OKUSBB63528Bluetooth Water Dancing Speaker

Make sure Bluetooth is enabled on your device. Once " " appears The unit will send out a piece of tone once a connection is established. in the list of external device, select it. If asked for a password, enter Instruction Manual Press the Standby Button , the water will be stoping. Press the SOURCE Button repeatedly until the indicator turns RED. Press the SOURCE button until the indicator turns BLUE. TSB-63628 peaker Press the SOURCE button repeatedly until the indicator turns GREEN. 79 5.8V 11.6 Press the SOURCE button until indicator turns BLUE. / TUNE - / TUNE + / TUNE - / TUNE + MODEL: WDW-26345B / WDW-26345R Bluetooth Water Dancing Speaker Instruction Manual TUNE-TUNE+ VOL-VOL+ SOURCE Front View Rear View 2 4 2. Remote Sensor 4. Indicator 6. / TUNE - Button 7. / TUNE + Button 5. (Standby) Button 9. VOL - (Volume Down) 10. VOL + (Volume Up) 13. AUX IN Jack 11. SOURCE Button 12. DC IN Jack TUNE-TUNE+ VOL-VOL+ SOURCE TUNE-TUNE+ VOL-VOL+ SOURCE Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. AUX IN Cable Adapter Instruction Manual AUX IN Cable Adapter Accessories DC 5.0V FM ANT AUX IN DC 5.0V FM ANT AUX IN 1011 56789 121314 8. (Play/Pause) Button 14. FM ANT(Antenna) TSB-63628 TSB-63628 send out a piece of tone. 3 3. Speakers 1 1. Water Dancing Cover Press the Standby Button , the LED light will light in the water cover and water will dance. During playback: Water dancing up and down will be controlled by the volume level. During playback: Water dancing up and down will be controlled by the volume level. Water dancing up and down will be controlled by the volume level. 2A up to Limited Warranty This manufacturer's product warranty extends to the original consumer purchaser of the product. Neither the retailer nor any other company involved in the sale or promotion of this product is a co‐ warrantor of this manufacturer warranty. WARRANTY DURATION:All materials and workmanship are warranted to the original consumer purchaser for a period of ninety (90) days from the original purchase date. WARRANTY COVERAGE:This product is warranted against defective materials or workmanship. This warranty is void if the product has been damaged by accident, in shipment, unreasonable use, misuse, neglect, improper service, commercial use, repairs by unauthorized personnel or other causes not arising out of defects in materials or workmanship. This warranty doesn’t cover the following which may be supplied with this product, including but not limited to; LCD Screens, glass parts, lenses, bulbs etc. This warranty is effective only if the product is purchased and operated in USA and Canada, and does not extend to any units which have been used in violation of written instructionsfurnishedbymanufacturerortounitswhichhavebeenalteredormodifiedor,todamaged products or parts thereof which have had the serial number removed, altered, defaced or rendered illegible. WARRANTY DISCLAIMERS:This warranty is in lieu of all warranties expressed or implied and no representative or person is authorized to assume for manufacturer any other liability in connection with the sale of our products. There shall be no claims for defects or failure under any theory of tort, contractor commercial law including but not limited to, negligence, gross negligence, strict liability, breach of warranty and breach of contract. Under no circumstances will Manufacturer’s / Distributor’s maximum liability exceed the retail value of the product. WARRANTY PERFORMANCE:During the above 90 day warranty period, a product with a defect will be either repaired or replaced with a reconditioned comparable model (at manufacturer's option). The repaired or replacement product will be in warranty for the balance of the 90 day warranty period and an additional one‐month period. No charge will be applicable for such repair or replacement. SERVICE AND REPAIR:If service is required for this product, you should first contact Midwest Trading Group Customer Service [email protected] or by calling 1 (866) 815‐4714, Monday to Friday 10am to 6pm EST. NOTE:Manufacturer cannot assume responsibility for loss or damage during incoming shipment. As a precautionary measure, carefully package the product for shipment, and insure it with the carrier. Be sure to enclose the following details with the product: your full name, return address and daytime phone number, a note describing the problem you experienced, a copy of your sales receipt or other proof of purchase to determine warranty status. C.O.D. shipments cannot be accepted.

Shenzhen Junlan Electronic Ltd No.277 PingKui Road, Shijing Community, Pingshan Street, Pingshan New District, Shenzhen, China. Shenzhen Junlan Electronic Ltd and No.277 PingKui Road, Shijing Community, Pingshan Street, Pingshan New District, Shenzhen, China.

To whom concern, We company SHENZHEN JUNLAN ELECTRONIC LTD hereby declares: The product model(s), WDW-2/6345R, WDW-2/6345B, SC-1127BT, TSB-27318, SC-1128BT, TSB-63513, TSB-27320, SC-1127BT are identical in the same PCB layout, interior structure and electrical circuits with the model TSB-63528 which tested in Global Unit Technology Co., Ltd., the only differences are the model name for commercial purpose.

FCC ID: OKUSBB63528 Shenzhen Junlan Electronic Ltd No.277 PingKui Road, Shijing Community, Pingshan Street, Pingshan New District, Shenzhen, China.

