VNY-3509Dancing Waters Light & Fountain Show Remote

INSTRUCTIONS Remove from pool when not in use or while cleaning so unit is not damaged by skim- mers or other devices. This product should be operated in at least 12 inches of water to get the maximum water height. It is recommended to clean out the filter screen at bottom of unit periodically to ensure proper water flow. NOTE: MP3 player and speakers are not included. Ba TTER y INST allaTION Make sure the product is thoroughly dr y before replacing batteries. Main Unit 1. Turn cap on battery casing counter clockwise to open. 2. R emove battery cover and insert four (4) “D” batteries. 3. Line up the notches of the battery cover with the notches on the battery casing and press firmly . 4. Screw cap on battery casing and tighten securely to ensure that water does not seep into battery casing . Remote Control 1. Compress the battery door latch and remove battery door. 2. Insert one (1) 9V battery making sure that the terminals are aligned. 3. R e-insert the battery door into the notches on the casing. 4. Push the door closed until the battery door re-latches. NOTE! • Do not mix old and new batteries. • Do not dispose battery into fire. Batteries may explode or leak. • Do not mix alkaline, standard, or rechargeable batteries. • Non-rechargeable batteries are not to be recharged. • The supply terminal is not to be short circuited. • Remove exhausted batteries promptly and dispose of properly. • Batteries are to be inserted with the correct polarity. REMOTE CONTROl SET Up • Connect 3.5mm jack to audio source (MP3 player, stereo) NOTE: The remote control is a pass through analyzer. The music passes through the remote, unchanged. The fountain will ‘dance’ without having speakers plugged into the remote control. To hear the sound, you’ll need something plugged into the output of the remote control. IMpORTaNT: Do NOT put amplified, speaker-level signal into the Dancing Fountain remote – only signal level (not amplified, or meant for headphones). Amplified speaker power levels will destroy the remote, and void the warranty. • Plug speakers into the “OUT” jack on the back of the remote control. A 3.5mm input jack is required (not included). • Turn on music source. Adjust output volume to MIDDLE setting. Turn on speakers. Adjust volume to preference. Note that the volume of the amplified speaker system does not affect the light display – the frequency analysis happened by the time the signal gets to the speakers. continued 3509 INSTR R0A 120810 Designed in the USA. Made in China. U.S. Patent 7,413,319 © 2010 GAME: Great American Merchandise & Events™ All rights reserved. Great American Merchandise & Events™ (GAME™) 16043 N. 82nd Street Scottsdale, AZ 85260 - 1800 USA tel: 888DUCKY88 (382.5988) fax: 602.957.POOL (7665) email: [email protected] www.game-group.com 3.5mm jack Output to speaker (3.5mm jack) Remote Control • T urn on Dancing Fountain Remote by pressing the ON button. A red LED will light up. • If you don’t want to play music, you may press the Fountain button on the Remote to put the Fountain into “Random Non-Dancing” mode. The Fountain will switch OFF automatically after one hour of use in Random Non-Dancing mode. • Remote reacts to a sound signal of any type. A hiss or other noise will be interpreted as signal. Most MP3 type players do not have this problem, older stereo systems or computer-based systems may. • When you switch on music, Fountain switches to Dancing mode, and reacts to the frequencies. • The R emote analyzes the music, and divides it into four frequencies: Bass, Mid-Bass, Midrange, and High End. When volume of these levels reaches a certain point, it causes a set of LEDs to switch on. • R emote has a Sensitivity Wheel. This adjusts the volume at which the LEDs activate. This depends on two things: The output volume from your source (MP3 Player, Stereo) and the adjustment of the sensitivity wheel. Example 1: Leaving your Audio Source at mid-volume output, you can adjust the sensitivity wheel on the Remote. The light show will change depending on the musical data and where you adjust the sensitivity wheel. The volume of the amplified speakers will not go up or down. Example 2: You adjust the output (volume) of your player up, and leave the sensitivity wheel set where it is. The light show will change, and the output volume of the amplified speakers will also go up (the output from the audio source, which the speaker system is amplifying, has gone up.) When you are done playing music, and switch your Audio Source “off”, the Fountain will automatically switch “off” in 10 seconds. After this time, you may press the “Fountain” button on the Remote, and activate the “Random Non-Dancing” mode on the Fountain. LIGHTS ONLY mode - press the LIGHTS button on fountain. Lights will run in Dancing and Random mode with no spray until the Fountain is switched off (or switches Off automatically) or LIGHTS button is pressed again. • The Input wire on R emote plugs into your Audio Source. • Y our speaker system or headphones plug into the Remote’s Output jack. • The Audio Source volume control affects light show . • The Sensitivity wheel on R emote affects the light show. • The sensitivity wheel adjusts volume levels from Audio Source at which LEDs are switched on or off at their respective frequencies. • The volume on amplified speak er system does NOT affect the light show. • The R emote is a pass-though, does not create sound nor adjust volume. • Fountain switches off 10 seconds after music ends, or one hour after Random Non- Dancing mode is activated. WARNING: SEIZURES - pEOplE wITh phOTOSENSITIvE EpIlEpSy CaN havE SEIZURES TRIggEREd By flICkERINg OR flaShINg lIghTS SUCh aS STROBE OR dISCO lIghTS. kEEp OUT Of REaCh Of ChIldREN. ThIS IS NOT INTENdEd aS a TOy. CaUTION: Changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits …

