UFW-DETDUO-FWGround Penetrating Radar

T ot pag. N°. = 74 - P RO/010/M1 Rev 4 - INGEGNERIA DEI SISTEMI S.p.A. Rev. 1.1 N°doc: MN/2009/028 Config.: DETECTOR DUO-PRCS-OUT-MN DETECTOR DUO USER MANUAL DETECTOR DUO SYSTEM – User manual Pisa, 12/02/2010 IDS Ingegneria Dei Sist emi S.p.A. N doc: MN/2009/028 - Rev. 1.1 DETECTOR DUO SYSTEM – User manual 2 / 74 All inform ation contained in this document is property of IDS. All rights reserved KEY WORDS GEORADAR, DETECTOR DUO, ANTENNA S UMMARY This manual contains a co mp lete descrip tion of the Detector Duo radar sy stem, detailin g the assemb ly p rocedure, the correct use of the data acquisition software, the work p rocedure and the gen eral op erating p rocedures of the sy stem. Document Evolution Revision Data Reason of modification Rev. 1.0 09/07/2009 First edition. It has been added a warnin g disclaimer and a new installation kit. Rev. 1.1 12/02/2010 FCC Information up dated SW Versions covered by this manual DETECTOR DUO V.02.00.000, 02.00.001, 02.00.006 OUR CONTACTS IDS Ingegneria dei Sistemi S .p.A. – GeoRadar Division Via Sterp ulino, 20 56121 Osp edaletto (PISA) - ITALIA Tel: +39.050.967111 Fax: +39.050.967121 inforis@ids-sp a.it Customer Care department: customercare. gp r@ids-sp a.it Tel.: +39.050.967122 S ales & Marketing department: sales.gp r@ids-sp a.it Tel.: +39.050.967123/24/43 IDS Ingegneria Dei Sist emi S.p.A. N doc: MN/2009/028 - Rev. 1.1 DETECTOR DUO SYSTEM – User manual 3 / 74 All inform ation contained in this document is property of IDS. All rights reserved DISCLAIMER IDS WILL NOT BE HELD RESPONSIBLE FOR THE CONSEQUENCES OF AN IMPROPER USE OF THE EQUIPM ENT AND/OR THE SOFTWARE. THIS SOFTWARE MAY INCLUDE AUTOMATED DATA PROCESSING AND ANALYSIS TOOLS. WHILE EVER Y EFFORT IS M ADE TO ENSURE THE ACCURACY OF THE INFORMATION PROVIDED BY THOSE TOOLS, THEY M UST NOT BE INTENDED AS A SUBSTITUTE FOR INTELLIGENT ANALYSIS; RATHER, THEY HAVE TO BE INTENDED AS AN ADVISOR AND THE USER MUST NOT COM PLETELY RELY ON THE RESULTS PROVIDED BY THEM TO GIVE THE COM PLETE ANSWER. IDS INGEGNERIA DEI SISTEM I SPA ASSUM ES NO LIABILITY FOR ANY DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES OR INJURIES CAUSED BY SUCH RELIANCE ON THE ACCURACY, RELIABILITY, OR TIM ELESS OF THE INFORM ATION PROVIDED BY THOSE TOOLS. ANY PERSON OR ENTITY WHO RELIES ON INFORM ATION OBTAINED FROM THE AUTOMATED DATA PROCESSING/ANALYSI S TOOLS ONLY, DOES SO AT HIS OR HER OWN RISK IDS Ingegneria Dei Sist emi S.p.A. N doc: MN/2009/028 - Rev. 1.1 DETECTOR DUO SYSTEM – User manual 4 / 74 All inform ation contained in this document is property of IDS. All rights reserved CONFORMITY TO EUROPEAN REGULATIONS The equipment conforms to the following requirements set by EC regulat ions, including subsequent modifications, and to the legis lat ion set by the member states that implement these regulations: 1999/05/EEC Radio Directive Warning: this equipment is destined for use in industrial environments (Class A apparatus). In residential, commercial