KNF6TXAutomotive Aftermarket Transmitter

® Installation Manual & Operation Instructions 6 Button Transmitter & Receiver (DK-6Button-TX & DK-Antenna) Limited Warranty Statement SPAL USA WARRANTY STATEMENT SPAL USA warrants this product to be free from defects in material and workmanship for a periodof one (1) year from the date of sale to the original purchaser, and not more than two (2) yearsfrom the date of manufacture. SPAL USA will repair this product free of charge if, in the judgment of SPAL USA, it has been proven defective within the warranty period. The productshould be returned, at the customer expense, to the location of original purchase. This warrantydoes not cover any expenses incurred in the removal and/or reinstallation of the product.This warranty does not apply to any product damaged by improper installation, accidental misuse, abuse, improper line voltage, fire, flood, lightning, or other acts of God, or a productaltered or repaired by anyone other than SPAL USA.This warranty is in lieu of other warranties, expressed or implied, including any implied warrantyof merchantability. No person is authorized to assume for SPAL USA any other liability concerning the sale of this product. IMPORTANT-KEEP YOUR INVOICE WITH THIS WARRANTY STATEMENT! SPAL USA, 512 Tuttle Street, Des Moines, IA 50309-4618 [email protected], www.spalusa.com Main/Sales: 800-345-0327, Sales: 888-SPAL-USA Te ch Support Line: 800-454-7725 06/04 "This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that maycause undesired operation." FCC IC ID#: XXXXXX-6TX (XXXXXX will be replaced with the company number issued by Canada) “The term “IC:” before the radio certification number only signifies that Industry Canadatechnical specifications were met. Industry Canada Caution: changes or modifications not expressly approved by SPAL USA will void theuser's authority to operate the equipment. Disclaimer Statement Frequency: 433.92 MHz T ypical Transmitter Battery Life: 1.5-3years T ransmitter Battery Used: One, model 23A (12V Alkaline) Number of Channels and type of activation: 6 channels with momentary activationProducts Size: 1.45”x2.65”x0.5” Receiver: 2”x6”x0.58” Other Features:• Water-resistant• Rubber buttons• Keychain loop Specifications Operation II I III VVI IV Channel 246 Oper ation: -To activate channel #1: Press the button labeled I-To activate channel #2: Press the button labeled II-To activate channel #3: Press the button labeled III-To activate channel #4: Press the button labeled IV-To activate channel #5: Press the button labeled V-To activate channel #6: Press the button labeled VI +5V GND DATA Channel 135 DK-Antenna +5V GND DATA Installation -Plug antenna/receiver into control module.-Program transmitters into control module as per manufacturers instructions. To replace the battery in the transmitter, you will need a small flat screwdriver. Insert the tip of the screwdriver into the hole thatthat is used to attached to your keychain and twist. Inside thecase you will find a PCB and battery. Make sure to avoid con-taminating the circuit board with liquids or oils because this couldharm the transmitter. Replacement batteries can be purchasedfrom SPAL USA or your local battery retailer. Battery Replacement

EXHIBIT 3 ENGINEER'S DECLARATION OF COMPLIANCE This equipment has been tested in accordance with the requirements contained in the appropriate Industry Canada regulations. To the best of my knowledge, these tests were performed using measurement procedures consistent with industry or Industry Canada standards and demonstrate that the equipment complies with appropriate standards. Each unit manufactured, imported or marketed as defined in the Industry Canada regulations, will conform to the sample(s) tested within the variations that can be expected due to quantity production and testing on a statistical basis. I further certify that the necessary measurements were made by: Dated this _______29th_______________ day of ______June_2004______________ Agency agreement expiration date: None By: Brian J. Mattson Signature Printed Title: General Manager - D.L.S. Electronic Systems, Inc. Telephone: 847-537-6400 Applicant: SPAL USA