Text truncated - open the document above for the full version.

Applicant：Great American Duck Races, Inc. FCC ID：VNY-3509 Block Diagram

FCC Certification label Sample

FCC Certification Label Location Sample Label location

Antenna

Applicant：Great American Duck Races, Inc. FCC ID：VNY-3509 Operation Description The button on the TX is use to control the RX on & off. When the audio connect with MP3, the OP-Amp will choose the frequency ( 200Hz, 600Hz, 2.5KHz, 6KHz ) and then send to 4 corresponding MCU I/O, MCU will analysis there are which frequency input when received the signal and then will send out the serial code to TX module, the module will start to decode and send out to RX. Antenna is formed by a spiral copper. Common grounding on PCB is not connected to real external ground. Power supply is DC 9V by Size “9V” battery.

123456 A B C D 6 54321 D C B A Title NumberRevisionSize C Date:19-Nov-2010Sheet of File:G:\xian\Product\GAME\03509_Dancing Fountain Release Packet\DDB\ULS_mp3.DDBDrawn By: R31 NL R3710R Q5 8550 C171uF C10 100uF K1 9V BAT 4.5V O 3 I 2 1 ADJ U84.5V Dancing ULS QM-ULS-TX03 01 2010.11.09 VSS 1 P0.1 2 P0.2 3 P0.3 4 P0.4 5 P0.5 6 P0.6 7 P0.7 8 P5.0 9 P5.1 10 P5.2 11 P5.3 12 P5.4 13 P4.0 14 P4.1 15 P4.2 16 P4.3 17 P4.4 18 P0.0 19 VDD 20 U6 SN8P2722S ANT GND DATA VDD LW203M PCB Trace Antenna (915MHz) U4-C D3 IN4148 R912.7K R12 6.37K R66.37K R22 100K R7100R C2210nF C2110nF C3 1uF R8 NP Q3 8050 VREF C181uF U4-D D4 IN4148 R402.65K R38 1K R24 100K R10100R C2514.7nF C2314.7nF C4 1uF R11 NP Q4 8050 VREF C141uF U4-A D1 IN4148 R15 100K R35.4K R1100R R202.7K C1 1uF R195.4K R2 NP Q1 8050 C8100nF C13 267nF C151uF U4-B D2 IN4148 VREF R256.37K R27 1.69K R233.18K R21 100K R4100R C20100nF C19100nF C2 1uF R5 NP Q2 8050 VREF U5-A R29 10K R26 510R R131K C16 104 C7 1uF VREF R1610K C510uF R141K C610uF R28 10K Audio Out Audio In U5-B R410R R18100K VREF R17 100K VCC 4.5V C9 10uF SW D244001 D234001 R36 1K D27 LED R3010K C26 10uF 5V DC Supply (USB Mini-A) C2429.4nF + - 3 2 + - 5 6 VCC VCC + - 3 2 + - 5 6 + - 10 9 + - 12 13 C27 104 200Hz LP 600Hz BP 2.5KHz BP 6KHz HP GND(Black) R (Red) L(White) R5 10R 1 7 81 7 8 14 4 267nF=0.26 7uF 270nF=0.27uF 14.7nF=0.0147uF 15nF=0.015uF 29.4nF=0.0294uF 30nF=0.03uF 5.4K 5.6K 6.37K 6.34K 12.73K 12.7K 3.18K 3.16K 2.65K 2.67K D5IN4148 * * R3410R * * VCC *