041500001041501590 TO 流水号贴纸 尺寸：30*5MM 白底黑字 用量:1PC BT Water Dancing Tower Speaker Model: SC-1128BT Power Source: DC 16V,1.8A FM Frequency:87.5-108 MHz MADE IN CHINA 铭牌贴纸 尺寸：70*40MM 黑底白字,过光胶 用量:1PC FCC ID:OKUSBB63528 15057B SC-1128BT 胡本林 贴纸 TSB-27320 SUPERSONIC 品号：3227E704004201 品号：322740LE150571 2 备注：A2版贴纸由12V,2.5A改成16V, 1.8A

FCC ID: OKUSBB63528 According to 447498 D01 General RF Exposure Guidance v05 The 1-g and 10-g SAR test exclusion thresholds for 100 MHz to 6 GHz at test separation distances ≤ 50 mm are determined by: [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance, mm)] ·[√f(GHz)] ≤ 3.0 for 1-g SAR and ≤ 7.5 for 10-g extremity SAR, where --f(GHz) is the RF channel transmit frequency in GHz --Power and distance are rounded to the nearest mW and mm before calculation --The result is rounded to one decimal place for comparison eirp = pt x gt = (EXd) 2 /30 where: pt = transmitter output power in watts, gt = numeric gain of the transmitting antenna (unitless), E = electric field strength in V/m, --- 10 ((dBuV/m)/20) /10 6 d = measurement distance in meters (m) --- 3m So pt = (EXd) 2 /30 x gt Field strength = 97.24dBuV/m @3m Ant gain =0dBi, so Ant numeric gain= 1.0 So pt={ [10 (97.24) /10 6 x 3] 2 /30x1.0 }x1000 mW = 1.589mW So (1.589 mW /5mm)x √2.48 = 0.454<3 Then SAR evaluation is not required

Global United Technology Services Co., Ltd. Report No.: GTSE14120226101 Authorized Signature: Robinson Lo Laboratory Manager This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the GTS product certification mark. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of GTS or testing done by GTS in connection with, distribution or use of the product described in this report must be approved by GTS in writing. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. FCC REPORT Applicant: Shenzhen Junlan Electronic Ltd Address of Applicant: No.277 PingKui Road, Shijing Community, Pingshan Street, Pingshan New District, Shenzhen, China. Equipment Under Test (EUT) Product Name: Bluetooth Water Dancing Speaker Model No.: TSB-63528, WDW-2/6345R, WDW-2/6345B, SC-1127BT, TSB-27318, SC-1128BT, TSB-63513, TSB-27320, SC-1127BT Trade Mark: Soundlogic XT, Supersonic FCC ID: OKUSBB63528 Applicable standards: FCC CFR Title 47 Part 15 Subpart C Section 15.249:2013 Date of sample receipt: December 26, 2014 Date of Test: January 07-09, 2015 Date of report issued: January 09, 2015 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. Report No.: GTSE14120226101 Global United Technology Services Co., Ltd. Project No.: GTSE141202261RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 2 of 31 2 Version Version No. Date Description 00 January 09, 2015 Original Prepared By: Date: January 09, 2015 Project Engineer Check By: Date: January 09, 2015 Reviewer Report No.: GTSE14120226101 Global United Technology Services Co., Ltd. Project No.: GTSE141202261RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 3 of 31 3 Contents Page 1 COVER PAGE .............................................................................................................................................1 2 VERSION ...................................................................................................................................................2 3 CONTENTS ...............................................................................................................................................3 4 TEST SUMMARY ......................................................................................................................................4 5 GENERAL INFORMATION .......................................................................................................................5 5.1 CLIENT INFORMATION ..........................................................................................................................5 5.2 GENERAL DESCRIPTION OF EUT ..........................................................................................................5 5.3 TEST MODE .........................................................................................................................................7 5.4 DESCRIPTION OF SUPPORT UNITS ........................................................................................................7 5.5 TEST FACILITY ....................................................................................................................................7 5.6 TEST LOCATION ..................................................................................................................................7 5.7 OTHER INFORMATION REQUESTED BY THE CUSTOMER ..........................................................................7 6 TEST INSTRUMENTS LIST ......................................................................................................................8 7 TEST RESULTS AND MEASUREMENT DATA .......................................................................................9 7.1 ANTENNA REQUIREMENT ......................................................................................................................9 7.2 CONDUCTED EMISSIONS ....................................................................................................................10 7.3 RADIATED EMISSION METHOD ............................................................................................................13 7.3.1 Field Strength of The Fundamental Signal ..................................................................................15 7.3.2 Spurious emissions .....................................................................................................................16 7.3.3 Bandedge emissions ...................................................................................................................20 7.4 20DB OCCUPY BANDWIDTH ...............................................................................................................21 8 TEST SETUP PHOTO .............................................................................................................................23 9 EUT CONSTRUCTIONAL DETAILS ........................................…

Text truncated - open the document above for the full version.

Report No.: GTSE14120226101 Global United Technology Services Co., Ltd. Project No.: GTSE141202261RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 23 of 31 8 Test Setup Photo Radiated Emission Report No.: GTSE14120226101 Global United Technology Services Co., Ltd. Project No.: GTSE141202261RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 24 of 31 Conducted Emissions