TA8AKRC161134-2WCDMA Radio Equipment

Ericsson Internal EXHIBIT 13 1 (1) Prepared (also subject responsible if other) No. EJIAXIA TA8AKRC161134-2 Uen Approved Checked Date Rev Reference CBC/XRV/EP/EJIAXIA EXUEJUN 2007-9-20 A Federal Communications Commission Authorization & Evaluation Division 7435 Oakland Mills Road Columbia, Maryland 21046 Attention: Equipment Authorization Branch September 11, 2007 SP Technical Research Institute of Sweden Brinellgatan 4 Box 857 SE-501 15 Borås Sweden Subject: Certification for FCC ID: TA8AKRC161134-2 To Whom It May Concern: Ericsson AB requests a Grant of Certification (Type Acceptance) for the above mentioned FCC Identifier. This Radio Equipment (RE) is designed for use in the WCDMA 1900 MHz cellular telephone system. The transmitter will operate from 1932.4 to 1987.6 MHz with 4.17 MHz bandwidth. The receiver circuit supports 1852.4 to 1907.6 MHz. The RE operates in the 1900 MHz broadband PCS services as per 47 CFR Part 24 subpart E. It meets the requirements of 3GPP specification for operation in WCDMA cellular systems. This RE will in normal mode operate at a nominal power out of 40 watts at the output connector. Ericsson AB requests confidentiality under CFR 0.459 according to attached letter. We further certify that the applicant nor any party to the application is subject to a denial of Federal benefits, that includes FCC benefits, pursuant to section 5301 of the Anti-Drug abuse Act of 1988, 21 U.S.C. Section 862. Ericsson AB accepts by this request the agreement set out in the document “Bilaga SPCR 125 – Avtal om marknadskontroll för radioutrustning certifierad för USA-marknaden”. If additional information is needed, please contact me on the below listed number. Regards, Xiaoying Jiang Product Approval Engineer, RBS I&V Ericsson (China) Communications Company Ltd. Ericsson Tower No.5 Lize East Street, Chaoyang District Beijing 100102, P.R.China Telephone: +86 10 8476 7125 Fax: +86 10 8476 7730 E-mail: [email protected]

Ericsson Internal EXHIBIT 13 1 (1) Prepared (also subject responsible if other) No. EJIAXIA TA8AKRC161134-2 Uen Approved Checked Date Rev Reference CBC/XRV/EP/EJIAXIA EXUEJUN 2007-09-11 A Federal Communications Commission Authorization & Evaluation Division 7435 Oakland Mills Road Columbia, Maryland 21046 Attention: Equipment Authorization Branch September 11, 2007 SP Technical Research Institute of Sweden Brinellgatan 4 Box 857 SE-501 15 Borås Sweden Subject: Request for Confidentiality To Whom It May Concern: We, Ericsson AB, hereby request that the Exhibits/Items listed below be withheld from public inspection in accordance with Sections 0.457 and 0.459 of the Commission’s Rules. This due to the following reasons: DS-CDMA Base Stations (BS) are designed strictly based on the technical specifications of the international project 3GPP (the 3 rd Generation Partnership Project). The competition in this field is very intense and a less advanced solution/design could get an unfair advantage by accessing the information as listed below from common domain. As we believe that we have implemented groundbreaking solutions and designs into our recent BS/Radio Equipment (RE) compared to the previous BS/RE, the listed Exhibits/Items need to be protected from disclosure to our competitors in the industry. As the FCC records have in-depth information and a very wide distribution, we believe that you can understand our concerns. We are strong in our belief that all vendors in the industry need to compete by their own merits. We regard these Exhibits/Items to be our intellectual property and therefore as confidential information. As our RE is generally installed in restricted places, public access is not possible although some types of our RE under certain circumstances can be installed in an unrestricted place, but the RE is single unit with an enclosure which can not be opened. It is therefore that individual modules within our RE should not be revealed to the public. There are advanced technical and design solutions/information in the Exhibits/Items, as mentioned above, that we regard as Ericsson proprietary, with actual and potential patents pending. The information can be advantageous to our competitors as well as sources seeking ways to hack past the built in security functionality. These solutions or information thereof are not accessible even for our customers or partners unless non-disclosure agreements for particular item(s) have been signed. Confidential product information can be found in, but not necessarily limited to, internal photos of the RE, block diagrams, schematics diagrams, and parts lists as well as certain documents, such as the user’s manuals. Those documents can only be accessible by the customers who purchase our BS and accept the conditions and therefore are provided with unique information access tools. EXHIBIT 9 Internal Photos of Radio Equipment RRU22 1940 EXHIBIT 4 Block Diagrams EXHIBIT 5 Schematics Diagrams EXHIBIT 8 Manuals EXHIBIT 10 Parts List EXHIBIT 12 Technical Circuit Description If additional information is needed, please contact me on the below listed number. Regards, Xiaoying Jiang Product Approval Engineer, RBS I&V Ericsson (China) Communications Company Ltd. Ericsson Tower No.5 Lize East Street, Chaoyang District Beijing 100102, P.R.China Telephone: +86 10 8476 7125 Fax: +86 10 8476 7730 E-mail: [email protected]

