MSAB15GF-1LCD Monitor

Printed in KoreaPart No. 942205020001-01 www.hansolel.co.kr TFT-LCD Color Monitor USER'S MANUAL 15 Printed on the recyclable paper Parts 3 Connection to Signal Source 4 the range of control Angle 5 Installing Monitor Driver 6 Name and Function of Front 8 Power Management Feature 10 Adjusting OSD 11 Standard Signal Table 18 Specification 19 Troubleshooting 20 Warning 22 Table of Contents INFORMATION TO USER : This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmfulinterference in a residential installation.This equipment generates, uses and canradiate radio frequency energy and,if not installed and used in accordance withthe instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particularinstallation; if this equipment does cause harmful interference to radio ortelevision reception, which can be determined by determined by turning theequipment off and on, the user is encouraged to try to crrent the interference byone or more of the fllowing measures: 1. Reorient/Relocate the receiving antenna.2. Increase the separation between the equipment and receiver.3. Connect the equipment into an outlet on a circuit difference from that to which the recerver is connected. 4. Consult the dealer or an experienced radio/TV technician for help. CAUTION Changes or modifications not expressly approved by themanufacturer responsible for compliance could void the user's authority to operate the equipment ENERGY STAR As an ENERGY STAR partner, Hansol Electronics Inc. has determined that this product meets energy Star guidelines for energy efficiency. English - 3 2 - English Parts LCD Monitor Place the monitor to face the user and then adjust the monitor angle.Take a break (for about 10 minutes) at every hour during the work with monitor. Refer to the following figure to take the correct posture. about 50cm Look down the monitor below the horizon. Relax shoulders and arms, and sit back on the chair. Adjust the monitor to prevent reflection. Adjust the monitor stand to acquire required angle. Keep feet flat on the ground. Maintain the arms horizontally and place hands softly on the keyboard. Good Posture Guide User's Manual / Warranty Card Signal Cable AC Power Cable Installation Diskette Stereo Cable(Option) English - 5 4 - English Connection to Signal Source T he range of control Angle Basic Connection How to Adjust the Stand Forward 4 Default Backward 31 1. Use 220 V or 110 V. (Free Voltage)2. Connect monitor and Signal Source via Signal cable3. Power on the monitor and computer.4. Connection is finished. General For Macintosh Adapter for Macintosh (Optional)Refer to the table on the rear side ofthe optional Macintosh adapter andadjust DIP switch by the resolution. Port for AC power cable Port for Audio cable from a udio source. Port for Head Phone or External SpeakerPort for signal cable from signal source. < Power source connection > < Signal cable connection> English - 7 6 - English Click 'Finish'. Click 'Next>'. Click 'Advanced..'. Click 'Next>'. Click 'Monitor'. Click 'Change..'. Click 'Display a list of all...'.Click 'Next>'. Click 'Have Disk..'. Select the driver and click 'OK'. Click 'Next>'. 3. Select "Exit" if the monitor model is changed, and then reboot the Windows. Installing Monitor Driver 1. Insert the Diskette to the Floppy Diskette driver. 2. Double-click "Install.exe". 3. Select the model and click "OK" button.4. Select inf file, and then click "OK" button.5. Click "Exit" button to close the installation. Automatic Installation Manual Installation 1. Insert the Diskette to the Floppy Diskette driver.2. Click 'My Computer' and follow the procedure below. Click 'Control Panel'. Click 'Display'. Click 'Settings'. Run (Click) "Install" at Floppy Diskette driver and select the model name toset the optimum display in Window 95, 98 or 2000, XP. Use the Driver provided. +/ -/ English - 9 8 - English Power button Power button is located in the lower center of the Front Bezel.You can push the button to turn on/off the power. Power Indicating LED Dark : Power off Green : Normal modeGreen blinking : DPMS mode or Check Signal Cable mode. On Screen Display (OSD) Function Button OSD buttons on the front of bezel perform the following functions. MUTE : Press this button for mute controlMENU/EXIT : Press this button to display menus. if you press this button when OSD is displayed, you can switch display to the previous menu and exit menu. SELECT/ AUTO : Press this button, when OSD is not displayed, to perform automatic setting. When OSD is displayed, You can select icons. POWER : Power button. : By pressing these button when OSD is displayed, You can move cursor into the menus which you want. After press the SELECT button, you can change gauge level or select submenus.When OSD is not displayed, you can adjust brightness or contrast. VOLUME : Press this button for volume control Name and Function of Front Front panel Functions SELECT/ AUTO BUTTON MENU/EXIT BUTTON MUTE BUTTON VOL BUTTON +/ BUTTON BUTTON POWER BUTTON -/ English - 11 10 - English No image is displayed with Green blinking. Monitor is in power saving mode.Use mouse or keyboard to release power saving mode. No image is displayed without LED on. Power cable plug must be pulled out.Check the power plug on monitor and on the wall. "Out of range" displayed on the screen. This message is displayed when the signal from video card exceeds themaximum frequency of the monitor. Readjust resolution and frequency inaccordance with the monitor capacity. (Refer to Standard Signal Table) Power Management Feature The monitor is equipped with a power saving circuit that confirms to the world-standard Display Power Manager Signalling(DPMS) mode of Video Electronics Standard Association (VESA).The power management feature requires th…

Text truncated - open the document above for the full version.

