VZB-FM3963RWII Wireless Classic Controller

FM3963， ，， ，Wii wireless classic controller manual 一 一一 一、 、、 、Function Description Adopting 2.4G transmition mode,powered by 2pcs AAA battery.Exceptly its function is same as the official wii nunchuk,it also has Turbo and low power indication function 二 二二 二、 、、 、USER GUIDE （ （（ （一 一一 一） ）） ）Performance Guide： ：： ： 1. 6pcs input button：a、b、x、y、ZR、ZL； 2. 3pcs basic function key：SELECT、HOME、START； 3. D-pad button：Up、Down、Left、Right； 4. 2pcs 3D stick ：LX、LY、RX、RY； 5. 2pcs shoulder button：L、R； 6. 2pcs shoulder trigger button:ZL,ZR ； （ （（ （二 二二 二） ）） ）Set up Turbo function： ：： ： 1．Press down Turbo button,then press any button a/b/x/y； ；； ； 2．During above operation,red Turbo LED will flash.After finishing setting, will flash red when pressing a \ b \ x \ y by oneself； 3．Repeating above operation if cancel the Turbo function； 4．Pressing fixed fire button solely when playing game,there will be flashed red LED;if no fixed button,no LED indicates （ （（ （三 三三 三） ）） ）How to link 1．Put 2pcs AAA battery into controller,slide switch to “ON” position； 2．Blue LED start to flash when turn-on ,please press down SYNC button,blue LED on the pads will flash rapidly,begin to search and link；（As attached photo） 3. Plug the receiver to the end of remote,blue LED at the bottom of receiver will rapidly flash, after 1 second it will be successfully linked, receiver’s blue LED will be lighting.When the Voltage is below 2.3V,blue LED will flash FM3963， ，， ，Wii wireless classic controller manual slowly,it minds that should replace with new battery; 4．When they be paired well,it will fulfil all the function as official wii classic controller, operating interface and playing games.The wireless pads will enter into sleeping mode if the receiver has no signal up to 1 minutes or the pads has no signal up to 5minutes.And press one of these buttons(include:Start,Select,a,b,x,y,ZL,ZR,D-pad,L,R,Sync) can wake up. 5. It has memory function,after first paired successfully,it can pair again automaticly 三 三三 三、 、、 、Dims： ：： ： Controller:（L）151 *（W）95 *（H）42 mm Receiver:（L）36mm *（W）31mm *（H）26 mm 四 四四 四、 、、 、Caution 1. Do not expose to high temperature 2. Do not disassemble or clean with causticity liquid This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FM3963， ，， ，Wii wireless classic controller manual

1 Photographs ---construction details

Authorized Signature: Jack Zhang Laboratory Manager The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of SGS International Electrical Approvals or testing done by SGS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by SGS International Electrical Approvals in writing. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. This Test Report is issued by the Company subject to its General Conditions of Service printed overleaf. Attention is drawn to the limitations of liability, indemnification and jurisdictional issues defined therein. The results shown in this test report refer only to the sample(s) tested unless otherwise stated. This Test Report cannot be reproduced, except in full, without prior written permission of the Company. SGS-CSTC Standards Technical Services Ltd. No. 1 Workshop, M-10, Middle section, Science & Technology Park, Shenzhen, Guangdong, China 518057 Telephone: +86 (0) 755 2601 2053 Fax: +86 (0) 755 2671 0594 Email: [email protected] Report No.: SZEMO10050236502 Page: 1 of 26 FCC REPORT Application No. : SZEMO100502365RF Applicant: ShenZhen Xinzhensheng electronics CO LTD Product Name: WII Wireless Classic Controller Operation Frequency: 2402MHz to 2476MHz FCC ID: VZB-FM3963R Standards: FCC CFR Title 47 Part 15 Subpart C Section 15.249: 2008 Date of Receipt 05 May 2010 Date of Test 05 to 20 May 2010 Date of Issue 24 May 2010 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. SGS-CSTC Standards Technical Services Ltd. Report No.: SZEMO10050236502 Page: 2 of 26 “This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm . Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” 2 Contents Page 1 COVER PAGE ...........................................................................................................................................1 2 CONTENTS.............................................................................................................................................................. 2 3 TEST SUMMARY.................................................................................................................................................... 3 4 GENERAL INFORMATION.................................................................................................................................... 4 4.1 CLIENT INFORMATION....................................................................................................................................... 4 4.2 GENERAL DESCRIPTION OF E.U.T................................................................................................................... 4 4.3 E.U.T OPERATION MODE.................................................................................................................................. 6 4.4 TEST FACILITY........................................................................................................................................................ 6 4.5 TEST LOCATION................................................................................................................................................ 6 4.6 OTHER INFORMATION REQUESTED BY THE CUSTOMER.................................................................................. 6 4.7 TEST INSTRUMENT LIST...................................................................................................................................... 7 5 TEST RESULTS AND MEASUREMENT DATA................................................................................................. 8 5.1 ANTENNA REQUIREMENT:................................................................................................................................. 8 5.2 RADIATED EMISSION................................................................................................................................................. 9 5.1.1 Field Strength Of The Fundamental Signal.......................................................................................... 11 5.1.2 Spurious Emissions................................................................................................................................. 12 5.1.3 Band edge (Radiated Emission).......................................................................................…

Text truncated - open the document above for the full version.

1 Photographs - Test Setup Photo Radiated Emission