XYO-AS31GPS tracker

FCC Regulations:  This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/ TV technician for help.  Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. FCC RF Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF Exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for the transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co‐located or operating in conjunction with any other antenna or transmitter.

Asiatelco Technologies Co. Request for Confidentiality Date: _2020-08-21_ Subject: Confidentiality Request for: _____ FCC ID: XYO-AS31______ Pursuant to FCC 47 CRF 0.457(d) and 0.459 and IC RSP-100, Section 10, the applicant requests that a part of the subject FCC application be held confidential. Type of Confidentiality Requested Exhibit Short Term Permanent Block Diagrams Short Term External Photos Short Term Permanent* 1 Internal Photos Short Term Permanent Operation Description/Theory of Operation Short Term Permanent Parts List & Placement/BOM Short Term Permanent Tune-Up Procedure Short Term Permanent Schematics Short Term Test Setup Photos Short Term Permanent* User’s Manual *Note: ______(Insert Explanation as Necessary)______ ______ Asiatelco Technologies Co. _____ has spent substantial effort in developing this product and it is one of the first of its kind in industry. Having the subject information easily available to "competition" would negate the advantage they have achieved by developing this product. Not protecting the details of the design will result in financial hardship. Permanent Confidentiality: The applicant requests the exhibits listed above as permanently confidential be permanently withheld from public review due to materials that contain trade secrets and proprietary information not customarily released to the public. Short-Term Confidentiality: The applicant requests the exhibits selected above as short term confidential be withheld from public view for a period of __0_ days from the date of the Grant of Equipment Authorization and prior to marketing. This is to avoid premature release of sensitive information prior to marketing or release of the product to the public. Applicant is also aware that they are responsible to notify TCB in the event information regarding the product or the product is made available to the public. TCB will then release the documents listed above for public disclosure pursuant to FCC Public Notice DA 04-1705. NOTE for Industry Canada Applications: The applicant understands that until such time that IC distinguishes between Short Term and Permanent Confidentiality, either type of marked exhibit above will simply be marked Confidential when submitted to IC. Sincerely, By: Ranran Zhou (Signature/Title 2 ) (Print name)

Asiatelco Technologies Co. POWER OF ATTORNEY DATE: 08/21/2020 To: Federal Communications Commission, Authorization & Evaluation Division, 7435 Oakland Mills Road, Columbia, MD 21046 We, the undersigned, hereby authorize TA Technology (Shanghai) Co., Ltd. /Lu Rui on our behalf, to apply to FCC on our equipment for FCC ID: XYO-AS31. Any and all acts carried out by TA Technology (Shanghai) Co., Ltd. / Lu Rui on our behalf shall have the same effect as acts of our own. Sincerely, Signature ： Print name: Ranran Zhou Company: Asiatelco Technologies Co.

Asiatelco Technologies Co. Dear Sir, BG96 module has been certified and the corresponding FCC ID is XMR201707BG96 The RF test report numbers for BG96 module are R1811A0536‐R2 BG96 FCC Part24 EMTC,R1811A0536‐R3 BG96 FCC Part27 EMTC. BG96 module Support GSM1900, CATM B2/4/12/13/25. AS31 product 's FCC ID is XYO‐AS31.It only support CATM B2/4/12/13/25 ,so only the data of BG96 module CATM B2/4/12/13/25 is referenced Sincerely, DATE: 2020/9/1 Print name: Ranran Zhou Company: Asiatelco Technologies Co. Signature:

EUT Appearance Report No.: R2006A0424 TA Technology (Shanghai) Co., Ltd. Page 1 of 3 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. EUT Appearance EUT Appearance Report No.: R2006A0424 TA Technology (Shanghai) Co., Ltd. Page 2 of 3 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. EUT Appearance Report No.: R2006A0424 TA Technology (Shanghai) Co., Ltd. Page 3 of 3 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. a: EUT Picture 1: Constituents of EUT

Internal photo Report No.: R2006A0424 TA Technology (Shanghai) Co., Ltd. Page 1 of 6 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo Internal photo Report No.: R2006A0424 TA Technology (Shanghai) Co., Ltd. Page 2 of 6 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo Report No.: R2006A0424 TA Technology (Shanghai) Co., Ltd. Page 3 of 6 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo Report No.: R2006A0424 TA Technology (Shanghai) Co., Ltd. Page 4 of 6 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo Report No.: R2006A0424 TA Technology (Shanghai) Co., Ltd. Page 5 of 6 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo Report No.: R2006A0424 TA Technology (Shanghai) Co., Ltd. Page 6 of 6 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd.

