WM4760LED Wrist Band

LED Wrist Band Instruction Manual Table of Contents 1.0 Introduction 2.0 Specifications 3.0 Description and Settings of the LED Wrist Band 3.1 Mode selection of the LED Wrist Band 3.1.1 Details of each Mode – General Information Display 3.1.1.1 Daily Goal Level 3.1.1.2 Move Time and Active Time 3.1.2 Details of each Mode – Daily display 3.1.3 Step Display 3.1.4 Distance Display 3.1.5 Calories Burnt Display 3.1.6 Workout Mode Display 3.1.7 Workout Record Mode Display 3.1.8 Sleeping Mode 3.1.9 Battery Status and Charging 4.0 Home → Settings: Pairing the LED Wrist Band to an iOS and Android Product 4.1 Setting up your own profile 4.1.1 Setting up your Login ID and Password 4.2 Settings for the LED Wrist Band via your device 4.2.1 Alarm Settings 4.2.2 Daily Goals 4.2.3 Workout Goals 4.2.4 General Settings Table of Contents 4.2.5 Wrist Band Settings 4.2.5.1 Wear the band on the left or right hand 4.2.5.2 Auto Stride Enable 4.2.5.3 Tilt Wake Enable 4.2.5.4 Enable Auto Sleep 4.2.5.5 Beep on Button Stroke 4.2.5.6 Customize LED Screen 4.2.5.6.1 Custom Settings 4.2.5.6.1.1 Time Mode 4.2.5.6.1.2 Daily Mode 4.2.5.6.1.3 Workout Mode 4.2.5.6.1.4 Other Modes 4.2.5.7 Firmware upgrade 5.0 Home - Reports 6.0 Home - Workout History 7.0 Home - About 8.0 Wristband Main page 8.1 Home 8.2 Steps 8.3 Distance 8.4 Calories Burnt 8.5 Active Time 8.6 Summary 8.7 Sleep Time 8.8 Main page FCC Statement FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: — Reorient or relocate the receiving antenna. — Increase the separation between the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante. IC SAR Waring : IC Statement This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. 1.0 Introduction Thank you for your purchase of the LED Wrist Band. With this band, you can monitor your daily activities easily! Simply put the band on your wrist and this small device will record the number of steps taken, the distance travelled, the calorie burnt and the sleeping patterns in your daily activity for your review. This product has to be used in line with an iOS and Android devices that support Bluetooth 4.0 technology to review your daily activities. Your LED Wrist Band is carefully designed and produced. In order to fully utilize the features of the LED Wrist Band, it is advisable to use it in conformity with the notes mentioned below: Read this user’s manual carefully before using the LED Wrist Band and keep this manual in a safe place for future reference. Avoid exposing the LED Wrist Band to extreme conditions for an unreasonable time. Avoid rough use or severe impacts on the LED Wrist Band. Keep the LED Wrist Band away from magnets or appliances which contain magnetic components such as mobile phones, speakers or motors as these items may ruin the sensors. Clean the LED Wrist Band occasionally with a soft cloth. DO NOT expose the LED Wrist Band to strong chemicals…

Text truncated - open the document above for the full version.

EXHIBIT C - EUT EXTERNAL PHOTOGRAPHS EUT – Top View EUT – Bottom View EUT – Front View EUT – Rear View EUT – Left View EUT – Right View EUT – Charger View

EXHIBIT A - FCC ID LABEL AND LOCATION FCC ID Label FCC ID Label Location Information The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925)

EXHIBIT C - EUT INTERNAL PHOTOGRAPHS EUT – Cover off View EUT – Main Board Top View Antenna EUT – Main Board Bottom View EUT – Antenna View EUT – Battery View

Note: This test report is prepared for the customer shown above and for the equipment described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. FCC PART 15.247 TEST REPORT For Latitude Limited 7/F, Southeast Industrial Building, 611-619 Castle Peak Road, N.T., HK FCC ID: WM4760 Report Type: Original Report Product Type: LED Wrist Band Test Engineer: Mike Hu Report Number: RSZ140504004-00 Report Date: 2014-05-15 Reviewed By: Jimmy Xiao RF Engineer Prepared By: Bay Area Compliance Laboratories Corp. (Shenzhen) 6/F, the 3rd Phase of WanLi Industrial Building ShiHua Road, FuTian Free Trade Zone Shenzhen, Guangdong, China Tel: +86-755-33320018 Fax: +86-755-33320008 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp. (Shenzhen) Report No.: RSZ140504004-00 FCC Part 15.247 Page 2 of 33 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 4 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 4 OBJECTIVE ................................................................................................................................................................... 4 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 4 TEST METHODOLOGY .................................................................................................................................................. 4 TEST FACILITY ............................................................................................................................................................. 4 SYSTEM TEST CONFIGURATION .......................................................................................................................... 5 DESCRIPTION OF TEST CONFIGURATION ...................................................................................................................... 5 EUT EXERCISE SOFTWARE .......................................................................................................................................... 5 SPECIAL ACCESSORIES ................................................................................................................................................. 5 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 5 SUPPORT EQUIPMENT LIST AND DETAILS .................................................................................................................... 5 EXTERNAL I/O CABLE .................................................................................................................................................. 5 BLOCK DIAGRAM OF TEST SETUP ................................................................................................................................ 6 SUMMARY OF TEST RESULTS ............................................................................................................................... 7 FCC§15.247 (i), §1.1307 (b) (1) &§2.1093 – RF EXPOSURE ........................................................................................ 8 APPLICABLE STANDARD .............................................................................................................................................. 8 FCC §15.203 - ANTENNA REQUIREMENT ............................................................................................................. 9 APPLICABLE STANDARD .............................................................................................................................................. 9 ANTENNA CONNECTOR CONSTRUCTION ...................................................................................................................... 9 FCC §15.207 (a) – AC LINE CONDUCTED EMISSIONS ..................................................................................... 10 APPLICABLE STANDARD ............................................................................................................................................ 10 MEASUREMENT UNCERTAINTY .................................................................................................................................. 10 EUT SETUP ................................................................................................................................................................ 10 EMI TEST RECEIVER SETUP ....................................................................................................................................... 11 TEST PROCEDURE ...................................................................................................................................................... 11 CORRECTED FACTOR & MARGIN CALCULATION ....................................................................................................... 11 TEST EQUIPMENT LIST AND DETAILS ......................................................................................................................... 11 TEST RESULTS SUMMARY .......................................................................................................................................... 12 TEST DATA ................................................................................................................................................................ 12 FCC §15.209, §15.205 & §15.247(d) - SPURIOUS EMISSIONS ............................................................................. 15 APPLICABLE STANDARD ............................................................................................................................................ 15 MEASUREMENT UNCERTAINTY ......…

Text truncated - open the document above for the full version.

EXHIBIT D - TEST SETUP PHOTOGRAPHS Conducted Emissions - Front View Conducted Emissions - Side View Radiated Emissions View (30-1000 MHz) Radiated Emissions View (1-25 GHz)