PANWA720011n Travel AP/ Router

User’s Manual WLAN Travel AP/Router Version: 1.0 Trademarks Copyright @2012 Contents are subject to change without notice. All trademarks belong to their respective proprietors. Copyright Statement THIS DOCUMENT CONTAINS OF PROPRIETARY TECHNICAL INFORMATION THAT IS THE PROPERTY OF THIS COMPANY. AND NO PART OF THIS DOCUMENTATION MAY BE REPRODUCED, STORED IN A RETRIEVAL SYSTEM OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRICAL OR MECHANICAL, BY PHOTOCOPYING, RECORDING, OR OTHERWISE, WITHOUT THE PRIOR WRITTEN CONSENT OF THIS COMPANY. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. USER’S MANUAL OF WLAN TRAVEL AP/ROUTER Version: 1.0 i Table of Contents REVISION HISTORY ........................................................................................................................I TERMINOLOGY .............................................................................................................................. II 1 INTRODUCTION....................................................................................................................... 1 1.1 PACKAGE CONTENTS................................................................................................................1 1.2 PRODUCT FEATURES................................................................................................................1 1.3 PANEL DESCRIPTION................................................................................................................3 2 INSTALLATION ........................................................................................................................ 4 2.1 H ARDWARE INSTALLATION......................................................................................................4 2.2 SOFTWARE INSTALLATION........................................................................................................5 3 APP SOFTWARE CONFIGURATION .................................................................................... 6 4 SOFTWARE CONFIGURATION ............................................................................................ 7 4.1 PREPARE YOUR PC TO CONFIGURE THE WLAN TRAVEL AP/ROUTER......................................7 4.2 CONNECT TO THE WLAN TRAVEL AP/ROUTER.......................................................................9 4.3 MANAGEMENT AND CONFIGURATION ON THE WLAN TRAVEL AP/ROUTER - AP MODE..........9 4.3.1 Operation Mode ............................................................................................................9 4.3.2 Wireless - Basic Settings............................................................................................. 10 4.3.3 Wireless - Advanced Settings ..................................................................................... 12 4.3.4 Wireless - Security Setup ............................................................................................ 14 4.3.5 Site Survey .................................................................................................................. 17 4.3.6 WPS ............................................................................................................................ 18 4.3.7 Schedule ...................................................................................................................... 19 4.3.8 LAN Interface Setup ................................................................................................... 20 I Static DHCP Setup .......................................................................................................22 4.3.9 Status........................................................................................................................... 23 4.3.10 Management - Statistics .............................................................................................. 25 4.3.11 Management - Time Zone Setting............................................................................... 25 4.3.12 Management - Log ...................................................................................................... 26 4.3.13 Manageme…

Text truncated - open the document above for the full version.

CC&C Technologies, Inc. Date (05/07/2013) BABT TCB Forsyth House, Churchfield Road, Walton-on-Thames, Surrey, KT12 2TD Confidentiality Request FCC ID: PANWA7200 Pursuant to Sections 0.457(d)(1)(ii) and 0.459 of the Commission’s Rules, CC&C Technologies, Inc. hereby requests permanent confidential treatment of information accompanying this application as outlined below: Block Diagram Circuit Diagram Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457(d)(1)(ii), disclosure of this Application and all accompanying materials will not be made before the date of the Grant for this Application. Yours sincerely,

Compliance Certification Services Inc. Report No.: T130625W01 Date of Issue: July 9, 2013 A1 - 1 / 6 Rev. 00 APPENDIX 1 - PHOTOGRAPHS OF EUT EXTERNAL PHOTOGRAPHS OF EUT Compliance Certification Services Inc. Report No.: T130625W01 Date of Issue: July 9, 2013 A1 - 2 Rev. 00

1177 WLAN 11n Router Rating: Made in China 1.0A+5V Model: WA-7200 FCC ID: PANWA7200 LAN MAC: SSID: S/N: *SSID--”Travel”+LAN MAC 13.7mm 29.3mm Label Location Label

Compliance Certification Services Inc. Report No.: T130625W01 Date of Issue: July 9, 2013 A1 - 3 Rev. 00 INTERNAL PHOTOGRAPHS OF EUT Compliance Certification Services Inc. Report No.: T130625W01 Date of Issue: July 9, 2013 A1 - 4 Rev. 00 Back Front Compliance Certification Services Inc. Report No.: T130625W01 Date of Issue: July 9, 2013 A1 - 5 Rev. 00 Front Compliance Certification Services Inc. Report No.: T130625W01 Date of Issue: July 9, 2013 A1 - 6 Rev. 00 Back Antenna & Module

