SWTIC-510SWiFi Video Scope

Steelman PRO Video Scope Steelman PRO Video Scope Steelman_PRO_Video_Scope videos (MP4) and mixing user vocies via MIC with the bundled application Videoscope (not included) Wi-FiVideo Scope Steelman_PRO_Video_Scope teelnideoco e teelnideoco e Video scope. Steelman PRO Video Scope i i ideo co e Steelman_PRO_Video_Scope Steelman PRO Video Scope Steelman PRO Video Scope teeln ideo co e teeln ideo co e Steelman_PRO_Video_Scope Steelman PRO Video Scope Steelman PRO Video Scope teeln ideo co e oduct inc teeln ideo co e i i ideo co e FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. This device and its antenna( s) must not be co-located or operation in conjunction with any other antenna or transmitter

Calibeur Measurements (Hong Kong) Co., Limited B46 Bldg., 2nd Ind . Zone, TangLang, XiLi ,Shenzhen, China. Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 To whom it may concern: The testing model of our Calibeur Measurements (Hong Kong) Co., Limited brand of FCC approval is IC-510S and we have models or brands for listed. We hereby certify that the interior structure, electrical circuit and schematics of the listed models are the same as the testing model except the below list. And just for the marketing requirement. Our listed models is as follows: Product name: Wi-Fi Video Scope Brand: N/A Model: IC-510S, IC-510M, IC-510R Your assistance on this mater is highly appreciated. Alan Heung / Export Manager

Calibeur Measurements (Hong Kong) Co., Limited B46 Bldg., 2nd Ind . Zone, TangLang, XiLi ,Shenzhen, China. Letter of Authorization Company: Calibeur Measurements (Hong Kong) Co., Limited Address: B46 Bldg., 2nd Ind . Zone, TangLang, XiLi ,Shenzhen, China. Product Name: Wi-Fi Video Scope Model Number: IC-510S, IC-510M, IC-510R We authorize MiCOM Labs Inc, 575 Boulder Court, Pleasanton, California 94566, USA, to act on our behalf on all matters concerning the above named equipment. Any individual within MiCOM Labs is authorized to act on our behalf and take action on the application. This shall include the following: ∑ Testing ∑ Approval applications (includes complete product documentation package, including Confidential information) and procedures ∑ Payment of approval fees We declare that MiCOM Labs Inc, 575 Boulder Court, Pleasanton, California 94566, USA, is allowed to forward all information related to the approval project to the applied notified body and to the notification entities and to discuss any issues concerning the approval application. Any and all acts carried out by MiCOM Labs on our behalf shall have the same effect as acts of our own. Name: Alan Heung Date: August 19, 2015 Title: Export Manager Signature of applicant:

Calibeur Measurements (Hong Kong) Co., Limited B46 Bldg., 2nd Ind . Zone, TangLang, XiLi ,Shenzhen, China. Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 Date: August 19, 2015 Confidentiality Request FCC ID: SWTIC-510S Pursuant to Sections 0.457(d)(1)(ii) and 0.459 of the Commission’s Rules, Calibeur Measurements (Hong Kong) Co., Limited hereby requests permanent confidential treatment of information accompanying this application as outlined below: Schematics Block Diagrams Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457(d)(1)(ii), disclosure of this Application and all accompanying materials will not be made before the date of the Grant for this Application. Yours sincerely, Alan Heung / Export Manager

IC-510S EUT top view EUT bottom view IC-510M EUT top view EUT bottom view IC-510R EUT top view EUT bottom view

The following note shall be conspicuously placed in the users manual: “Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.” The Label must not be a stick-on paper label. The Label on these products must be permanently affixed to the product and readily visible at the time of purchase and must last the expected lifetime of the equipment not be readily detachable. Proposed Label Location on EUT FCC ID: SWTTG-510

The test report consists 61 pages in total. It may be duplicated completely for legal use with the allowance of the applicant. It shall not be reproduced except in full, without the written approval of Ke Mei Ou Laboratory Corporation. The test result in the report only applied to the tested sample. FCC TEST REPORT Under FCC 15 Subpart C, Paragraph 15.247 & (Operating in 2400 ~ 2483.5 MHz Band) Prepared For : Calibeur Measurements (Hong Kong) Co., Limited B46 Bldg., 2nd Ind . Zone, TangLang, XiLi ,Shenzhen, China. FCC ID: SWTIC-510S EUT: Wi-Fi Video Scope Model: IC-510S, IC-510M, IC-510R August 31, 2015 Issue Date: Original Report Report Type: Test Engineer: Eric Guo Review By: Apollo Liu / Manager E506, 5th Floor, No.39 Keji Middle 2nd Rd, Science & Technology Park, Nanshan District, Shenzhen, P. R. China Tel: + 86 755 83642690 Fax: + 86 755 83297077 www.kmolab.com Calibeur Measurements (Hong Kong) Co., Limited Model: IC-510S KMO FCC Report Report #: KSZ2015051202J01 Page 2 of 61 TABLE OF CONTENTS 1. General Information ........................................................................................................................................................... 3 1. 1 Notes ............................................................................................................................................................................... 3 1. 2 Testing Laboratory .......................................................................................................................................................... 3 1. 3 Details of Applicant ........................................................................................................................................................ 3 1. 4 Application Details ......................................................................................................................................................... 3 1. 5 Test Item ......................................................................................................................................................................... 3 1. 6 Test Standards ................................................................................................................................................................. 3 2. Technical Test ....................................................................................................................................................................... 4 2. 1 Summary of Test Results ................................................................................................................................................ 4 2. 2 Antenna Requirement ..................................................................................................................................................... 4 3. EUT Modifications .............................................................................................................................................................. 4 4. Conducted Power Line Test ................................................................................................................................................ 5 4. 1 Test Equipment ............................................................................................................................................................... 5 4. 2 Test Procedure ................................................................................................................................................................ 5 4. 3 Test Setup ....................................................................................................................................................................... 5 4. 4 Configuration of the EUT ............................................................................................................................................... 6 4. 5 EUT Operating Condition ............................................................................................................................................... 8 4. 6 Conducted Power Line Emission Limits ........................................................................................................................ 8 4. 7 Conducted Power Line Test Result ................................................................................................................................. 9 5. FCC Part 15.247 Requirements for DTS Systems .......................................................................................................... 10 5. 1 Test Equipment ............................................................................................................................................................. 10 5. 2 Test Procedure .............................................................................................................................................................. 10 5. 3 Test Setup ..................................................................................................................................................................... 10 5. 4 Configuration of the EUT ............................................................................................................................................. 10 5. 5 EUT Operating Condition ............................................................................................................................................. 10 5. 6 Limit ..............................................................................................................................................................................11 5. 7 Test Result .................................................................................................................................................................... 12 6. Transmitter Spurious Radiated Emission at 3 Meters ....................................................................................…

Text truncated - open the document above for the full version.

Radiated Emission test view(Frequency from 30MHz to 1GHz) Radiated Emission test view(Frequency above 1GHz)