EUGDJ-V5TAmateur Transceiver

Feb 26, 1999 Federal Communications Commission Authorization & Evaluation Division 7435 Oakland NliUs Road, Columbia, Maryland 21046 To Whom It May Concern, 438 Amapola Ave., Suite 130 * Torrance, California 90501 Phone: 310/618-8616 Fax: 310/618-8758 This letter is wALaudiorize--the appoLnbn4p-nt of-Rhein Tochnwal Laboratermw,,-4nc,- to, act as our Agent in all FCC matters. This appoinbnent is effective until otherwise notified by ui This is to advise that we are in fuU compliance with the Anti-drug Abuse Act. The Applicant is not subject to denial of federal benefits pursuant to Section 5301 of the Anti- Drug Abuse Act of 1988,21 USC 862, and no party to the applicant is subject to a denial of federal benefits pursuant to that section. Sincerely, Katsumi Nakata Branch Manager USA Ahnoo Branch Tel: 310-618-8616 ext 188 E-Mail: [email protected] U.S.A. ALINCO BRANCH 438 Amapola Avenue, Suite 130 Torrance, California 90501

3.0PRODUCT LABELING FIGURE 1: FCC ID AND DOC LABEL FIGURE 2: LOCATION OF LABELS ON EUT ALINCO DJ-V5T WIDE BAND RECEIVER FCC ID: EUGDJ-V5T ALINCO, INC. JAPAN Location of FCC ID Label Location of DoC Label Alinco, Inc.DJ-V5T WIDE BAND RECEIVER FOR HOME OR OFFICE USE Tested to Comply With FCC Standards FCC part 15 statement This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.

9.0PHOTOS OF TESTED EUT The following photos are attached: FIGURE 3: Front of EUT FIGURE 4: Back of EUT FIGURE 5: Back of EUT without Battery Pack FIGURE 6: Back of EUT without Battery Pack (close up showing FCC ID) FIGURE 7: Front of Battery Pack FIGURE 8: Back of Battery Pack FIGURE 9: Antenna FIGURE 10: AC Adaptor FIGURE 11: SP Serial Cable FIGURE 12: Earphone FIGURE 13: EUT without cover FIGURE 14: Top of CPU board (LCD Side) FIGURE 15: Bottom of CPU Board FIGURE 16: Main Board with copper shield FIGURE 17: Main Board without copper shield FIGURE 18: Top of Main Board FIGURE 19: Bottom of Main Board FIGURE 20: Bottom of CPU Board FIGURE 21: Top of CPU Board FIGURE 22: Bottom of Main Board FIGURE 23: Top of Main Board FIGURE 3: Front of EUT FIGURE 4: Back of EUT FIGURE 5: Back of EUT without Battery Pack FIGURE 6: Back of EUT without Battery Pack (close up showing FCC ID) FIGURE 7: Front of Battery Pack FIGURE 8: Back of Battery Pack FIGURE 9: Antenna FIGURE 10: AC Adaptor FIGURE 11: SP Serial Cable FIGURE 12: Earphone FIGURE 13: EUT without cover FIGURE 14: Top of CPU board (LCD Side) FIGURE 15: Bottom of CPU Board FIGURE 16: Main Board with copper shield FIGURE 17: Main Board without copper shield FIGURE 18: Top of Main Board FIGURE 19: Bottom of Main Board FIGURE 20: Bottom of CPU Board FIGURE 21: Top of CPU Board FIGURE 22: Bottom of Main Board FIGURE 23: Top of Main Board

The EUT pictures sent previously are not clear. Please replace the EUT pictures with the following. 9.0PHOTOS OF TESTED EUT The following photos are attached: FIGURE 3: Front of EUT FIGURE 4: Back of EUT FIGURE 5: Back of EUT without Battery Pack FIGURE 6: Back of EUT without Battery Pack (close up showing FCC ID) FIGURE 7: Front of Battery Pack FIGURE 8: Back of Battery Pack FIGURE 9: Antenna FIGURE 10: AC Adaptor FIGURE 11: SP Serial Cable FIGURE 12: Earphone FIGURE 13: EUT without cover FIGURE 14: Top of CPU board (LCD Side) FIGURE 15: Bottom of CPU Board FIGURE 16: Main Board with copper shield FIGURE 17: Main Board without copper shield FIGURE 18: Top of Main Board FIGURE 19: Bottom of CPU Board FIGURE 20: Top of CPU Board FIGURE 21: Bottom of Main Board FIGURE 22: Top of Main Board FIGURE 3: Front of EUT FIGURE 4: Back of EUT FIGURE 5: Back of EUT without Battery Pack FIGURE 6: Back of EUT without Battery Pack (close up showing FCC ID) FIGURE 7: Front of Battery Pack FIGURE 8: Back of Battery Pack FIGURE 9: Antenna FIGURE 10: AC Adaptor FIGURE 11: SP Serial Cable FIGURE 12: Earphone FIGURE 13: EUT without cover FIGURE 14: Top of CPU board (LCD Side) FIGURE 15: Bottom of CPU Board FIGURE 16: Main Board with copper shield FIGURE 17: Main Board without copper shield FIGURE 18: Top of Main Board FIGURE 19: Bottom of CPU Board FIGURE 20: Top of CPU Board FIGURE 21: Bottom of Main Board FIGURE 22: Top of Main Board

