QVL-BM68X-2Contactless Smart Card Reader

Drilling template • 10mm (0.39”) diameter hole for wire entry • 2 x 3.6mm (0.14”) diameter holes for mounting screws Specifications Output protocols Wiegand or RS485 (BM686 only) Power requirement 6 – 18V DC (Nominal operating voltage 12V DC) Current consumption 37mA (Average) 83mA (Peak) Read range 20-40mm (0.8”-1.6”) at 12V DC depends on the type of card used Operating temperature -25’C to +65’C (-13’F to 149’F) Relative humidity 90% max, operating non-condensing Reader dimensions 84.55mm(L) x 42.95mm(W) x 20.70mm(D) (3.33”x1.69”x0.81”) Status LED Green & Red Audible tone Internal and external buzzer control, Configurable using “Configuration Card” Colour finish Charcoal IP rating IP65 Information obtained in this document is subject to change without notice. For further technical information, visit our website at www.bqtsolutions.com or email [email protected]. Alternatively contact us at one of our global locations AUSTRALIA & PACIFIC BQT Solutions (Australia) Pty Limited Level 1, 82 Waterloo Road Macquarie Park, NSW 2113, Australia Phone: +61 (0)2 8817 2800 Fax: +61 (0)2 8817 2811 Email: [email protected] EUROPE AND MIDDLE EAST BQT Solutions (UK) Limited Regal House, 70 London Road Twickenham, TW1 3QS United Kingdom Phone: +44 (0)20 8622 4428 Fax: +44 (0)20 8622 4401 Email: [email protected] GREATER ASIA BQT Solutions Singapore Office Mediapolis 71 Ayer Rajah Crescent #03-03 Singapore 139951 Phone: +65 6220 7970 Fax: +65 6220 7656 Email: [email protected] Copyright © 2012 BQT Solutions Limited. BQT Solutions and the BQT solutions logo are registered trademarks of BQT Solutions (Australia) Pty Ltd. Wiring diagram Note: • A shielded cable is recommended to be used. The shield is connected to controller 0V reference • Maximum wiegand data cable length: 150 meters (500 feet) • Buzzer and LED are activated when buzzer and LED line go below 2.5V. • RS485 lines and Relay lines are only for optional use • Some models have additional wires/connectors which are not specified in the diagram above. These wires are for other requirements. DO NOT connect them unless specified from BQT Solutions or a BQT authorized distributor. Any damage caused by incorrect connection will void the warranty • Terminate or insulate all un-used wires Regulatory Information C-Tick: This device is C-Tick complied. CE: The device has passed all relevant tests and obtained CE approval. FCC: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference and 2) this device must accept any interference received, including interference that may cause undesired operation of the device. Warning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressively approved by BQT Solutions could void the user’s authority to operate this equipment. Mini Series INSTALLATION GUIDE Version1.3 Disassemble 1. Use fingers to squeeze the reader cover 2. Pull the cover from the top of reader Note: DO NOT use a screw driver or other implement to remove cover. Incorrect removal of cover may damage the LED and void the warranty. Mounting 1. If necessary, use the drilling template provided to drill holes. 2. The mounting screw size is #3 gauge. Note: Be careful of cables when drilling For installation on standard electrical gang box, a universal mounting adaptor plate (BQT Part number: BP-BM) can be used. Please contact BQT for further information. Wire connection Note: Power to the unit is provided from the listed control unit or from a separately UL listed 12V DC power-limited, access control power source. DO NOT supply power during installation. Wiring methods shall be in accordance with the Electrical Wiring Regulation in your country / region Check your circuit diagram for the colour coding of the circuit wiring. The reader can be damaged beyond repair if the wiring is connected incorrectly. This will void the warranty. 1. Connect the 0V wire to the power 0V line; Note: The 0V line of all power supplies must be connected to a common 0V reference point. 2. Connect the Wiegand data wires; 3. Connect the Buzzer and LED wires; 4. Connect 12V DC wire; 5. Place reader on the wall (Make sure the wires are not crushed. This will void the warranty of damage occurs) 6. Insert and hand tighten the screws; 7. Check that the reader is level before tightening the screws; Note: Excessive tightening of screws may deform the casing, resulting in a damaged unit. This will void the warranty. 8. Turn on the 12V DC power to power up reader. 9. Allow 5 – 10 seconds for reader to finish initialization (depends on the application). Make sure reader is functioning correctly according to the application specification. Cover After checking reader function, attach front cover back to the reader 1. Align the bottom of front cover with the bottom of reader; Note: Make sure LED is aligned to the LED hole on the cover;…

Text truncated - open the document above for the full version.