Compliance Certification Services Inc. Report No.: T130625W01 Date of Issue: July 18, 2013 Page 1 Rev.00 This report shall not be reproduced except in full, without the written approval of Compliance Certification Services. APPENDIX I RADIO FREQUENCY EXPOSURE LIMIT According to §15.247(i), systems operating under the provisions of this section shall be operated in a manner that ensures that the public is not exposed to radio frequency energy levels in excess of the Commission's guidelines. See § 1.1307(b)(1) of this chapter. EUT Specification EUT 11n Travel AP/ Router Model WA-7200 Frequency band (Operating) 802.11b/g/n HT20: 2.412GHz ~ 2.462GHz 802.11n HT40: 2.422GHz ~ 2.452GHz Others Device category Portable (<20cm separation) Mobile (>20cm separation) Others Exposure classification Occupational/Controlled exposure (S = 5mW/cm 2 ) General Population/Uncontrolled exposure (S=1mW/cm 2 ) Antenna Specification Dipole Antenna / Gain: 0 dBi, (Numeric gain: 1) Max. output power IEEE 802.11b : 16.94 dBm (49.431mW) IEEE 802.11g : 14.88 dBm (30.761mW) IEEE 802.11n HT20 : 12.92 dBm (19.588mW) IEEE 802.11n HT40 : 12.73 dBm (18.750mW) Evaluation applied MPE Evaluation* SAR Evaluation N/A Remark: The maximum output power is 16.94dBm (49.431mW) at 2437MHz (with 1 numeric antenna gain.) Compliance Certification Services Inc. Report No.: T130625W01 Date of Issue: July 18, 2013 Page 2 Rev.00 This report shall not be reproduced except in full, without the written approval of Compliance Certification Services. TEST RESULTS No non-compliance noted. Calculation Given d GP E   30 & 377 2 E S Where E = Field strength in Volts / meter P = Power in Watts G = Numeric antenna gain d = Distance in meters S = Power density in milliwatts / square centimeter Combining equations and re-arranging the terms to express the distance as a function of the remaining variables yields: 2 377 30 d GP S   Changing to units of mW and cm, using: P (mW) = P (W) / 1000 and d (cm) = d(m) / 100 Yields   22 0796.0 100/377 1000/30 d GP d GP S      Equation 1 Where d = Distance in cm P = Power in mW G = Numeric antenna gain S = Power density in mW / cm 2 Compliance Certification Services Inc. Report No.: T130625W01 Date of Issue: July 18, 2013 Page 3 Rev.00 This report shall not be reproduced except in full, without the written approval of Compliance Certification Services. Maximum Permissible Exposure Substituting the MPE safe distance using d = 20 cm into Equation 1: GPS000199.0 Where P = Power in mW G = Numeric antenna gain S = Power density in mW / cm 2 IEEE 802.b mode: Ch.Frq.(MHz)P (mW)Gain (num.)D (cm) Power density in mW / cm 2 Limit (mW/cm2) 6243749.4311200.00981 IEEE 802.g mode: Ch.Frq.(MHz)P (mW)Gain (num.)D (cm) Power density in mW / cm 2 Limit (mW/cm2) 6243730.7611200.00611 IEEE 802.n HT20 mode: Ch.Frq.(MHz)P (mW)Gain (num.)D (cm) Power density in mW / cm 2 Limit (mW/cm2) 6243719.5881200.00391 IEEE 802.n HT40 mode: Ch.Frq.(MHz)P (mW)Gain (num.)D (cm) Power density in mW / cm 2 Limit (mW/cm2) 3242218.751200.00371