Page 1 of 26 FCC CERTIFICATION On Behalf of Great American Duck Races, Inc. Dancing Waters Light & Fountain Show Remote Model No.: 3509 FCC ID: VNY-3509 Prepared for : Great American Duck Races, Inc. Address : 16043 N. 82 nd Street, Scottsdale, AZ 85260, USA Prepared by : Accurate Technology Co., Ltd. Address : F1, Bldg. A, Changyuan New Material Port, Keyuan Rd. Science & Industry Park, Nanshan, Shenzhen, Guangdong P.R. China Tel: (0755) 26503290 Fax: (0755) 26503396 Report Number : ATE20102683 Date of Test : December 20-21, 2010 Date of Report : December 23, 2010 FCC ID: VNY-3509 ACCURATE TECHNOLOGY CO., LTD REPORT NO. ATE20102683 Page 2 of 26 FCC ID: VNY-3509 ACCURATE TECHNOLOGY CO., LTD REPORT NO. ATE20102683 TABLE OF CONTENTS Description Page Test Report Certification 1. GENERAL INFORMATION.......................................................................................................... 4 1.1. Description of Device (EUT)....................................................................................................................4 1.2. Description of Test Facility......................................................................................................................5 1.3. Measurement Uncertainty.........................................................................................................................5 2. MEASURING DEVICE AND TEST EQUIPMENT..................................................................... 6 3. SUMMARY OF TEST RESULTS................................................................................................... 7 4. FUNDAMENTAL AND HARMONICS RADIATED EMISSION FOR SECTION 15.249(A)8 4.1. Block Diagram of Test Setup....................................................................................................................8 4.2. The Emission Limit..................................................................................................................................9 4.3. Configuration of EUT on Measurement...................................................................................................9 4.4. Operating Condition of EUT....................................................................................................................9 4.5. Test Procedure........................................................................................................................................10 4.6. The Field Strength of Radiation Emission Measurement Results..........................................................11 5. SPURIOUS RADIATED EMISSION FOR SECTION 15.249(D)............................................. 12 5.1. Block Diagram of Test Setup..................................................................................................................12 5.2. The Emission Limit For Section 15.249(d)............................................................................................13 5.3. EUT Configuration on Measurement.....................................................................................................13 5.4. Operating Condition of EUT..................................................................................................................13 5.5. Test Procedure........................................................................................................................................14 5.6. The Emission Measurement Result........................................................................................................15 6. BAND EDGES................................................................................................................................. 16 6.1. The Requirement....................................................................................................................................16 6.2. EUT Configuration on Measurement.....................................................................................................16 6.3. Operating Condition of EUT..................................................................................................................16 6.4. Test Procedure........................................................................................................................................17 6.5. The Measurement Result........................................................................................................................18 7. ANTENNA REQUIREMENT........................................................................................................ 19 7.1. The Requirement....................................................................................................................................19 7.2. Antenna Construction.............................................................................................................................19 APPENDIX I ( TEST CURVES) (6 pages) Page 3 of 26 Test Report Certification Applicant : Great American Duck Races, Inc. Manufacturer : Qualiman Industrial CO., LTD EUT Description : Dancing Waters Light & Fountain Show Remote (A) MODEL NO.: 3509 (B) SERIAL NO.: N/A (C) POWER SUPPLY: 9V DC (“9V”battery 1×) Measurement Procedure Used: FCC Rules and Regulations Part 15 Subpart C Section 15.249 ANSI C63.4: 2003 The device described above is tested by Accurate Technology Co., Ltd. to determine the maximum emission levels emanating from the device. The maximum emission levels are compared to the FCC Part 15 Subpart C Section15.249 limits. The measurement results are contained in this test report and Accurate Technology Co., Ltd. is assumed full responsibility for the accuracy and completeness of these measurements. Also, this report shows that the Equipment Under Test (EUT) is to be technically compliant with the FCC requirements. This report applies to above tested sample only. This report shall not be reproduced in part without written approval of Accurate Technology Co., Ltd. Date of Test : February 6-7, 2010 Prepar…

Text truncated - open the document above for the full version.

Radiated emissions test < 1GHz Radiated emissions test > 1GHz