WSVSUNVOTEBASE1XWireless Voting Base Station

FAST OPERATION MANUL EA1000 EA1000 FAST OPERATION MANUL INDICATE LED · The Status LED indicates the communication status with PC, when flash quickly, it stands that it received the data from PC. · When the Data LED light, it stands receiving data from keypad BASE STATION CONNECTION · Connect the base station with PC USB port , the Status LED will flash every half second if connection is successful. · The Status LED will flash quickly after the software and base station communicate normally. · Initial installation, PC will automatically remind that have found new device and install the drive automatically. RADIO CHANNEL SET · After logging in application software, choose the new channel in the “channel” of “base station set”, then click “set”. · When using the multiple base station solution, the frequency channel of each base station should be different, and it’s better not to set the neighboring channel · Only when frequency channel is interfered or communication is not good, then you need to consider changing and resetting the channel, usually you needn’t. BASE STATION TEST After connetion is ok, power on keypads, then do keypads testing. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no Status LED Data LED USB Port PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn FAST OPERATION MANUL EA1000 guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2 Rev 2.0 2206 Ringwood Avenue San Jose, CA 95131 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Reason for Amendment (current / obsolete) Revision History Approved Date From To Initial Release (current) 1.0 1.0 Nov-14-2006 Revised wording (current) 1.0 2.0 Sept–25-2007 SCS-F18: Project and Product Certification Representative Authorization Letter Page 2 of 2 Rev 2.0 ChangSha SunSky Electronic Design&Development Co., Ltd Room1024,Building A,Biaozhi Business Center,No.198 XiangFu Road,Tianxin District,ChangSha,China 2011-9-1 To: SIEMIC, INC. 2206 Ringwood Avenue, San Jose, CA 95131 USA Dear Sir/Madam, Re: Project and Product Certification Representative Authorization Letter We, Changsha SunSky Electronic Design & Development Co., Ltd. hereby authorize SIEMIC, INC. to act as a Certification Body for certifying for the following project(s): Product description: Wireless Voting Base Station model name: EA1000 FCC ID: WSVSUNVOTEBASE1X We affirm that between SIEMIC and Changsha SunSky Electronic Design & Development Co., Ltd., any difference in understanding, including test plan, measurement methods, applicable standards and relevant procedures and processes have been resolved prior to commencement of testing activities. Sincerely, Client’s signature Client’s name / title：Jack Pei/CTO Contact information / address：1024/ Room1024, Building A, Biaozhi Business Center, No. 198 Xiang Fu Road, Tianxin District, Changsha，China

SCS-F19: Confidentiality Request Letter Page 1 of 2 Rev 2.0 2206 Ringwood Avenue San Jose, CA 95131 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Confidentiality Request Letter Reason for Amendment (current / obsolete) Revision History Approved Date From To Initial Release (current) 1.0 1.0 Nov-14-2006 Adding CFR 2.459 1.0 2.0 August – 11 - 2008 SCS-F19: Confidentiality Request Letter Page 2 of 2 Rev 2.0 ChangSha SunSky Electronic Design&Development Co., Ltd Room1024,Building A,Biaozhi Business Center,No.198 XiangFu Road,Tianxin District,ChangSha,China 2011-9-1 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Confidentiality Request regarding application for certification of FCC ID: WSVSUNVOTEBASE1X We hereby request confidential treatment of information accompanying this application as outlined below: - Block Diagram - Operational Description - Schematic The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Client’s signature Client’s name / title：Jack Pei/CTO Contact information / address：1024/ Room1024, Building A, Biaozhi Business Center, No. 198 Xiang Fu Road, Tianxin District, Changsha，China