Letter of Agency Date: July 2, 2004 American Telecommunications Certification Body, Inc. 6731 Whittier Avenue Suite C110 McLean, VA 22101 To Whom It May Concern: Please be advised that SPAL USA authorizes D.L.S. Electronic Systems, Inc. to act on our behalf, until otherwise notified, for applications submitted to American Telecommunications Certification Body, Inc. (ATCB). We certify that we are not subject to denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse ACT of 1988, U.S.C. 862. Further, no party, as defined in 47 CFR 1.2002(b), to the application is subject to denial of federal benefits, that includes FCC benefits. Thank you for your attention to this matter. Signatory, Arnom C. Rowe EMC ENGINEER EMC-001375-NE D.L.S. Electronic Systems, Inc. FCC Labeling Requirements and Information Date: July 2, 2004 American Telecommunications Certification Body, Inc. 6731 Whittier Avenue Suite C110 McLean, VA 22101 RE: FCC Labeling Requirements FCC ID: KNF6TX The following label information is required by the FCC Rules and Regulations for certified devices. Also attached, please find marketing information required by the FCC Rules and Regulations. Thank you for your attention to these matters. Sincerely, Arnom C. Rowe EMC ENGINEER EMC-001375-NE D.L.S. Electronic Systems, Inc. Request for Confidentiality Date: July 2, 2004 American Telecommunications Certification Body, Inc. 6731 Whittier Avenue Suite C110 McLean, VA 22101 RE: Certification Application FCC ID: KNF6TX Please be advised that the following information is to be held confidential and behalf of APPLICANT NAME: • Block Diagram • Schematics • Parts Lists The application contains technical information which SPAL USA deems to be trade secrets and proprietary. If made public, the information might be used to the disadvantage of the applicant in the market place. Thank you for your attention to this matter. Signatory Arnom C. Rowe EMC ENGINEER EMC-001375-NE D.L.S. Electronic Systems, Inc. Modification Letter Date: July 2, 2004 American Telecommunications Certification Body, Inc. 6731 Whittier Avenue Suite C110 McLean, VA 22101 RE: Certification Application FCC ID: KNF6TX Please be advised that the following information is a list of modifications that will be included in the production process for the above-referenced equipment. Change 1: There were no modifications made during testing. Change 2: Change 3: Change 4: Change 5: Change 6: Change 7: Change 8: Change 9 Change 10: Thank you for your attention to this matter. Signatory Arnom C. Rowe EMC ENGINEER EMC-001375-NE D.L.S. Electronic Systems, Inc. Manufacturer’s Letter Date: July 2, 2004 American Telecommunications Certification Body, Inc. 6731 Whittier Avenue Suite C110 McLean, VA 22101 RE: Certification Application FCC ID: KNF6TX To Whom It May Concern: Please be advised that the manufacturer will ensure that the above-referenced model will be manufactured in accordance with the FCC Rules and Regulations. Thank you for your attention to this matter. Signatory Arnom C. Rowe EMC ENGINEER EMC-001375-NE D.L.S. Electronic Systems, Inc.

FCC ID: KNF6TX D.L.S. ELECTRONIC SYSTEMS, INC. 1250 Peterson Drive Wheeling, Illinois 60090 FCC Authorization & Evaluation Division 7435 Oakland Mills Road Columbia, Maryland 21045-0429 Gentlemen: We are submitting for Iowa Export-Import, Inc., a 6 Button 433 MHz Transmitter, Model Number: DK-6BUTTON-TX, with a FCC ID: KNF6TX for Certification. This unit has been tested and complies to Part 15, Subpart C. If there are any questions in regards to this application, please call D.L.S. Electronic Systems, Inc. at (847) 537 6400. Enclosed you will find a copy of our test report with the information and results of tests that is required under Part 15, Section 15.231. Thank you for your assistance in this matter. Sincerely, Arnom C. Rowe EMC-001375-NE DLS/mm

Product: DK-ANTENNA & DK-6BUTTON-TX Operational description: This RF unit can be used to operate up to 6 functions, but only one function can be activated at a time. Pressing any one of the 6 buttons on the transmitter activates a channel. Each channel has momentary output, so the unit will output as long as you press the transmitter.

