IR5RK786EXNotebook Computer

NOTEBOOK COMPUTER RK786 USER’S GUIDE Copyright © 2004 All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language, or computer language, in any form, or by any means, electronic, mechanical, magnetic, optical, chemical, or other, without the prior written permission of the manufacturer. The manufacturer reserves the right to revise this publication and to make changes to the contents hereof without obligation to notify any person of such revision or changes. The manufacturer makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties as to merchantability or fitness for any particular purpose. Any of the software described in this manual is sold or licensed "as is". Should the programs prove defective following purchase, the buyer (and not the manufacturer, its distributor, or its dealer), assumes the entire cost of all necessary servicing, repair and any incidental or consequential damages resulting from any software defects. Trademark Acknowledgments IBM, PC, AT, XT are registered trademarks of International Business Machines Corp. MS-DOS and Windows are registered trademarks of Microsoft Corp. Pentium is the registered trademark of Intel Corp. All product and company names are trademarks or registered trademarks of their respective holders. Federal Communications Commission Statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ---Reorient or relocate the receiving antenna. ---Increase the separation between the equipment and receiver. ---Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ---Consult the dealer or an experienced radio/TV technician for help. Regulatory information / Disclaimers Any changes or modifications (including the antennas) made to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment. Safety Information In order to maintain compliance with the FCC RF exposure guidelines, this equipment should be installed and operated with minimum distance 20cm between the radiator and your body. Use only with supplied antenna. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. CE Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms: EN 55022 ( CISPR 22 ) Radio Frequency Interference EN 55024 ( EN61000-4-2, EN61000-4-3, EN61000-4-4, EN61000-4-5, EN61000-4-6,EN61000-4-8,EN61000-4-11,EN61000-3-2, EN61000-3-3) Generic Immunity Standard EN 60950 ( IEC950 ) Product Safety R&TTE (CE) MANUAL REGULATORY REQUIREMENT (WLAN - IEEE 802.11b/g) 802.11b/g Restrictions: European standards dictate maximum radiated transmit power of 100mW EIRP and frequency range 2.400-2.4835GHz. In France, the equipment must be restricted to the 2.4465-2.4835GHz frequency range and must be restricted to indoor use. CE Declaration of Conformity Is herewith confirmed to comply with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating to Electromagnetic Compatibility (89/336/EEC), Low- voltage Directive (73/23/EEC) and the Amendment Directive (93/68/EEC), the procedures given in European Council Directive 99/5/EC and 89/336EEC. The equipment was passed. The test was performed according to the following European standards. EN 300 328 V.1.4.1 (2003-04) EN 301 489-1 V.1.4.1 (2002-04) / EN 301 489-17 V.1.2.1 (2002-04) EN 50371:2002 EN 60950:2000 UL, TÜV AC Adapter (TÜV includes EN60950 LVD) E-Mark Registered: e13 Power Conservation This computer consumes much less power than conventional computers; however, power consumption may be reduced by properly configuring the Power Management Setups. It is recommended that the power saving functions be enabled even when not running on battery power. Power Management generally does not degrade system performance while saving power. Material Safety and Recycling All materials used in the construction of this unit are recyclable or environmentally friendly. No CFC or related materials were used in the manufacturing process or inside the product. Please recycle the packing materials, and at the end of the computer's life, all other materials in accordance with the local regulations. Please refer “Material and Recycling” for the contents of the materials. CONTENTS GETTING STARTED............................................................................................ 1 UNPACKING........................................................................................................................... 1 QUICK OPERATION............................................................................................................ 2 CONTROLS AND INDICATORS....................................................................................... 3 USEFUL INFORMATION...............................................................................…

Text truncated - open the document above for the full version.

Confidentiality Letter October 27, 2004 Federal Communications Commission Authorization and Evaluation Division FCC ID: IR5RK786EX Confidentiality Request Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, the Applicant hereby requests confidential treatment of information accompanying this Application as outlined below: 1. Schematics 2. Operational description 3. Block diagram The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457, disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Name: Willie Title: Sr. Engineer CReTE SYSTEM INC.

Power of Attorney Date: October 27, 2004 We, the undersigned, hereby authorize Compliance Certification Services Inc. to act on our behalf in all matters relating to all processes related to FCC applications and communications issue. Any and all acts carried out by Compliance Certification Services Inc. on our behalf shall have the same effects as acts of our own. If you have any questions regarding this authorization, please don’t hesitate to contact us. Thank you. Sincerely yours, _____________________________ Name: Willie Title: Sr. Engineer CReTE SYSTEM INC.

Compliance Certification Services Inc. Report No: 40922002 Date of Issue: October 29, 2004 Page 1of 10 EXTERNAL PHOTOGRPHS OF EUT Compliance Certification Services Inc. Report No: 40922002 Date of Issue: October 29, 2004 Page 2 Compliance Certification Services Inc. Report No: 40922002 Date of Issue: October 29, 2004 Page 3 Compliance Certification Services Inc. Report No: 40922002 Date of Issue: October 29, 2004 Page 4

Compliance Certification Services Inc. Report No: 40922002 Date of Issue: October 29, 2004 Page 5 INTERNAL PHOTOGARPHS OF EUT Compliance Certification Services Inc. Report No: 40922002 Date of Issue: October 29, 2004 Page 6 Compliance Certification Services Inc. Report No: 40922002 Date of Issue: October 29, 2004 Page 7 Compliance Certification Services Inc. Report No: 40922002 Date of Issue: October 29, 2004 Page 8 Compliance Certification Services Inc. Report No: 40922002 Date of Issue: October 29, 2004 Page 9 Compliance Certification Services Inc. Report No: 40922002 Date of Issue: October 29, 2004 Page 10

