2AB7K-A78122.4GHz Wireless Mouse

Model:SM-608AG The RF2.4GHz optical mouse use 3.7V LI-ion batteries. Trun on swith “ON” position Nano receiver * This mouse is equipped with Traveling-Power-Save function. When you are traveling with this mouse, the LED of the mouse will be switched off automatically for the purpose of power-save, but the pre-condition is that the receiver is disconnected with your notebook or PC. * when your mouse no any clik or scroll or moving, the mouse will come to sleep state for the economize after about 8 minutes, for the wake up, you can click any button for this Your optical 6 button mouse is provide 800&1200&1600 dpi switch. 1:when you want use the mouse ,you can take out the receiver to computer by the list step; 2:when you need stop the work or to travel, you can store the receiver on the mouse for the moving by the list step. DPI Switch 1.Connect the USB plug nano to USB port of the computer FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving an tenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Trun on swith

SCS-F18:ProjectandProductCertificationRepresentativeAuthorizationLetterPage1of2Rev5.0 775MontagueExpressway Milpitas,CA95035 Tel:408-526-1188 Fax:408-526-1088 Email:[email protected] ProjectandProduct CertificationRepresentative AuthorizationLetter ReasonforAmendment(current/obsolete) RevisionHistory ApprovedDate FromTo InitialRelease(obsolete)1.01.0Nov-14-2006 Revisedwording(obsolete)1.02.0Sept–25-2007 Updatedcompanytemplate(obsolete)2.03.0Jan-31-2012 Updatedletterinformation(obsolete)3.04.0May-23-2014 AddedFCCIDfield(current)4.05.0Sept162014 SCS-F18:ProjectandProductCertificationRepresentativeAuthorizationLetterPage2of2Rev5.0 (AnkerTechnologyCo.,Limited) (2015-05-12) To:SIEMIC,INC. 775MontagueExpressway, Milpitas,CA95035 USA DearSir/Madam, Re:ProductCertificationRepresentativeAuthorizationLetter We,_____AnkerTechnologyCo.,Limited_____herebyauthorizeSIEMIC,Inc.toactasa CertificationBodyforcertifyingforthefollowingproject(s): Productdescription:2.4GHzWirelessMouse Modelname:A7812 FCCID:2AB7K-A7812 Sincerely, Client’ssignature SimonZhang/ProductManager CompanyName:AnkerTechnologyCo.,Limited Address:Room1318-19,HollywoodCommercialCenter,610NathanRoad,Mongkok,Kowloon, Hongkong Email:[email protected]

SCS-F19:ConfidentialityRequestLetterPage 1 of 2 Rev4.0 775MontagueExpressway Milpitas,CA95035 Tel:408-526-1188 Fax:408-526-1088 Email:[email protected] Confidentiality RequestLetter ReasonforAmendment(current/obsolete) RevisionHistory ApprovedDate FromTo InitialRelease(obsolete)1.01.0Nov-14-2006 AddingCFR2.459(obsolete)1.02.0August–11-2008 Updatedcompanytemplate&Addedtextbox (obsolete) 2.03.0Jan-31-2012 AddedICconfidentialityletterform(current)3.04.0March-26-2015 SCS-F19:ConfidentialityRequestLetterPage 2 of 2 Rev4.0 (AnkerTechnologyCo.,Limited) (2015-05-12) To: FederalCommunicationsCommission AuthorizationandEvaluationDivision 7435OaklandMillsRoad Columbia,MD Subject:PermanentConfidentialityRequestforFCCID:2AB7K-A7812 Weherebyrequestconfidentialtreatmentofinformationaccompanyingthisapplicationasoutlinedbelow: -BlockDiagram -Schematics -OperationalDescription Theabovematerialscontaintradesecretsandproprietaryinformationnotcustomarilyreleasedtothepublic.The publicdisclosureofthesematerialsmaybeharmfultotheapplicantandprovideunjustifiedbenefitstoits competitors. TheapplicantunderstandsthatpursuanttoSection0.457&0.459oftheRules,disclosureofthisapplicationand allaccompanyingdocumentationwillnotbemadebeforethedateoftheGrantforthisapplication. Sincerely, Client’ssignature SimonZhang/ProductManager CompanyName:AnkerTechnologyCo.,Limited Address:Room1318-19,HollywoodCommercialCenter,610NathanRoad,Mongkok,Kowloon,Hongkong Email:[email protected]

Figure1 TheEUT-TopView Figure2 TheEUT-BottomView Figure3 TheEUT-FrontView Figure4 TheEUT-BackView Figure5 TheEUT-RightView Figure6 TheEUT-LeftView

