WSGSK-BH-M12Bluetooth Headset

FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. (Example- use only shielded interface cables when connecting to computer or peripheral devices). This equipment complies with Part 15 of FCC RF Rules. Operation is subject to the following two conditions: 1) This device may not cause interference and 2) This device must accept any interference, including interference that may cause undesired operation of the device. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment 1.This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2.This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. Caution! The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment.

Neutron Engineering Inc. Project No.: 1005C022 Page 2 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 2 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 3 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 3 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 4 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 4 of 8 1005C022 1005C022

Neutron Engineering Inc. Project No.: 1005C022 Page 5 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 5 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 6 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 6 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 7 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 7 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 8 of 8 1005C022 1005C022 Neutron Engineering Inc. Project No.: 1005C022 Page 8 of 8 1005C022 1005C022

Neutron Engineering Inc. FCC RF EXPOSURE REPORT FCC ID: WSGSK-BH-M12 Project No. : 1005C022 Equipment : Bluetooth Headset Model Name : SK-BH-M12; SK-BH-V1;SK-BH-V2;SK-BH-V6; SK-BH-V8;SK-BH-V9;SK-BH-V10;SK-BH-V11; SK-BH-V12;SK-BH-M10;SK-BH-M11; SK-BH-M20;SK-BH-M22;SK-BTH-030 Applicant : SKY WING Communication Electronics Co.,Ltd Address : No.10 Road 63#, Long yan, Humen Town, Dongguan City, Guangdong China According: : FCC Guidelines for Human Exposure IEEE C95.1 Neutron Engineering Inc. No.3, Jinshagang 1st Road, ShiXia, Dalang Town, Dong Guan, China. TEL : (0769) 8318-3000 FAX : (0769) 8319-6000 Neutron Engineering Inc. GENERAL CONCULUSION: No evaluation required if power is below this threshold: F(GHz) P(mW) Low 2.412 High 2.462 24.620 Maximum measured transmitter power: Out Power (dBm) Out Power (mW) Conducted Power2.18 1.652 EIRP Power 4.1 2.570 Note: Table for Filed Antenna Ant. Brand Model NameAntenna Type Connector Gain (dBi) 1 N/A N/A PRINTED ANT(BT ANT) N/A 1.92 Threshold for no SAR evaluation is 24.620mW. Transmitter power is1.652 mW Conclusion: No SAR evaluation required since transmitter power is below FCC threshold