1.1PRODUCT DESCRIPTION

 APPLICATION FOR FCC CLASS B CERTIFICATION SCANNING RECEIVER ALINCO, Inc. 438 Amapola Ave. Suite 130 Torrance, CA 90501 MODEL: DJ-V5T FCC ID: EUGDJ-V5T Serial Number: February 19, 1999 REPORT PREPARED BY: EMI Technician:K. Franck Schuppius Administrative Writer:Melissa Fleming Rhein Tech Laboratories, Inc. Document Number: 990087 No part of this report may be reproduced without the full written approval of Rhein Tech Laboratories, Inc. This report concerns (check one):Original Grant: X Class II Change: Equipment Type: Scanning Receiver Deferred grant requested per 47 CFR 0.457 (d) (1) (ii)?Yes:No: X If yes, defer until: Date Company name agrees to notify the Commission by: (date) of the intended date of announcement of the product so that the grant can be issued on that date. Transition Rules Request per 15.37?Yes:No: X If no, assumed Part 15, subpart B for unintentional radiators - the new 47 CFR [10-1-90 Edition] provision.. i TABLE OF CONTENTS 1.0GENERAL INFORMATION..................................................................................................................1 1.1PRODUCT DESCRIPTION.....................................................................ERROR! BOOKMARK NOT DEFINED. 1.2RELATED SUBMITTAL(S)/GRANT(S).........................................................................................................2 1.3TEST SYSTEM DETAILS...........................................................................................................................2 1.4CONFIGURATION OF TESTED SYSTEM.......................................................................................................3 1.5TEST METHODOLOGY.............................................................................................................................4 1.6TEST FACILITY.......................................................................................................................................4 2.0STATEMENT FROM THE MANUFACTURER IN SUPPORT OF FCC SECTION 15.121...............5 3.0PRODUCT LABELING............................................................ERROR! BOOKMARK NOT DEFINED. 4.0SYSTEM TEST CONFIGURATION......................................................................................................6 4.1JUSTIFICATION........................................................................................................................................6 4.2EUT EXERCISE SOFTWARE.....................................................................................................................7 4.3SPECIAL ACCESSORIES............................................................................................................................7 4.4MODE OF OPERATION.............................................................................................................................7 4.5CONFORMANCE STATEMENT...................................................................................................................8 5.0CONDUCTED MEASUREMENT PHOTOS...........................ERROR! BOOKMARK NOT DEFINED. 6.0CONDUCTED EMISSION DATA........................................................................................................10 7.0RADIATED MEASUREMENT PHOTOS................................ERROR! BOOKMARK NOT DEFINED. 8.0RADIATED EMISSION DATA............................................................................................................15 8.1FIELD STRENGTH CALCULATION...........................................................................................................19 9.0PHOTOS OF TESTED EUT.....................................................ERROR! BOOKMARK NOT DEFINED. APPENDIX LISTING APPENDIX A: SCHEMATICS OF DJ-V5T.........................................................................................................9 APPENDIX B: EMISSIONS EQUIPMENT LIST..............................................................................................20 APPENDIX C: CONDUCTED AND RADIATED TEST METHODOLOGY.....................................................21 APPENDIX D: USER’S MANUAL...................................................................................................................22 ii FIGURE INDEX FIGURE 1: FCC ID AND DOC LABEL..............................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 2: LOCATION OF LABELS ON EUT......................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 3: FRONT OF EUT.............................................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 4: BACK OF EUT...............................................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 5: BACK OF EUT WITHOUT BATTERY PACK.......................................ERROR! BOOKMARK NOT DEFINED. FIGURE 6: BACK OF EUT WITHOUT BATTERY PACK (CLOSE UP SHOWING FCC ID)ERROR! BOOKMARK NOT DEFINED. FIGURE 7: FRONT OF BATTERY PACK.............................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 8: BACK OF BATTERY PACK..............................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 9: ANTENNA.....................................................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 10: AC ADAPTOR...............................................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 11: SP SERIAL CABLE.........................................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 12: EARPHONE....................................................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 13: EUT WITHOUT COVER...................................................................ERROR! BOOKMARK NOT DEFINED. FIGURE 14: TOP OF CPU BOARD (LCD SIDE)...................................................ERROR! BOOKMARK NOT DEFINED. F…

Text truncated - open the document above for the full version.

