ULZ-TXK001TPMS

TPMS TX-K001-BL/TX-K002-BL User's Manual Frequency 315/433.92 MHz Pressure Range 100~900 kPa Temperature Range -40 ~125°C Operating Humidity Max. 95% Operating Temperature -40 ~105°C Storage Temperature -40 ~125°C (1) Dismount tire and sensor from the wheel. And clear valve stem hole in rim of Dismount tire and sensor from the wheel. Push the valve stem thru the rim, install the washer and nut, then tighten the nut to 36 in-lb Hold the sensor body against the rim and install then tighten the screw to 20 in-lb Mount the tire back to vehicle FCC Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. RF exposure warning: The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment. The equipment must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC ID: ULZ-TXK001 EUT 1 EUT 2 FCC ID: ULZ-TXK001 EUT 3 EUT 4 FCC ID: ULZ-TXK001 EUT 5 EUT 6 FCC ID: ULZ-TXK001 EUT 7 EUT 8 FCC ID: ULZ-TXK001 EUT 9

FCC ID: ULZ-TXK001 International Standards Laboratory Corp. Report Number: ISL-19LR306FC433 EUT 10 EUT 11 FCC ID: ULZ-TXK001 International Standards Laboratory Corp. Report Number: ISL-19LR306FC433 EUT 12 EUT 13 FCC ID: ULZ-TXK001 International Standards Laboratory Corp. Report Number: ISL-19LR306FC433 EUT 14 ~ End of Report ~