Block -Diagram(B15GF-1) MRTMASCOTV) : EmbeddedADC ANALOG RGB ( PC) AUDIO IN/O UT

      





































  
 



 

 



   
!"
9# 
      





































  
 



 
!"  9#  

Made in KOREA HJ HS Manufactured: ELECTRICAL RATING AC 100 -240V 50/60 Hz, 0.45A CAUTION TO PREVENT ELECTRIC SHOCK, DO NOT REMOVE COVER, NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. ATTENTION AFIN D’EVITER TOUT RISQUE D’ELECTROCUTION, NE PAS ENLEVER L’ARRIERE. AUCUNE PIECE REPARABLE PAR L’USAGER A L’INTERIEUR. POUR REPARATIONS, APPELER UN TECHNICIEN QUALIFIE. FCC ID : MSA B15GF -1 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions. 1) This device may not cause harmful interference and 2) This device must accept any interference received, including interference that may cause undesired operation. MODEL Name : H550 MODEL No. : B15 GF Hansol Electronics Inc. 27-29 Hanchon-Ri Duksan-Myun Jinchon-Kun Choongbuk, KOREA

      





































  
 





 


 













  2  325 2 3permanently affixed      2 = 3  =32 2 2           



!"
  #  

   

      





































  
 



 
!" 9# 1  
      





































  
 



 
!" 9# 4  
      





































  
 



 
!"
9#! (   
      





































  
 



 
•  9#! (    
      





































  
 



 
•
9#:( 
 
      





































  
 



 
•  9#:( 


      





































  
 



 
•
9#   
      





































  
 



 
•  9#   
      





































  
 



 
• 
9#5(   
      





































  
 



 
•  9#5(   

      





































  
 





     
             




!"




   

 Manufacturer: Hansol Electronics Inc. Dates of Issue : January 23, 2003 #27-29, Hanchun-ri, Ducksan-Myun, Test Report No. : NK2DE036
      Test Site : Nemko Korea Co., Ltd. Attn      EMC site, Korea FCC ID Brand Name Contact Person












 





















  















 












!

"
# 



                                         !"#$%%&!                               '    !            (       ' !            !"    # $    % & $ 












 



 ' $'  ( )*+*,  -
          '.  /   01* 23 435 1453

      





































  
 



 

 

                
     
              
!   !   "#! !   $ !   !!  %     &'(  $ !    &('    !   &')  )#   '   &' )  )   &' *!    &
')!   ! + , - . / 0 12 11 1+ 1, 1- 13 1. 1/ 10 41 ++ +, 

      





































  
 



 




 

Measurement and determination of electromagnetic emissions (EME) of radio frequency devices including intentional and/or unintentional radiators for compliance with the technical rules and regulations of the Federal Communications Commission under FCC part 15.
Responsible Party* : Contact Person : Manufacturer :
        
     !"#
 $%! #&% '!(%#)  $%!*%# +$,%'#*  Tel No .: 

!"
 #$%&'
!"   (  
!" !

"
# 
!"    !"  !"  !"  !"  !"  
 
 !"# $ % &'( )!**$ +  !",$--(+  !',$--(   ./  ,0 1& /$-('







      





































  
 



 

   
 2      3  %    &  12   1    4    0546 7   8    2 7*.9:)-;9:% &'( )4!**$5       7            7
    

 




 2    5   
          2 
             2    ./   0 1&             "-. (- 2  &   %/ %,  (-. !< 242    &     2=   3        52 3    7    8   = 3    2 8       2  7 &1 =    2     2     5  3   52  28  
$ *)<   7% &'( ) >3!*,!**$ 































7 ! 2  3=252& / =    





 
   





 









 
 !"!"
#$ !
!"$% 
&&'()
*+,(-
. /+,(-

      





































  
 







 


  


  
25   325  2 ?9@      2     ?9@      ?9@   ,2 2      25 2  3=                00,1  ()- ! <  2  %5 3  &A BC;;'!& 1  9 ,
1&%!";
4! ! "  2  %5 3 ! < 2  43 3 &A  A% /3   ; ,1 "!<! ! <  2    3  &A  A% &1 072,1 14)<  ! " 2   3  &A  A% & .! "  2   3&A  A%   9,1  "<B-% ! "  2  %5 3  ! < &2 43 3 &A &;<<!(!;D

      





































  
 




 …

Text truncated - open the document above for the full version.

      





































  
 





 



   
  2
"
1 $
"
1 25254  7     3      !"    !"     
      





































  
 



 


!"   

!"