2ANJHWVODB1BASE STATION

Wyze Cam Outdoor Base Station Base Station Power Adapter Base Station Ethernet Cable Camera Charging USB Cable Quick Start Guide Screw Assembly x1 x1 x1 x1 x1 x1 x1 IN THE BOX Power AdapterUSB Cable Ethernet Cable MicroSD Slot (MicroSD not included) 2 SYNC Button 1 LAN Port 6 Power Input 5 USB Charging port 4 Reset 3 Status Light 7 1 2 Micro SD SYNC RIGHT Power LAN 5 6 BACK RESET 3 4 LEFT 7 TOP SURFACE SETUP 3 Follow the Wyze app to set up the camera. 4 Follow the Wyze app to mount the camera. Screw Assembly Microphone 3 Removable Magnetic Mounting Base 4 Lens 2 Light Sensor 1 MicroSD Slot (SD card not included) 8 SYNC Button 7 Ceiling Mounting Hole 10 Wall Mounting Hole 9 On-O Switch USB Charging Port 5 Status Light 6 1 2 3 4 FRONT 5 6 OPEN BACK 10 9 BOTTOM Removable Magnetic Mounting Base SYNC Micro SD 7 8 Base Station Wall Mounting Ceiling Mounting Troubleshooting & FAQs support.wyze.com Community forums.wyze.com Contact Us [email protected] 1-844-WYZECAM Tutorial Videos www.youtube.com/wyzelabs NEED HELP? LIGHT INDICATIONS Solid yellow light The device is powered on and initializing Solid blue light The device is working properly Flashing yellow & blue lights The device is pairing with camera Flashing blue light The device is connecting to the network Wyze Cam Outdoor Solid yellow light The device is powered on and initializing Solid blue light The device is working properly Flashing red light The device is charging Solid red light The device is fully charged No indicator light The device is powered o or sleeping Flashing yellow & blue lights The device is pairing with base station Flashing blue light The device is connecting network Using the camera in the car under direct sun exposure could exceed the operating tempera- ture of the battery, resulting in irreversible damage to the battery. FCC Warning: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits ISEDC RSS warning : This device complies with ISEDC licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'ISEDC applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. ISEDC Radiation Exposure Statement: This equipment complies with ISEDC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance 20cm between the radiator& your body. 1 Follow the Wyze app to set up base station 2 Download the Wyze app and create an account. ①③ ② ①③ ② Precautions: QUICK START GUIDE CAM OUTDOOR set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Cet appareil estconforme aux limitesd'exposition de rayonnement RF ISEDC établiespour un environnement non contrôlé. Cetémetteur ne doit pas être co-implanté oufonctionner en conjonction avec toute autreantenne ou transmetteur. Industrial cellular router doit être installé et utiliséavec une distance minimale de 20cm entre leradiateur & votre corps. Front Back

QA-FR-170-B 7/29/2014 TianJin HuaLai Technology Co., Ltd. Add: No.10 JinPing Road, Ya An Street, Nankai District, Tianjin, China Tel: 18202589622 Fax: 87614860 E-mail: [email protected] FCC Authorization Date:2019-11-1 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Agent Authorization To whom it may concern: We TianJin HuaLai Technology Co., Ltd., Hereby authorizes Bay Area Compliance Laboratories Corp. to act on its behalf in all matters relating to application for Equipment authorization, including the signing of all documents relating to these matters. All acts carried out by Bay Area Compliance Laboratories Corp. on our behalf shall have the same effect as our own action. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. Sincerely Yours, Signature Printed Name: Guoqing Wang Title: Manager

QA-FR-171-A TianJin HuaLai Technology Co., Ltd. Add: No.10 JinPing Road, Ya An Street, Nankai District, Tianjin, China Tel: 18202589622 Fax: 87614860 E-mail: [email protected] FCC Confidential Authorization Date:2019-11-1 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Confidentiality Request regarding application for certification of FCC ID: 2ANJHWVODB1 In accordance with Sections 0.457 and 0.459 of the Commission’s Rules, TianJin HuaLai Technology Co., Ltd. hereby requests long-term confidential treatment of information accompanying this application as outlined below:  Block Diagram  Schematics  Operation Description The above materials contain proprietary and confidential information not customarily released to the public. The public disclosure of these materials provides unjustified benefits to its competitors in the market. Sincerely, Signature: Printed Name: Guoqing Wang Title: Manager

EXHIBIT B - EXTERNAL PHOTOGRAPHS

label here BASE STATION Model: WVODB1 12V 1A FCC ID: 2ANJHWVODB1 IC : 24984-- WVODB1 MAC: XX:XX:XX:XX:XX:XX WYZE LABS, Inc. Made in China -

