UNHCCH-YY888TRAFFICJAMZ

OPERATING INSTRUCTIONS 1>. Turn on iPod player; plug the device into the input connector port of iPod 2>. Plug the transmitter into the cigarette lighter in your car 3>. Start the car radio and set an acceptable frequency and then adjust to your acceptable volume 4>. Adjust the frequency, “+” Increase 0.1 MHz frequency; “_” decrease 0.1 MHz frequency 5>. When is working, charge for ipod as well FM module: Ipod player Audio output R ch & L ch audio signal pass through audio mixer and be mixed with RF VCO, VCO frequency, is controlled by PLL circuit, amplified by RF AMP, and transmitted through antenna. Full frequency and is changeable, Adjust the frequency through “+” to Increase 0.1 MHz frequency and “_” to decrease 0.1 MHz frequency FCC NOTE: The antenna provided is a unique antenna. By installation of unauthorized antenna to this equipment. Such unauthorized installation could void the user’s authority to operate the equipment. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could also void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.

cch-yy888 (938x613x24b jpeg)

Newer Technology, Inc. FCC ID: UNHCCH-YY888 Report No. SE006I-393R Page 18 of 21 FCC PART 15.239 Report APPENDIX B - EUT PHOTOGRAPHS EUT - Whole View EUT - Top View Newer Technology, Inc. FCC ID: UNHCCH-YY888 Report No. SE006I-393R Page 19 of 21 FCC PART 15.239 Report EUT - Bottom View EUT - Side View

Newer Technology, Inc. FCC ID: UNHCCH-YY888 Report No. SE006I-393R Page 17 of 21 FCC PART 15.239 Report APPENDIX A - PRODUCT LABELING FCC ID Label Specification Specification: Text is Black or white in color and is left justified. Labels are printed in indelible ink on permanent adhesive backing and shall be affixed at a conspicuous location on the EUT or silk-screened onto the EUT. FCC ID: UNHCCH-YY888 Proposed Label Location on EUT EUT Proposed FCC ID Label Location FCC ID Label Location

Newer Technology, Inc. FCC ID: UNHCCH-YY888 Report No. SE006I-393R Page 20 of 21 FCC PART 15.239 Report EUT – PCB View

Operation Description R ch & L ch audio signal pass through audio mixer and be mixed with RF VCO, VCO frequency is controlled by phase locked loop(PLL) circuit, amplified by RF AMP, and transmitted through antenna. FM output channels can be adjusted by DIP switches. There is no external ground connection. The ground is only that of the printed circuit board. The input voltage of this FM Transmitter is 12V supplied by a car battery.

FCC PART 15 C MEASUREMENT AND TEST REPORT For Newer Technology, Inc. Building 4, Ji'antai Industry Garden, Industry Bivd, Fuyong Town, Bao’an District, Shenzhen, China FCC ID: UNHCCH-YY888 September 27, 2006 This Report Concerns: Original Report Equipment Type: TrafficJamz Test Engineer: Rocky Ge Report Number: SE06I-393R Test Date: September 25-26 , 2006 Reviewed By: Prepared By: S&E Technologies Laboratory Ltd Room407,Block A Shennan Garden,Hi-Tech Industrial Park, Shenzhen 518057, P.R. China. Tel: 86-755-26636573, 26630631 Fax: 86-755-26630557 Note: This test report is limited to the above client company and the product model only. It may not be duplicated without prior written consent of S&E Technologies Laboratory Ltd. Newer Technology, Inc. FCC ID: UNHCCH-YY888 Report No. SE006I-393R Page 2 of 21 FCC PART 15.239 Report TABLE OF CONTENTS 1 - GENERAL INFORMATION ....................................................................................................................... 3 1.1 Product Description for Equipment Under Test (EUT)..............................................................3 1.2 Test Standards...........................................................................................................................4 1.3 Test Summary............................................................................................................................4 1.4 Test Methodology ......................................................................................................................4 1.5 Test Facility................................................................................................................................4 1.6 Test Equipment List and Details................................................................................................5 2 - SYSTEM TEST CONFIGURATION ........................................................................................................... 6 2.1 Justification ................................................................................................................................6 2.2 EUT Exercise Software .............................................................................................................6 2.3 Special Accessories...................................................................................................................6 2.4 Equipment Modifications ...........................................................................................................6 2.5 Basic Test Setup Block Diagram...............................................................................................6 3 – DISTURBANCE VOLTAGE AT THE MAINS TERMINALS ..................................................................... 7 3.1 Measurement Uncertainty .........................................................................................................7 3.2 Applicable Standard...................................................................................................................7 3.3 Test Description .........................................................................................................................7 4- RADIATED DISTURBANCES .................................................................................................................... 8 4.1 Measurement Uncertainty .........................................................................................................8 4.2 Limit of Radiated Disturbances .................................................................................................8 4.3 EUT Setup .................................................................................................................................8 4.4 Test Receiver Setup ..................................................................................................................8 4.5 Test Procedure ..........................................................................................................................9 4.6 Corrected Amplitude & Margin Calculation ...............................................................................9 4.7 Radiated Emissions Test Result ...............................................................................................9 5- OCCUPIED BANDWIDTH ........................................................................................................................ 13 5.1 Requirement of Occupied Bandwidth......................................................................................13 5.2 Test Procedure ........................................................................................................................13 5.3 Occupied Bandwidth Test Result ............................................................................................13 APPENDIX A - PRODUCT LABELING ........................................................................................................ 17 FCC ID Label Specification ...........................................................................................................17 Proposed Label Location on EUT .................................................................................................17 APPENDIX B - EUT PHOTOGRAPHS ......................................................................................................... 18 EUT - Whole View..........................................................................................................................18 EUT - Top View..............................................................................................................................18 EUT - Bottom View ........................................................................................................................19 EUT - Side View.............................................................................................................................19 EUT – PCB View...................................…

Text truncated - open the document above for the full version.

Newer Technology, Inc. FCC ID: UNHCCH-YY888 Report No. SE006I-393R Page 21 of 21 FCC PART 15.239 Report APPENDIX C – TEST SETUP PHOTOGRAPHS Radiated Emission