2AGBW9290023986XDigital device

Dimmer Switch Mounting materials not included. Wall Plate 3222 639 06041 On/Off button A B click click 3s © 2020 Signify Holding hold IP20 A Please go to www.meethue.com to learn more about Hue and how to use it. APPROBATIONS FCC, IC, UL, Zigbee This device complies with Part 15 of the FCC Rules and with RSS of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: FCC Radiation Exposure Statement: The advanced interface module complies with FCC radiation exposure limits set forth for an uncontrolled environment. IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment complies with IC RSS radiation exposure limits set forth for an uncontrolled environment. This Class B digital apparatus complies with Canadian ICES-003. This digital apparatus does not exceed the class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications. NOTICE:Changes or modifications made to this device not expressly approved by Signify North America Corporation (“Signify”) may void the U.S. FCC and Canadian authorization to operate this device. This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna Increase the separation between the device and receiver Consult the dealer or an experienced radio/television technician for help Perchlorate Material – special handling may apply WARNINGS AND CAUTIONS: Keep away from young children Keep away from liquids and humidity The device is for indoor use only. Do not use the device in wet locations, e.g. bathrooms or outdoors. This device is not a toy designed to be played with by children. Donotplacethedeviceonhotsurfaces. Risk of explosion if the battery is replaced by an incorrect type. CAUTION: Do not ingest battery – Chemical burn hazard This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. Always switch off power prior to installation If in doubt, consult a qualified or licensed electrician. Ensure the product is always installed according to relevant regulations Batteries should be installed by an adult. Different types of batteries and new and used batteries are not to be mixed. Batteries are to be inserted with the correct polarity. The supply terminals are not to be short-circuited. Do not use rechargeable batteries. Non-rechargeable batteries are not to be charged. Exhausted batteries are to be removed from the product. Remove batteries when product is not in use for some time. LIMITED WARRANTY: Signify warrants that this device will be free from defects in material and workmanship and will operate for 2 years when used as directed. If this device does not conform to the warranty, Signify will send you, at its election, a replacement device or refund your original purchase price upon receipt of the returned device, register receipt and proof of purchase. Please call our toll-free number 1-800-555-0050, write to Signify (address indicated on the packaging) or send an email at the website www.philips.com/lighting to find out how to return the device. This limited warranty does not cover devices subject to accident, neglect, abuse, misuse or acts of God. REPLACEMENT OR REFUND IS YOUR SOLE REMEDY. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS HEREBY EXPRESSLY EXCLUDED. Some states and provinces do not allow exclusion of incidental or consequential damages, so the above limitation or exclusion - may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state and province to province. CLEANING AND MAINTENANCE: To avoid scratching, the product should only be cleaned with a soft dry cloth. Do not use cleaning agents to clean the device. Manage in accordance with disposal laws in your area. Remove the batteries when you discard the remote control. Do not throw the batteries away with normal household waste. They must be handed in at an official collection point or at a Philips Dealer, both of which will dispose of the batteries in an environmentally friendly way. Specifications Hue Dimmer Switch Weight of remote: 33 g Weight of wall mount: 43 g Size: Remote only: 1.38" x 3.62" x 0.43". With Wall mount plate: 3.15" x 4.92" x 0.59". Batteries: 1x CR2032 Number of buttons: 4 control buttons and 1 set-up button Wireless specification: Wireless RF mode frequency band: 2400-2483.5 MHz Wireless communications protocol: IEEE 802.15.4 Operating channels: channels 11 - 26 Installing the Hue Dimmer Switch on or near metal surfaces may lead to reduce…

Text truncated - open the document above for the full version.

UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. Appendix I External Photographs Page 2 of 5 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. . . All View of EUT Page 3 of 5 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. . . Front View of EUT Back View of EUT Page 4 of 5 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. . . Top View of EUT Bottom View of EUT Page 5 of 5 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. . . Left View of EUT Right View of EUT

Model: 9290023986 FCC ID: 2AGBW9290023986X IC: 20812-3986X Made in Thailand Note: label locates on the back of the device

Appendix II Internal Photographs Page 2 of 6 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. . Open View of EUT Internal View of EUT-1 Page 3 of 6 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. . Internal View of EUT-2 Internal View of EUT-3 Page 4 of 6 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. . Internal View of EUT-4 Internal View of EUT-5 Page 5 of 6 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. . RF Module location Page 6 of 6 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. . Antenna location