Compliance Certification Services Inc. Report No.: 40922002-RP1 FCC ID: IR5RK786EX Date of Issue: October 29, 2004 Note: This report shall not be reproduced except in full, without the written approval of Compliance Certification Services Inc. This document may be altered or revised by Compliance Certification Services Inc. personnel only, and shall be noted in the revision section of the document. Page 1 of 64 FCC 47 CFR PART 15 SUBPART C TEST REPORT For CRETE SYSTEMS INC. Notebook Computer Model: RK786 Trade Name: CReTE Prepared for CRETE SYSTEMS INC. 7F, No.250, Sec.3, Pei Shen Rd., Shen Keng Hsiang, Taipei County, Taiwan. Prepared by Compliance Certification Services Inc. No. 81-1, Lane 210, Bade Rd. 2, Luchu Hsiang, Taoyuan Hsien, (338) Taiwan, R.O.C. TEL: 886-3-324-0332 FAX: 886-3-324-5235 Compliance Certification Services Inc. Report No.: 40922002-RP1 FCC ID: IR5RK786EX Date of Issue: October 29, 2004 Page 2 TABLE OF CONTENTS 1. TEST RESULT CERTIFICATION........................................................................................................3 2. EUT DESCRIPTION..............................................................................................................................4 3. TEST METHODOLOGY.......................................................................................................................5 3.1 EUT CONFIGURATION........................................................................................................................5 3.2 EUT EXERCISE....................................................................................................................................5 3.3 GENERAL TEST PROCEDURES.............................................................................................................5 3.4 FCC PART 15.205 RESTRICTED BANDS OF OPERATIONS........................................................6 3.5 DESCRIPTION OF TEST MODES...........................................................................................................6 4. INSTRUMENT CALIBRATION...........................................................................................................7 5. FACILITIES AND ACCREDITATIONS ..............................................................................................8 5.1 FACILITIES....................................................................................................................................... 8 5.2 EQUIPMENT........................................................................................................................................8 5.3 LABORATORY ACCREDITATIONS AND LISTING..................................................................................8 5.4 TABLE OF ACCREDITATIONS AND LISTINGS.......................................................................................9 6. SETUP OF EQUIPMENT UNDER TEST...........................................................................................10 6.1 SETUP CONFIGURATION OF EUT.......................................................................................................10 6.2 SUPPORT EQUIPMENT ...............................................................................................................10 7. FCC PART 15.247 REQUIREMENTS ................................................................................................11 7.1 6DB BANDWIDTH.............................................................................................................................11 7.2 PEAK POWER....................................................................................................................................16 7.3 BAND EDGES MEASUREMENT ................................................................................................21 7.4 PEAK POWER SPECTRAL DENSITY....................................................................................................22 7.5 RADIO FREQUENCY EXPOSURE........................................................................................................32 7.6 SPURIOUS EMISSIONS ................................................................................................................38 7.7 POWERLINE CONDUCTED EMISSIONS...............................................................................................60 APPENDIX 1 PHOTOGRPHS OF TEST SETUP......................................................................................63 Compliance Certification Services Inc. Report No.: 40922002-RP1 FCC ID: IR5RK786EX Date of Issue: October 29, 2004 Page 4 2. EUT DESCRIPTION Product Notebook Computer Trade Name CReTE Model Number RK786 Model Discrepancy N/A Power Supply (E.P.S.) INC. Model: F10903-A I/P: 100-240V, 1.2A, 50-60Hz O/P: 19V, 4.75A Battery: 9 x 18650 cells Lithium Ion 11.1V 6000mAH Frequency Range 2412 ~ 2462 MHz Transmit Power IEEE802.11b mode: 19.39 dBm IEEE802.11g mode: 14.30 dBm Modulation Technique IEEE802.11b: DSSS (CCK; DQPSK; DBPSK) IEEE802.11g: OFDM Transmit Data Rate IEEE802.11b: 1Mbps IEEE802.11g: 6Mbps Number of Channels 11 Channels Antenna Specification Patch Antenna Gain: -1.86 dBi Note: This submittal(s) (test report) is intended for FCC ID: IR5RK786EX filing to comply with Section 15.207, 15.209 and 15.247 of the FCC Part 15, Subpart C Rules. Compliance Certification Services Inc. Report No.: 40922002-RP1 FCC ID: IR5RK786EX Date of Issue: October 29, 2004 Page 5 3. TEST METHODOLOGY The tests documented in this report were performed in accordance with ANSI C63.4 and FCC CFR 47 2.1046, 2.1047, 2.1049, 2.1051, 2.1053, 2.1055, 2.1057, 15.207, 15.209 and 15.247. 3.1 EUT CONFIGURATION The EUT configuration for testing is installed on RF field strength measurement to meet the Commissions requirement and operating in a manner that intends to maximize its emission characteristics in a continuous normal application. 3.2 EUT EXERCISE The EUT was operated in the engineering mode to fix the TX frequency that was for t…

Text truncated - open the document above for the full version.

Compliance Certification Services Inc. Report No.: 40922002-RP1 FCC ID: IR5RK786EX Date of Issue: October 29, 2004 Page 63 APPENDIX 1 PHOTOGRPHS OF TEST SETUP Radiated Emission Set up Photos Compliance Certification Services Inc. Report No.: 40922002-RP1 FCC ID: IR5RK786EX Date of Issue: October 29, 2004 Page 64 Conducted Emission Set Up Photos