and light industry environments, this apparatus may generate radio interference: in this case, the user may be required to operate while taking appropriate countermeasures. The apparatus is sensitive to the presence of external electromagnetic fields, which may reduce its performance. RADIO-FREQUENCY EXPOSURE COMPLIANCE This product operated is usually operated at least 1 m from the operator. Typical power density levels at a distance of 1 m or greater is below 1 μW/cm 2 (0.01 W/m 2 ) which are far below the levels specified by the current regulations. Thus, this product pose no health and safety risk when operated in the normal manner of intended use. IDS Ingegneria Dei Sist emi S.p.A. N doc: MN/2009/028 - Rev. 1.1 DETECTOR DUO SYSTEM – User manual 5 / 74 All inform ation contained in this document is property of IDS. All rights reserved ! WARNING CLEANING INFORMATION Before cleaning any external parts of the apparatus, make sure that all cables have been disconnected, including the power supply cable. If a damp cloth is used, make sure it is not too wet, to avoid any damage to the electrical components of the equipment. Wait until the equipm ent is totally dry before reconnecting the cables. The Detector Duo should be cleaned periodically using a damp cloth. Do not use solvents or abrasive detergents. Do not apply liquid directly to the electrical contacts of the various connectors. If a specific spray is used to clean the PC TFT monitor, make sure it is not flammable; ion any case, do not spray it directly on the screen, instead, spray it onto the cleaning cloth. IDS Ingegneria Dei Sist emi S.p.A. N doc: MN/2009/028 - Rev. 1.1 DETECTOR DUO SYSTEM – User manual 6 / 74 All inform ation contained in this document is property of IDS. All rights reserved BATTERIES REMOVAL INFORMATION Laptop Batteries: Manufacturer: PANASONIC Type: Li-ion Ni Characteristics: 10.65V 5.7Ah Removal instructions: 1. turn off the laptop; 2. open the drawer with the symbol of the batteries; 3. extract the battery pack pulling the tab. Radar batteries: Manufacturer: FIAMM FG21202 / SAFT MP176065 Type: rechargeable lead acid / rechargeable lithium-ion Characteristics: 12V & 12Ah / 15V & 6.8Ah Removal instructions: 1. disconnect the battery from the instrument: a. pull the connector wings; b. separate the connectors; 2. remove the battery from the cover (optional) opening the strap. IDS Ingegneria Dei Sist emi S.p.A. N doc: MN/2009/028 - Rev. 1.1 DETECTOR DUO SYSTEM – User manual 7 / 74 All inform ation contained in this document is property of IDS. All rights reserved RECICLYING The crossed out wheeled bin symbol shown on the equipment indicates that the product must be recycled separately from other waste at the end of its useful life. Separate waste disposal of this product at the end of its useful life will be organised and managed by IDS. When you decide to dispose of the equipment, contact IDS and follow the system that IDS has set up to permit the separate collection of the apparatus…