EXHIBIT C - INTERNAL PHOTOGRAPHS Chip Antenna

Bay Area Compliance Laboratories Corp. (Dongguan) Report No.: RBJ190328050-00 Page 13 of 65 FCC §15.247 (i) & §1.1310 & §2.1091- MAXIMUM PERMISSIBLE EXPOSURE (MPE) Applicable Standard According to subpart 15.247(i)and subpart §1.1310, systems operating under the provisions of this section shall be operated in a manner that ensures that the public is not exposed to radio frequency energy level in excess of the Commission’s guidelines. Limits for Maximum Permissible Exposure (MPE) (§1.1310, §2.1091) (B) Limits for General Population/Uncontrolled Exposure Frequency Range (MHz) Electric Field Strength (V/m) Magnetic Field Strength (A/m) Power Density (mW/cm 2 ) Averaging Time (minutes) 0.3–1.34 614 1.63 *(100) 30 1.34–30 824/f 2.19/f *(180/f²) 30 30–300 27.5 0.073 0.2 30 300–1500 / / f/1500 30 1500–100,000 / / 1.0 30 f = frequency in MHz; * = Plane-wave equivalent power density; According to §1.1310 and §2.1091 RF exposure is calculated. Calculation formula: Prediction of power density at the distance of the applicable MPE limit S = PG/4R² = power density (in appropriate units, e.g. mW/cm 2 ); P = power input to the antenna (in appropriate units, e.g., mW); G = power gain of the antenna in the direction of interest relative to an isotropic radiator, the power gain factor, is normally numeric gain; R = distance to the center of radiation of the antenna (appropriate units, e.g., cm); Calculated Data: Frequency (MHz) Antenna Gain Conducted output power including Tune- up Tolerance Evaluation Distance (cm) Power Density (mW/cm 2 ) MPE Limit (mW/cm 2 ) (dBi) (numeric) (dBm)(mW) 2412-2462 21.58 20100.00200.03153 1.0 Result: The device meet FCC MPE at 20 cm distance

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. (Dongguan). This report must not be used by the customer to claim product certification, approval, or endorsement by A2LA* or any agency of the Federal Government. * This report may contain data that are not covered by the A2LA accreditation and are marked with an asterisk “*”. FCC PART 15.247 TEST REPORT For TianJin HuaLai Technology Co.,Ltd. No.10 JinPing Road,Ya An Street,Nankai District Tianjin.China Report Type: Original Report Product Type: BASE STATION Re port Number: RBJ190328050-00 Re port Date: 2019-05-22 Reviewed By: Dean Lau RF Supervisor Test Laboratory: Bay Area Compliance Laboratories Corp. (Dongguan) No.69 Pulongcun, Puxinhu Industry Area, Tangxia, Dongguan, Guangdong, China Tel: +86-769-86858888 Fax: +86-769-86858891 www.baclcorp.com.cn FCC ID: 2ANJHWVODB1 Bay Area Compliance Laboratories Corp. (Dongguan) Report No.: RBJ190328050-00 Page 2 of 65 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 4 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 4 OBJECTIVE ................................................................................................................................................................... 4 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 4 TEST METHODOLOGY .................................................................................................................................................. 4 MEASUREMENT UNCERTAINTY .................................................................................................................................... 5 TEST FACILITY ............................................................................................................................................................. 5 SYSTEM TEST CONFIGURATION .......................................................................................................................... 6 DESCRIPTION OF TEST CONFIGURATION ...................................................................................................................... 6 EUT EXERCISE SOFTWARE .......................................................................................................................................... 6 EQUIPMENT MODIFICATIONS ..................................................................................................................................... 10 SUPPORT EQUIPMENT LIST AND DETAILS .................................................................................................................. 10 SUPPORT CABLE LIST AND DETAILS .......................................................................................................................... 10 BLOCK DIAGRAM OF TEST SETUP .............................................................................................................................. 11 SUMMARY OF TEST RESULTS ............................................................................................................................. 12 FCC §15.247 (i) & §1.1310 & §2.1091- MAXIMUM PERMISSIBLE EXPOSURE (MPE) ....................................... 13 APPLICABLE STANDARD ............................................................................................................................................ 13 FCC §15.203 - ANTENNA REQUIREMENT ........................................................................................................... 14 APPLICABLE STANDARD ............................................................................................................................................ 14 ANTENNA CONNECTOR CONSTRUCTION .................................................................................................................... 14 FCC §15.207 (a) – AC LINE CONDUCTED EMISSIONS ..................................................................................... 15 APPLICABLE STANDARD ............................................................................................................................................ 15 EUT SETUP ................................................................................................................................................................ 15 EMI TEST RECEIVER SETUP ....................................................................................................................................... 15 TEST PROCEDURE ...................................................................................................................................................... 16 CORRECTED AMPLITUDE & MARGIN CALCULATION ................................................................................................. 16 TEST EQUIPMENT LIST AND DETAILS ......................................................................................................................... 16 TEST DATA ................................................................................................................................................................ 16 FCC §15.209, §15.205 & §15.247(d) - SPURIOUS EMISSIONS ............................................................................. 19 APPLICABLE STANDARD ............................................................................................................................................ 19 EUT SETUP ................................................................................................................................................................ 19 EMI TEST RECEIVER &…

Text truncated - open the document above for the full version.

EXHIBIT D - TEST SETUP PHOTOGRAPHS Conducted emissions front View Conducted emissions side View Radiated Emission Below 1GHz Radiated Emission Above 1GHz