
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
15.21 Federal Communications Commission (FCC) Statement The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the part responsible for compliance could void the userβs authority to operate the equipment. You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the userβs authority to operate the equipment. 15.105(b) Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Page 22 Rev. 00 APPENDIX 2 EXTERNAL PHOTOGRAPHS OF EUT C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Page 23 Rev. 00 Front View of EUT Front View of EUT C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Page 24 Rev. 00 Back View of EUT
FCC ID LABEL FORMAT AND LOCATION Applicant: Globlink Technology Inc. FCC ID: OR7GM3000 FCC ID: OR7GM3000 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID LABEL AREA
C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 APPENDIX 3 INTERNAL PHOTOGRAPHS OF EUT C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Internal of EUT β Open Internal of EUT β 1 C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Internal of EUT β 2 Internal of EUT β 3 C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Internal of EUT β 4 Internal of EUT β 5 C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Internal of EUT β 6
C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GM3000 DATE: 09/10/2002 Page 1 of 18 Rev. 00 ELECTROMAGNETIC EMISSIONS COMPLIANCE REPORT INTENTIONAL RADIATOR CERTIFICATION TO FCC PART 15 SUBPART C REQUIREMENT OF Optical mouse MODEL No.: M-30 Optical mouse BRAND NAME: i-free FCC ID: OR7GM3000 REPORT NO: 020049-RF-ID ISSUE DATE: September 10, 2002 Prepared for Globlink Technology Inc. 2Fl., No. 101, Feenliau Street, Nei-hu (114) Taipei, Taiwan, R.O.C. Prepared by C&C LABORATORY, CO., LTD. #B1, 1 st Fl., Universal Center, No. 183, Sec. 1, Tatung Rd., Hsi Chih, Taipei Hsien, Taiwan, R.O.C. TEL: (02)8642-2071~3 FAX: (02)8642-2256 C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Page 2 Rev. 00 Table of Contents 1. GENERAL INFORMATION ............................................................................................... 4 1.1 P RODUCT D ESCRIPTION ........................................................................................................................ 4 1.2 R ELATED S UBMITTAL ( S ) / G RANT ( S )................................................................................................... 4 1.3 T EST M ETHODOLOGY ............................................................................................................................ 4 1.4 T EST F ACILITY ...................................................................................................................................... 4 1.5 S PECIAL A CCESSORIES .......................................................................................................................... 5 1.6 E QUIPMENT M ODIFICATIONS ................................................................................................................ 5 2. SYSTEM TEST CONFIGURATION .................................................................................. 6 2.1 EUT C ONFIGURATION ........................................................................................................................... 6 2.2 EUT E XERCISE ...................................................................................................................................... 6 2.3 T EST P ROCEDURE .................................................................................................................................. 6 2.4 L IMITATION ........................................................................................................................................... 7 2.5 C ONFIGURATION OF T ESTED S YSTEM ................................................................................................... 8 3. SUMMARY OF TEST RESULTS ..................................................................................... 10 4. DESCRIPTION OF TEST MODES .................................................................................. 10 5. CONDUCTED EMISSIONS TEST (NOT APPLICABLE IN THIS REPORT)........ 11 5.1 M EASUREMENT P ROCEDURE : ............................................................................................................. 11 5.2 T EST SET-UP (B LOCK D IAGRAM OF C ONFIGURATION ) ..................................................................... 11 5.3 MEASUREMENT EQUIPMENT USED: .................................................................................................... 11 5.4 M EASUREMENT R ESULT : .................................................................................................................... 11 5.5 C ONDUCTED M EASUREMENT P HOTOS :............................................................................................... 11 6. RADIATED EMISSION TEST .......................................................................................... 12 6.1 MEASUREMENT PROCEDURE............................................................................................................... 12 6.2 T EST SET-UP (B LOCK D IAGRAM OF C ONFIGURATION ) ..................................................................... 13 6.3 M EASUREMENT E QUIPMENT U SED : .................................................................................................... 14 6.4 FIELD STRENGTH CALCULATION........................................................................................................ 14 6.5 M EASUREMENT R ESULT ..................................................................................................................... 15 6.6 M EASUREMENT R ESULT ..................................................................................................................... 16 C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Page 3 Rev. 00 7. OCCUPIED BANDWIDTH................................................................................................ 17 7.1 MEASUREMENT PROCEDURE............................................................................................................... 17 7.2 T EST SET-UP (B LOCK D IAGRAM OF C ONFIGURATION ) ..................................................................... 17 7.3 M EASUREMENT E QUIPMENT U SED : .................................................................................................... 17 7.4 M EASUREMENT R ESULTS : R EFER TO ATTACHED DATA CHART . ...................................................... 17 C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Page 4 Rev. 00 1. GENERAL INFORMATION 1.1 Product Description The Globlink Technology Inc. Model: M-30 Optical mouse (referred to as the EUT in this report) The EUT is an short range, lower power, wireless Mouse designed as an " Input Device. It is designed by way of utilizing the FSK modulation achieves the system operating. A major technical descriptions of EUT is described as following: A). Operation Frequency: 27.12 MHz, one channel. B). Modulation : Frequency Shifting Key (FSK) Modulation C). Antenna Designation: Non-User Replaceable (Fixed) D). Power Supply: 3 Vdcβ¦
Text truncated - open the document above for the full version.
C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 APPENDIX 1 PHOTOGRAPHS OF SET UP C&C Laboratory Co. Ltd. REPORT NO: 020049-RF-ID FCC ID: OR7GW3000 DATE: 09/10/2002 Radiated Emission Setup Photos
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 15C | 27.12 MHz - 27.12 MHz | - |

Wireless Ring Mouse
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
Wireless Free Wheel Mouse
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
Wireless Free Wheel Mouse
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
Wireless Big Optical Trackball Mouse
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
2.4 GHz RF Wireless Optical Presentation Mouse
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter