AFJ325000Communications Receiver

INSTRUCTION MANUAL iR6 COMMUNICATIONS RECEIVER This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW. i FOREWORDThank you for purchasing this Icom product. The IC-R6 COMMUNICATIONS RECEIVER is designed and built with Icom’s superior technology and craftsmanship. With proper care, this product should provide you with years of trouble-free operation.We want to take a moment of your time to thank you for mak-ing your IC-R6 your radio of choice, and hope you agree with Icom’s philosophy of “technology first.” Many hours of research and development went into the design of your IC-R6. D FEATURES  Covers 0.100–1309.995 MHz* wide frequency range * Some frequency bands are inhibited , depending on the version  External power supply operation  1350 memory channels* with 22 banks available *Including 200 auto write and 50 scan edge channels  Built-in bar-antenna  New DMS (Dynamic Memory Scan) System IMPORTANTREAD ALL INSTRUCTIONS carefully and completely before using the receiver. SAVE THIS INSTRUCTION MANUAL— This instruction manual contains important operating instructions for the IC-R6. EXPLICIT DEFINITIONS WORD DEFINITION R WARNING! CAUTION NOTE Personal injury, fire hazard or electric shock may occur.Equipment damage may occur.Recommended for optimum use. No risk of personal injury, fire or electric shock. ii R WARNING! NEVER operate the receiver with a earphone, headphones or other audio accessories at high volume levels. Hearing experts advise against continuous high volume operation. If you experience a ringing in your ears, reduce the volume level or discontinue use. R WARNING! NEVER operate the receiver while driving a vehicle. Safe driving requires your full attention—anything less may result in an accident. R WARNING! NEVER connect the receiver to an AC outlet. This may pose a fire hazard or result in an electric shock. R WARNING! NEVER throw a battery cell into a fire since as internal battery gas can cause explosion. R WARNING! NEVER disassemble the battery cell. If the battery cell’s internal material (electrolyte liquid) gets into your eyes, wash your eyes with water and obtain treat- ment from an eye doctor immediately. NEVER connect the receiver to a power source of more than 6 V DC directly. This will damage the receiver. NEVER connect the receiver to a power source using reverse polarity. This will damage the receiver. NEVER expose the receiver to rain, snow or any liquids. The receiver may be damaged. NEVER operate or touch the receiver with wet hands. This may result in an electric shock or damage the receiver. NEVER solder the battery cell. This may damage the bat- tery. DO NOT use or place the receiver in direct sunlight or in areas with temperatures below –10°C (+14 ̊F) or above +60°C (+140 ̊F). DO NOT use harsh solvents such as benzine or alco- hol to clean the transceiver, because they can damage the transceiver’s surfaces.Even when the receiver power is OFF, a slight current still flows in the circuits. Remove batteries from the receiver when not using it for a long time. Otherwise, the installed batteries will become exhausted, and will need to be recharged. PRECAUTIONS iii FCC INFORMATION• FOR CLASS B UNINTENTIONAL RADIATORS:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-able protection against harmful interference in a residential installation. This equipment generates, uses and can radi-ate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter-ference to radio communications. However, there is no guar-antee that interference will not occur in a particular instal-lation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit differ- ent from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV techni- cian for help. OPERATING THEORYElectromagnetic radiation, which has frequencies of 20,000 Hz (20 kHz*) and above, is called radio frequency (RF) energy because, it is useful in radio transmissions. The IC-R6 receives RF energy from 0.150 MHz* to 1309.995 MHz and converts it into audio frequency (AF) energy which in turn actuates a loudspeaker to create sound waves. AF energy is in the range of 20 to 20,000 Hz.*kHz is an abbreviation of kilohertz or 1000 hertz, MHz is abbrevi- ation of megahertz or 1,000,000 hertz, where hertz is a unit of fre-quency. OPERATING NOTESThe IC-R6 may receive its own oscillated frequency, result-ing in no reception or only noise reception, on some fre-quencies.The IC-R6 may receive interference from extremely strong signals on different frequencies or when using an external high-gain antenna.Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the United Kingdom, Germany, France, Spain, Russia and/or other countries. CAUTION: Changes or modifications to this device, not expressly approved by Icom Inc., could void your authority to operate this device under FCC regulations. iv 123456789101112131415 16 123456789101112131415 16 TABLE OF CONTENTSFOREWORD ......................................................... iIMPORTANT ..........................................…

Text truncated - open the document above for the full version.

