
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
Userβs Manual PA-20 Portable Data Terminals DOC NO. UM-P2005-01 Sep. 2009 Version 1.1 Empower the Bar Code II CAUTION: This userβs manual may be revised or withdrawn any time without prior notice. Copyright 2008, Argox Information Co., Ltd. All rights reserved. This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or converted to any electronic or machine readable form without prior written consent of Argox. Limited warranty and disclaimers By opening the package of this product you agree to become bound by the liability and warranty conditions as described below. Under all circumstances this manual should be read attentively before installing and or using the product. In no event, Argox will be liable for any direct, indirect, consequential or incidental damages arising out of use or inability to use both the hardware and software, even if Argox has been informed about the possibility of such damages. A series number appears on all Argox products. This official registration number is strictly related to the device purchased. Make sure that the serial number appearing on your Argox device has not been removed. Servicing by our service department can only be carried out under warranty. All Argox products are warranted for the legal warranty period after purchase, covering defects in material and workmanship. Argox will repair or, at its opinion, replace products that prove to be defective in material or workmanship under proper use during the warranty period. Argox will not be liable in case modifications are made by the customer. In such case the standard repair charge will be applicable. The standard charge for repair will also be applicable in case no defect is found at all. These rules also apply for products that are still under warranty. Therefore, you are advised to have the product specifications always at hand. Trademarks used are property of their respective owners. The general use and functioning of the terminal together with the cradle will be described in this manual. The exact behaviour of the terminal depends on the user application that is running. For instructions about applications please consult the documentation of that software. Please read this manual carefully before using the terminal, to maximize the efficiency of this terminal. III FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/ TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF exposure warning This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. IV Table of Content 1. INTRODUCTION ..................................................................................................1 1.1 ABOUT THIS MANUAL .....................................................................................1 1.2 USER AND PRODUCT SAFETY .........................................................................2 1.3 SPECIFICATIONS .............................................................................................4 2. GETTING STARTED ...........................................................................................6 2.1 CHECK THE PACKAGE ....................................................................................6 2.1.1 PDT Package .......................................................................................6 2.1.2 Cradle Package ....................................................................................7 2.2 DETAILED VIEW .............................................................................................8 2.2.1 Terminal ...............................................................................................8 2.2.2 Cradle ..................................................................................................9 2.3 ASSEMBLY ..................................................................................................... 10 2.3.1 Terminal ............................................................................................. 10 2.3.2 Cradle ................................................................................................ 11 2.4 INSTALLING, REPLACING AND CHARGING BATTERIES ...β¦
Text truncated - open the document above for the full version.
Report No.: 1410049R-RFUSP01V00 Page : 1 of 16 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 2 of 16 (3) EUT Photo (4) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 3 of 16 (5) EUT Photo (6) EUT Photo
Argox Information Co.,Ltd. FCC ID.: XGIFBE1 7F., No.126, Ln. 235, Baociao Rd., Sindian Dist., New Taipei City 231, Taiwan (R.O.C.) Tel : 886-2-8912-1121 FCC ID Label
Report No.: 1410049R-RFUSP01V00 Page : 4 of 16 (7) EUT Photo (8) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 5 of 16 (9) EUT Photo (10) EUT Photo Antenna Report No.: 1410049R-RFUSP01V00 Page : 6 of 16 (11) EUT Photo (12) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 7 of 16 (13) EUT Photo (14) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 8 of 16 (15) EUT Photo (BT Module) (16) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 9 of 16 (17) EUT Photo (18) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 10 of 16 (19) EUT Photo (20) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 11 of 16 (21) EUT Photo (22) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 12 of 16 (23) EUT Photo (24) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 13 of 16 (25) EUT Photo (26) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 14 of 16 (27) EUT Photo (28) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 15 of 16 (29) EUT Photo (30) EUT Photo Report No.: 1410049R-RFUSP01V00 Page : 16 of 16 (31) EUT Photo
Report No. 1410049R-RFUSP01V00 Page: 1 of 3 RF Exposure Evaluation declaration Product Name Mobile Computer Model No. PA-2010,PA-2110 FCC ID NBF-PA-2X10 Applicant Argox Information Co.,Ltd. Address 7F., No.126, Ln. 235, Baociao Rd., Sindian Dist., New Taipei City 231, Taiwan (R.O.C.) Date of Receipt Dec. 27, 2013 Date of Declaration Jan. 28, 2014 Report No. 1410049R-RFUSP01V00 The declaration results relate only to the samples calculated. The declaration shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by TAF any agency of the U.S. Government Report No. 1410049R-RFUSP01V00 Page: 2 of 3 1. RF Exposure Evaluation 1.1. Limits According to FCC 1.1310: The criteria listed in the following table shall be used to evaluate the environment impact of human exposure to radio frequency (RF) radiation as specified in 1.1307(b) LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) Frequency Range (MHz) Electric Field Strength (V/m) Magnetic Field Strength (A/m) Power Density (mW/cm 2 ) Average Time (Minutes) (A) Limits for Occupational/ Control Exposures 300-1500 -- -- F/300 6 1500-100,000 -- -- 5 6 (B) Limits for General Population/ Uncontrolled Exposures 300-1500 -- -- F/1500 6 1500-100,000 -- -- 1 30 F= Frequency in MHz Friis Formula Friis transmission formula: Pd = (Pout*G)/(4*pi*r 2 ) Where Pd = power density in mW/cm 2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 R = distance between observation point and center of the radiator in cm Pd id the limit of MPE, 1 mW/cm 2 . If we know the maximum gain of the antenna and the total power input to the antenna, through the calculation, we will know the distance r where the MPE limit is reached. 1.2. Test Procedure Software provided by client enabled the EUT to transmit and receive data at lowest, middle and highest channel individually. The temperature and related humidity: 18Β°Cand 78οΌ RH. Report No. 1410049R-RFUSP01V00 Page: 3 of 3 1.3. Test Result of RF Exposure Evaluation Product : Mobile Computer Test Item : RF Exposure Evaluation Test Site : No.3 OATS Operation Frequency 2402~2480MHz Maximum Conducted output power 3.78dBm Antenna gain 4.1dBi Output Power Into Antenna & RF Exposure Evaluation Distance: Output Power to Antenna (mW) Power Density at R = 20 cm (mW/cm2) 2.3878 0.001221 Power density in column 4 is much lower than the limit (1 mW/cm 2 ).
