O9YFULIGPS Tracker

Page | 1 Fuli‐User Manual 1 Step1 Use tweezers to press the following switch for three seconds, and wait for the LED light to turn red, indicating that the device is turned on. 2 Step2 Yo u can use the device's test line for debugging. As follows： Page | 2 3 Step3 If you need to install a SIM card, you need to remove the 4 screws of the device, and then pull out the Pcb and battery together to install the sim card. 6 FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/ TV technician for help. Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. FCC RF Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF Exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for the transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co‐located or operating in conjunction with any other antenna or transmitter. ISED Warning statements This device complies with Canada's licence-exempt RSSs. Operation is subject to the following two conditions: (l) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitationestautorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible d'encompromettre le fonctionnement. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. Pour se conformer aux exigences de conformité CNR 102 RF exposition, une distance de séparationd'aumoins 20 cm doitêtremaintenue entre l'antenne de cetappareilettoutes les personnes. This Class B digital apparatus complies with Canadian ICES-003. Cetappareilnumeriquede la classe B estconforme a la norme NMB-003 du Canada.

EUT Appearance Report No.: R2303A0244 TA Technology (Shanghai) Co., Ltd. TA-MB-01-032E Page 1 of 4 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. EUT Appearance EUT Appearance Report No.: R2303A0244 TA Technology (Shanghai) Co., Ltd. TA-MB-01-032E Page 2 of 4 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. EUT Appearance Report No.: R2303A0244 TA Technology (Shanghai) Co., Ltd. TA-MB-01-032E Page 3 of 4 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. a: EUT EUT Appearance Report No.: R2303A0244 TA Technology (Shanghai) Co., Ltd. TA-MB-01-032E Page 4 of 4 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. b: Battery Picture 1: Constituents of EUT

Internal photo FCC ID: O9YFULI TA Technology (Shanghai) Co., Ltd. TA-MB-01-033E Page 1 of 7 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo Internal photo FCC ID: O9YFULI TA Technology (Shanghai) Co., Ltd. TA-MB-01-033E Page 2 of 7 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo FCC ID: O9YFULI TA Technology (Shanghai) Co., Ltd. TA-MB-01-033E Page 3 of 7 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo FCC ID: O9YFULI TA Technology (Shanghai) Co., Ltd. TA-MB-01-033E Page 4 of 7 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo FCC ID: O9YFULI TA Technology (Shanghai) Co., Ltd. TA-MB-01-033E Page 5 of 7 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo FCC ID: O9YFULI TA Technology (Shanghai) Co., Ltd. TA-MB-01-033E Page 6 of 7 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Internal photo FCC ID: O9YFULI TA Technology (Shanghai) Co., Ltd. TA-MB-01-033E Page 7 of 7 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd.