Scanning Receiver Model No.: IC-R6 FCC ID: AFJ325000 Applicant: ICOM Incorporated 1-1-32, Kamiminami, Hirano-ku Osaka, Japan, 547-0003 Tested in Accordance With Federal Communications Commission (FCC) 47 CFR, Part 15, Subpart B Scanning Receivers Operating in the Frequency Band 30 MHz - 960 MHz (excluding cellular bands) UltraTech's File No.: ICOM-227F15B121 This Test report is Issued under the Authority of Tri M. Luu, Professional Engineer, Vice President of Engineering UltraTech Group of Labs Date: December 17, 2009 Report Prepared by: Santhosh Fernandez Issued Date: December 17, 2009 Tested by: Wayne Wu, EMI/RFI Technician Test Dates: December 3, 4 and 10, 2009 ƒ The results in this Test Report apply only to the sample(s) tested, and the sample tested is randomly selected. ƒ This report must not be used by the client to claim product endorsement by NVLAP or any agency of the US Government. UltraTech 3000 Bristol Circle, Oakville, Ontario, Canada, L6H 6G4 Tel.: (905) 829-1570 Fax.: (905) 829-8050 Website: www.ultratech-labs.com , Email: [email protected], Email: [email protected] Korea KCC-RRL 91038 1309 46390-2049 NvLap Lab Code 200093-0 SL2-IN-E-1119R CA2049 FCC Part 15, Subpart B, Section 15.121 Scanning Receiver, Model: IC-R6 FCC ID: AFJ325000 ULTRATECH GROUP OF LABS File #: ICOM-227F15B121 3000 Bristol Circle, Oakville, Ontario, Canada L6H 6G4 December 17, 2009 Tel.: 905-829-1570, Fax. : 905-829-8050 All test results contained in this engineering test report are traceable to National Institute of Standards and Technology (NIST) TABLE OF CONTENTS EXHIBIT 1. INTRODUCTION ...................................................................................................................................... 1 1.1. SCOPE...................................................................................................................................................................... 1 1.2. RELATED SUBMITTAL(S)/GRANT(S)................................................................................................................ 1 1.3. NORMATIVE REFERENCES ................................................................................................................................ 1 EXHIBIT 2. PERFORMANCE ASSESSMENT ........................................................................................................... 2 2.1. CLIENT INFORMATION ....................................................................................................................................... 2 2.2. EQUIPMENT UNDER TEST (EUT) INFORMATION .......................................................................................... 2 2.3. EUT’S TECHNICAL SPECIFICATIONS ............................................................................................................... 3 2.4. LIST OF EUT’S PORTS .......................................................................................................................................... 3 2.5. ANCILLARY EQUIPMENT ................................................................................................................................... 3 EXHIBIT 3. EUT OPERATING CONDITIONS AND CONFIGURATIONS DURING TESTS ............................ 2 3.1. OPERATIONAL TEST CONDITIONS & ARRANGEMENT FOR TEST SIGNALS ........................................... 2 EXHIBIT 4. SUMMARY OF TEST RESULTS ............................................................................................................ 3 4.1. LOCATION OF TESTS ........................................................................................................................................... 3 4.2. APPLICABILITY & SUMMARY OF EMC EMISSION TEST RESULTS ............................................................ 3 4.3. MODIFICATIONS REQUIRED FOR COMPLIANCE .......................................................................................... 3 EXHIBIT 5. MEASUREMENTS, EXAMINATIONS & TEST DATA FOR EMC EMISSIONS............................ 4 5.1. TEST PROCEDURES.............................................................................................................................................. 4 5.2. MEASUREMENT UNCERTAINTIES ...................................................................................................................4 5.3. MEASUREMENT EQUIPMENT USED................................................................................................................. 4 5.4. POWER LINE CONDUCTED EMISSIONS [§ 15.107(A)]..................................................................................... 5 5.5. RECEIVER ANTENNA POWER SPURIOUS/HARMONIC CONDUCTED EMISSIONS [§15.111(A)] ............ 8 5.6. SPURIOUS/HARMONIC RADIATED EMISSIONS FROM RECEIVER AND CLASS B UNINTENTIONAL RADIATORS (DIGITAL DEVICES) [§ 15.109(A)] ......................................................................................................... 12 5.7. REQUIREMENTS FOR SCANNING RECEIVERS [§ 15.121]............................................................................ 15 5.8. SCANNING RECEIVERS CELLULAR BAND REJECTION [§ 15.121(B)] ....................................................... 18 EXHIBIT 6. TEST EQUIPMENTS LIST .................................................................................................................... 23 EXHIBIT 7. MEASUREMENT UNCERTAINTY...................................................................................................... 24 7.1. LINE CONDUCTED EMISSION MEASUREMENT UNCERTAINTY.............................................................. 24 7.2. RADIATED EMISSION MEASUREMENT UNCERTAINTY ............................................................................ 25 FCC Part 15, Subpart B, Section 15.121 Page 1 Scanning Receiver, Model: IC-R6 FCC ID: AFJ325000 ULTRATECH GROUP OF LABS File #: ICOM-227F15B121 3000 Bristol Circle, Oakville, Ontario, Canada L6H 6G4 December 17, 2009 Tel.: 905-829-1570, Fax. : 905-829-8050 Al…

Text truncated - open the document above for the full version.

ANNEXE 1 Test Setup Photos Icom Inc. Scanning receiver, Model: IC-R6 FCC ID:AFJ325000 1 AC Power Line Conducted Emissions ANNEXE 1 Test Setup Photos Icom Inc. Scanning receiver, Model: IC-R6 FCC ID:AFJ325000 2 AC Power Line Conducted Emissions ANNEXE 1 Test Setup Photos Icom Inc. Scanning receiver, Model: IC-R6 FCC ID:AFJ325000 3 Radiated Emissions @ 3m ANNEXE 1 Test Setup Photos Icom Inc. Scanning receiver, Model: IC-R6 FCC ID:AFJ325000 4 Radiated Emissions @ 3m ANNEXE 1 Test Setup Photos Icom Inc. Scanning receiver, Model: IC-R6 FCC ID:AFJ325000 5 Radiated Emissions @ 3m