2011-9-1 To: Federal Communications Commission 7435 Oakland Mills Road Columbia, MD To Whom It May Concern: This letter is to ascertain that Changsha SunSky Electronic Design & Development Co., Ltd. : EA1000 has been the units used for conducting FCC compliance testing, the DoC part will be tested by FCC recognized test lab. If you have any question or concerns, pls. contact us. Sincerely, Signature Abby /Manager Client’s signature Client’s name / title：Jack Pei/CTO Contact information / address：1024/ Room1024, Building A, Biaozhi Business Center, No. 198 Xiang Fu Road, Tianxin District, Changsha，China

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. In Put: 5V==0~200mA P<1.0W FCC ID: WSVSUNVOTEBASE1X PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn

Label Location

FCCID:WSVSUNVOTEBASE1X Portable device According to § 15.247(e)(i) and § 1.1307(b)(1), systems operating under the provisions of this section shall be operated in a manner that ensures that the public is not exposed to radio frequency energy level inexcess of the Commission’s guidelines. According toKDB 447498 (2)(a)(i) Frequency Range Low Frequency (MHz)High Frequency(MHz) Center frequency (MHz) 60/f SAR Limitation (mw) 2404 2466 243224.67 Maximum measured transmitter power ConductedPower (mw)Max Antenna Gain (dBi)EIRP (mw) 6.565.322.24 Threshold at which no SAR required is 24.67mw. Maximum Tx power is22.24mw EIRP. Conclusion:No SAR is required. SIMULTANEOUS TRANSMISSIONEVALUATION N/A

