VZB-FM39011game controller plus

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. 112*230mm FM39011

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2 Rev 2.0 2206 Ringwood Avenue San Jose, CA 95131 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (current) 1.0 1.0 Nov-14-2006 Revised wording (current) 1.0 2.0 Sept–25-2007 SCS-F18: Project and Product Certification Representative Authorization Letter Page 2 of 2 Rev 2.0 ShenZhen Xinzhensheng electronics CO LTD 2010-09-25 To: SIEMIC, INC. 2206 Ringwood Avenue, San Jose, CA 95131 USA Dear Sir/Madam, Re: Project and Product Certification Representative Authorization Letter We, ___ ShenZhen Xinzhensheng electronics CO LTD _ hereby authorize SIEMIC, INC. to act as a Certification Body for certifying for the following project(s): game controller plus We affirm that between SIEMIC and __ ShenZhen Xinzhensheng electronics CO LTD ___, any difference in understanding, including test plan, measurement methods, applicable standards and relevant procedures and processes have been resolved prior to commencement of testing activities. Sincerely, Client’s signature: Client’s name / title: Contact information / address: Building49, Baotian Industrial Zone, Xixiang Town, Shenzhen, China

SCS-F19: Confidentiality Request Letter Rev 1.0 Nov 14, 2006 Confidentiality Request Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (current) 1.0 1.0 Nov-14-2006 SCS-F19: Confidentiality Request Letter Rev 1.0 Nov 14, 2006 ShenZhen Xinzhensheng electronics CO LTD 2010-09-25 To: Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of VZB-FM39011 We hereby request confidential treatment of information accompanying this application as outlined below: - Schematics - Block Diagram - Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Client’s signature: Client’s name / title: Contact information / address: Building49, Baotian Industrial Zone, Xixiang Town, Shenzhen, China

Model:FM39011 Game Controller Plus Input:3.0V 120mA FCC ID :VZB-FM39011 IC :8383A-FM39011 MCAI10MA Made In China 20.5*11.5mm

Global United Technology Service Co., Ltd. Report No: GTSE10090021401 Authorized Signature: Robinson Lo Laboratory Manager This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the GTS product certification mark. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of GTS International Electrical Approvals or testing done by GTS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by GTS International Electrical Approvals in writing. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” FCC REPORT Applicant: ShenZhen Xinzhensheng electronics CO LTD Address of Applicant: Building49, Baotian Industrial Zone, Xixiang Town, Shenzhen, China Equipment Under Test (EUT) Product Name: game controller plus Model No.: FM39011 FCC ID: VZB-FM39011 Standards: FCC CFR Title 47 Part 15 Subpart C Section 15.249: 2009 Date of Receipt: 23 Sep., 2010 Date of Test: 23-24 Sep., 2010 Date of Issue: 25 Sep., 2010 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. Report No: GTSE10090021401 Global United Technology Service Co., Ltd. Project No.: GTSE100900214RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 2 of 20 2 Contents Page 1 COVER PAGE ...........................................................................................................................................1 2 CONTENTS..............................................................................................................................................................2 3 TEST SUMMARY....................................................................................................................................................3 4 GENERAL INFORMATION...................................................................................................................................4 4.1 CLIENT INFORMATION....................................................................................................................................... 4 4.2 GENERAL DESCRIPTION OF E.U.T................................................................................................................... 4 4.3 TEST ENVIRONMENT AND MODE........................................................................................................................ 6 4.4 TEST FACILITY................................................................................................................................................... 6 4.5 TEST LOCATION................................................................................................................................................ 6 4.6 OTHER INFORMATION REQUESTED BY THE CUSTOMER.................................................................................. 6 4.7 TEST INSTRUMENTS LIST:................................................................................................................................. 7 5 TEST RESULTS AND MEASUREMENT DATA................................................................................................8 5.1 ANTENNA REQUIREMENT:................................................................................................................................. 8 5.2 RADIATED EMISSION......................................................................................................................................... 9 5.2.1 Field Strength Of The Fundamental Signal......................................................................................... 11 5.2.2 Spurious Emissions................................................................................................................................. 12 5.2.3 Band edge (Radiated Emission)............................................................................................................ 16 5.3 20DB BANDWIDTH........................................................................................................................................... 18 Report No: GTSE10090021401 Global United Technology Service Co., Ltd. Project No.: GTSE100900214RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 3 of 20 3 Test Summary Test Item Section in CFR 47 Result Antenna requirement 15.203 Passed Field strength of the fundamental signal 15.249 (a) Passed Spurious emissions 15.249 (a) (d)/15.209 Passed Band edge (Radiated Emission) 15.249 (d)/15.205 Passed 20dB Occupied Bandwidth 15.215 (c) Passed Remark: ● Passed: The EUT complies with the essential requirements in the standard. ● Failed: The EUT does not comply with the essential requirements in the standard. ● Tx: In this whole report Tx (or tx) means Transmitter. ● Rx: In this whole report Rx (or rx) means Receiver. Report No: GTSE10090021401 Global United Technology Service Co., Ltd. Project No.: GTSE100900214RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Ro…

Text truncated - open the document above for the full version.