NBF-AI-68X1Handheld Barcode Scanner

AI-6821 2D Scanner User Guide i Regulatory Compliance This device complies with Part 15 of the FCC Rules. Operation shall be subject to the following two conditions: (1) This device may not cause harmful interface, and (2) This device must accept any interface received, including interface that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. ii -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/ TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. Note All brands and trademarks shall belong to their respective owner. Note Specification is subject to changes without notice. RF EXPOSURE WARNING: The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment. The equipment must not be co-located or operating in conjunction with any other antenna or transmitter. iii 警告： 電池若未妥善處理， 可能會導致爆炸。 請勿拆卸電池， 或用火銷毀電池。 請將電池放置於兒童拿不 到的地方。 請使用專用充電器充電， 並請依照當地政府或法 律規定妥善處理廢棄電池。 CAUTION: EXPLOSION HAZARD Do not disassemble, short circuit, heat the battery or dispose of in fire. Store battery pack in a proper place. Do not expose to temperature above 60°C/140°F. Use specified charger only. Please dispose of the used batteries following the rules or laws issued by the local government. iv Contents 1 Introduction .......................................................... 1 1.1 Unpacking ........................................................ 1 1.2 Understand your scanner ................................ 3 1.2.1 Scanner ..................................................... 3 1.2.2 Cradle ........................................................ 4 1.3 Indicators......................................................... 5 1.3.1 Status lights ............................................... 5 1.3.2 Status sound ............................................. 6 1.3.3 Vibration ................................................... 6 2 Get started ............................................................ 7 2.1 Installation....................................................... 7 2.1.1 Set up your scanner .................................. 7 2.1.2 How to scan .............................................. 9 2.1.3 Work with the ASCII table ....................... 10 2.1.4 Search your scanner................................ 10 2.2 Battery ........................................................... 10 2.2.1 Charge the battery .................................. 11 2.2.2 Replace the battery................................. 11 2.3 Connection .................................................... 14 2.3.1 Connect to your cradle again .................. 14 2.3.2 Connect to a Bluetooth adapter ............. 14 2.3.3 Connect to a mobile device .................... 18 Connect to an iOS device ........................ 18 Connect to an Android device ................ 20 3 Controls and settings........................................... 23 3.1 Data transmission .......................................... 23 3.1.1 Character length ..................................... 23 3.1.2 Name of the bar code type ..................... 24 v 3.1.3 AIM symbology ID ................................... 24 3.1.4 Acknowledge timeout ............................. 25 3.1.5 Prefix and suffix ...................................... 27 3.2 Volume and vibration .................................... 28 3.2.1 Good scan beep duration ....................... 28 3.2.2 Inquiry beep (cradle only) ....................... 29 3.2.3 Scan volume ............................................ 31 3.2.4 Vibration ................................................. 32 3.2.5 Power on alert ........................................ 33 3.3 Operating mode ............................................ 34 3.3.1 Handcuff mode ....................................... 34 3.3.2 Batch mode ............................................. 35 3.3.3 Sleep mode (cradle only) ........................ 36 3.3.4 Auto-sensing mode ................................. 37 3.4 Interface selection (cradle only) .................... 37 3.4.1 HID setting .............................................. 38 Country (cradle only) .............................. 38 Caps Lock (cradle only) ........................... 40 Function key (cradle only) ....................... 41 Alphanumeric keys (cradle only) ............. 42 3.4.2 RS-232 settings ....................................... 43 Flow control (cradle only) ....................... 43 Response delay (cradle only) .................. 44 Baud (cradle only) ................................... 46 Parity check (cradle only) ........................ 46 3.5 Update firmware ........................................... 49 Install driver ............................................ 55 3.6 Miscellaneous ............................................... 57 3.6.1 Status lights control ................................ 57 3.6.2 Fill-in light intensity ................................ 57 vi …

Text truncated - open the document above for the full version.

Argox Information Co.,Ltd. 7F., No.126, Ln. 235, Baociao Rd., Sindian Dist., New Taipei City 231, Taiwan (R.O.C.) TEL No: 886-2-8912-1121 FAX No: 886-2-8912-1124 Attestation for FCC Declaration of Conformity FCC ID: NBF-AI-68X1 Data: Sep. 18, 2015 Please be notified that we, the undersigned, Argox Information Co.,Ltd., declares that the product which bears the above FCC ID is also compliant with the FCC requirements for DoC. The test report number supporting the DoC is 1580057R-ITUSP01V00. Testing in regards to this report was done by QuieTek Corporation, located at 2F, No.345, Xinhu 2nd Rd., Neihu District,Taipei City 114,Taiwan,R.O.C. which has been accredited in accordance to all of the requirements of 47CFR 2.948 (d) and (e) of the FCC rules and KDB349827. Sincerely, ------------------------------------------------------------------------ Rickly Chou / Program Manager Argox Information Co.,Ltd. Tel: 886-2-8912-1121 Fax: 886-2-8912-1124 Email: [email protected]

Report No.: 1580057R-RFUSP03V00 Page : 1 of 21 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 2 of 21 (3) EUT Photo

Argox Information Co.,Ltd. FCC ID.: NBF-AI-68X1 7F., No.126, Ln. 235, Baociao Rd., Sindian Dist., New Taipei City 231, Taiwan (R.O.C.) Tel : 886-2-8912-1121 FCC ID Label

Argox Information Co.,Ltd. FCC ID.: NBF-AI-68X1 7F., No.126, Ln. 235, Baociao Rd., Sindian Dist., New Taipei City 231, Taiwan (R.O.C.) Tel : 886-2-8912-1121 The FCC ID will be placed on the equipment as shown in the photograph below.