ChangshaSunSkyElectronic Design&DevelopmentCo.,Ltd. WirelessVotingBaseStation Model:EA1000 25August,2011 ReportNo.:11070046 (This report supersedesNONE) Modifications made to the product : None This Test Report is Issued Under the Authority of: PeterCai TestEngineer Spring Zhou Technical Manager This test report may be reproduced in full only. Test result presented in this testreport is applicable to the representative sample only. Title:RFTest Report forWirelessVotingBaseStation Model:EA1000 To:FCC15.247:2010 Serial#:11070046 Issue Date:25August,2011 Page:2of52 www.siemic.com.cn Laboratory Introduction ATION SIEMIC,headquartered in the heart of Silicon Valley, with superior facilities in US andAsia, is one of the leading independent testing and certification facilities providingcustomers withone-stop shop servicesfor Compliance Testing and Global Certifications. In addition totestingandcertification, SIEMIC providesinitial design reviews andcompliance managementthrough out a project. Our extensive experience withChina,Asia Pacific,North America, European, and internationalcompliance requirements, assures the fastest, most cost effective way to attain regulatorycompliance for theglobal markets. Accreditations for Conformity Assessment Country/RegionAccreditation BodyScope USAFCC, A2LAEMC , RF/Wireless, Telecom CanadaIC, A2LA, NISTEMC,RF/Wireless, Telecom TaiwanBSMI , NCC , NISTEMC, RF, Telecom , Safety Hong KongOFTA , NISTRF/Wireless,Telecom AustraliaNATA, NISTEMC, RF, Telecom , Safety KoreaKCC/RRA, NISTEMI, EMS, RF , Telecom, Safety JapanVCCI, JATE, TELEC,RFTEMI,RF/Wireless, Telecom MexicoNOM, COFETEL,CanietySafety,EMC , RF/Wireless, Telecom EuropeA2LA, NISTEMC, RF, Telecom , Safety Accreditations for Product Certifications CountryAccreditation BodyScope USAFCCTCB, NISTEMC , RF , Telecom CanadaICFCB, NISTEMC , RF , Telecom SingaporeiDA, NISTEMC , RF , Telecom EUNBEMC & R&TTE Directive Title:RFTest Report forWirelessVotingBaseStation Model:EA1000 To:FCC15.247:2010 Serial#:11070046 Issue Date:25August,2011 Page:3of52 www.siemic.com.cn This page has been left blank intentionally. Title:RFTest Report forWirelessVotingBaseStation Model:EA1000 To:FCC15.247:2010 Serial#:11070046 Issue Date:25August,2011 Page:4of52 www.siemic.com.cn CONTENTS 1EXECUTIVE SUMMARY &EUT INFORMATION.............................................................................................................5 2TECHNICAL DETAILS..................................................................................................................................................6 3MODIFICATION............................................................................................................................................................7 4TEST SUMMARY..........................................................................................................................................................8 5MEASUREMENTS, EXAMINATION AND DERIVED RESULTS........................................................................................9 ANNEX A. TEST INSTRUMENT & METHOD.........................................................................................................................35 ANNEX B.EUT AND TEST SETUPPHOTOGRAPHS...........................................................................................................39 ANNEX C.TEST SETUP AND SUPPORTING EQUIPMENT...................................................................................................45 ANNEXD.USER MANUAL / BLOCKDIAGRAM / SCHEMATICS/ PART LIST.......................................................................49 ANNEXE.SIEMIC ACCREDITATIONCERTIFICATES..........................................................................................................50 Title:RFTest Report forWirelessVotingBaseStation Model:EA1000 To:FCC15.247:2010 Serial#:11070046 Issue Date:25August,2011 Page:5of52 www.siemic.com.cn 1Executive Summary & EUT information The purpose of this test programme was to demonstrate compliance of theChangshaSunSky ElectronicDesign&DevelopmentCo.,Ltd.WirelessVotingBaseStation, and modelEA1000against the current Stipulated Standards. TheWirelessVotingBaseStationhasdemonstrated compliance with theFCC15.247:2010. EUT Information EUT Description : WirelessVotingBaseStation Model No :EA1000 Serial No :N/A Input Power :5Vdc Classification Per Stipulated Test Standard : DTS Title:RFTest Report forWirelessVotingBaseStation Model:EA1000 To:FCC15.247:2010 Serial#:11070046 Issue Date:25August,2011 Page:6of52 www.siemic.com.cn 2TECHNICAL DETAILS Purpose Compliance testing of WirelessVotingBaseStationwithstipulated standard Applicant / Client ChangshaSunSkyElectronicDesign&DevelopmentCo.,Ltd. Room1024,BuildingA,BiaozhiBusinessCenter, No.198XiangFuRoad,TianxinDistrict,Changsha,China Manufacturer ChangshaSunSkyElectronicDesign&DevelopmentCo.,Ltd. Room1024,BuildingA,BiaozhiBusinessCenter, No.198XiangFuRoad,TianxinDistrict,Changsha,China Laboratory performing the tests SIEMIC Nanjing(China)Laboratories NO.2-1,Longcang Dadao, Yuhua Economic Development Zone, Nanjing, China Tel:+86(25)86730128/86730129 Fax:+86(25)86730127 Email:[email protected] Test report reference number11070046 Date EUT received8August,2011 Standard appliedFCC15.247:2010 Dates of test (from–to)8August~11August,2011 No of Units:#1 Equipment Category:DTS Trade Name:SunVote Model :EA1000 RFOperating Frequency (ies)2404MHz–2466MHz Number of Channels :32 Modulation :MSK FCC ID：WSVSUNVOTEBASE1X Title:RFTest Report forWirelessVotingBaseStation Model:EA1000 To:FCC15.247:2010 Serial#:11070046 Issue Date:25August,2011 Page:7of52 www.siemic.com.cn 3MODIFICATION NONE Title:RFTest Report forWirelessVotingBaseStation Model:EA1000 To:FCC15.247:2010 Serial#:11070046 Issue Date:25August,2011 Page:8of52 www.siemic.com.cn 4TEST SUMMARY The product was tested in accordance with the following specifications. Alltesting has been performed according to below product classification: Spr…

Text truncated - open the document above for the full version.

Conducted Emission Test Setup Front View Conducted Emission Test Setup Side View Radiated Emission Test Setup Front View below 1GHz Radiated Emission Test Setup Front View above 1GHz