10 4.0SYSTEM TEST CONFIGURATION The EUT was configured for testing by connecting a monopole test antenna to a signal generator. The signal generator provided an indirect coupling of the transceivers input signal. One lower, middle and upper frequency within the band listed below were entered on the signal generator with the RF amplitude output set at –60dBm. The audio input port of EUT was connected to a microphone. An Alinco AC adaptor was connected to the DC power jack. The EUT was set in the AC charging unit during the test. The auxiliary service port was connected via a serial cable to the laptop computer’s auxiliary serial port. TABLE 1: CHANNEL FREQUENCY RECEIVER BANDSFREQUENCY (MHz) 76MHz to 174MHzLower76 Middle125 Upper174 174MHz to 520MHzLower174 Middle347 Upper520 520MHz to 824MHzLower520 Middle672 Upper824 850MHz to 869MHzLower850 Middle859.5 Upper869 895MHz to 960MHzLower895 Middle947.5 Upper960 4.1JUSTIFICATION The EUT was tested as a scanning receiver per FCC rules and regulations. The FCC does not regulate the transmitter section of the Transceiver, since it is an Amateur transceiver and its operating frequency falls under the amateur band. 19 TABLE 6: CONDUCTED EMISSIONS: (V BAND 895-960 MHZ) Neutral Side (L1) EMISSION FREQUENCY (MHz) TEST DETECTOR (1) ANALYZER READING (dBuV) SITE CORRECTION FACTOR (dBuV) CORRECTED EMISSION LEVEL (dBuV) FCC LIMIT (dBuV) FCC MARGIN (dBuV) 0.451Pk42.70.543.248.0-4.8 0.625Pk35.00.535.548.0-12.5 0.690Pk36.80.537.348.0-10.7 5.892Pk24.41.726.148.0-21.9 12.312Pk19.02.221.248.0-26.8 23.691Pk22.73.025.748.0-22.3 Hot Side (L2) 0.452Pk41.80.442.248.0-5.8 0.663Pk36.70.537.248.0-10.8 1.004Pk25.60.626.248.0-21.8 7.147Pk27.71.829.548.0-18.5 8.055Pk23.72.025.748.0-22.3 15.028Pk26.02.728.748.0-19.3 Input frequency = 947.5 MHz (1) Pk = Peak; QP = Quasi-Peak; Av = Average TEST PERSONNEL: Signature: Date:2/17/99 Typed/Printed Name: K. Franck Schuppius 24 TABLE 17: RADIATED EMISSIONS: 895 MHZ (Temperature: 46°F Degree, Humidity: 29%) EMISSION FREQUENCY (MHz) ANTENNA POLARITY (H/V) TURNTABLE AZIMUTH (deg) ANTENNA HEIGHT (m) ANALYZER READING (dBuV) SITE CORRECTION FACTOR (dB/m) EMISSION LEVEL (dBuV/m) FCC LIMIT (dBuV/ m) FCC MARGIN (dB) 855.850H1801.044.0-2.741.346.0-4.7 TABLE 18: RADIATED EMISSIONS: 947.5 MHZ (Temperature: 46°F Degree, Humidity: 29%) EMISSION FREQUENCY (MHz) ANTENNA POLARITY (H/V) TURNTABLE AZIMUTH (deg) ANTENNA HEIGHT (m) ANALYZER READING (dBuV) SITE CORRECTION FACTOR (dB/m) EMISSION LEVEL (dBuV/m) FCC LIMIT (dBuV/ m) FCC MARGIN (dB) 908.350H1351.042.0-1.440.646.0-5.4 *All readings are quasi-peak, unless stated otherwise. See Appendix B for Radiated Test Methodology. TEST PERSONNEL: Signature: Date:February 19, 1999 Typed/Printed Name: K. Franck Schuppius

5.0CONDUCTED MEASUREMENT PHOTOS 7.0RADIATED MEASUREMENT PHOTOS