Page: 1 of 30 TEST REPORT of FCC Part 15 Subpart C New Application; Class I PC; Class II PC Product : TPMS Brand: MOBILETRON Model: TX-K001; TX-K002 and other models listed in page 6 Model Difference: Model differences in appearance and market segmentation FCC ID: ULZ-TXK001 FCC Rule Part: §15.231 (e) Applicant: Mobiletron Electronics Co., Ltd. Address: 85, Sec.4, Chung-Ching Rd., Ta-Ya District, Taichung 428, Taiwan Test Performed by: International Standards Laboratory Corp. <LT Lab.> *Site Registration No. BSMI: SL2-IN-E-0013; MRA TW0997; TAF: 0997 *Address: No. 120, Lane 180, Hsin Ho Rd., Lung-Tan Dist., Tao Yuan City 325, Taiwan *Tel : 886-3-407-1718; Fax: 886-3-407-1738 Report No.: ISL-19LR306FC315 Issue Date : 2019/11/22 Test results given in this report apply only to the specific sample(s) tested and are traceable to national or international standard through calibration of the equipment and evaluating measurement uncertainty herein. This report MUST not be used to claim product endorsement by TAF or any agency of the Government. This test report shall not be reproduced except in full, without the written approval of International Standards Laboratory. -2 of 30- FCC ID: ULZ-TXK001 International Standards Laboratory Corp. Report Number: ISL-19LR306FC315 VERIFICATION OF COMPLIANCE Applicant: Mobiletron Electronics Co., Ltd. Product Description: TPMS Brand Name: MOBILETRON FCC ID: ULZ-TXK001 FCC Rule Part: §15.231 (e) Model No.: TX-K001; TX-K002 and other models listed in page 6 Model Difference: Model differences in appearance and market segmentation Date of test: 2019/10/13 ~ 2019/10/23 Date of EUT Received: 2019/10/09 We hereby certify that: All the tests in this report have been performed and recorded in accordance with the standards described above and performed by an independent electromagnetic compatibility consultant, International Standards Laboratory. The test results contained in this report accurately represent the measurements of the characteristics and the energy generated by sample equipment under test at the time of the test. The sample equipment tested as described in this report is in compliance with the limits of above standards. Test By: Date: 2019/11/22 Bill Huang / Engineer Prepared By: Date: 2019/11/22 Elisa Chen / Sr. Engineer Approved By: Date: 2019/11/22 Jerry Liu / Technical Manager -3 of 30- FCC ID: ULZ-TXK001 International Standards Laboratory Corp. Report Number: ISL-19LR306FC315 Version Version No. Date Description 00 2019/11/22 Initial creation of document Uncertainty of Measurement Description Of Test Uncertainty Conducted Emission (AC power line) 2.586 dB Field Strength of Spurious Radiation <=30MHz: 2.96dB 30-1GHz: 4.22 dB 1-40 GHz: 4.08 dB Conducted Power 2.412 GHz: 1.30 dB 5.805 GHz: 1.55 dB Power Density 2.412 GHz:1.30 dB 5.805 GHz: 1.67 dB Frequency 0.0032% Time 0.01% DC Voltage 1% -4 of 30- FCC ID: ULZ-TXK001 International Standards Laboratory Corp. Report Number: ISL-19LR306FC315 Table of Contents 1. GENERAL INFORMATION ............................................................................................ 6 1.1 PRODUCT DESCRIPTION ................................................................................................................... 6 1.2 RELATED SUBMITTAL(S) / GRANT (S) .............................................................................................. 8 1.3 TEST METHODOLOGY ....................................................................................................................... 8 1.4 TEST FACILITY ................................................................................................................................. 8 1.5 SPECIAL ACCESSORIES ..................................................................................................................... 8 1.6 EQUIPMENT MODIFICATIONS ........................................................................................................... 8 2. SYSTEM TEST CONFIGURATION ............................................................................... 9 2.1 EUT CONFIGURATION ...................................................................................................................... 9 2.2 EUT EXERCISE ................................................................................................................................. 9 2.3 TEST PROCEDURE ............................................................................................................................. 9 2.4 LIMITATION .................................................................................................................................... 10 2.5 CONFIGURATION OF TESTED SYSTEM ............................................................................................ 12 3. SUMMARY OF TEST RESULTS .................................................................................. 13 4. DESCRIPTION OF TEST MODES .............................................................................. 13 5. AC CONDUCTED EMISSIONS TEST .......................................................................... 14 5.1 MEASUREMENT PROCEDURE: ........................................................................................................ 14 5.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION) ................................................................ 14 5.3 MEASUREMENT EQUIPMENT USED: ............................................................................................... 14 5.4 MEASUREMENT RESULT: ............................................................................................................... 14 6. DUTY CYCLE (AVERAGE CORRECTION FACTOR) MEASUREMENT ............ 15 6.1 MEASUREMENT PROCEDURE.......................................................................................................... 15 6.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION) ................................................................ 15 6.3 MEASUREMENT EQUIPMENT …

Text truncated - open the document above for the full version.

