SU7FFII310LID21KRemote Controller

Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: . Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. . Consult the dealer or an experienced radio/TV technician for help. FCC Caution :To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Registration number: W6M21012-11086-C-1 FCC ID: SU7FFII310LID21K Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 12 of 17 External Photos Registration number: W6M21012-11086-C-1 FCC ID: SU7FFII310LID21K Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 13 of 17

Model number: 310 FCC ID: SU7FFII310LID21K Label Size: 22 x 14 mm Model: 310 FCC ID: SU7FFII310LID21K

Registration number: W6M21012-11086-C-1 FCC ID: SU7FFII310LID21K Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 14 of 17 Internal Photos Registration number: W6M21012-11086-C-1 FCC ID: SU7FFII310LID21K Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 15 of 17 Registration number: W6M21012-11086-C-1 FCC ID: SU7FFII310LID21K Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 16 of 17

of Applicant: Controlled Entry Distributors, Inc. Address: 2500 South 3850 West Suite A Salt Lake City 84120 Utah United States Tested and Prepared by Worldwide Testing Services (Taiwan) Co., Ltd. FCC Registration No.: 930600 Industry Canada filed test laboratory Reg. No. IC 5679A-1 A2LA Accredited No.: 2732.01 Report No.: W6M21012-11086-C-1 6F, NO. 58, LANE 188, RUEY-KUANG RD., NEIHU TAIPEI 114, TAIWAN, R.O.C. TEL: 886-2-66068877 FAX: 886-2-66068879 E-mail: [email protected] FCC PART 15 SUBPART C TEST REPORT for Remote Controller Model No.: 310 FCC ID: SU7FFII310LID21K Registration number: W6M21012-11086-C-1 FCC ID: SU7FFII310LID21K Worldwide Testing Services(Taiwan) Co., Ltd. Page 1 of 19 TABLE OF CONTENTS 1 General Information........................................................................................................................2 1.1 Notes ..........................................................................................................................................2 1.2 Testing laboratory .......................................................................................................................3 1.2.1 Location ..................................................................................................................................3 1.2.2 Details of accreditation status ................................................................................................3 1.3 Details of approval holder...........................................................................................................3 1.4 Application details ......................................................................................................................4 1.5 Test item .....................................................................................................................................4 1.6 Test standards ...............................................................................................................................5 2 Technical test ..................................................................................................................................5 2.1 Summary of test results...............................................................................................................5 2.2 Test environment ........................................................................................................................5 2.3 Test Mode ...................................................................................................................................5 2.4 Test equipment utilized...............................................................................................................6 2.5 General Test Procedure...................................................................................................................8 3 Test results (enclosure) ...................................................................................................................9 3.1 Transmission Requirements..........................................................................................................10 3.1.1 Limit of Transmission Time ..................................................................................................10 3.1.2 Active Time ...........................................................................................................................10 3.2 Output Power (Field Strength)..................................................................................................11 3.3 Out of Band Radiated Emissions ..............................................................................................12 3.4 Transmitter Radiated Emissions in restricted Bands ................................................................13 3.5 Spurious Emission radiated, Transmitter ..................................................................................14 3.6 Channel Bandwidth...................................................................................................................16 3.7 Antenna requirement.................................................................................................................17 3.8 Duty Cycle ................................................................................................................................18 3.9 Conducted Measurement at (AC) Power Line..........................................................................19 Registration number: W6M21012-11086-C-1 FCC ID: SU7FFII310LID21K Worldwide Testing Services(Taiwan) Co., Ltd. Page 2 of 19 1 General Information 1.1 Notes The purpose of conformity testing is to increase the probability of adherence to the essential requirements or conformity specifications, as appropriate. The complexity of the technical specifications, however, means that full and thorough testing is impractical for both technical and economic reasons. Furthermore, there is no guarantee that a test sample which has passed all the relevant tests conforms to a specification. Neither is there any guarantee that such a test sample will interwork with other genuinely open systems. The existence of the tests nevertheless provides the confidence that the test sample possesses the qualities as maintained and that is performance generally conforms to representative cases of communications equipment. The test results of this test report relate exclusively to the item tested as specified in 1.5. The test report may only be reproduced or published in full. Reproduction or publication of extracts from the report requires the prior written approval of the Worldwide Testing Services(Taiwan) Co., Ltd. Tester: December 21, 2010 Rick Chen Date WTS-Lab. Name Signature Technical responsibility for area of testing: December 21, 2010 Chang Tse-Ming Date WTS Name Signature Registration number: W6M21012-11086-C-1 FCC ID: SU7FFII310LID21K Worldwide Testing Services(Taiwan) Co., Ltd. Page 3 of 19 1.…

Text truncated - open the document above for the full version.

Registration number: W6M21012-11086-C-1 FCC ID: SU7FFII310LID21K Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 17 of 17 Set Up Photos