PB4-MT550PORTABLE WIRELESS SPEAKER

73952779 A memorex.com MW550 Guía del usuario Lea estas instrucciones de forma completa antes de operar este producto. memorex.com MW550 User Guide Please read these instructions completely before operating this product. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. ATTENTION: The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: Users of this product are cautioned not to make modifications or changes that are not approved by Imation Corp, doing so may void the compliance of this product and may result in the loss of the user’s authority to operate the equipment. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT AND FULLY INSERT. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that can cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. • The rating information is located at the bottom of the apparatus. 2. Turn your mobile device on and place it within 30 feet (without barrier) of the speaker. 3. Press the Source Button until the Bluetooth Indicator LED is illuminated (blue). 4. Press the Pair Button once. You will hear a single tone. The speaker is now in Pairing mode. The Bluetooth indicator LED will blink quickly. Upon successful connection a tune will be heard through the speaker. If pairing and connection fail or are not completed within 3 minutes, the speaker will exit pairing mode, indicated by a long beep. 5. Refer to your mobile device for instructions on enabling Bluetooth. It is usually located in the Settings menu or similar location. After enabling, “Memorex MW550” will appear as an option. Select it and your mobile device will pair with the Memorex MW550. When successfully paired the Bluetooth Indicator LED will change from blinking to solidly illuminated. Notes: • Bluetooth connection will not terminate when toggling between Bluetooth and Line-In sources. • When powered on and in Bluetooth source mode, the system will automatically connect to the most recently connected device if available. Listen to Music 1. Turn your mobile device on and place it within 30 feet (without barrier) of the speaker. 2. Turn on the speaker by turning the Power/Volume Dial clockwise until it clicks. If the system has recently been connected with the mobile device, the Bluetooth Indicator LED will illuminate solidly, indicating the connection. If you have not paired the mobile device or if the indicator blinks slowly, pair them as described in the Pair a Bluetooth-Enabled Mobile Device section above. 3. Play your music on your mobile device and the sound will be heard through the speaker. 4. The volume can be controlled using the volume setting on your mobile device, or via the Power/Volume Dial. Turn the knob clockwise to increase volume, counter-clockwise to reduce volume or to turn off the speaker. Listen to Music Using Line-In Source Insert one end of the audio cable (not included) into the LINE OUT jack on your external audio unit and the other end into the Line-In Jack on the rear of this unit. With the output device and the MW550 turned on, press the Source Button to select Line-In mode. The Line-In Indicator LED will be lit. The external audio unit’s output will be heard through the system’s speaker. If you wish to listen to the Bluetooth-enabled mobile device, press the Source Button to select Bluetooth mode. The Bluetooth LED will illuminate. To maximize audio quality and minimize sound distortion, set your personal digital music device volume to high and use the volume control on the MW550 speaker to adjust the listening level. Sleep Mode • The unit enters sleep mode after 20 minutes without a line-in signal or audio streaming signal from a Bluetooth connection. The Bluetooth connection is terminated and indicated by a tone. • During sleep mode, the unit will automatically power up if a line-in audio signal is detected. It can also be reactivated by pressing any buttons, or by rotating the Power/Volume Dial to “off”, then “on” again. Note: The system will automatically try to connect to the most recently connected device if available. Speakerphone INCOMING CALLS 1. When a call is received with the mobile de…

Text truncated - open the document above for the full version.

Imation Corp. FCC ID: PB4-MT550 POWER OF ATTORNEY June 12, 2012 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 To Whom It May Concern: We, the undersigned, hereby authorize Waltek Services (ShenZhen) Co., Ltd. (Philo Zhong) on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by Waltek Services (ShenZhen) Co., Ltd. (Philo Zhong) on our behalf shall have the same effect as acts of our own. This authorization expires on June 11,2013 This is to advise that we are in full compliance with the Anti-Drug Abuse Act. We, Imation Corp. are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Sincerely, Imation Corp. ....................................................................................

Imation Corp. Date: July 31, 2012 To: Federal Communications Commission 7435 Oakland Mi lls Road Columbia, MD FCC ID: PB4-MT550 To Whom It May Concern: This letter is to ascertai n that Imation Corp., Portable Wireless Speaker has been the units used for conducting FCC compliance testing, the DoC part was tested by PEP Testi ng Laboratory (Test Report No.:F12080805 ). If you have any question or concerns, pls. contact us. Sincerely, ----------------------------------------[signature] Michelle Zhang Imation Corp. E-mail: [email protected] Phone: 651-704-3004 Fax: 651-704-5172 Address: 1 Imation Way, Oakdale, MN 55128-3421, USA