Report No. 1410049R-RFUSP01V00 Page: 1 of 74 FCC Test Report Product Name Mobile Computer Model No. PA-2010,PA-2110 FCC ID. NBF-PA-2X10 Applicant Argox Information Co.,Ltd. Address 7F., No.126, Ln. 235, Baociao Rd., Sindian Dist., New Taipei City 231, Taiwan (R.O.C.) Date of Receipt Dec. 27, 2013 Issued Date Jan. 28, 2014 Report No. 1410049R-RFUSP01V00 Report Version V1.0 The Test Results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by TAF or any agency of the U.S. Government Report No. 1410049R-RFUSP01V00 Page: 2 of 74 Test Report Certification Issued Date: Jan. 28, 2014 Report No.: 1410049R-RFUSP01V00 Product Name Mobile Computer Applicant Argox Information Co.,Ltd. Address 7F., No.126, Ln. 235, Baociao Rd., Sindian Dist., New Taipei City 231, Taiwan (R.O.C.) Manufacturer Argox Information Co.,Ltd. Model No. PA-2010,PA-2110 FCC ID. NBF-PA-2X10 EUT Rated Voltage AC 100-240V, 50-60Hz EUT Test Voltage AC 120V/60Hz Trade Name ARGOX Applicable Standard FCC CFR Title 47 Part 15 Subpart C: 2012 ANSI C63.4: 2003, ANSI C63.10: 2009 Test Result Complied The Test Results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by TAF or any agency of the U.S. Government Documented By : ( Senior Adm. Specialist / Joanne Lin ) Tested By : ( Engineer / Andy Lin ) Approved By : ( Director / Vincent Lin) Report No. 1410049R-RFUSP01V00 Page: 3 of 74 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION ...............................................................................................................5 1.1. EUT Description......................................................................................................................................5 1.2. Operational Description...........................................................................................................................7 1.3. Tested System Details..............................................................................................................................8 1.4. Configuration of Tested System ..............................................................................................................8 1.5. EUT Exercise Software ...........................................................................................................................8 1.6. Test Facility .............................................................................................................................................9 2. CONDUCTED EMISSION ................................................................................................................10 2.1. Test Equipment ......................................................................................................................................10 2.2. Test Setup ..............................................................................................................................................10 2.3. Limits.....................................................................................................................................................11 2.4. Test Procedure .......................................................................................................................................11 2.5. Uncertainty ............................................................................................................................................11 2.6. Test Result of Conducted Emission .......................................................................................................12 3. PEAK POWER OUTPUT ..................................................................................................................14 3.1. Test Equipment ......................................................................................................................................14 3.2. Test Setup ..............................................................................................................................................14 3.3. Limit .....................................................................................................................................................14 3.4. Test Procedure .......................................................................................................................................14 3.5. Uncertainty ............................................................................................................................................14 3.6. Test Result of Peak Power Output .........................................................................................................15 4. RADIATED EMISSION .....................................................................................................................17 4.1. Test Equipment ......................................................................................................................................17 4.2. Test Setup ..............................................................................................................................................17 4.3. Limits.....................................................................................................................................................18 4.4. Test Procedure .......................................................................................................................................19 4.5. Uncertainty ............................................................................................................................................19 4.6. Test Result of Radiated Emission .........................................................................................................β¦
Text truncated - open the document above for the full version.
Report No.: 1410049R-RFUSP01V00 Page : 1 of 3 Attachment 1: EUT Test Setup Photographs Front View of Conducted Test Back View of Conducted Test Report No.: 1410049R-RFUSP01V00 Page : 2 of 3 Front View of Radiated Test Back View of Radiated Test Report No.: 1410049R-RFUSP01V00 Page : 3 of 3 Front View of Radiated Test (Horn) Back View of Radiated Test (Horn)
No.5-22, Rueishu Keng, Linkou Dist., Β· Taiwan
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 15C | 2.40 GHz - 2.48 GHz | 2.40 mW |

Barcode Scanner
Equipment Class
DTS - Digital Transmission System
Handheld Barcode Scanner
Equipment Class
DSS - Part 15 Spread Spectrum Transmitter
Mobile Computer
Equipment Class
DSS - Part 15 Spread Spectrum Transmitter
Mobile Computer
Equipment Class
DSS - Part 15 Spread Spectrum Transmitter
Mobile Computer
Equipment Class
DSS - Part 15 Spread Spectrum Transmitter