Neutron Engineering Inc. Report No.: NEI-FCCP-1-1005C022 Page 2 of 91 Declaration Neutron represents to the client that testing is done in accordance with standard procedures as applicable and that test instruments used has been calibrated with the standards traceable to National Measurement Laboratory (NML) of R.O.C., or National Institute of Standards and Technology (NIST) of U.S.A. Neutron's reports apply only to the specific samples tested under conditions. It is manufacture’s responsibility to ensure that additional production units of this model are manufactured with the identical electrical and mechanical components. Neutron shall have no liability for any declarations, inferences o r generalizations drawn by the client or others from Neutron issued reports. Neutron’s reports must not be used by the client to claim product endorsement by the authorities or any agency of the Government. This report is the confidential property of the client. As a mutual protection to the clients, the public and Neutron-self, extracts from the test report shall not be reproduced except in full with Neutron’s authorized written approval. Neutron’s laboratory quality assurance procedures are in compliance with the ISO Guide 17025 requirements, and accredited by the conformity assessment authorities listed in this test report. Limitation For the use of the authority's logo is limited unless the Test Standard(s)/Scope(s)/Item(s) mentioned in this test report is (are) included in the conformity assessment authorities acceptance respective. Neutron Engineering Inc. Report No.: NEI-FCCP-1-1005C022 Page 3 of 91 Table of Contents Page 1 . CERTIFICATION 6 2 . SUMMARY OF TEST RESULTS 7 2.1 TEST FACILITY 8 2.2 MEASUREMENT UNCERTAINTY 8 3 . GENERAL INFORMATION 9 3.1 GENERAL DESCRIPTION OF EUT 9 3.2 DESCRIPTION OF TEST MODES 11 3.3 TABLE OF PARAMETERS OF TEXT SOFTWARE SETTING 11 3.4 BLOCK DIGRAM SHOWING THE CONFIGURATION OF SYSTEM TESTED 12 3.5 DESCRIPTION OF SUPPORT UNITS(CONDUCTED MODE) 13 4 . EMC EMISSION TEST 14 4.1 CONDUCTED EMISSION MEASUREMENT 14 4.1.1 POWER LINE CONDUCTED EMISSION LIMITS 14 4.1.2 MEASUREMENT INSTRUMENTS LIST AND SETTING 14 4.1.3 TEST PROCEDURE 15 4.1.4 DEVIATION FROM TEST STANDARD 15 4.1.5 TEST SETUP 15 4.1.6 EUT OPERATING CONDITIONS 16 4.1.7 TEST RESULTS 17 4.2 RADIATED EMISSION MEASUREMENT 19 4.2.1 RADIATED EMISSION LIMITS 19 4.2.2 MEASUREMENT INSTRUMENTS LIST ANS SETTING 20 4.2.3 TEST PROCEDURE 21 4.2.4 DEVIATION FROM TEST STANDARD 21 4.2.5 TEST SETUP 22 4.2.6 EUT OPERATING CONDITIONS 22 4.2.7 TEST RESULTS (BETWEEN30 – 1000 MHZ) 23 4.2.8 TEST RESULTS (ABOVE 1000 MHZ) 25 5 . NUMBER OF HOPPING CHANNEL 49 5.1 APPLIED PROCEDURES / LIMIT 49 5.1.1 MEASUREMENT INSTRUMENTS LIST AND SETTING 49 5.1.2 TEST PROCEDURE 49 5.1.3 DEVIATION FROM STANDARD 49 5.1.4 TEST SETUP 49 5.1.5 EUT OPERATION CONDITIONS 49 5.1.6 TEST RESULTS 50 Neutron Engineering Inc. Report No.: NEI-FCCP-1-1005C022 Page 4 of 91 Table of Contents Page 6 . AVERAGE TIME OF OCCUPANCY 52 6.1 APPLIED PROCEDURES / LIMIT 52 6.1.1 MEASUREMENT INSTRUMENTS LIST 52 6.1.2 TEST PROCEDURE 52 6.1.3 DEVIATION FROM STANDARD 52 6.1.4 TEST SETUP 53 6.1.5 EUT OPERATION CONDITIONS 53 6.1.6 TEST RESULTS 54 7 . HOPPING CHANNEL SEPARATION MEASUREMENT 66 7.1 APPLIED PROCEDURES / LIMIT 66 7.1.1 MEASUREMENT INSTRUMENTS LIST AND SETTING 66 7.1.2 TEST PROCEDURE 66 7.1.3 DEVIATION FROM STANDARD 66 7.1.4 TEST SETUP 66 7.1.5 EUT OPERATION CONDITIONS 66 7.1.6 TEST RESULTS 67 8 . BANDWIDTH TEST 71 8.1 APPLIED PROCEDURES / LIMIT 71 8.1.1 MEASUREMENT INSTRUMENTS LIST AND SETTING 71 8.1.2 TEST PROCEDURE 71 8.1.3 DEVIATION FROM STANDARD 71 8.1.4 TEST SETUP 71 8.1.5 EUT OPERATION CONDITIONS 71 8.1.6 TEST RESULTS 72 9 . PEAK OUTPUT POWER TEST 76 9.1 APPLIED PROCEDURES / LIMIT 76 9.1.1 MEASUREMENT INSTRUMENTS LIST AND SETTING 76 9.1.2 TEST PROCEDURE 76 9.1.3 DEVIATION FROM STANDARD 76 9.1.4 TEST SETUP 76 9.1.5 EUT OPERATION CONDITIONS 76 9.1.6 TEST RESULTS 77 10 . ANTENNA CONDUCTED SPURIOUS EMISSION 81 10.1 APPLIED PROCEDURES / LIMIT 81 10.1.1 MEASUREMENT INSTRUMENTS LIST AND SETTING 81 10.1.2 TEST PROCEDURE 81 10.1.3 DEVIATION FROM STANDARD 81 10.1.4 TEST SETUP 82 10.1.5 EUT OPERATION CONDITIONS 82 Neutron Engineering Inc. Report No.: NEI-FCCP-1-1005C022 Page 5 of 91 Table of Contents Page 10.1.6 TEST RESULTS 83 11 . RF EXPOSURE TEST 87 11.1 APPLIED PROCEDURES / LIMIT 87 11.1.1 MEASUREMENT INSTRUMENTS LIST 87 11.1.2 MPE CALCULATION METHOD 88 11.1.3 DEVIATION FROM STANDARD 88 11.1.4 TEST SETUP 88 11.1.5 EUT OPERATION CONDITIONS 88 11.1.6 TEST RESULTS 89 12 . EUT TEST PHOTO 90 Neutron Engineering Inc. Report No.: NEI-FCCP-1-1005C022 Page 6 of 91 1. CERTIFICATION E q u i p m e n t : Bluetooth Headset Brand Name : BLUETIGER Model Name : SK-BH-M12; SK-BH-V1;SK-BH-V2;SK-BH-V6; SK-BH-V8;SK-BH-V9;SK-BH-V10;SK-BH-V11; SK-BH-V12;SK-BH-M10;SK-BH-M11; SK-BH-M20;SK-BH-M22;SK-BTH -030 A p p l i c a n t : SKY WING Communication Electronics Co.,Ltd Date of Test: May. 15, 2010 ~ Jun. 15, 2010 T e s t I t e m : ENGINEERING SAMPLE Standards : FCC Part15, Subpart C(15.247) / ANSI C63.4 : 2003 The above equipment has been tested and found compliance with the requirement of the relative standards by Neutron Engineering Inc. EMC Laboratory. The test data, data evaluation, and equipment configuration contained in our test report (Ref No. NEI-FCCP-1-1005C022) were obtained utilizing the test procedures, test instruments, test sites that has been accredited by the Authority of NVLAP and TAF according to the ISO-17025 quality assessment standard and technical standard(s). Neutron Engineering Inc. Report No.: NEI-FCCP-1-1005C022 Page 7 of 91 2. SUMMARY OF TEST RESULTS Test procedures according to the technical standards: FCC Part15 (15.247) , Subpart C Standard Section Test Item Judgment Remark 15.207 Conducted Emission PASS 15.247 (c) Antenna conducted Spurious EmissionPASS 15.247 (a)(1) Hopping Channel Separation PASS 15.247 (b)(1) Peak Output Power PASS 15.247 (c) Radiated Spurious Emission PAS…

Text truncated - open the document above for the full version.

Neutron Engineering Inc. Report No.: NEI-FCCP-1-1005C022 Page 90 of 91 12. EUT TEST PHOTO Conducted Measurement Photos Neutron Engineering Inc. Report No.: NEI-FCCP-1-1005C022 Page 90 of 91 12. EUT TEST PHOTO Conducted Measurement Photos Neutron Engineering Inc. Report No.: NEI-FCCP-1-1005C022 Page 91 of 91 Radiated Measurement Photos Neutron Engineering Inc. Report No.: NEI-FCCP-1-1005C022 Page 91 of 91 Radiated Measurement Photos