FCC RADIO TEST REPORT Report No. : EP271740 SPORTON International Inc. PAGE NUMBER : B1 OF B8 TEL : 886-3-327-3456 ISSUED DATE : Nov. 14, 2012 FAX : 886-3-327-0973 APPENDIX B. Photographs of EUT Marketing Name BM682/BM683/BM684 /BM686 FCC RADIO TEST REPORT Report No. : EP271740 SPORTON International Inc. PAGE NUMBER : B2 OF B8 TEL : 886-3-327-3456 ISSUED DATE : Nov. 14, 2012 FAX : 886-3-327-0973 Marketing Name BT930 FCC RADIO TEST REPORT Report No. : EP271740 SPORTON International Inc. PAGE NUMBER : B3 OF B8 TEL : 886-3-327-3456 ISSUED DATE : Nov. 14, 2012 FAX : 886-3-327-0973 FCC RADIO TEST REPORT Report No. : EP271740 SPORTON International Inc. PAGE NUMBER : B4 OF B8 TEL : 886-3-327-3456 ISSUED DATE : Nov. 14, 2012 FAX : 886-3-327-0973

FCC RADIO TEST REPORT Report No. : EP271740 SPORTON International Inc. PAGE NUMBER : B4 OF B8 TEL : 886-3-327-3456 ISSUED DATE : Nov. 14, 2012 FAX : 886-3-327-0973 FCC RADIO TEST REPORT Report No. : EP271740 SPORTON International Inc. PAGE NUMBER : B5 OF B8 TEL : 886-3-327-3456 ISSUED DATE : Nov. 14, 2012 FAX : 886-3-327-0973 FCC RADIO TEST REPORT Report No. : EP271740 SPORTON International Inc. PAGE NUMBER : B6 OF B8 TEL : 886-3-327-3456 ISSUED DATE : Nov. 14, 2012 FAX : 886-3-327-0973 FCC RADIO TEST REPORT Report No. : EP271740 SPORTON International Inc. PAGE NUMBER : B7 OF B8 TEL : 886-3-327-3456 ISSUED DATE : Nov. 14, 2012 FAX : 886-3-327-0973

