SU7DOLGDO433DRemote Controller

Thank you for your purchase of the Transmitter Solutions Dolphin wireless keypad. The DOLGDO3433D will accommodate one 4 digit PIN to activate a signal transmission. Package contains: Keypad 9 volt battery 2 screws + wall anchors Keypad instructions Please follow the detailed instructions below in order to set up the Dolphin keypad to operate with your garage door opener or receiver. 2. OPERATIONAL FEATURES Keypad Instructions Dolphin Wireless Garage Door Keypad 433 MHz Dip Switch Pr oduct # DOLGDO433D Pressing any key illuminates the keypad for 5 seconds. A "buzzer" indicates each button depression. After 20 incorrect key entries, the keypad will “lock up” for 40 seconds. If the battery is low the single LED flashes rapidly for 5 seconds, indicating it is time to replace the battery. After you have entered a valid code, the keypad LED will flash during the 5 second "time out" period. During the “time out” period you may press any key and the keypad will send another signal to your receiver each time you press a key. The key resets your entry. If you make a mistake while entering your PIN, pressing the key resets your entry so you can start over. HINT: If you always begin your PIN with the you will reduce the likelihood of faulty operation. 3 (Old Access Code) (New Access Code) Frequency Output Code Indicator LED Dip Switch Keypad LED S2 S3 8 Port 310 MHz300 MHz 10 Port 1 1 2 2 3 3 LED 4LED 2 LED 5LED 3 V2 V3 S3 2-3 DIP TO CHANGE TO RADIO CODE: DIP switch must be set to match the code on the 10 position switch on the garage door operator receiver. TO CHANGE TO ACCESS CODE: # # 1-2-3-4 1-3-5-7 # LEDS: Indicator LED: Indicator LED ON: Into change access code mode Indicator LED blink The code is enter incorrectly Keypad LED: Keypad LED blink Access code passed Keypad LED blink rapidly 5sec Battery low (7V) PRESET FACTORY CODES: Access code : * - 1 - 2 - 3 - 4 - # (Note: To reset the access code remove 9 volt battery form unit, Depress any key on the keypad and wait 5 seconds before installing Position the keypad on the garage door frame with the provided screws. Lift up the cover and insert the long screw above the keypad in the slot provided (a). Remove the battery cover and insert the second long screw in the lower slot (b). Replace the battery cover. 4 5. RETURN TO DEFAULT SETTINGS cover 1. Desconnect the power by removing the battery. 2. Press the , , and keys simultaneously. 3. Re-connect the battery to power up the keypad. 4. Release the , , and keys. Note: The keypad is returned to the defaul “Master Code” . And all User Entry Codes are deleted. 1432 147 147 Return to Default Settings 7 The keypad is approved by the FCC and it complies with Part 15 of the FCC Rules. Its operation is subject to the following 2 conditions: 1. This device may not cause harmful interference. 2. The device must accept any interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC ID: SU7DOLGDO433D DO NOT let children use the keypad without adult supervision. Children can injure themselves, or others, if left unsupervised. Make sure all the required safety devices are installed before operating any door. If this transmitter triggers other doors in your neighborhood, change all your transmitters and receivers to a new code setting. 6 ORANGE - Key depress GREEN - Code was entered correctly and the keypad is transmitting GREEN - Programming Mode RED - (Flashing 3 times) Error was made in either programming mode or in code entry. Multi-color status LED 8 The warranty period of this product is 24 months, beginning from the manufacturing date. During this period, if the product does not operate correctly, due to a defective component, the product will be repaired or replaced at the sole discretion of Transmitter Solutions. This warranty does not extend to the product casing which can be damaged by conditions outside of the control of Transmitter Solutions. EXCEPT AS SET FORTH ABOVE, TRANSMITTER SOLUTIONS MAKES NO WARRANTIES REGARDING THE GOODS, EXPRESS OR IMPLIED, INCLUDING WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE. BUYER MAKES NO RELIANCE ON ANY REPRESENTATION OF TRANSMITTER SOLUTIONS, EXPRESS OR IMPLIED, WITH REGARD TO THE GOODS AND ACCEPTS THEM “AS-IS/WHERE-IS”. TRANSMITTER SOLUTIONS SELLS THE GOODS TO BUYER ON CONDITION THAT TRANSMITTER SOLUTIONS WILL HAVE NO LIABILITY OF ANY KIND AS A RESULT OF THE SALE. BUYER AGREES THAT TRANSMITTER SOLUTIONS SHALL HAVE NO LIABILITY FOR DAMAGES OF ANY KIND, WHETHER DIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING INJURIES TO PERSONS OR PROPERTY, TO BUYER, ITS EMPLOYEES OR AGENTS, AS A RESULT OF THE SALE. BUYER ALSO AGREES TO HOLD TRANSMITTER SOLUTIONS HARMLESS FROM ANY CLAIMS BUYER, OR ANY THIRD PARTY, MAY HAVE AS A RESULT OF BUYER’S USE OR DISPOSAL OF THE GOODS. BUYER HAS READ THIS DISCLAIMER AND AGREES WITH ITS TERMS IN CONSIDERATION OF RECEIVING THE GOODS.

Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 10 of 20 External Photos Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 11 of 20 Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 12 of 20 Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 13 of 20 Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 14 of 20 Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 15 of 20 Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 16 of 20

FCCID: SU7DOLGDO433D

Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 17 of 20 Internal Photos Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 18 of 20 Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 19 of 20

of Applicant: Controlled Entry Distributors, Inc. Address: 2500 South 3850 West Suite A Salt Lake City Utah United States 84120 Tested and Prepared by Worldwide Testing Services (Taiwan) Co., Ltd. FCC Registration No.: 930600 Industry Canada filed test laboratory Reg. No. IC 5679A-1, IC-5107A-1 A2LA Accredited No.: 2732.01 Report No.: W6M21503-14867-C-1 6F, NO. 58, LANE 188, RUEY-KUANG RD., NEIHU TAIPEI 114, TAIWAN, R.O.C. TEL: 886-2-66068877 FAX: 886-2-66068879 E-mail: [email protected] FCC PART 15 SUBPART C TEST REPORT for Remote Controller Model No.: Keypad GDO_433M FCC ID: SU7DOLGDO433D Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Page 1 of 19 TABLE OF CONTENTS 1 General Information........................................................................................................................2 1.1 Notes ...........................................................................................................................................2 1.2 Testing laboratory .......................................................................................................................3 1.2.1 Location ..................................................................................................................................3 1.2.2 Details of accreditation status ................................................................................................3 1.3 Details of approval holder...........................................................................................................3 1.4 Application details ......................................................................................................................4 1.5 Test item .....................................................................................................................................4 1.6 Test standards .............................................................................................................................5 2 Technical test ..................................................................................................................................5 2.1 Summary of test results...............................................................................................................5 2.2 Test environment ........................................................................................................................5 2.3 Test equipment utilized...............................................................................................................6 2.4 General Test Procedure...............................................................................................................8 3 Test results (enclosure) ...................................................................................................................9 3.1 Transmission Requirements......................................................................................................10 3.1.1 Limit of Transmission Time ..................................................................................................10 3.1.2 Active Time ...........................................................................................................................10 3.2 Output Power (Field Strength)..................................................................................................11 3.3 Out of Band Radiated Emissions ..............................................................................................12 3.4 Transmitter Radiated Emissions in restricted Bands ................................................................13 3.5 Spurious Emission radiated, Transmitter ..................................................................................14 3.6 Channel Bandwidth...................................................................................................................16 3.7 Antenna requirement.................................................................................................................17 3.8 Duty Cycle ................................................................................................................................18 3.9 Conducted Measurement at (AC) Power Line..........................................................................19 Appendix: Diagrams and photos Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Page 2 of 19 1 General Information 1.1 Notes The purpose of conformity testing is to increase the probability of adherence to the essential requirements or conformity specifications, as appropriate. The complexity of the technical specifications, however, means that full and thorough testing is impractical for both technical and economic reasons. Furthermore, there is no guarantee that a test sample which has passed all the relevant tests conforms to a specification. Neither is there any guarantee that such a test sample will interwork with other genuinely open systems. The existence of the tests nevertheless provides the confidence that the test sample possesses the qualities as maintained and that is performance generally conforms to representative cases of communications equipment. The test results of this test report relate exclusively to the item tested as specified in 1.5. The test report may only be reproduced or published in full. Reproduction or publication of extracts from the report requires the prior written approval of the Worldwide Testing Services(Taiwan) Co., Ltd. Tester: March 18, 2015 Leon Chueh Date WTS-Lab. Name Signature Technical responsibility for area of testing: March 18, 2015 Kevin Wang Date WTS Name Signature Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Page 3 of 19 1.2 Testing laboratory 1.2.1 Location OATS No.5-1, Lishui, Shuang Sing Village, Wanli Dist., New Taipei City 207, Taiwan (R.O.C.…

Text truncated - open the document above for the full version.

Registration number: W6M21503-14867-C-1 FCC ID: SU7DOLGDO433D Worldwide Testing Services(Taiwan) Co., Ltd Appendix Page 20 of 20 Set Up Photos of Radiated emission