M65NVTX464Remote Control Transmitter

T464 II Operation Manual NoticeThe changes or modifications not expressly approved by the party responsible for compliance could void the user , s authority to operate the equipment IMPORTANT NOTETo comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user , s authority to operate the operate the device.

1 Mike Kuo From: iris [[email protected]] Sent: December182003Thursday 6:41 PM To: Mike Kuo Subject: Re: SUPER NOVA CO., LTD., FCC ID:M65NVT464, AN03T3491 Exhibit-A-Block_Dia gram.pdf Exhibit-G-Circuit-Dia gram.pdf Hi Mike, Please see the attachment. The correct ID is M65NVTX464. And the Model is T464. Best Regards, Iris Lin ----- Original Message ----- From: "Mike Kuo" <[email protected]> To: "ETC/Iris (E-mail)" <[email protected]>; "Liou, S. S. (E-mail)" <[email protected]> Sent: Tuesday, December 16, 2003 6:49 AM Subject: FW: SUPER NOVA CO., LTD., FCC ID:M65NVT464, AN03T3491 > > > -----Original Message----- > From: CERTADM > Sent: Monday, December 15, 2003 2:48 PM > To: Mike Kuo > Subject: SUPER NOVA CO., LTD., FCC ID:M65NVT464, AN03T3491 > > > Notice_content > ------------- > Question #1: Block Diagram submitted is for the receiver not for the > transmitter. Please submit correct functional block diagram > > Question #2: FCC ID number on the FCC ID label format does not agree with > TCB application form and FCC ID listed in the test report. Please make > necessary correction. > > Best Regards > > Mike Kuo > The items indicated above must be submitted before processing can continue > on the above referenced application. Failure to provide the requested > information within 30 days of the original e-mail date may result in > application dismissal and forfeiture of the filing fee. Also, please note > that partial responses increase processing time and should not be submitted. > Any questions about the content of this correspondence should be directed to > the e-mail address listed below the name of the sender.

ETC Report No.:ET92R-11-065-01 FCC ID.: M65NVTX464 Rev. No 2.0 CONSTRUCTED PHOTOS of EUT Front View of EUT Rear View of EUT ETC Report No.:ET92R-11-065-01 FCC ID.: M65NVTX464 Rev. No 2.0 CONSTRUCTED PHOTOS of EUT Side View of EUT Side View of EUT

ETC Report No.:ET92R-11-065-01 FCC ID.: M65NVTX464 Rev. No 2.0 CONSTRUCTED PHOTOS of EUT Internal View of EUT ETC Report No.:ET92R-11-065-01 FCC ID.: M65NVTX464 Rev. No 2.0 CONSTRUCTED PHOTOS of EUT Component View of PCB Solder View of PCB

BUTTON 1A. Press and release to Arm/Disarm B. Press and hold for 4 seconds to activate panic mode. BUTTON 2A. Quickly press and release to Arm/Disarm with no siren chirp(silent). B. Press and hold for 2 seconds to activate AUX channel # 1. BUTTON 12Press together for 1.5 sec. To activate AUX channel # 2.

Rev. No 2.0 FCC Part 15 EMI TEST REPORT of E.U.T. : Transmitter FCC ID. : M65NVTX464 MODEL : T464 Working Frequency : 433.958 MHz for APPLICANT : SUPER NOVA CO., LTD. ADDRESS : No. 34 Wu-Chuan 6 Rd, Wu-Ku Industrial Zone, Wu-Ku Hsiang, Taipei Hsien, Taiwan, R.O.C. Test Performed by ELECTRONICS TESTING CENTER, TAIWAN NO. 34, LIN 5, DING FU TSUN, LINKOU HSIANG TAIPEI HSIEN, TAIWAN, R.O.C. Tel:(02)26023052 Fax:(02)26010910 Report Number : ET92R-11-065-01 ETC Report No.:ET92R-11-065-01 FCC ID.: M65NVTX464 Rev. No 2.0 TEST REPORT CERTIFICATION Applicant : SUPER NOVA CO., LTD. No. 34 Wu-Chuan 6 Rd, Wu-Ku Industrial Zone, Wu-Ku Hsiang, Taipei Hsien, Taiwan, R.O.C. Manufacturer : SUPER NOVA CO., LTD. No. 34 Wu-Chuan 6 Rd, Wu-Ku Industrial Zone, Wu-Ku Hsiang, Taipei Hsien, Taiwan, R.O.C. Description of EUT : a) Type of EUT : Transmitter b) Trade Name : ---- c) Model No. : T464 d) FCC ID : M65NVTX464 e) Working Frequency : 433.958 MHz f) Power Supply : DC 1.5V Regulation Applied : FCC Rules and Regulations Part 15 Subpart C (2002) I HEREBY CERTIFY THAT; The data shown in this report were made in accordance with the procedures given in ANSI C63.4 and the energy emitted by the device was founded to be within the limits applicable. I assume full responsibility for accuracy and completeness of these data. Note : 1. The results of the testing report relate only to the items tested. 2. The testing report shall not be reproduced except in full, without the written approval of ETC. Issued Date : Dec. 05, 2003 Test Engineer : ( Vincent Chang ) Approve & Authorized Signer : Will Yauo, Manager EMC Dept. II of ELECTRONICS TESTING CENTER, TAIWAN ETC Report No.:ET92R-11-065-01 FCC ID.: M65NVTX464 Rev. No 2.0 Table of Contents Page 1. GENERAL INFORMATION.....................................................................................................................................................1 1.1 P RODUCT D ESCRIPTION ...........................................................................................................................................................1 1.2 C HARACTERISTICS OF D EVICE :...............................................................................................................................................1 1.3 T EST M ETHODOLOGY ..............................................................................................................................................................1 1.4 T EST F ACILITY ..........................................................................................................................................................................1 2. DEFINITION AND LIMITS.......................................................................................................................................................2 2.1 D EFINITION ................................................................................................................................................................................2 2.2 R ESTRICTED B ANDS OF O PERATION .....................................................................................................................................2 2.3 L IMITATION ...............................................................................................................................................................................2 2.4 L ABELING R EQUIREMENT .......................................................................................................................................................4 2.5 U SER I NFORMATION .................................................................................................................................................................4 3 SYSTEM TEST CONFIGURATION.........................................................................................................................................5 3.1 J USTIFICATION ..........................................................................................................................................................................5 3.2 D EVICES FOR T ESTED S YSTEM ...............................................................................................................................................5 4. RADIATED EMISSION MEASUREMENT.............................................................................................................................6 4.1 A PPLICABLE S TANDARD .........................................................................................................................................................6 4.2 M EASUREMENT P ROCEDURE ..................................................................................................................................................6 4.3 T EST D ATA .................................................................................................................................................................................8 4.3.1 Tx Protion..........................................................................................................................................................................8 4.3.2 Other Emissions...............................................................................................................................................................9 4.4 F IELD S TRENGTH C ALCULATION ..........................................................................................................................................9 4.5 A CTIVATE T IME ........................................................................................................................................................................9 4.6 C ALCULATION OF D UTY F ACTOR .........................................................................................................................................9 4.8 M EASURING I NSTRUMENT S ETUP .................................................................…

Text truncated - open the document above for the full version.

ETC Report No.:ET92R-11-065-01 FCC ID.: M65NVTX464 Rev. No 2.0 4.9 Radiated Measurement Photos