Text truncated - open the document above for the full version.

Transmitter board TX LF dipole RX LF dipole Receiver board Antenna connector & multiplexer board Transmitter board TX HF dipole RX HF dipole Receiver board Metallic shield + RAM layers ch1 ch2

Power supply External Battery A/D &Timing circuit Trigger amplifier board CPU & PC interface Front panel Rear panel High voltage section Low voltage section Ethernet Port WheelAntenna ON Switch LED

Digital Antenna Driver (D.A.D.) Unit: external picture Fig. 1: DAD external picture

EXTERNAL PICTURES

1.5” 3” FCC ID: UFW-DETDUO-FW This device complies with Part 15 of the Rules. Operation is subject to the two conditions: (1) this device may not harmful interference, and (2) this device accept any interference received, interference that may cause undesired operation.


 









page 2 of 45




























    

   

  
  



























































CONTENTS 1 Introduction ................................................................................ 1-3 1.1 Scope ........................................................................................ 1-3 1.2 Test specifications, methods & procedures ............................... 1-3 2 General Description of Equipment under Test ........................ 2-4 2.1 Applicant .................................................................................... 2-4 2.2 Manufacturer ............................................................................. 2-4 2.3 Equipment classification ............................................................ 2-4 2.4 Basic description of equipment under test................................. 2-5 2.5 Feature of equipment under test ............................................... 2-5 3 Test Configuration of EUT......................................................... 3-6 3.1 EUT Operating test conditions................................................... 3-6 3.2 EUT Configurations ................................................................... 3-6 3.3 Description of support equipment .............................................. 3-6 4 General Test Set-Up ................................................................... 4-7 4.1 Environmental conditions........................................................... 4-7 4.2 Description................................................................................. 4-7 4.3 Drawings.................................................................................... 4-8 5 Summary Of Test Results.......................................................... 5-9 6 Measurements and Tests Data................................................ 6-10 7 Technical Documentation........................................................ 7-41 8 Photographic Documentation ................................................. 8-42 8.1 EUT Identification .................................................................... 8-42 8.2 Test set-up............................................................................... 8-43 9 Measurement Uncertainty ....................................................... 9-44 9.1 Radiated Emission Measurement Uncertainty from 30 to 1000 MHz9-44 9.2 Radiated Emission Measurement Uncertainty above 1000 MHz ......9-44 10 List Of Measuring Equipment And Calibration Information 10-45









































 









page 3 of 45




























    

   

  
  



























































1 INTRODUCTION 1.1 Scope Obtain FCC Certification Authorization with the requirement of Title 47 of the Code of Federal Regulations Part 15 subpart F. 1.2 Test specifications, methods & procedures Publication Year Title 47 CFR Part 15 2008 Radio Frequency Device ANSI C63.4 2004 Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and Electronic Equipment in the Range of 9 kHz to 40 GHz FCC Order, ET Docket No. 98- 153 (FCC 02-48) 2002 Revision of Part 15 of the Commission’s Rules Regarding Ultra-Wideband Transmission Systems KDB Publication No. 393764 2007 UWB Compliance Measurements









































 









page 4 of 45




























    

   

  
  



























































2 GENERAL DESCRIPTION OF EQUIPMENT UNDER TEST 2.1 Applicant NAME IDS INGEGNERIA DEI SISTEMI S.p.A. ADDRESS Via Livornese, 1019 – I-56122 PISA COUNTRY ITALY 2.2 Manufacturer NAME IDS INGEGNERIA DEI SISTEMI S.p.A. ADDRESS Via Sterpulino, 20 – I-56121 PISA COUNTRY ITALY 2.3 Equipment classification According to the definition 15.503 EUT is a Ground penetrating radar (GPR) system so it shall fulfil provisions of 47 CFR Part 15 Subpart F – Ultra Wideband Operation– Section 15.509.









































 









page 5 of 45




























    

   

  
  



























































2.4 Basic description of equipment under test Parameters Value Type of equipment Ground penetrating radar (GPR) system Model DETECTOR DUO FCC ID UFW-DETDUO-FW Trade Name IDS INGEGNERIA DEI SISTEMI S.p.A. General Overview The DETECTOR DUO system is a Ground penetrating radar (GPR) system, i.e., according to the FCC definition, a field disturbance sensor that is designed to operate only when in contact with the ground for the purpose of detecting or obtaining the images of buried objects or determining the physical properties within the ground. The Detector Duo uses a high performance electromagnetic sensor equipped with e.m. transmitters and receivers. The fundamental characteristic of this system is the simultaneous use of two frequencies, permitting the identification of both shallow and deep utilities at the same time. 2.5 Feature of equipment under test Parameters Value Power supply type DC 12 V battery supplied Operating frequency 47,00 to 582,00 MHz (10 dB Bandwidth) Channel Spacing Not applicable Pulse Repetition Frequency (PRF) 200 KHz Antenna description Integral permanently attached Antenna Type Dipole









































 









page 6 of 45




























    

   

  
  


























































…

Text truncated - open the document above for the full version.