Page: 1 of 32 TEST REPORT of FCC Part 15 Subpart C New Application; Class I PC; Class II PC Product : TPMS Brand: MOBILETRON Model: TX-K001; TX-K002 and other models listed in page 6 Model Difference: Model differences in appearance and market segmentation FCC ID: ULZ-TXK001 FCC Rule Part: §15.231 (e) Applicant: Mobiletron Electronics Co., Ltd. Address: 85, Sec.4, Chung-Ching Rd., Ta-Ya District, Taichung 428, Taiwan Test Performed by: International Standards Laboratory Corp. <LT Lab.> *Site Registration No. BSMI: SL2-IN-E-0013; MRA TW1036; TAF: 0997 *Address: No. 120, Lane 180, Hsin Ho Rd. Lung-Tan Dist., Tao Yuan City 325, Taiwan *Tel : 886-3-407-1718; Fax: 886-3-407-1738 Report No.: ISL-19LR306FC433 Issue Date : 2019/11/22 Test results given in this report apply only to the specific sample(s) tested and are traceable to national or international standard through calibration of the equipment and evaluating measurement uncertainty herein. This report MUST not be used to claim product endorsement by TAF or any agency of the Government. This test report shall not be reproduced except in full, without the written approval of International Standards Laboratory. -2 of 32- FCC ID: ULZ-TXK001 International Standards Laboratory Corp. Report Number: ISL-19LR306FC433 VERIFICATION OF COMPLIANCE Applicant: Mobiletron Electronics Co., Ltd. Product Description: TPMS Brand Name: MOBILETRON FCC ID: ULZ-TXK001 FCC Rule Part: §15.231 (e) Model No.: TX-K001; TX-K002 and other models listed in page 6 Model Difference: Model differences in appearance and market segmentation Date of test: 2019/10/13 ~ 2019/10/23 Date of EUT Received: 2019/10/09 We hereby certify that: All the tests in this report have been performed and recorded in accordance with the standards described above and performed by an independent electromagnetic compatibility consultant, International Standards Laboratory. The test results contained in this report accurately represent the measurements of the characteristics and the energy generated by sample equipment under test at the time of the test. The sample equipment tested as described in this report is in compliance with the limits of above standards. Test By: Date: 2019/11/22 Bill Huang / Engineer Prepared By: Date: 2019/11/22 Elisa Chen / Sr. Engineer Approved By: Date: 2019/11/22 Jerry Liu / Technical Manger -3 of 32- FCC ID: ULZ-TXK001 International Standards Laboratory Corp. Report Number: ISL-19LR306FC433 Version Version No. Date Description 00 2019/11/22 Initial creation of document Uncertainty of Measurement Description Of Test Uncertainty Conducted Emission (AC power line) 2.586 dB Field Strength of Spurious Radiation <=30MHz: 2.96dB 30-1GHz: 4.22 dB 1-40 GHz: 4.08 dB Conducted Power 2.412 GHz: 1.30 dB 5.805 GHz: 1.55 dB Power Density 2.412 GHz:1.30 dB 5.805 GHz: 1.67 dB Frequency 0.0032% Time 0.01% DC Voltage 1% -4 of 32- FCC ID: ULZ-TXK001 International Standards Laboratory Corp. Report Number: ISL-19LR306FC433 Table of Contents 1. GENERAL INFORMATION ............................................................................................ 6 1.1 PRODUCT DESCRIPTION ................................................................................................................... 6 1.2 RELATED SUBMITTAL(S) / GRANT (S) .............................................................................................. 8 1.3 TEST METHODOLOGY ....................................................................................................................... 8 1.4 TEST FACILITY ................................................................................................................................. 8 1.5 SPECIAL ACCESSORIES ..................................................................................................................... 8 1.6 EQUIPMENT MODIFICATIONS ........................................................................................................... 8 2. SYSTEM TEST CONFIGURATION ............................................................................... 9 2.1 EUT CONFIGURATION ...................................................................................................................... 9 2.2 EUT EXERCISE ................................................................................................................................. 9 2.3 TEST PROCEDURE ............................................................................................................................. 9 2.4 LIMITATION .................................................................................................................................... 10 2.5 CONFIGURATION OF TESTED SYSTEM ............................................................................................ 12 3. SUMMARY OF TEST RESULTS .................................................................................. 13 4. DESCRIPTION OF TEST MODES .............................................................................. 13 5. AC CONDUCTED EMISSIONS TEST .......................................................................... 14 5.1 MEASUREMENT PROCEDURE: ........................................................................................................ 14 5.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION) ................................................................ 14 5.3 MEASUREMENT EQUIPMENT USED: ............................................................................................... 14 5.4 MEASUREMENT RESULT: ............................................................................................................... 14 6. DUTY CYCLE (AVERAGE CORRECTION FACTOR) MEASUREMENT ............ 15 6.1 MEASUREMENT PROCEDURE.......................................................................................................... 15 6.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION) ................................................................ 15 6.3 MEASUREMENT EQUIPMENT US…

Text truncated - open the document above for the full version.

FCC ID: ULZ-TXK001 Radiated Emission Setup Photos FCC ID: ULZ-TXK001