PB4-MT212UNIVERSAL WIRELESS SPEAKER

7395784-A memorex.com MW212 Guía del usuario Lea estas instrucciones de forma completa antes de operar este producto. memorex.com MW212 User Guide Please read these instructions completely before operating this product. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. ATTENTION: The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: Users of this product are cautioned not to make modifications or changes that are not approved by Imation Corp, doing so may void the compliance of this product and may result in the loss of the user’s authority to operate the equipment. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT AND FULLY INSERT. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that can cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. • The rating information is located at the bottom of the apparatus. Listen to Music 1. Turn on the MW212 by pressing the Power Button . 2. Turn on your Bluetooth enable device and place it within 30 feet (without barrier) of the speaker. If the system has recently been connected with the mobile device, the Bluetooth Indicator LED will illuminate solidly, indicating a connection. If you have not paired the devices, or the indicator blinks slowly, pair them as described in the Pair a Bluetooth-Enabled Mobile Device section above. 3. Use the connected mobile device to play and pause music. Sound will be heard through the speaker. 4. Adjust the speaker volume level either by pushing the “+” or “–” Volume Buttons on the top of the MW212, or by using the volume controls on the mobile device. Listen to Music Using Line-In Source 1. Press the Power Button at the top of the MW212 until the blue LED is on to turn on the MW212. 2. Insert one end of the audio cable (not included) into the Line-out (or headphone jack) on your external audio unit and the other end into the Line-In Jack on the rear of the MW212. 3. Use the connected external audio unit to play and pause music. Sound will be heard through the speaker. 4. Adjust the speaker volume level either by pushing the “+” or “–” Volume Buttons on the top of the MW212, or by using the volume controls on the mobile device. Notes: • There will be no audible tone effects when connected to a Line-in source • Once an external audio unit is connected, its music will override music from a connected Bluetooth-enabled device. • The MW212 will revert to the last set volume level. • To maximize audio quality and minimize sound distortion, set your personal digital music device volume to high and use the volume control on the MW212 speaker to adjust the listening level when connected to a Line-in source. AUTO OFF The MW212 will automatically shut off if there is no music from a Line-in source or from a Bluetooth-enabled device for more than 20 minutes. MAINTAINING YOUR SYSTEM FOR CONTINUED ENjOYMENT • When not in use, turn OFF the MW212. To extend the battery life of your external audio/mobile device, turn off the Bluetooth signal when not in use. • Keep the unit away from direct sunlight and excessive heat. • Protect your furniture when placing the unit on wood and lacquered finishes. SURGE PROTECTORS: It is recommended to use a surge protector for AC connection. Lightning and power surges ARE NOT covered under warranty for this product. Imation Enterprises Corp 1 Imation Way, Oakdale, MN 55128-3414 USA © Imation Corp www.memorex.com Memorex and the Memorex logo are trademarks of Imation Corp and its affiliates. The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Imation Corp is under license. All other trademarks are the property of their respective owners. For additional setup, operating assistance or an electronic version of this user manual, please visit www.memorex.com For consumer replaceable part(s), verify part number(s) then contact our parts and accessory fulfillment center at: 1-800-321-6993 ADVERTENCIA: PARA EVITAR EL RIESGO DE INCENDIO O DESCARGA, NO EXPONGA ESTA UNIDAD A LA LLUVIA O LA HUMEDAD. Este aparato digital Clase B cumple con la norma canadiense ICES-003. Imatio…

Text truncated - open the document above for the full version.

Imation Corp. FCC ID: PB4-MT212 POWER OF ATTORNEY June 12, 2012 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 To Whom It May Concern: We, the undersigned, hereby authorize Waltek Services (ShenZhen) Co., Ltd. (Philo Zhong) on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by Waltek Services (ShenZhen) Co., Ltd. (Philo Zhong) on our behalf shall have the same effect as acts of our own. This authorization expires on June 11,2013 This is to advise that we are in full compliance with the Anti-Drug Abuse Act. We, Imation Corp. are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Sincerely, Imation Corp. ....................................................................................

