TZI-BC090LED Bulb

82 % energy savings 3 2 1 Easy Installation BC090 PROOF OF PURCHASE Turns on/off with app or standard switch 40 Replacement 7 LED = Lasts up to 22.8 YEARS Limited Warranty Star Technologies warrants that this bulb will be free from defects in material and workmanship and will operate for 25,000 hours. This bulb has a three year Warranty from time of purchase. If it fails or you are not satisfied with its performance, Star will send you a replacement bulb. Please call our toll free number 1-844-STAR-LED, or send a copy of your original purchase receipt, proof of purchase decal from box and the bulb to our customer care center. This replacement is the sole remedy available and liability for incidental or consequential damage is expressly excluded.Garantía Limitada Star Technologies garantiza que esta bombilla estará libre de defectos de material y mano de obra y que funcionará por 25.000 horas. Esta bombilla tiene una garantía de tres años desde el momento de la compra. Si falla o si no está conforme con su funcionamiento, Star le enviará una bombilla de reemplazo. Comuníquese con nuestra línea gratuita 1-844-STAR-LED, o envíe una copia de su ticket de compra original, la etiqueta autoadhesiva del comprobante de compra de la caja y la bombilla a nuestro centro de atención al cliente. Este reemplazo es el único recurso disponible y la responsabilidad por daños incidentales o emergentes está expresamente excluida. !Caution! - DO NOT USE WITH DIMMERS or DIMMING FIXTURES . • Use only on 120v, 60Hz. • When installing or changing, make sure that the power to the fixture is off. • Suitable for damp locations – the bulb is suitable for use in wet locations when in an outdoor rated fixture • This product is NOT intended for use in emergency light fixtures or exit signs. ¡Precaución! - NO USAR CON ATENUADORES DE LUZ. • Usar solo con 120v, 60Hz. • Para la instalación o el cambio, asegúrese de que la alimentación del accesorio esté desactivada. • La bombilla es apta para su uso en lugares húmedos cuando se encuentra en un accesorio con capacidad nominal para exteriores. • Este producto NO está diseñado para su uso en accesorios de iluminación de emergencia o señales de salida. 450 lumen Brightness$0.85 Estimated Yearly Energy CostBased on 3 hrs/day, 11¢/kWh Cost depends on rates and use22.8 years Life ( Based on 3 hrs/day) Star Technologies LLCBowling Green, KY 42101STARtechllc.comMade in China Free AppNo Extra Fees 40 Replacement 7 LED = TM TM TM TM 7 w LED replacement Select the light xture you would like to control and install the bulb. Download the “Colori c Bulb” app from the App Store or Google Play. Open the app and nd the bulbs. Quick App Set-Up Simple Operation ++ Lighting Control Control 1 or up to 10 bulbs with app from up to 100ft away On Off Dim LED Bulb FREE App NO Extra Fees NO Router Needed NO WIFI Needed Colori fi c Bulb Colori fi c Bul b Accent Tones 12 TM m t he eeeeeeee Operates like standard LED bulb when not being controlled by app. Change Color This package is produced from recycled materials. We plant 5 times more trees a year than we use in the package production. During the production or disposal the inks and glues that were used to produce this packages do not have any toxic effects o n our environment. Using LED light bulbs saves energy, produces less trash and annually saves you time & effort replacing light bulbs. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance cou ld void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Radiation Exposure Statement: This equipment complies with FCC and Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Déclaration d’IC sur l’exposition aux radiations: Cet équipement est conforme aux limites d’exposition aux radiations définies par le Canada pour des environnements non contrôlés. Cet équipement doit être installé et utilisé à une distance minimum de 20 cm entr e l’antenne et votre corps. Cet émetteur ne doit pas être installé au même endroit ni utilisé avec une autre antenne ou un autre émetteur. mood setting , DramaticDD functional & alway fun! Lighting Control 12 colors Changeable LED Bulb

DATE : Sep. 19, 2014 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: TZI-BC090 Product Name: LED Bulb Request for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential: (List here the documents for which you are seeking confidentiality – for example ...) • Schematics • Block diagram • Operation description These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors. Dated this Agency agreement expiration date: Sep. 19, 2014 to Sep. 18, 2015 By: SH Lee Signature Printed Title: Safety Engineer On behalf of : Arts Electronics Co., Ltd. Telephone: +86-769-8554115

