SJ6-W6055Wireless Solar Keyboard

FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. CAUTION:

Page 21 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F APPENDIX I(External Photos) Figure 1 The EUT-Front View Figure 2 The EUT-Back View Page 22 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F Figure 3 The EUT-Side View

FCC ID Label Sample for FCC ID: SJ6-W6055 FCC ID: SJ6-W6055 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.

1. Label Location: The EUT Back View

Page 23 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F APPENDIX II(InternalPhotos) Figure 4 The EUT-Inside View Figure 5 The EUT-Inside View Page 24 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F Figure 6 The EUT-Inside View Figure7 PCB of the EUT-Front View Page 25 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F Figure 8 PCB of the EUT-Back View

Page 1 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F FCC TEST REPORT for Shenzhen Weijian Plastics Co., Ltd Wireless Solar keyboard Model No.: W6055, KB6055, SL-6439-BK Report Number : 201208663F Date of Test : Aug. 02~22, 2012 Date of Report : Aug. 23, 2012 Prepared for : Shenzhen Weijian Plastics Co., Ltd Address : Shangpai Industrial Park, Shiyan Township Baoan District, Shenzhen，China Prepared By : Anbotek Compliance Laboratory Limited Address : 1/F, 1 /Building, SEC Industrial Park, No. 4 Qianhai Road, Nanshan District, Shenzhen, 518054, China Tel: (86) 755-26014771 Fax: (86) 755-26014772 Page 2 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F TABLE OF CONTENTS Description Page Test Report 1.GENERAL INFORMATION ..........................................................................................................4 1.1.Description of Device (EUT).....................................................................................................................4 1.2.Auxiliary Equipment Used during Test .....................................................................................................5 1.3.Description of Test Facility .......................................................................................................................6 1.4.Measurement Uncertainty..........................................................................................................................6 2. TEST PROCEDURE ....................................................................................................................... 7 3. CONDUCTED LIMITS .................................................................................................................. 8 3.1. Block Diagram of Test Setup ...................................................................................................................8 3.2. Power Line Conducted Emission Measurement Limits (15.207) .............................................................8 3.3. Configuration of EUT on Measurement ...................................................................................................8 3.4. Operating Condition of EUT ....................................................................................................................8 3.5. Test Procedure ..........................................................................................................................................9 3.6. Power Line Conducted Emission Measurement Results ..........................................................................9 4. RADIATION INTERFERENCE.................................................................................................. 12 4.1. Requirements (15.249, 15.209): .............................................................................................................12 4.2 Test Procedure .........................................................................................................................................12 4.3 Test Results..............................................................................................................................................12 5. OCCUPIED BANDWIDTH..........................................................................................................16 5.1. Requirements (15.249): ..........................................................................................................................16 5.2. Test Procedure ........................................................................................................................................16 5.3. Test Configuration:.................................................................................................................................16 5.4. Test Results.............................................................................................................................................16 6.PHOTOGRAPH.............................................................................................................................. 18 6.1. Photo of Power Line Conducted Emission Measurement ......................................................................18 6.2. Photo of Radiation Emission Test ..........................................................................................................19 APPENDIX (Photos of EUT) (4 Pages) Page 3 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F TEST REPORT Applicant : Shenzhen Weijian Plastics Co., Ltd Manufacturer : Shenzhen Weijian Plastics Co., Ltd. EUT : Wireless Solar keyboard Model No. : W6055, KB6055, SL-6439-BK Serial No. : N/A Rating : DC 3.7V, 5mA Trade Mark : N.A. Measurement Procedure Used: FCC Part15 Subpart C, Paragraph 15.207, 15.249 & 15.209 The device described above is tested by Anbotek Compliance Laboratory Limited to determine the maximum emission levels emanating from the device and the severe levels of the device can endure and its performance criterion. The measurement results are contained in this test report and Anbotek Compliance Laboratory Limited is assumed full of responsibility for the accuracy and completeness of these measurements. Also, this report shows that the EUT (Equipment Under Test) is technically compliant with the FCC Part 15 Subpart C requirements. This report applies to above tested sample only and shall not be reproduced in part without written approval of Anbotek Compliance Laboratory Limited Date of Test : Aug. 02~22, 2012 Prepared by : (Engineer / Andy Chen) Reviewer : (Project Manager / Jerry Du) Approved & Authorized Signer : (Manager / Tom Chen) Page 4 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F 1. GENERAL INFORMATION 1.1. Description of Device (EUT) EUT : Wireless Solar keyboard Model Number : W6055, KB6055, SL-6439-BK(Note: All samples are the same except the model number & shape of applia…

Text truncated - open the document above for the full version.

Page 18 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F 6. PHOTOGRAPH 6.1. Photo of Power Line Conducted Emission Measurement Page 19 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F 6.2. Photo of Radiation Emission Test Below 1G Page 20 of 25 FCC ID: SJ6-W6055 Anbotek Compliance Laboratory Limited Report No.201208663F Above 1G