1250 Peterson Dr., Wheeling, IL 60090 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 FCC Rules and Regulations / Intentional Radiators Periodic operational in the 40.66-40.70 MHz Band and above 70 MHz. Part 15, Subpart C, Section 15.231 THE FOLLOWING ''MEETS'' THE ABOVE TEST SPECIFICATION Formal Name: 6 Button 433 MHz Transmitter Kind of Equipment: Automotive Aftermarket Test Configuration: NA Model Number(s): DK-6BUTTON-TX Model(s) Tested: DK-6BUTTON-TX Serial Number(s): NA Date of Tests: May 4 & 10, 2004 Test Conducted For: SPAL USA 512 Tuttle St Des Moines, Iowa 50309 NOTICE: “This report must not be used by the client to claim product endorsement by NVLAP or any agency of the U.S. Government”. Please see the "Additional Description of Equipment Under Test" page listed inside of this report. This report must not be reproduced (except in full), without the approval of D.L.S. Electronic Systems. Page - 1 - 1250 Peterson Dr., Wheeling, IL 60090 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 SIGNATURE PAGE Report By: Arnom C. Rowe Test Engineer EMC-001375-NE Reviewed By: William Stumpf OATS Manager Approved By: Brian Mattson General Manager Company Official: SPAL USA Page - 2 - 1250 Peterson Dr., Wheeling, IL 6009 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 Page -3- 1250 Peterson Dr., Wheeling, IL 6009 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 Page -4- 1250 Peterson Dr., Wheeling, IL 6009 Page -4- Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 1250 Peterson Dr., Wheeling, IL 6009 Page -5- Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 1250 Peterson Dr., Wheeling, IL 6009 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 Page -6- 1250 Peterson Dr., Wheeling, IL 6009 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 Page -7- 1250 Peterson Dr., Wheeling, IL 6009 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 Page -8- 1250 Peterson Dr., Wheeling, IL 6009 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 Page -9- 1250 Peterson Dr., Wheeling, IL 6009 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 Page -10- 1250 Peterson Dr., Wheeling, IL 6009 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 Page -11- 1250 Peterson Dr., Wheeling, IL 6009 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 Page -12- 1250 Peterson Dr., Wheeling, IL 6009 Company: SPAL USA Model Tested: DK-6BUTTON-TX Report Number: 10724 TABLE OF CONTENTS i. Cover Page.......................................................................................................................................1 ii. Signature Page.................................................................................................................................2 iii. NVLAP Certificate of Accreditation...............................................................................................3 iv. NVLAP Scope of Accreditation......................................................................................................4 v. Table of Contents...........................................................................................................................13 1.0 Summary of Test Report................................................................................................................14 2.0 Introduction....................................................................................................................................14 3.0 Object.............................................................................................................................................14 4.0 Test Set-Up....................................................................................................................................15 5.0 Test Equipment..............................................................................................................................16 6.0 Ambient Measurements.................................................................................................................17 7.0 Description of Test Sample............................................................................................................18 8.0 Additional Description of Test Sample..........................................................................................21 9.0 Photo Information and Test Set-Up...............................................................................................22 10.0 Radiated Photos Taken During Testing.........................................................................................23 11.0 Results of Tests..............................................................................................................................24 12.0 Conclusion.....................................................................................................................................24 TABLE 1 – EQUIPMENT LIST...............................................................................................................25 Appendix A – Electric Field Radiated Emissions Test..............................................................................27 1.0 Pulsed Operation (Duty Cycle Correction Factor).........................................................................28 1.0 Graph(s) taken of the Pulsed Operation (DCCF)...........................................................................29 2.0 Bandwidths....................................................................................................................................33 2.0 Graph(s) taken of the Bandwidth Emissions.................................................................................34 3.0 Field Strength of Spurious Emission Measurements.....................................................................36 3.0 Graph(s) taken of the …

Text truncated - open the document above for the full version.