FCC label information: FCCID: TZI‐BC090

The 1-g and 10-g SAR test exclusion thresholds for 100 MHz to 6 GHz at test separation distances ≤ 50 mm are determined by: [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance, mm)] · [√f(GHz)] ≤ 3.0 for 1-g SAR and ≤ 7.5 for 10-g extremity SAR, where z f(GHz) is the RF channel transmit frequency in GHz z Power and distance are rounded to the nearest mW and mm before calculation z The result is rounded to one decimal place for comparison The test exclusions are applicable only when the minimum test separation distance is ≤ 50 mm and for transmission frequencies between 100 MHz and 6 GHz. When the minimum test separation distance is < 5 mm, a distance of 5 mm is applied to determine SAR test exclusion. 3. EUT RF Exposure The Max Conducted Peak Output Power is -0.33dBm (0.93mW) in middle channel and the Max Conducted Average Output Power is less than 0.93mW. The best case gain of the antenna is 0dBi. 0.93/5*√2.402=0.29 ≤3.0 Conclusion: No SAR is required.

Report No. : EESZG08200016 Page 1 of 35 TEST REPORT Product : LED Bulb Trade mark : ST Model/Type reference : BC090 Serial number : N/A Ratings : AC 120V/60Hz FCC ID : TZI-BC090 Report number : EESZG08200016 Date : Sep. 18, 2014 Regulations : See below Test Standards Results 47 CFR FCC Part 15 Subpart C 15.247: 2013 PASS Prepared for: Arts Electronics Co., Ltd. No. 1, Shangxing Lu, Shangjiao Community, Changan Town, Dongguan, Guangdong, China Prepared by: Centre Testing International (Shenzhen) Corporation Hongwei Industrial Zone, 70 Area, Bao’an District, Shenzhen, Guangdong, China TEL: +86-755-3368 3668 FAX: +86-755-3368 3385 Tested by: Reviewed by: Approved by: Date: Sep. 18, 2014 Jimmy Li Lab manager Check No.: 1996250152 Report No. : EESZG08200016 Page 2 of 35 TABLE OF CONTENTS 1. CERTIFICATION INFORMATION ............................................................................................................... 4 2. TEST SUMMARY ........................................................................................................................................ 4 3. MEASUREMENT UNCERTAINTY .............................................................................................................. 5 4. PRODUCT INFORMATION ......................................................................................................................... 5 5. TEST EQUIPMENT LIST ............................................................................................................................. 5 6. SUPPORT EQUIPMENT LIST .................................................................................................................... 5 7. 6DB BANDWIDTH MEASUREMENT ......................................................................................................... 6 7.1. LIMITS ................................................................................................................................................. 6 7.2. BLOCK DIAGRAM OF TEST SETUP .................................................................................................. 6 7.3. TEST PROCEDURE ........................................................................................................................... 6 7.4. TEST RESULT .................................................................................................................................... 6 8. POWER SPECTRAL DENSITY .................................................................................................................. 9 8.1. LIMITS ................................................................................................................................................. 9 8.2. BLOCK DIAGRAM OF TEST SETUP .................................................................................................. 9 8.3. TEST PROCEDURE ........................................................................................................................... 9 8.4. TEST RESULT .................................................................................................................................... 9 9. MAXIMUM PEAK CONDUCTED OUTPUT POWER MEASUREMENT .................................................. 12 9.1. LIMITS ............................................................................................................................................... 12 9.2. BLOCK DIAGRAM OF TEST SETUP ................................................................................................ 12 9.3. TEST PROCEDURE ......................................................................................................................... 12 9.4. TEST RESULT .................................................................................................................................. 12 10. CONDUCTED BANDEDGE EMISSION MEASUREMENT .................................................................. 15 10.1. LIMITS ............................................................................................................................................... 15 10.2. BLOCK DIAGRAM OF TEST SETUP ................................................................................................ 15 10.3. TEST PROCEDURE ......................................................................................................................... 15 10.4. TEST RESULT .................................................................................................................................. 15 11. CONDUCTED SPURIOUS EMISSION MEASUREMENT ........................................................................ 17 Report No. : EESZG08200016 Page 3 of 35 11.1. LIMITS ............................................................................................................................................... 17 11.2. BLOCK DIAGRAM OF TEST SETUP ................................................................................................ 17 11.3. TEST PROCEDURE ......................................................................................................................... 17 11.4. TEST RESULT .................................................................................................................................. 17 12. RADIATED BANDEDGE EMISSION / RADIATED SPURIOUS EMISSION MEASUREMENT........... 20 12.1. LIMITS ............................................................................................................................................... 20 12.2. BLOCK DIAGRAM OF TEST SETUP ................................................................................................ 20 12.3. TEST PROCEDURE ......................................................................................................................... 21 12.4. TEST RESULT .................................................................................................................................. 22 13. AC CONDUCTED EMISSION TEST .…

Text truncated - open the document above for the full version.