LabelLocationOnEUT

ProductName:2.4GHzWirelessMouse ModelNo.:A7812 FCCID:2AB7K-A7812

Figure7 TheEUT-InsideView Figure8 PCBoftheEUT-FrontView Figure9 PCBoftheEUT-BackView Figure10 PCBoftheEUT-FrontView Figure11 PCBoftheEUT-BackView Figure12 PCBoftheEUT-ModuleView Antenna

Shenzhen Anbotek Compliance Laboratory Limited FCC ID: 2AB7K-A7812 Page 1 of 33 Report No.: R011503584E Shenzhen Anbotek Compliance Laboratory Limited Tel:(86)755-26066544Fax:(86)755-26014772www.anbotek.com FCC TEST REPORT for Anker Technology Co., Limited 2.4GHz Wireless Mouse Model No.: A7812 ReportNumber:R011503584E DateofTest:May04~12,2015 DateofReport:May13,2015 Preparedfor:AnkerTechnologyCo.,Limited Address:Room 1318-19, Hollywood Commercial Center, 610 Nathan Road,Mongkok,Kowloon,Hongkong PreparedBy:ShenzhenAnbotekComplianceLaboratoryLimited Address:1/F., Building 1, SEC Industrial Park, No.0409 Qianhai Road, NanshanDistrict,Shenzhen,Guangdong,China Tel:(86)755-26066544 Fax:(86)755-26014772 Shenzhen Anbotek Compliance Laboratory Limited FCC ID: 2AB7K-A7812 Page 2 of 33 Report No.: R011503584E Shenzhen Anbotek Compliance Laboratory Limited Tel:(86)755-26066544Fax:(86)755-26014772www.anbotek.com TABLE OF CONTENTS Description Page Test Report 1. GENERAL INFORMATION......................................................................................................4 1.1. Description of Device (EUT)................................................................................................................4 1.2. Auxiliary Equipment Used during Test................................................................................................5 1.3. Description of Test Facility.................................................................................................................. 5 1.4. Measurement Uncertainty.....................................................................................................................5 2. TEST PROCEDURE....................................................................................................................6 3. RADIATION INTERFERENCE................................................................................................ 7 3.1. Requirements (15.249, 15.209):............................................................................................................7 3.2. Test Procedure...................................................................................................................................... 7 3.3. Test Results...........................................................................................................................................7 4. BANDEDGE................................................................................................................................13 4.1. Requirements (15.249):.......................................................................................................................13 4.2. Test Procedure.................................................................................................................................... 13 4.3. Test Configuration:............................................................................................................................. 13 4.4. Test Results.........................................................................................................................................14 5. OCCUPIED BANDWIDTH...................................................................................................... 23 5.1. Requirements :.................................................................................................................................... 23 5.2. Test SET-UP....................................................................................................................................... 23 5.3 Test Equipment....................................................................................................................................23 5.4. Test Results.........................................................................................................................................23 6. ANTENNA APPLICATION......................................................................................................26 6.1. Antenna requirement...........................................................................................................................26 6.2. Result.................................................................................................................................................. 26 7. PHOTOGRAPH......................................................................................................................... 27 7.1. Photo of Radiation Emission Test.......................................................................................................27 APPENDIX I (External Photos) (3 Pages) APPENDIX II (Internal Photos) (3 Pages) Shenzhen Anbotek Compliance Laboratory Limited FCC ID: 2AB7K-A7812 Page 3 of 33 Report No.: R011503584E Shenzhen Anbotek Compliance Laboratory Limited Tel:(86)755-26066544Fax:(86)755-26014772www.anbotek.com TEST REPORT Applicant: Anker Technology Co., Limited Manufacturer: Anker Technology Co., Limited EUT: 2.4GHz Wireless Mouse Model No.: A7812 Serial No.: N.A. Trade Mark: Anker Rating: DC 3.7V, 7mA Measurement Procedure Used: FCC Part15 Subpart C, Paragraph 15.207, 15.249 & 15.209 The device described above is tested by Shenzhen Anbotek Compliance Laboratory Limited to determine the maximum emission levels emanating from the device and the severe levels of the device can endure and its performance criterion. The measurement results are contained in this test report and Shenzhen Anbotek Compliance Laboratory Limited is assumed full of responsibility for the accuracy and completeness of these measurements. Also, this report shows that the EUT (Equipment Under Test) is technically compliant with the FCC Part 15 Subpart C requirements. This report applies to above tested sample only and shall not be reproduced in part without written approval of Shenzhen Anbotek Compliance Laboratory Limited. DateofTest:May04~12,2015 Preparedby: (TestedEngineer/KeboZhang) Reviewer: (ProjectManager/AmyDing) App…

Text truncated - open the document above for the full version.

1.PhotoofRadiationEmissionTest