The results reported herein have been performed in accordance with the laboratory’s terms of accreditation. This report shall not be reproduced except in full without the written approval of the Laboratory. The results in this report apply to the test sample(s) mentioned above at the time of the testing period only and are not to be used to indicate applicability to other similar products. This report does not imply that the product(s) has met the criteria for certification. FCC 47 CFR PART 15 SUBPART C ISED RSS-247 ISSUE 2 CERTIFICATION TEST REPORT For Digital device MODEL NUMBER: 9290023986 PROJECT NUMBER: 4789439400 REPORT NUMBER: 4789439400-1 FCC ID: 2AGBW9290023986X IC: 20812-3986X ISSUE DATE: Aug. 14, 2020 Prepared for Signify (China) Investment Co., Ltd. Prepared by UL-CCIC COMPANY LIMITED No. 2, Chengwan Road, Suzhou Industrial Park, People’s Republic of China Tel: +86 512-6808 6400 Fax: +86 512-6808 4099 Website: www.ul.com REPORT No.: 4789439400-1 Page 2 of 69 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. Revision History Rev. Issue Date Revisions Revised By V0 08/14/2020 Initial Issue REPORT No.: 4789439400-1 Page 3 of 69 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. TABLE OF CONTENTS 1. ATTESTATION OF TEST RESULTS ................................................................................. 4 2. TEST METHODOLOGY ..................................................................................................... 6 3. FACILITIES AND ACCREDITATION ................................................................................. 6 4. CALIBRATION AND UNCERTAINTY ................................................................................ 7 4.1. MEASURING INSTRUMENT CALIBRATION .............................................................. 7 4.2. MEASUREMENT UNCERTAINTY ............................................................................... 7 5. EQUIPMENT UNDER TEST ............................................................................................... 8 5.1. DESCRIPTION OF EUT .............................................................................................. 8 5.2. MAXIMUM OUTPUT POWER...................................................................................... 9 5.3. CHANNEL LIST ........................................................................................................... 9 5.4. TEST CHANNEL CONFIGURATION ..........................................................................10 5.5. THE WORSE CASE POWER SETTING PARAMETER ..............................................10 5.6. DESCRIPTION OF AVAILABLE ANTENNAS .............................................................11 5.7. TEST ENVIRONMENT ...............................................................................................12 5.8. DESCRIPTION OF TEST SETUP ...............................................................................13 5.9. MEASURING INSTRUMENT AND SOFTWARE USED ..............................................14 6. MEASUREMENT METHODS ............................................................................................15 7. ANTENNA PORT TEST RESULTS ...................................................................................16 7.1. ON TIME AND DUTY CYCLE .....................................................................................16 7.2. 6 dB BANDWIDTH AND 99% OCCUPIED BANDWIDTH ...........................................18 7.3. CONDUCTED OUTPUT POWER ...............................................................................22 7.4. POWER SPECTRAL DENSITY ..................................................................................26 7.5. CONDUCTED BANDEDGE AND SPURIOUS EMISSIONS ........................................30 7.6. RADIATED TEST RESULTS ......................................................................................45 7.6.1. LIMITS AND PROCEDURE .................................................................................45 7.6.2. TEST ENVIRONMENT ........................................................................................50 7.6.3. RESTRICTED BANDEDGE .................................................................................50 7.6.4. SPURIOUS EMISSIONS .....................................................................................55 8. ANTENNA REQUIREMENTS ............................................................................................69 REPORT No.: 4789439400-1 Page 4 of 69 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. 1. ATTESTATION OF TEST RESULTS Applicant Information Company Name: Signify (China) Investment Co., Ltd. Address: Building no.9, Lane 888, Tianlin Road, Minhang District Shanghai China Manufacturer Information Company Name: Signify (China) Investment Co., Ltd. Address: Building no.9, Lane 888, Tianlin Road, Minhang District Shanghai China Factory Information Company Name: LEEDARSON LIGHTING CO LTD. Address: XINGDA RD XINGTAI INDUSTRIAL ZONE CHANGTAI COUNTY ZHANGZHOU, FUJIAN 363900 CHINA. Company Name: L&E MANUFACTURING CO., LTD. Address: 45/27 MOO 3,TALINGCHAN-SUPHANBURI RD, NAMAI, LADLUMKAEO, PATHUMTHANI PROVINCE,12140 THAILAND. EUT Description Product Name Digital device Model Name 9290023986 Sample Number 2992188 Data of Receipt Sample Apr. 2, 2020 Date Tested Apr. 2, 2020~ Aug. 13, 2020 APPLICABLE STANDARDS STANDARD TEST RESULTS CFR 47 Part 15 Subpart C ISED RSS-247 ISSUE 2 PASS PASS REPORT No.: 4789439400-1 Page 5 of 69 UL-CCIC COMPANY LIMITED This report shall not be reproduced except in full, without the written approval of UL-CCIC COMPANY LIMITED. Summary of Test Results Clause Test Items FCC/IC Rules Test Results 1 6dB Bandwidth and 99% Occupied Bandwidth FCC Part 15.247 (…

Text truncated - open the document above for the full version.

Appendix III Setup Photographs RADIATED RF MEASUREMENT SETUP (Below 30MHz) RADIATED RF MEASUREMENT SETUP (30MHz~1GHz) RADIATED RF MEASUREMENT SETUP (ABOVE 1 GHz- X axis) RADIATED RF MEASUREMENT SETUP (ABOVE 1 GHz- Y axis) RADIATED RF MEASUREMENT SETUP (ABOVE 1 GHz- Z axis)