TA Techn o Code CFR demonstrat P TA T ology (Shangh R47 Part15B ( ting complian Prepared by: L Techn Building 3 EM Ap FC C Pro Bra Mo Rep Iss hai) Co., Ltd. (2022)/ ANSI nce with the re Liu Wei ology 3, No.145, Jint TEL: +8 FAX: +86- 0 MC TE plicant C ID oduct and odel port No. ue Date tested the ab C63.4-2014. equirements y (Shan tang Rd, Pudo 6-021-507911 021-50791141 EST R Spireo O9YF GPS T Spireo FULI R230 3 April 1 bove equipme . The test res as document Approved by nghai) ong Shanghai, 141/2/3 1/2/3-8000 REPO on Inc FULI Tracker on 3A0244-E 17, 2023 ent in accorda sults show tha ted in this rep y: Fan Guang ) Co., L P.R.China ORT E1 ance with the at the equipm port. gchang Ltd. e requirement ment tested is ts in FCC capable of EMC Test Report Report No.: R2303A0244-E1 TA Technology (Shanghai) Co., Ltd. TA-MB-06-001E Page 2 of 17 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Table of Contents 1 Test Laboratory ............................................................................................................................... 4 1.1 Notes of the Test Report ......................................................................................................... 4 1.2 Test Facility ............................................................................................................................. 4 1.3 Testing Location ...................................................................................................................... 4 2 General Description of Equipment Under Test ............................................................................... 5 2.1 Applicant and Manufacturer Information.................................................................................. 5 2.2 General Information ................................................................................................................ 5 2.3 Applied Standards ................................................................................................................... 6 2.4 Test Mode ................................................................................................................................ 7 3 Test Case Results .......................................................................................................................... 8 3.1 Radiated Emission .................................................................................................................. 8 3.2 Conducted Emission ............................................................................................................. 13 4 Uncertainty Measurement ............................................................................................................ 14 5 Main Test Instruments .................................................................................................................. 15 ANNEX A: The EUT Appearance .................................................................................................. ....... 16 ANNEX B: Test Setup Photos .............................................................................................................. 17 EMC Test Report Report No.: R2303A0244-E1 TA Technology (Shanghai) Co., Ltd. TA-MB-06-001E Page 3 of 17 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Summary of measurement results Number Test Case Clause in FCC Rules Conclusion 1 Radiated Emission FCC Part15.109, ANSI C63.4-2014 PASS 2 Conducted Emission FCC Part15.107, ANSI C63.4-2014 NA Date of Testing: March 19, 2023 ~ March 20, 2023 Date of Sample Received: March 14, 2023 Note: All indications of Pass/Fail in this report are opinions expressed by TA Technology (Shanghai) Co., Ltd. based on interpretations and/or observations of test results. Measurement Uncertainties were not taken into account and are published for informational purposes only. EMC Test Report Report No.: R2303A0244-E1 TA Technology (Shanghai) Co., Ltd. TA-MB-06-001E Page 4 of 17 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. 1 Test Laboratory 1.1 Notes of the Test Report This report shall not be reproduced in full or partial, without the written approval of TA Technology (Shanghai) Co., Ltd. The results documented in this report apply only to the tested sample, under the conditions and modes of operation as described herein. Measurement Uncertainties were not taken into account and are published for informational purposes only. This report is written to support regulatory compliance of the applicable standards stated above. 1.2 Test Facility FCC (Designation number: CN1179, Test Firm Registration Number: 446626) TA Technology (Shanghai) Co., Ltd. has been listed on the US Federal Communications Commission list of test facilities recognized to perform measurements. A2LA (Certificate Number: 3857.01) TA Technology (Shanghai) Co., Ltd. has been listed by American Association for Laboratory Accreditation to perform measurement. 1.3 Testing Location Company: TA Technology (Shanghai) Co., Ltd. Address: Building 3, No.145, Jintang Rd, Pudong Shanghai, P.R.China City: Shanghai Post code: 201201 Country: P. R. China Contact: Fan Guangchang Telephone: +86-021-50791141/2/3 Fax: +86-021-50791141/2/3-8000 Website: http://www.ta-shanghai.com E-mail: [email protected] EMC Test Report Report No.: R2303A0244-E1 TA Technology (Shanghai) Co., Ltd. TA-MB-06-001E Page 5 of 17 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. 2 General Description of Equipment Under Test 2.1 Applicant and Manufacturer Information Applicant Spireon Inc Applicant address 18881 Von Karman Ave., Suite #1500, Irvine, CA 92612, United States Manufacturer Asiatelco Technologies Co. Manufacturer address No. 68 Huatuo Road, Building-8, Zh…

Text truncated - open the document above for the full version.

EMC Test Setup Report No.: R2303A0244 TA Technology (Shanghai) Co., Ltd. TA-MB-01-031E Page 1 of 1 This report shall not be reproduced except in full, without the written approval of TA Technology (Shanghai) Co., Ltd. Part 15B Test Setup 30MHz-1GHz 1GHz-18GHz Picture 1: Radiated Emission Test Setup