Report No.: 1580057R-RFUSP03V00 Page : 3 of 21 (4) EUT Photo (5) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 4 of 21 (6) EUT Photo (7) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 5 of 21 (8) EUT Photo (9) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 6 of 21 (10) EUT Photo (11) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 7 of 21 (12) EUT Photo (13) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 8 of 21 (14) EUT Photo (15) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 9 of 21 (16) EUT Photo (17) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 10 of 21 (18) EUT Photo (19) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 11 of 21 (20) EUT Photo (21) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 12 of 21 (22) EUT Photo (23) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 13 of 21 (24) EUT Photo (25) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 14 of 21 (26) EUT Photo (27) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 15 of 21 (28) EUT Photo (29) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 16 of 21 (30) EUT Photo (31) EUT Photo TX Antenna Report No.: 1580057R-RFUSP03V00 Page : 17 of 21 (32) EUT Photo (33) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 18 of 21 (34) EUT Photo (35) EUT Photo RF Chip Report No.: 1580057R-RFUSP03V00 Page : 19 of 21 (36) EUT Photo (37) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 20 of 21 (38) EUT Photo (39) EUT Photo Report No.: 1580057R-RFUSP03V00 Page : 21 of 21 (40) EUT Photo (41) EUT Photo

RF Exposure Statement 1. Standard Applicable According to 1.1307 (b)(1), systems operating under the provisions of this section shall be operated in a manner that ensure that the public is not exposed to radio frequency energy level in excess of the Commission’s guideline. 2. Measurement Result: According to KDB 447498 D01 Mobile Portable RF Exposure v05, Operation frequency = 2450MHz and antenna separation distance = 5mm, SAR Test Exclusion Threshold = 10mW The Device max peak output power = 6.61dBm, Equivalent to 4.58mW and less than 10mW The SAR/MPE measurement is not necessary.

Report No.: 1580057R-RFUSP03V00 Page: 1 of 60 FCC Test Report Product Name Handheld Barcode Scanner Model No. AI-68XX Scanner (X can be 0-9, A-Z, or blank) FCC ID. NBF-AI-68X1 Applicant Argox Information Co.,Ltd. Address 7F., No.126, Ln. 235, Baociao Rd., Sindian Dist., New Taipei City 231, Taiwan (R.O.C.) Date of Receipt July 20, 2015 Issued Date Aug. 28, 2015 Report No. 1580057R-RFUSP03V00 Report Version V1.0 The test results relate only to the samples tested. The test results shown in the test report are traceable to the national/international standard through the calibration report of the equipment and evaluated measurement uncertainty herein. This report must not be used to claim product endorsement by TAF or any agency of the government. The test report shall not be reproduced without the written approval of QuieTek Corporation. Report No.: 1580057R-RFUSP03V00 Page: 2 of 60 Test Report Issued Date: Aug. 28, 2015 Report No.: 1580057R-RFUSP03V00 Product Name Handheld Barcode Scanner Applicant Argox Information Co.,Ltd. Address 7F., No.126, Ln. 235, Baociao Rd., Sindian Dist., New Taipei City 231, Taiwan (R.O.C.) Manufacturer Argox Information Co.,Ltd. Model No. AI-68XX Scanner (X can be 0-9, A-Z, or blank) FCC ID. NBF-AI-68X1 EUT Rated Voltage By Battery 3.7V EUT Test Voltage By Battery 3.7V Trade Name ARGOX Applicable Standard FCC CFR Title 47 Part 15 Subpart C: 2014 ANSI C63.4: 2014, ANSI C63.10: 2013 Test Result Complied Documented By : ( Senior Adm. Specialist / Genie Chang ) Tested By : ( Assistant Engineer / Nick Chen ) Approved By : ( Director / Vincent Lin ) Report No.: 1580057R-RFUSP03V00 Page: 3 of 60 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION ...............................................................................................................5 1.1. EUT Description......................................................................................................................................5 1.2. Operational Description...........................................................................................................................7 1.3. Tested System Details..............................................................................................................................8 1.4. Configuration of Tested System ..............................................................................................................8 1.5. EUT Exercise Software ...........................................................................................................................8 1.6. Test Facility .............................................................................................................................................9 2. CONDUCTED EMISSION ................................................................................................................10 2.1. Test Equipment ......................................................................................................................................10 2.2. Test Setup ..............................................................................................................................................10 2.3. Limits.....................................................................................................................................................11 2.4. Test Procedure .......................................................................................................................................11 2.5. Uncertainty ............................................................................................................................................11 2.6. Test Result of Conducted Emission .......................................................................................................12 3. PEAK POWER OUTPUT ..................................................................................................................13 3.1. Test Equipment ......................................................................................................................................13 3.2. Test Setup ..............................................................................................................................................13 3.3. Limit .....................................................................................................................................................13 3.4. Test Procedure .......................................................................................................................................13 3.5. Uncertainty ............................................................................................................................................13 3.6. Test Result of Peak Power Output .........................................................................................................14 4. RADIATED EMISSION .....................................................................................................................16 4.1. Test Equipment ......................................................................................................................................16 4.2. Test Setup ..............................................................................................................................................16 4.3. Limits.....................................................................................................................................................17 4.4. Test Procedure .......................................................................................................................................18 4.5. Uncertainty ............................................................................................................................................18 4.6. Test Result of Radiated Emission ..........................................................................................................19 5. RF ANTE…

Text truncated - open the document above for the full version.

Report No.: 1580057R-RFUSP03V00 Page : 1 of 2 Attachment 1: EUT Test Setup Photographs Front View of Radiated Test Back View of Radiated Test Report No.: 1580057R-RFUSP03V00 Page : 2 of 2 Front View of Radiated Test (Horn) Back View of Radiated Test (Horn)