FCC RADIO TEST REPORT Report No. : FR271740 SPORTON International Inc. Report Format Version: a FCC RADIO TEST REPORT According to 47 CFR FCC Part 15 Subpart C § 15.225 Equipment : 13.56MHz Contactless Smart Card Reader Brand Name : BQT Solutions Model Name BM68X Marketing Name : BM682/BM683/BM684/BM686/BT930 FCC ID : QVL-BM68X-2 Applicant Manufacturer : BQT Solutions (Australia) Pty Ltd Level 1, 82 Waterloo Rd, Macquarie Park, NSW 2113, Australia Received Date : Jul. 19, 2012 Final Test Date : Dec. 04, 2012 Statement The test result in this report refers exclusively to the presented test model / sample. Without written approval of SPORTON International Inc., the test report shall not be reproduced except in full. The measurements and test results shown in this test report were made in accordance with the procedures and found in compliance with the limit given in ANSI C63.4-2003 and 47 CFR FCC Part 15 Subpart C. The test equipment used to perform the test is calibrated and traceable to NML/ROC. SPORTON International Inc. No. 52, Hwa Ya 1 st Rd., Hwa Ya Technology Park, Kwei-Shan Hsiang, Tao Yuan Hsien, Taiwan, R.O.C. FCC RADIO TEST REPORT Report No. : FR271740 SPORTON International Inc. Page No. : i of ii TEL : 886-3-327-3456 Issued Date : Dec. 06, 2012 FAX : 886-3-327-0973 FCC ID : QVL-BM68X-2 Table of Contents 1. SUMMARY OF THE TEST RESULT .................................................................................................................. 2 2. GENERAL INFORMATION................................................................................................................................ 3 1.1 Product Details ............................................................................................................................................................................................. 3 2.1 Table for Test Modes ................................................................................................................................................................................... 3 1.2 Table for Testing Locations ......................................................................................................................................................................... 3 1.3 Table for Supporting Units ........................................................................................................................................................................... 3 2.2 Test Configurations ...................................................................................................................................................................................... 4 3. TEST RESULT .................................................................................................................................................. 6 3.1 AC Power Line Conducted Emissions Measurement ................................................................................................................................. 6 3.2 Field Strength of Fundamental Emissions and Mask Measurement........................................................................................................ 10 3.3 20dB Spectrum Bandwidth Measurement ................................................................................................................................................ 13 3.4 Radiated Emissions Measurement............................................................................................................................................................ 16 3.5 Frequency Stability Measurement ............................................................................................................................................................. 20 3.6 Antenna Requirements .............................................................................................................................................................................. 22 4. LIST OF MEASURING EQUIPMENTS............................................................................................................. 23 5. TEST LOCATION ............................................................................................................................................ 25 6. TAF CERTIFICATE OF ACCREDITATION ...................................................................................................... 26 APPENDIX A. TEST PHOTOS ............................................................................................................................ A6 APPENDIX B. PHOTOGRAPHS OF EUT ............................................................................................................ B8 FCC RADIO TEST REPORT Report No. : FR271740 SPORTON International Inc. Page No. : ii of ii TEL : 886-3-327-3456 Issued Date : Dec. 06, 2012 FAX : 886-3-327-0973 FCC ID : QVL-BM68X-2 History of This Test Report Original Issue Date: Nov. 14, 2012 Report No.: FR271740 Ƒ No additional attachment. Ŷ Additional attachment were issued as following record: Attachment No. Issue Date Description FR271740 Nov. 14, 2012 Initial issue of report FR271740 Dec. 06, 2012 Add. AC Power Line Conducted Emissions tested. 15.205(a) 15.209(a) 47 CFR FCC Part 15 Subpart C Further, this requirement does not apply to intentional radiators that must be professionally installed. FCC RADIO TEST REPORT Report No. : FR271740 SPORTON International Inc. Page No. : 1 of 26 TEL : 886-3-327-3456 Issued Date : Dec. 06, 2012 FAX : 886-3-327-0973 FCC ID : QVL-BM68X-2 CERTIFICATE OF COMPLIANCE According to 47 CFR FCC Part 15 Subpart C § 15.225 Equipment : 13.56MHz Contactless Smart Card Reader Brand Name : BQT Solutions Model No. : BM68X Applicant : BQT Solutions (Australia) Pty Ltd Level 1, 82 Waterloo Rd, Macquarie Park, NSW 2113, Australia Sporton International as requested by the applicant to evaluate the EMC performance of the product sample received on Jul. 19, 2012 would like to declare that the tes…

Text truncated - open the document above for the full version.

FCC RADIO TEST REPORT Report No. : FR271740 SPORTON INTERNATIONAL INC. Page No. : A1 of A6 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973 Appendix A. Test Photos FCC RADIO TEST REPORT Report No. : FR271740 SPORTON INTERNATIONAL INC. Page No. : A2 of A6 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973 Photographs of Conducted Emissions Test Configuration FRONT VIEW REAR VIEW FCC RADIO TEST REPORT Report No. : FR271740 SPORTON INTERNATIONAL INC. Page No. : A3 of A6 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973 SIDE VIEW FCC RADIO TEST REPORT Report No. : FR271740 SPORTON INTERNATIONAL INC. Page No. : A4 of A6 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973 1 Photographs of Radiated Emissions Test Configuration For radiated emissions 9kHz~30MHz FRONT VIEW REAR VIEW FCC RADIO TEST REPORT Report No. : FR271740 SPORTON INTERNATIONAL INC. Page No. : A5 of A6 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973 For radiated emissions 30MHz~1GHz FRONT VIEW REAR VIEW FCC RADIO TEST REPORT Report No. : FR271740 SPORTON INTERNATIONAL INC. Page No. : A6 of A6 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973 EUT take a close-up. FRONT VIEW REAR VIEW