UBBRSKT06Bluetooth Pen Pad; Bluetooth Tablet II

Pen Pad Users Manual  The R&TTE Directive We, the manufacturer (WALTOP International Corp.) hereby declare that this equipment (Bluetooth Pen Pad- Flying Pad), model RSK-T06 is in compliance with the essential requirements and other relevant provisions of Directive 1995/5/EC. FCC Caution This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. FCC RF Radiation Exposure Statement: The equipment complies with FCC RF radiation exposure limits set for the fore an uncontrolled environment. This Transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. 1. 2. • • •  Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. • • • •  Contents The R&TTE Directive 1 FCC Caution 1 Federal Communication Commission Interference Statement 2 Introduction 4 Hardware introduction 4 Function introduction 5 How to change the battery 5 How to replace the Pen Refill 6 Software Introduction of Bluetooth Pen Pad Manager 7 Wireless mode 8 Wired mode 8 LED Indicator information 8 USB mode 9 Important information for you to read! 10 Installation 11 Wired mode 11 Wireless mode 12 How to Unpairing 27 Troubleshooting 29 Product Specification 31 Bluetooth Pen Pad 31 Maintenance 33 Environment 34 — — — — — — — — — — —  Introduction Thank you for purchasing this product. Bluetooth Pen Pad provides two modes of connection with a PC: Wireless mode and wired mode. Both modes provide a convenient working environment. Please note that the setup procedures are different from wired and wireless mode and these will be stressed through this manual. Hardware introduction — Battery cover Pad “USB port Power Button Unpairing (press 5 seconds to unpair) Macro key Pen Slot  Function introduction Upper side button Pen clip Down side button LED Indicator How to change the battery — — Pen tip Battery ( + - )  How to replace the Pen Refill Pull out the used pen tip with the Refill Tweezers provided. Insert the Pen Refill to the pen. Press firmly on a hard surface for 5 seconds till the Pen Refill is locked. — 1. 2. 3.  Software Introduction of Bluetooth Pen Pad Manager Pen (Absolute mode) – the area of the Bluetooth Pen Pad corresponds to the whole area of the screen. For example, if place your wireless pen at the top right hand corner the mouse pointer will always be at the top right of the screen. Mouse (Relative mode) – acts like a mouse, moves in relation to where the mouse pointer currently is. For example, place your wireless pen anywhere on the pen pad. If you move up, the mouse pointer will follow, regardless of where you start the tablet. There are two buttons on the wireless pen. Each of these can be allocated a mouse action. — • • About Buttons Function Key  Wireless mode Bluetooth Pen Pad + Bluetooth Adapter on PC PS. Make sure that you have powerful batteries in the battery chart and switch the power button to on. Wired mode Bluetooth Pen Pad + USB Cable on PC. LED Indicator information There are two LED’s built in. One is Red and the other is Blue. Bluetooth mode: When the Bluetooth Tablet is turned on, the two LED will flash once. When the battery power is low, the Red LED will start to flash until the batteries are exhausted. Please change the battery once the Red LED flash. The Blue LED will flash continuously while the Bluetooth link to the PC in active. The Blue LED will be on when the pen is detected within the working area but will be off as soon as the pen touches the tablet. — — — 1. 2. 3. 4.  USB mode When the USB cable is initially connected to the Tablet, the Red LED will flash once and the Blue LED will flash continuously. The Blue LED will be on when the pen is detected within the working area but will be off as soon as the pen touches the tablet. Bluetooth Mode USB mode Power on ( Bluetooth mode) Blue flash once Red flash once Red flash once Blue flash continuously Working Blue flash continuously Blue flash continuously Pen within working areaBlue light Blue light Pen tip on the working area of tablet offoff Low battery Red light-- — 1. 2. USB cable plugged (USB mode) 0 Important information for you to read! Bluetooth Pen Pad ships with a bundled Broadcom IC Bluetooth device and WIDCOMM Bluetooth Software. We do not test with Bluetooth software from other manufactures, but in many cases, Our Bluetooth Pen Pad will work well with these third party Bluetooth software packages if their device support WIDCOMM Bluetooth Software version 5.0.1.1600. The Important factors to consider are the source of the Bluetooth software and the version of the Bluetooth software. …

Text truncated - open the document above for the full version.

SPORTON International Inc. PAGE NUMBER : A1 OF A5 TEL : 886-2-2696-2468 ISSUED DATE : FAX : 886-2-2696-2255 APPENDIX A. Photographs of EUT SPORTON International Inc. PAGE NUMBER : A2 OF A5 TEL : 886-2-2696-2468 ISSUED DATE : FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A3 OF A5 TEL : 886-2-2696-2468 ISSUED DATE : FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A4 OF A5 TEL : 886-2-2696-2468 ISSUED DATE : FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A5 OF A5 TEL : 886-2-2696-2468 ISSUED DATE : FAX : 886-2-2696-2255

