2AEBXRF-21-ARemote control

FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2Rev 5.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Revised wording (obsolete) 1.0 2.0 Sept–25-2007 Updated company template (obsolete) 2.0 3.0 Jan-31-2012 Updated letter information (obsolete) 3.0 4.0 May-23-2014 Added FCC ID field (current) 4.0 5.0 Sept 16 2014 SCS-F18: Project and Product Certification Representative Authorization Letter Page 2 of 2Rev 5.0 EGLO Hong Kong Lighting Ltd 2015.03.10 To: SIEMIC, INC. 775 Montague Expressway, Milpitas, CA 95035 USA Dear Sir/Madam, Re: Product Certification Representative Authorization Letter We, __ EGLO Hong Kong Lighting Ltd _ _hereby authorize SIEMIC, Inc. to act as a Certification Body for certifying for the following project(s): Product description：Remote control model name: RF-21-A FCC ID: 2AEBXRF-21-A Sincerely, Client’s signature Client’s name / title ：Mony. Ung / General Manager Contact information / address ：Rm 2101, 21/F Multifield Centre, 426 Shangha Street, Mongkok ,Hong Kong ,China

SCS-F19: Confidentiality Request Letter Page 1 of 2 Rev 4.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Confidentiality Request Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Adding CFR 2.459 (obsolete) 1.0 2.0 August – 11 - 2008 Updated company template & Added text box (obsolete) 2.0 3.0 Jan-31-2012 Added IC confidentiality letter form (current)3.0 4.0 March-26-2015 SCS-F19: Confidentiality Request Letter Page 2 of 2 Rev 4.0 EGLO Hong Kong Lighting Ltd 2015.03.10 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Subject: Permanent Confidentiality Request for FCC ID: 2AEBXRF-21-A We hereby request confidential treatment of information accompanying this application as outlined below: - Block Diagram - Schematics - Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Client’s signature Client’s name / title ：Mony. Ung / General Manager Contact information / address ：Rm 2101, 21/F Multifield Centre, 426 Shangha Street, Mongkok ,Hong Kong ,China

External Photos M/N: RF-21-A External Photos M/N: RF-21-A External Photos M/N: RF-21-A

Label Location

Internal Photos M/N: RF-21-A Internal Photos M/N: RF-21-A Antenna

FCC ID: 2AEBXRF-21-A EST Technology Co.,Ltd Report No. ESTE-R1503004 Page 1 of 27 APPLICATION FOR CERTIFICATION On Behalf of EGLO Hong Kong Lighting Ltd Model Number: RF-21-A FCC ID: 2AEBXRF-21-A Prepared for : EGLO Hong Kong Lighting Ltd Address : Rm 2101, 21/F Multifield Centre, 426 Shangha Street, Mongkok ,Hong Kong, China Prepared By : EST Technology Co., Ltd. Address : Santun(guantai Road), Houjie Town, DongGuan City,GuangDong, China Tel: +86-769-83081888 Fax: +86-769-83081878 Report Number : ESTE-R1503004 Date of Test : March 01~09, 2015 Date of Report : March 10, 2015 FCC ID: 2AEBXRF-21-A EST Technology Co.,Ltd Report No. ESTE-R1503004 Page 2 of 27 TABLE OF CONTENTS Test Report Declaration Page 1. GENERAL PRODUCT INFORMATION ...................................................................................4 1.1. Description of Device (EUT) ................................................................................................................ 4 1.2. Difference between Model Numbers .................................................................................................... 4 1.3. Independent Operation Modes .............................................................................................................. 4 2. TEST SITES....................................................................................................................................5 2.1. Test Facilities ........................................................................................................................................ 5 2.2. Description of Standards and Results.................................................................................................... 6 2.3. Measurement uncertainty ...................................................................................................................... 7 2.4. List of Test and Measurement Instruments ........................................................................................... 8 3. TEST SET-UP AND OPERATION MODES ..............................................................................9 3.1. Principle of Configuration Selection..................................................................................................... 9 3.2. Block Diagram of Test Set-up............................................................................................................... 9 3.3. Test Operation Mode and Test Software............................................................................................... 9 3.4. Special Accessories and Auxiliary Equipment .....................................................................................9 3.5. Countermeasures to Achieve EMC Compliance ................................................................................... 9 4. EMISSION TEST RESULTS......................................................................................................10 4.1. Conducted Emissions .......................................................................................................................... 10 4.2. Antenna Requirements ........................................................................................................................ 11 4.3. Radiated emissions .............................................................................................................................. 12 4.4. 20dB Occupied Bandwidth ................................................................................................................. 17 4.5. Deactivation time ................................................................................................................................ 19 5. DUTY CYCLE CORRECTION FACTOR................................................................................21 6. PHOTOGRAPHS OF TEST SET-UP ........................................................................................22 7. PHOTOGRAPHS OF THE EUT ................................................................................................23 FCC ID: 2AEBXRF-21-A EST Technology Co.,Ltd Report No. ESTE-R1503004 Page 3 of 27 EST Technology Co., Ltd. Applicant: Address: EGLO Hong Kong Lighting Ltd Rm 2101, 21/F Multifield Centre, 426 Shangha Street, Mongkok , Hong Kong ,China. Manufacturer: Address: Dong Duan NewShengDa Lighting Co Ltd No.1 Shang Qiao Industrial Road. Dongcheng Town, DongGuan, GuangDong, China E.U.T: Remote control Model Number: RF-21-A Trade Name: EGLO Operating Frequency: 433.92 MHz Date of Receipt: March 01, 2015 Date of Test: March 01~09, 2015 Test Specification: FCC Rules and Regulations Part 15 Subpart C:2014 ANSI C63.10:2013 Test Result: The equipment under test was found to be compliance with the requirements of the standards applied. Issue Date: March 10, 2015 Prepared by: Tested by: Approved by: Ada / Assistant Tony / Engineer Iceman Hu / Manager Other Aspects: None. Abbreviations: OK/P=passed fail/F=failed n.a/N=not applicable E.U.T=equipment under tested This test report is based on a single evaluation of one sample of above mentioned products ,It is not permitted to be duplicated in extracts without written approval of EST Technology Co., Ltd. FCC ID: 2AEBXRF-21-A EST Technology Co.,Ltd Report No. ESTE-R1503004 Page 4 of 27 1. GENERAL PRODUCT INFORMATION 1.1. Description of Device (EUT) E.U.T. : Remote control Model No. : RF-21-A Operating Frequency : 433.92 MHz Number of Channels : 1 Channels Type of Modulation : ASK Antenna Type : Integral System Input Voltage : Nominal Voltage: DC 3V(Battery) 1.2. Difference between Model Numbers None. 1.3. Independent Operation Modes The basic operation modes are: TX mode FCC ID: 2AEBXRF-21-A EST Technology Co.,Ltd Report No. ESTE-R1503004 Page 5 of 27 2. TEST SITES 2.1. Test Facilities EMC Lab : Certificated by CNAL, CHINA Registration No.: L5288 Date of registration: November 13, 2014 Certificated by FCC, USA Registration No.: 989591 Date of registration: November 20, 2013 Ce…

Text truncated - open the document above for the full version.

Set-up for radiated measurements (30MHz to 1000MHz) Set-up for radiated measurements (1000MHz to 5000MHz)