KRC 161 134/2 R1C Date 2007-09-21 Page 1 of 3 External photos Front view Back view Left side Right side KRC 161 134/2 R1C Date 2007-09-21 Page 2 of 3 External photos Top view Bottom view KRC 161 134/2 R1C Date 2007-09-21 Page 3 of 3 External photos Front view without solar shield Top view without cover

KRC 161 134/2 R1C Date 2007-09-21 Page 1 of 1 FCC ID FCC ID label and placement

Date Reference Page REPORT 2007-10-18 F717120-F24 2 (2) FCC ID: TA8AKRC161134-2 Table of contents Description of the test object Appendix 1 Operation mode during measurements Appendix 1 Test setups Appendix 1 Purpose of test Appendix 1 RF power output Appendix 2 Occupied bandwidth Appendix 3 Band edge Appendix 4 Spurious emission at antenna terminals Appendix 5 Field strength of spurious radiation Appendix 6 Frequency stability Appendix 7 Receiver spurious emissions Appendix 8 External photos Appendix 9 Date Reference Page REPORT 2007-10-18 F717120-F24 1 (6) FCC ID: TA8AKRC161134-2 Appendix 1 Description – Test object Equipment: WCDMA Radio Equipment RRU22 1940, with 1900 MHz single and multi carrier configuration. Tx Frequency range: 1932.4-1987.6 MHz Modulations: QPSK and 16QAM Maximum output power: Single carrier: 1x 46 dBm (40W) Multi carrier: 2x 43 dBm (20W) Nominal power voltage: -48 VDC Tested channels UARFCN Frequency 9662 1932.4 MHz 9712 1942.4 MHz 9763 1952.6 MHz 9788 1957.6 MHZ 9813 1962.6 MHz 9888 1977.6 MHz 9938 1987.6 MHZ Operation mode during measurements Test models All measurements were performed with the test object transmitting the Test models 1 and 5 defined in 3GPP TS 25.141. Test model 1 uses the QPSK modulation only, and Test model 5 includes the 16QAM modulation. Conducted measurements All RF conducted measurements were performed with the test object powered with -48 VDC. All TX measurements were done at the output connector Ant 1 of the RRU22 1940, KRC 161134/2. All measurements were performed at maximum output power with both modulations. The settings below was found to be representative for all traffic scenarios when several settings were tested to find the setting for worst case. Single carrier Test model 1: 64 DPCH:s at 30 ksps (SF=128) Test model 5: 30 DPCH:s at 30 ksps (SF=128) and 8 HS-PDSCH:s at 240 ksps (SF=16) Multi carrier Test model 1: 32 DPCH:s at 30 ksps (SF=128) Test model 5: 30 DPCH:s at 30 ksps (SF=128) and 8 HS-PDSCH:s at 240 ksps (SF=16) Date Reference Page REPORT 2007-10-18 F717120-F24 2 (6) FCC ID: TA8AKRC161134-2 Appendix 1 Radiated measurements All radiated measurements were performed with the test object powered with -48 VDC, either directly (power configuration 1) or with 120 VAC, 60 Hz via the PSU AC/DC converter (power configuration 2) or via both PSU and ACCU (power configuration 3). The configurations were selected to represent worst cases. The RRU22 was activated as Single Carrier 1x 46 dBm and as Multi Carrier 2x 43 dBm. The RF output power ports were terminated with 50 ohm loads. The RRU22 was measured with the following settings: Single Carrier: Modulation QPSK 16QAM QPSK 16QAM QPSK 16QAM Downlink UARFCN 9662 (1932.4 MHz) 9662 (1932.4 MHz) 9788 (1957.6 MHz) 9788 (1957.6 MHz) 9938 (1987.6 MHz) 9938 (1987.6 MHz) Uplink UARFCN 9262 (1852.4 MHz) 9262 (1852.4 MHz) 9388 (1877.6 MHz) 9388 (1877.6 MHz) 9538 (1907.6 MHz) 9538 (1907.6 MHz) Test model 1 5 1 5 1 5 Power configuration 1 1 2 2 3 3 Test model 1: 64 DPCH:s at 30 ksps (SF=128) Test model 5: 30 DPCH:s at 30 ksps (SF=128) and 8 HS-PDSCH:s at 240 ksps (SF=16) Multi Carrier: Cell 1 2 Modulation QPSK 16QAM Downlink 9662 (1932.4 MHz) 9712 (1942.4 MHz) Uplink 9262 (1852.4 MHz) 9312 (1862.4 MHz) Test model 1 5 Power configuration 1 1 Test model 1: 32 DPCH:s at 30 ksps (SF=128) Test model 5: 30 DPCH:s at 30 ksps (SF=128) and 8 HS-PDSCH:s at 240 ksps (SF=16) Purpose of test The purpose of the tests is to verify compliance to the performance characteristics specified in applicable items of FCC CFR 47 and Industry Canada RSS-133. References Measurements were done according to relevant parts of the following standards: ANSI 63.4-2003 ANSI/TIA/EIA-603-B-2002 3GPP TS 25.141 Date Reference Page REPORT 2007-10-18 F717120-F24 3 (6) FCC ID: TA8AKRC161134-2 Appendix 1 Reservation The test results in this report apply only to the particular test object as declared in the report. Delivery of test object The test object was delivered: 2007-09-10 Manufacturer’s representative Xiaoying Jiang, Ericsson (China) Communications Company Ltd. Test engineers Jonas Bremholt, Stefan Larsson and Reinhold Reul Test witnesses Xiaoying Jiang and Bo Yang, Ericsson (China) Communications Company Ltd. Date Reference Page REPORT 2007-10-18 F717120-F24 4 (6) FCC ID: TA8AKRC161134-2 Appendix 1 Test set-up, TX conducted measurements Test object RRU22 1940, KRC 161 134/2, rev. R1C, serial no: CB44297485 Software CXP 9011610/1 rev. R11AG02 with updated RRU load module CXP9011683/2 rev. R2D01 FCC ID: TA8AKRC161134-2 Functional test equipment 1. RNC Mini-sim #48, 4780FA SN0218 Rev DBA 2. Hub, TP-Link, TL HP8MU, 10Base-T Ethernet 3. Computer, Sun Blade 1500, asset ID AP016574 4. RBS3418, product no. BFE4011019, serial no. TA63805732 5. Termination (50 ohm) Note: The Iub link between RNC Mini sim and RBS3418 is configured as T1. Interfaces: Type of port: Power input, -48 VDC Power Ant 1 (TX/RX): Coaxial cable with N connector and adaptor to 7/16” Antenna Ant 2 (RX): 50 ohm terminator with N connector and adaptor to 7/16” Antenna Oil - optical interface link, data connection between RBS3418 and EUT Opto interface Date Reference Page REPORT 2007-10-18 F717120-F24 5 (6) FCC ID: TA8AKRC161134-2 Appendix 1 Test set-up, radiated measurements Test object RRU22 1940, KRC 161 134/2, rev.R1C, serial no: CB44297485 Software CXP 9011610/1 rev. R11AG02 with updated RRU load module CXP9011683/2 rev. R2D01 FCC ID: TA8AKRC161134-2 Auxiliary equipment PSU, power supply unit, converting 120 VAC, 60 Hz to -48 VDC (only power configurations 2 and 3) ACCU, lightning protection (only power configuration 3) Functional test equipment 1. RNC Mini-sim #48, 4780FA SN0218 Rev DBA 2. Hub, TP-Link, TL HP8MU, 10Base-T Ethernet 3. Computer, Sun Blade 1500, asset ID AP016574 4. RBS3418, product no. BFE4011019, serial no. TA63805732 5. Terminator (50 ohm) Date Reference Page REPORT 2007-10-18 F717120-F24 6 (6) FCC ID: TA8AKRC161134-2 Appendix 1 Interfaces: Type of…

Text truncated - open the document above for the full version.