Compliance Certification Services Inc. FCC ID: PANWA7200 Report No.: T130625W01-RP Note: This report shall not be reproduced except in full, without the written approval of Compliance Certification Services Inc. This document may be altered or revised by Compliance Certification Services Inc. personnel only, and shall be noted in the revision section of the document. Page 1 / 107 Rev. 00 FCC 47 CFR PART 15 SUBPART C TEST REPORT For 11n Travel AP/ Router Model: WA-7200 Tra d e Na me: C C& C Issued to CC&C Technologies, Inc 8F, No. 150, Jian Yi Road, Chung Ho City, Taipei County, Taiwan 235, R. O. C. Issued by Compliance Certification Services Inc. No.11, Wugong 6th Rd., Wugu Dist., New Taipei City 24891, Taiwan. (R.O.C.) http://www.ccsrf.com [email protected] Issued Date: July 9, 2013 Compliance Certification Services Inc. FCC ID: PANWA7200 Report No.: T130625W01-RP Page 2 Rev. 00 Revision History Rev. Issue Date Revisions Effect Page Revised By 00 July 9, 2013 Initial Issue ALL Angel Cheng Compliance Certification Services Inc. FCC ID: PANWA7200 Report No.: T130625W01-RP Page 3 Rev. 00 TABLE OF CONTENTS 1. TEST RESULT CERTIFICATION .................................................................................................... 4 2. EUT DESCRIPTION ........................................................................................................................... 5 3. TEST METHODOLOGY .................................................................................................................... 6 3.1 EUT CONFIGURATION ........................................................................................................................ 6 3.2 EUT EXERCISE .................................................................................................................................... 6 3.3 GENERAL TEST PROCEDURES ............................................................................................................. 6 3.4 FCC PART 15.205 RESTRICTED BANDS OF OPERATIONS......................................................... 7 3.5 DESCRIPTION OF TEST MODES ........................................................................................................... 8 4. INSTRUMENT CALIBRATION ........................................................................................................ 9 4.1 MEASURING INSTRUMENT CALIBRATION ...................................................................................... 9 4.2 MEASUREMENT EQUIPMENT USED ......................................................................................... 9 4.3 MEASUREMENT UNCERTAINTY ............................................................................................. 10 5. FACILITIES AND ACCREDITATIONS ........................................................................................ 11 5.1 FACILITIES ....................................................................................................................................... 11 5.2 EQUIPMENT ...................................................................................................................................... 11 5.3 TABLE OF ACCREDITATIONS AND LISTINGS ..................................................................................... 12 6. SETUP OF EQUIPMENT UNDER TEST ....................................................................................... 13 6.1 SETUP CONFIGURATION OF EUT ....................................................................................................... 13 6.2 SUPPORT EQUIPMENT ............................................................................................................... 13 7. FCC PART 15.247 REQUIREMENTS ............................................................................................. 14 7.1 6DB BANDWIDTH ............................................................................................................................. 14 7.2 PEAK POWER .................................................................................................................................... 28 7.3 AVERAGE POWER ............................................................................................................................ 30 7.4 BAND EDGES MEASUREMENT ................................................................................................ 32 7.5 PEAK POWER SPECTRAL DENSITY .................................................................................................... 58 7.6 SPURIOUS EMISSIONS ................................................................................................................. 72 7.7 RADIATED EMISSIONS .............................................................................................................. 85 7.8 POWERLINE CONDUCTED EMISSIONS ............................................................................................. 102 APPENDIX I PHOTOGRAPHS OF TEST SETUP ............................................................................. 105 APPENDIX 1 - PHOTOGRAPHS OF EUT Compliance Certification Services Inc. FCC ID: PANWA7200 Report No.: T130625W01-RP Page 4 Rev. 00 1. TEST RESULT CERTIFICATION Applicant: CC&C Technologies, Inc 8F, No. 150, Jian Yi Road, Chung Ho City, Taipei County, Taiwan 235, R. O. C. Equipment Under Test: 11n Travel AP/ Router Tr a d e N a m e : CC&C Model: WA-7200 Date of Test: June 26 ~ 28, 2013 APPLICABLE STANDARDS STANDARD TEST RESULT FCC 47 CFR Part 15 Subpart C No non-compliance noted We hereby certify that: The above equipment was tested by Compliance Certification Services Inc. The test data, data evaluation, test procedures, and equipment configurations shown in this report were made in accordance with the procedures given in ANSI C63.4: 2009 and the energy emitted by the sample EUT tested as described in this report is in compliance with the requirements of FCC Rules Part 15.207, 15.209, 15.247. The test results of this report relate o…

Text truncated - open the document above for the full version.

Compliance Certification Services Inc. FCC ID: PANWA7200 Report No.: T130625W01-RP Page 105 Rev. 00 APPENDIX I PHOTOGRAPHS OF TEST SETUP Conducted Emissions Setup Photos Compliance Certification Services Inc. FCC ID: PANWA7200 Report No.: T130625W01-RP Page 106 Rev. 00 Radiated Emissions Setup Photos Compliance Certification Services Inc. FCC ID: PANWA7200 Report No.: T130625W01-RP Page 107 Rev. 00 Powerline Conducted Emissions Setup Photos