S4W6002AREVOLUTION- 2 SPEED TURNTABLE WITH USB

Revolution www.crosleyradio.com 910-101011-0020-200 Instruction Manual CR6002A Troubleshooting General Transporting Specification Power source:AC Adaptor AC120V/DC 9V 600mA Power Consumption:6W Antenna:Built-in antenna for FM TRANSMTTER Speed:33 1 / 3 ,45 RPM Speaker:28 x 40 mm 8ohm 2W Audio output:600mW Replacement Needle:NP4 FM Transmtter Frequency:88.1MHz / 89.9MHz * DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within an equilateral triangle is intended to alert user to the presence of important operating and maintenance (servicing) instruction in the literature accompanying the appliance. RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lighting flash with arrowhead symbol, within an equilateral triangle, is intended to alert user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute risk of electric shock to persons. 9 There is no Power 1Make sure unit is plugged in correctly. 2Replace batteries 3The unit is not turned on: press the POWER button to ON Position. There is no Sound 1Slide the VOLUME CONTROL to raise volume. 2Check to make sure headphones are not plugged into the unit. No signal on FM Transmitter 1Make sure TRANSMITTER SWITCH is on the ON position. 2Make sure the unit and the FM tuner are set to the same frequency. 3Check that the distance between the two is 20 feet or less. 4Remove obstructions to minimize interference. 5Try moving the Revolution closer to the FM tuner to reduce signal interference. To safely transport your Revolution, follow the steps below to prevent damage to your unit. 1Place protective needle cover over needle. 2Place the 45rpm adapter on the revolution as shown below 3Move the TONE ARM from the ARM REST and position it over the 45rpm adapter and align the TONE ARM with the grooves in the 45rpm adapter as shown below. 4Gently press TONE ARM into grooves on 45rpm adapter. 5Close the LID and check to make sure it is secure. This unit is equipped with a built in FM transmitter. This feature allows the user to listen to their albums on any FM radio within approximately 15-20 feet. To use this feature, follow the instructions below. 1Slide the TRANSMITTER ON/OFF switch to the ON position. 2Slide the FREQUENCY SELECT switch to either 88.1 or 89.9 MHz. 3Adjust the tuner on your FM radio to match the selected frequency from step 2. 4Follow the instructions for Turntable Operation on the left side of this page. 5Adjust the volume of your FM radio accordingly. Notes: 1Switch between the two frequencies listed above to determine which gives you the best signal for your location. 2The maximum range of the FM Transmitter is approximately 20 feet,depending on your location. 3For best performance, a clear line of sight between the Revolution and your FM radio is recommended. 1Press the POWER button to turn the unit on. 2Set the SPEED CONTROL SWITCH to the correct speed (33-1/3 or 45) for the selected record. 3Slide the LID LOCK towards the rear of the unit to open the lid. 4Lift the TONE ARM from its rest and gently move it to the right until it clicks into the ARM LOCK as shown below. 5Remove the 45rpm adapter from the unit. If you are playing a 45 rpm record, place the adapter on the spindle. 6Place record on the turntable. 7Gently move the tone arm from the ARM LOCK and lower it to the desired starting point on the record. 8Slide the VOLUME CONTROL to adjust the volume level. 9At the end of the record, lift the TONE ARM from the record and return it to the ARM REST. TurntableFM Transmitter Basic OperationControl Locators TONE ARM SPINDLE TURNTABLE POWER INDICATOR POWER ON/OFF SWITCH SPEED CONTROL SWITCH VOLUME CONTROL 45 RPM ADAPTER ARM HOOK 47 LID LOCKCARRY STRAP IMPORTANT SAFETY INSTRUCTION PLEASE READ CAREFULLY ALL THE FOLLOWING IMPORTANT SAFEGUARDS THAT ARE APPLICABLE TO YOUR EQUIPMENT 1.Read Instructions - All the safety and operating instructions should be read before the product is operated. 2.Retain instructions - The safety and operating instructions should be retained for future reference. 3.Heed Warnings - All warnings on the product and in the operating Instructions should be adhered to. 4.Follow Instructions - All operating and use instructions should be followed. 5.Cleaning - Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners.Use a damp cloth for cleaning. 6.Attachments - Do not use attachments not recommended by the product manufacturer as they may cause hazards. 7.Water and Moisture - Do not use this product near water - for example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like. 8.A product and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn. 9.Ventilation - Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered, The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should not be placed in a built - in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. 10.Power Sources - This product should be operated only from the type of power source indicated on the marking label, if you are not sure of the type of power supply to your home. Consult your pro…

Text truncated - open the document above for the full version.

                                          !"#$%&'!"(%)#*#++,+*-$.-!&/#$-!& ,001)% $)                                  2          2                   3     4     5 2 6     3 37           8 8100190     ,         2 8 100:00       !" #   $   % !"    %  :;90:090 <"+)="**-& #"+>"<!9?-.<2 %#+  !"-$"++%@A*-<.-##->"$B>-*-$)""-$+ 9<"+)="*&C$-*%+<!&.%#"$!.!$*$) :<"+)="*&%+** $C"$!.!$*!*"=)  "$*#%)"$B"$!.!$*<&C*%+%$)+"!)- !"-$                 ->! -%!* 9:0DE0F ->! -$+%& "-$ 104 %!!$"$B0:?    52     5  , 5    ,     2  3  2      & '      5 , 5     ,         & -!)@C-)!$!G"$B -$* + 9::0+G ! -%"+="##5$%*GCH0:0H 2   H4:H8 <"+)="**-& #"+>"<!9?-.<2 %#+  !"-$"++%@A*-<.-##->"$B>-*-$)""-$+ 9<"+)="*&C$-*%+<!&.%#"$!.!$*$) :<"+)="*&%+** $C"$!.!$*!*"=) "$*#%)"$B"$!.!$*<&C*%+%$)+"!)- !"-$ <"+ #++,)"B"# !%+*-& #"+>"< $)"$  001 2  2   !-)%**-& #"+>"<2%#+:9 2 %@*< !I #"*"-$)-.&$%.*%!  (     (       )     )   

OPERATIONAL DESCRIPTION: In phone mode position, to start playback recorder disc of the PCM data are transfer to the IC201 of the pre-amplifier and then it will pass to IC401 when receiving the audio data, the IC401 stores the first audio packet, which contained 1-Ms audio data, into the internal storage buffer. The IC401 starts playing the audio data to the USB device output then connects with the USB cable to through the computer of the USB enhanced host. After the operating system must be working on the host PC. The audio signal will pass through to the frequency modulation transmission (FM TX 88.1, 89.9 MHz). The frequency channel is selected by slide switch. The FM signal will pass to the capacitor and transmit by the antenna.

6 5 4 3 2 1 DCBA S H E E T : O F T I T L E : C O M P A N Y : C H E C K E D : D A T E D : D R A W N : S I Z E : R E V : 1 1 F M - T X 2 0 1 0 年 7 月 1 9 日 A 3 D A T E D : 0 0 0 DCBA 2 0 1 0 年 7 月 1 9 日 1 0 1 M H Z 1 0 2 M H Z 1 0 3 M H Z S W 1 频 率 切 换 GND XI XO IOVDD GND L_IN R_INRSTB GND GND SDA SCL GND PA_OUT GND SW U 1 K T 0 0 3 S D A S C L R S T B V S S C H 2 C H 3 T X L E D V D D U 2 R 0 0 1 S 2 - A C 7 1 0 4 R 5 2 2 0 R Y 2 7 . 6 M H Z C 3 4 1 5 p F C 3 5 1 5 p F C 1 1 0 4 R 2 1 0 K R 3 1 0 K F M - T X C 2 1 0 5 C 3 1 0 5 R 6 1 0 K R 7 1 0 K R 8 5 K 6 R 9 5 K 6 R 1 0 * * * R 1 1 * * * C 4 1 0 2 C 5 1 0 3 C 6 1 0 3 3 V 3 V R _ I N L _ I N PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.cn