Page 47 of 53 Report No.: WT12074810-S-S-F Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn 17 Photographs - Constructional Details 17.1 EUT – Appearance View Page 48 of 53 Report No.: WT12074810-S-S-F Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn Page 49 of 53 Report No.: WT12074810-S-S-F Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn

Page 53 of 53 Report No.: WT12074810-S-S-F Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn 18 FCC Label This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The Label must not be a stick-on paper. The Label on these products must be permanently affixed to the product and readily visible at the time of purchase and must last the expected lifetime of the equipment not be readily detachable. Proposed Label Location on EUT EUT Back View/ proposed FCC Label Location FCC ID: PB4-MT550 T his device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Model for MW550 PCB1 View PCB2 View RF module View

Page: 1 of 53 TEST REPORT Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn FCC ID : PB4-MT550 Applicant : Imation Corp. Address : 1 Imation Way, Oakdale, MN 55128-3421 USA. Manufacturer : Imation Corp. Address : 1 Imation Way, Oakdale, MN 55128-3421 USA. Equipment Under Test (EUT) : Product Name : Portable Wireless Speaker Model No. : MW550,TW550 Brand : memorex is the brand for MW550, TDK Life on Record is the brand for TW550 Rules : FCC CFR47 Part15 Section 15.247:2010 Date of Test : July 22~31, 2012 Date of Issue : July 31, 2012 Test Result : PASS* Remark: * The sample described above has been tested to be in compliance with the requirements of ANSI C63.4:2003. The test results have been reviewed and comply with the rules listed above and found to meet their essential requirements. PERPARED BY: Waltek Services (Shenzhen) Co., Ltd. 1/F, Fukangtai Building, West of Baima Road., Songgang Street, Bao’an District, Shenzhen, China Tel: +86-755-83551033 Fax: +86-755-83552400 Compiled by: Approved by: Zero Zhou / Project Engineer Philo Zhong / Manager Page 2 of 53 Report No.: WT12074810-S-S-F Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn 2 Test Summary Test Items Test Requirement Result Conducted Emissions 15.207 PASS Radiated Spurious Emissions 15.205(a) 15.209 15.247(d) PASS 20dB Bandwidth 15.247(a)(1) PASS Maximum Peak Output Power 15.247(b)(1) PASS Frequency Separation 15.247(a)(1) PASS Number of Hopping Frequency 15.247(a)(1)(iii) PASS Dwell time 15.247(a)(1)(iii) PASS Antenna Requirement 15.203 PASS Maximum Permissible Exposure (Exposure of Humans to RF Fields) 1.1307(b)(1) PASS Page 3 of 53 Report No.: WT12074810-S-S-F Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn 3 Contents Page 1 COVER PAGE ................................................................................................................................ 1 2 TEST SUMMARY ......................................................................................................................................................................2 3 CONTENTS .................................................................................................................................................................................3 4 GENERAL INFORMATION.....................................................................................................................................................5 4.1 GENERAL DESCRIPTION OF E.U.T. ................................................................................................................................... 5 4.2 DETAILS OF E.U.T. ............................................................................................................................................................ 5 4.3 CHANNEL LIST ..................................................................................................................................................................... 5 4.4 TEST FACILITY..................................................................................................................................................................... 6 4.5 TEST LOCATION................................................................................................................................................................... 6 4.6 GENERAL CONDITION .......................................................................................................................................................... 6 4.6.1 Environmental condition of test site.....................................................................................................................6 4.6.2 Test Mode ....................................................................................................................................................................6 5 EQUIPMENT USED DURING TEST ....................................................................................................................................7 5.1 EQUIPMENTS LIST................................................................................................................................................................ 7 5.2 MEASUREMENT UNCERTAINTY .......................................................................................................................................... 7 5.3 TEST EQUIPMENT CALIBRATION ........................................................................................................................................ 7 6 CONDUCTED EMISSION .......................................................................................................................................................8 6.1 E.U.T. TEST CONDITION .................................................................................................................................................... 8 6.2 EUT SETUP ......................................................................................................................................................................... 9 6.3 CONDUCTED EMISSION TEST RESULT............................................................................................................................... 9 7 RADIATED SPURIOUS EMISSIONS .............................................................................................................................. 12 7.1 EUT OPERATION: ............................................................................................................................................................. 12 7.2 TEST SETUP ....................................................................................................................................................................... 13 7.3 SPECTRUM ANALYZER SETUP......................................................................................................................................... 14 7.4 TEST PROCEDURE ....................................…

Text truncated - open the document above for the full version.

Page 45 of 53 Report No.: WT12074810-S-S-F Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn 16 Photographs –Test Setup 16.1 Conduction Emission 16.2 Radiation Spurious Emission Below 30MHz Page 46 of 53 Report No.: WT12074810-S-S-F Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn From 30-1000MHz Above 1GHz