Page: 45 of 50 The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F 16 Photographs - Constructional Details 16.1 EUT – Appearance View Page: 46 of 50 The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F

Page: 50 of 50 The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F 17 FCC Label This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The Label must not be a stick-on paper. The Label on these products must be permanently affixed to the product and readily visible at the time of purchase and must last the expected lifetime of the equipment not be readily detachable. Proposed Label Location on EUT EUT Back View/ proposed FCC Label Location FCC ID: PB4-MT212 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC ID Label Sample for Models: MW212, TW212 FCC ID: PB4-MT212 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Page: 47 of 50 The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F 16.2 EUT- Open View Page: 48 of 50 The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F 16.3 EUT – PCB1 View Page: 49 of 50 The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F 16.4 EUT – PCB2 View

Page: 1 of 51 TEST REPORT The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F FCC ID : PB4-MT212 Applicant : Imation Corp. Address : 1 Imation Way, Oakdale, MN 55128-3421 USA. Manufacturer : Imation Corp. Address : 1 Imation Way, Oakdale, MN 55128-3421 USA. Equipment Under Test (EUT) : Product Name : Universal Wireless Speaker Model No. : MW212, TW212 Brand : memorex is the brand for MW212, TDK Life on Record is the brand for TW212 Rules : FCC CFR47 Part15 Section 15.247:2010 Date of Test : July 12~17,2012 Date of Issue : July 17,2012 Test Result : PASS* Remark: * The sample described above has been tested to be in compliance with the requirements of ANSI C63.4:2003. The test results have been reviewed and comply with the rules listed above and found to meet their essential requirements. PERPARED BY: Waltek Services (Shenzhen) Co., Ltd. 1/F, Fukangtai Building, West of Baima Road., Songgang Street, Bao’an District, Shenzhen, China Tel: +86-755-83551033 Fax: +86-755-83552400 Compiled by: Approved by: Zero Zhou / Project Engineer Philo Zhong / Manager Page: 2 of 51 The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F 2 Test Summary Test Items Test Requirement Result Conducted Emissions (150kHz to 30MHz) 15.207 PASS Radiated Spurious Emissions (26MHz to 25GHz) 15.205(a) 15.209 15.247(d) PASS 20dB Bandwidth 15.247(a)(1) PASS Maximum Peak Output Power 15.247(b)(1) PASS Frequency Separation 15.247(a)(1) PASS Number of Hopping Frequency 15.247(a)(1)(iii) PASS Dwell time 15.247(a)(1)(iii) PASS Antenna Requirement 15.203 PASS Maximum Permissible Exposure (Exposure of Humans to RF Fields) 1.1307(b)(1) PASS Page: 3 of 51 The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F 3 Contents Page 1 COVER PAGE ...........................................................................................................................................1 2 TEST SUMMARY ................................................................................................................................................... 2 3 CONTENTS ............................................................................................................................................................. 3 4 GENERAL INFORMATION .................................................................................................................................. 5 4.1 GENERAL DESCRIPTION OF E.U.T. ................................................................................................................ 5 4.2 DETAILS OF E.U.T. .......................................................................................................................................... 5 4.3 CHANNEL LIST ................................................................................................................................................. 5 4.4 TEST FACILITY ................................................................................................................................................. 6 4.5 TEST LOCATION ............................................................................................................................................... 6 4.6 GENERAL CONDITION ...................................................................................................................................... 6 4.6.1 Environmental condition of test site ....................................................................................................... 6 4.6.2 Test Mode .................................................................................................................................................. 6 5 EQUIPMENT USED DURING TEST ................................................................................................................... 7 5.1 EQUIPMENTS LIST ........................................................................................................................................... 7 5.2 MEASUREMENT UNCERTAINTY ....................................................................................................................... 7 5.3 TEST EQUIPMENT CALIBRATION ..................................................................................................................... 7 6 CONDUCTED EMISSION ..................................................................................................................................... 8 6.1 E.U.T. TEST CONDITION ................................................................................................................................. 8 6.2 EUT SETUP ..................................................................................................................................................... 9 6.3 CONDUCTED EMISSION TEST RESULT ........................................................................................................... 9 7 RADIATED SPURIOUS EMISSIONS ............................................................................................................... 12 7.1 EUT OPERATION: .......................................................................................................................................... 12 7.2 TEST SETUP .................................................................................................................................................. 13 7.3 SPECTRUM ANALYZER SETUP .................................................................................................................…

Text truncated - open the document above for the full version.

Page: 43 of 50 The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F 15 Photographs –Test Setup 15.1 Conduction Emission 15.2 Radiation Spurious Emission Below 30MHz Page: 44 of 50 The results shown in this test report refer only to the sample(s) tested, This Test report cannot be reproduced, except in full, without prior written permission of the Company. WALTEK SERVICES Reference No.: WT12074639-S-S-F From 30-1000MHz Above 1GHz