70mm 39mm

SPORTON International Inc. PAGE NUMBER : A1 OF A3 TEL : 886-2-2696-2468 ISSUED DATE : FAX : 886-2-2696-2255 APPENDIX A. Photographs of EUT SPORTON International Inc. PAGE NUMBER : A2 OF A3 TEL : 886-2-2696-2468 ISSUED DATE : FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A3 OF A3 TEL : 886-2-2696-2468 ISSUED DATE : FAX : 886-2-2696-2255

SPORTON International Inc. No. 52, Hwa Ya 1st Rd., Kwei-Shan Hsiang, TaoYuan Hsien, Taiwan, R.O.C. Ph: 886-3-327-3456 / FAX: 886-3-327-0973 / www.sporton.com.tw Report Format Version: RF-15.247-2006-06-16-e FCC RADIO TEST REPORT Applicant’s company WALTOP International Corp. Applicant Address 6F,No.19-1 Industry E.Rd.IV,Hsinchu Science Park, Hsin-Chu 30077,Taiwan, R.O.C. FCC ID UBBRSKT06 Manufacturer’s company WALTOP International Corp. Manufacturer Address 6F,No.19-1 Industry E.Rd.IV,Hsinchu Science Park, Hsin-Chu 30077,Taiwan, R.O.C. Product Name Bluetooth Pen Pad; Bluetooth Tablet II, Brand Name WALTOP Model Name RSK-T06 Test Rule 47 CFR FCC Part 15 Subpart C § 15.247 Test Freq. Range 2400 ~ 2483.5MHz Receive Date May 23, 2006 Test Date Jun. 12, 2006 Submission Type Original Equipment Statement Test result included is only for the Bluetooth part of the product. The test result in this report refers exclusively to the presented test model / sample. Without written approval of SPORTON International Inc., the test report shall not be reproduced except in full. The measurements and test results shown in this test report were made in accordance with the procedures and found in compliance with the limit given in ANSI C63.4-2003 and 47 CFR FCC Part 15 Subpart C. The test equipment used to perform the test is calibrated and traceable to NML/ROC. Report No.: FR652319 Report Format Version: RF-15.247-2006-2-17-d Page No. : ii of ii FCC ID: UBBRSKT06 Issued Date : Jun. 20, 2006 Table of Contents 1. CERTIFICATE OF COMPLIANCE ......................................................................................................................... 1 2. SUMMARY OF THE TEST RESULT .......................................................................................................................... 2 3. GENERAL INFORMATION .................................................................................................................................. 3 3.1. Product Details....................................................................................................................................................................................3 3.2. Accessories .........................................................................................................................................................................................3 3.3. Table for Filed Antenna.......................................................................................................................................................................3 3.4. Table for Carrier Frequencies .............................................................................................................................................................3 3.5. Table for Test Modes ...........................................................................................................................................................................4 3.6. Table for Testing Locations..................................................................................................................................................................4 3.7. TTable for Supporting Units ..................................................................................................................................................................4 3.8. Table for Parameters of Test Software Setting .....................................................................................................................................5 3.9. Test Configurations .............................................................................................................................................................................6 4. TEST RESULT ..................................................................................................................................................... 8 4.1. AC Power Line Conducted Emissions Measurement...........................................................................................................................8 4.2. Maximum Peak Output Power Measurement ...................................................................................................................................12 4.3. Hopping Channel Separation Measurement ...................................................................................................................................14 4.4. Number of Hopping Frequency Measurement.................................................................................................................................19 4.5. Dwell Time Measurement..................................................................................................................................................................21 4.6. Radiated Emissions Measurement ....................................................................................................................................................28 4.7. Band Edge Emissions Measurement .................................................................................................................................................40 4.8. Antenna Requirements .....................................................................................................................................................................44 5. LIST OF MEASURING EQUIPMENTS ................................................................................................................... 45 6. SPORTON COMPANY PROFILE ........................................................................................................................ 47 6.1. Test Location.....................................................................................................................................................................................47 APPENDIX A. PHOTOGRAPHS OF EUT...................................................................................…

Text truncated - open the document above for the full version.

Report No.: FR652319 FCC ID: UBBRSKT06 Page No. : 1 of 8 Appendix B. Test Photos Report No.: FR652319 FCC ID: UBBRSKT06 Page No. : 2 of 8 1. Photographs of Conducted Emissions Test Configuration FRONT VIEW REAR VIEW Report No.: FR652319 FCC ID: UBBRSKT06 Page No. : 3 of 8 SIDE VIEW Report No.: FR652319 FCC ID: UBBRSKT06 Page No. : 4 of 8 2. Photographs of Radiated Emissions Test Configuration Below 30MHz FRONT VIEW REAR VIEW Report No.: FR652319 FCC ID: UBBRSKT06 Page No. : 5 of 8 Test Configuration: 30MHz~1GHz FRONT VIEW REAR VIEW Report No.: FR652319 FCC ID: UBBRSKT06 Page No. : 6 of 8 SIDE VIEW Report No.: FR652319 FCC ID: UBBRSKT06 Page No. : 7 of 8 Test Configuration: above 1GHz FRONT VIEW REAR VIEW Report No.: FR652319 FCC ID: UBBRSKT06 Page No. : 8 of 8 SIDE VIEW