EMC TEST REPORT Applicant Asiatelco Technologies Co. FCC ID XYO-AS31 Product GPS tracker Brand AS31 Model AS31 Report No. R2006A0424-E1 Issue Date August 19, 2020 TA Technology (Shanghai) Co., Ltd. tested the above equipment in accordance with the requirements in FCC Code CFR47 Part15B (2019)/ ANSI C63.4 (2014). The test results show that the equipment tested is capable of demonstrating compliance with the requirements as documented in this report. Performed by: Wei Liu/ Manager Approved by: Guangchang Fan/ Director TA Technology (Shanghai) Co., Ltd. No.145, Jintang Rd, Tangzhen Industry Park, Pudong Shanghai, China TEL: +86‐021‐50791141/2/3 FAX: +86‐021‐50791141/2/3‐8000 EMC Test Report Report No.: R2006A0424-E1 TA Technology (Shanghai) Co., Ltd. TA-MB-06-001E Page 2 of 15 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Table of Contents 1 Test Laboratory ............................................................................................................................... 4 1.1 Notes of the Test Report ......................................................................................................... 4 1.2. Test facility .............................................................................................................................. 4 1.3 Testing Location ...................................................................................................................... 4 2 General Description of Equipment under Test ................................................................................ 5 2.1 Applicant and Manufacturer Information.................................................................................. 5 2.2 General information ................................................................................................................. 5 2.3 Applied Standards ................................................................................................................... 6 2.4 Test Mode ................................................................................................................................ 7 3 Test Case Results .......................................................................................................................... 8 3.1 Radiated Emission .................................................................................................................. 8 3.2 Conducted Emission ............................................................................................................. 13 4 Main Test Instruments .................................................................................................................. 15 EMC Test Report Report No.: R2006A0424-E1 TA Technology (Shanghai) Co., Ltd. TA-MB-06-001E Page 3 of 15 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Summary of measurement results Number Test Case Clause in FCC Rules Conclusion 1 Radiated Emission FCC Part15.109, ANSI C63.4-2014 PASS 2 Conducted Emission FCC Part15.107, ANSI C63.4-2014 NA Test Date: June 30,2020~August 8, 2020 Note: NA=Not applicable. This device can only be powered by batteries, so test items are not applicable. All indications of Pass/Fail in this report are opinions expressed by TA Technology (Shanghai) Co., Ltd. based on interpretations and/or observations of test results. Measurement Uncertainties were not taken into account and are published for informational purposes only. EMC Test Report Report No.: R2006A0424-E1 TA Technology (Shanghai) Co., Ltd. TA-MB-06-001E Page 4 of 15 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. 1 Test Laboratory 1.1 Notes of the Test Report This report shall not be reproduced in full or partial, without the written approval of TA technology (shanghai) co., Ltd. The results documented in this report apply only to the tested sample, under the conditions and modes of operation as described herein .Measurement Uncertainties were not taken into account and are published for informational purposes only. This report is written to support regulatory compliance of the applicable standards stated above. 1.2. Test facility FCC (Designation number: CN1179, Test Firm Registration Number: 446626) TA Technology (Shanghai) Co., Ltd. has been listed on the US Federal Communications Commission list of test facilities recognized to perform electromagnetic emissions measurements. A2LA (Certificate Number: 3857.01) TA Technology (Shanghai) Co., Ltd. has been listed by American Association for Laboratory Accreditation to perform electromagnetic emission measurement. 1.3 Testing Location Company: TA Technology (Shanghai) Co., Ltd. Address: No.145, Jintang Rd, Tangzhen Industry Park, Pudong Shanghai, China City: Shanghai Post code: 201201 Country: P. R. China Contact: Fan Guangchang Telephone: +86-021-50791141/2/3 Fax: +86-021-50791141/2/3-8000 Website: http://www.ta-shanghai.com E-mail: [email protected] EMC Test Report Report No.: R2006A0424-E1 TA Technology (Shanghai) Co., Ltd. TA-MB-06-001E Page 5 of 15 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. 2 General Description of Equipment under Test 2.1 Applicant and Manufacturer Information Applicant Asiatelco Technologies Co. Applicant address #289 Bisheng Road, Building-8, 3F, Zhang jiang Hi-Tech Park, Pudong,Shanghai 201204, China Manufacturer Asiatelco Technologies Co. Manufacturer address #289 Bisheng Road, Building-8, 3F, Zhang jiang Hi-Tech Park, Pudong,Shanghai 201204, China 2.2 General information EUT Description Device Type: Movable Device Model: AS31 SN: BS204500001 HW Version: AS31_P1 SW Version: BG96MAR04A04M1G_BETA1207A_01.004.01.004_BETA1210A Antenna Type: Internal Antenna Frequency: Band Tx (MHz) Rx (MHz) LTE Band 2 1850 ~ 1910 1930 …

Text truncated - open the document above for the full version.

EMC Test Setup Report No.: R2006A0424 TA Technology (Shanghai) Co., Ltd. TA-MB-04-001E Page 1 of 1 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Part15B Test Setup 30MHz-1GHz 1GHz-18GHz Picture 1 Radiated Emission Test Setup