emissions ....................................................................................... 14 3.5 Transmitter Radiated Emissions in restricted Bands ......................................................... 15 3.6 Spurious emissions (tx)...................................................................................................... 16 3.7 Carrier Frequency Separation ............................................................................................ 20 3.8 Number of Hopping Frequencies....................................................................................... 21 3.8.1 Pseudorandom Frequency Hopping Sequence........................................................... 21 3.8.2 Coordination of hopping sequences to other transmitters ......................................... 21 3.8.3 System Receiver Hopping Capability ........................................................................ 21 3.9 Time of Occupancy (Dwell Time) ..................................................................................... 22 3.10 20dB Bandwidth ................................................................................................................ 24 3.10.1 System Receiver Input Bandwidth ............................................................................ 24 3.11 Band-edge Compliance of RF Emissions .......................................................................... 25 3.12 Radiated Emission from Digital Part ................................................................................. 26 3.13 Power Line Conducted Emission....................................................................................... 28 APPENDIX........................................................................................................................................ 30 Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd. Page 2 of 30 1 General Information 1.1 Notes The purpose of conformity testing is to increase the probability of adherence to the essential requirements or conformity specifications, as appropriate. The complexity of the technical specifications, however, means that full and thorough testing is impractical for both technical and economic reasons. Furthermore, there is no guarantee that a test sample which has Passed all the relevant tests conforms to a specification. Neither is there any guarantee that such a test sample will interwork with other genuinely open systems. The existence of the tests nevertheless provides the confidence that the test sample possesses the qualities as maintained and that is performance generally conforms to representative cases of communications equipment. The test results of this test report relate exclusively to the item tested as specified in 1.5. The test report may o…

Text truncated - open the document above for the full version.

Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 62 of 64 Set Up Photo of Radiated Emission RF Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 63 of 64 EMI Registration number: W6M20709-8516-P-15 FCC ID : QQGCP-2020 ETS Product Service (Taiwan) Co., Ltd.Appendix page 64 of 64 Set Up Photo of Conducted Emission