PQP-VT2RSPVideo Sender

Video Sender Operation Manual Table of Contents 1 Introduction............................................................................................................1 1.1 Features ..................................................................................................1 2 List of package contents.........................................................................................2 3 Outline....................................................................................................................3 4 Setting up units ......................................................................................................6 4.1 Transmitter : ...........................................................................................7 4.2 Receiver : ...............................................................................................8 5 Channel and dwell time selection ..........................................................................9 5.1 Transmitter channel setting ....................................................................9 5.2 Receiver setting......................................................................................9 6 Using the remote relay feature ............................................................................. 11 7 Trouble shooting ..................................................................................................12 IMPORTANT This equipment has been tested and found to comply with the limits for a Consumer Equipment RF Lighting device,pursuant to Part ISC of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuir different from that to which the receiver is connected --Consult the dealer or an experienced radio/TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment. Safety Pre-caution z To prevent fire or shock hazard, z Do not expose this product to rain or moisture. z Do not use near a bath tub, wash bowl, sink or laundry tub z Do not use in a wet basement or in or around a swimming pool. z Do not open the case of this product z Use only the power supply packed with it 1 Video Sender Manual Version 5/2 1 Introduction The new 2.4GHz system VF2RSP sends consistent, sharp audio and video images up to 100M to other rooms without running cable. The 2.4 GHz FM signal penetrates wall and avoids interference from other crowded 900 MHz band. Due to FM modulation, it provides a superior quality. With four channels, you could find optimal reception and transmit different sources using multiple pairs. The special hidden omni directional antenna maximizes the signal range. FCC,CE approved Easy installation. 1.1 Features z 2.4GHz signal avoids interference from the crowed 900MHz band z Provides clear reception up to 300 feet. z Four selectable PLL channels eliminate interference and allow use of multiple systems in the same area z Send stereo audio and clear video signals from Cable TV, VCR, LD, VCD, CD, satellite receiver to your TV in another room without running cable. z Penetrates walls, doors and ceilings. z Hidden 2.4GHz antenna design z Simple to use - just plug it in and switch it on. z infrared extender build-in 2 Video Sender Manual Version 5/2 2 List of package contents The following devices should be included in the box. One Transmitter TX One Receiver RX Two power adaptor One infrared extender Two A/V cable (or euro/scart cable) 3 Video Sender Manual Version 5/2 3 Outline Model# VF2RSP 4 Video Sender Manual Version 5/2 Transmitter (VT2RSP) Front REAR IR extender antenna Receives 433 remote control signals Power LED Power On/Off Switch Audio Right in Audio Left in VideoIn Channel selection DC12V out DC12V in IR Mouse in 5 Video Sender Manual Version 5/2 Receiver (VR2RSP) Front REAR IR extender antenna Send 433 remote control signals Power LED Video out Audio Left out Audio Right out Power On/Off Switch Channel selection Receives infrared signal from remoter controller DC12V in 6 Video Sender Manual Version 5/2 Setting up units It takes only few minutes to set up Video Sender. You could connect most of audio/video source to transmitter and connect TV to receiver in another location. There is no wire needed between transmitter and receiver. VCR VCD DVD TV Satellite Receiver Transmitter (VT2RSP) Receiver (VR2RSP) Camcorder 7 Video Sender Manual Version 5/2 3.1 Transmitter : z Make sure the ON/OFF switch is at the OFF position before setup. z Connect power adaptor to transmitter. z Plug power adaptor to wall outlet.. z Connect transmitter to A/V source you want to view or hear at another location. z Set the transmitting channel at back panel of transmitter. See “Channel and dwell time selection” to setup the channel.. z If you want to us remote relay function, please refer “Using the remote relay feature”. z Turn the ON/OFF switch to ON position, the related channel indicator should be lit. Example: From VCR with TV (must be purchased) TV RF IN Coaxial cable A/V 1 IN LINE A/V Cable OUT2 RF IN RF OUT LINE OUT1 LINE IN VCR Recommended TV connection for dual-output VCR Cable TV Hookup Signal from antenna To wall outlet CHANNEL 1 2 3 4 A/…

Text truncated - open the document above for the full version.

Report No.: 014H008FI Page : 1 of 10 Version : 1.0 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo

FCC ID.: PQP-VT2RSP 69, Tung-Yuan Rd., Chung-Li Industrial Park, Chung-Li City, Taoyuan, Taiwan. Tel: 886 3 461-5000 Fax: 886 3 461-4000 Video Sender Model No.:VTSRSP, VS1000, VS2000, VS3000 F F C C C C I I D D : : P P Q Q P P - - V V T T 2 2 R R S S P P This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. S/N: Made in Taiwan

FCC ID.: PQP-VT2RSP 69, Tung-Yuan Rd., Chung-Li Industrial Park, Chung-Li City, Taoyuan, Taiwan. Tel: 886 3 461-5000 Fax: 886 3 461-4000 FCC ID The FCC ID Label will be placed on the equipment as shown in the photograph below. Lable here

Report No.: 014H008FI Page : 2 of 10 Version : 1.0 (3) EUT Photo (4) EUT Photo Report No.: 014H008FI Page : 3 of 10 Version : 1.0 (5) EUT Photo (6) EUT Photo Report No.: 014H008FI Page : 4 of 10 Version : 1.0 (7) EUT Photo (8) EUT Photo Report No.: 014H008FI Page : 5 of 10 Version : 1.0 (9) EUT Photo Report No.: 014H008FI Page : 6 of 10 Version : 1.0 (10) EUT Photo Report No.: 014H008FI Page : 7 of 10 Version : 1.0 (11) EUT Photo (12) EUT Photo Report No.: 014H008FI Page : 8 of 10 Version : 1.0 (13) EUT Photo Report No.: 014H008FI Page : 9 of 10 Version : 1.0 Adapter: (14) EUT Photo (15) EUT Photo Report No.: 014H008FI Page : 10 of 10 Version : 1.0 (16) EUT Photo (17) EUT Photo

Report No. 014H008FI Page : 1 of 27 Version:1.0 Test Report Product Name : Video Sender Model No. : VT2RSP, VS1000, VS2000, VS3000 FCC ID.: PQP-VT2RSP Applicant : PRIME ELECTRONICS & SATELLITICS INC. Address : 69, Tung-Yuan Rd., Chung-Li Industrial Park, Chung-Li City, Taoyuan, Taiwan. Date of Receipt : March 30, 2001 Date of Test : June 26, 2001 Report No. : 014H008FI The Test Results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by NVLAP any agency of the U.S. Government Report No. 014H008FI Page : 3 of 27 Version:1.0 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION..............................................................................................................4 1.1. EUT Description ....................................................................................................................................4 1.2. Operation Description ............................................................................................................................4 1.3. Tested System Details ............................................................................................................................5 1.4. Configuration of tested System ..............................................................................................................5 1.5. EUT Exercise Software..........................................................................................................................5 1.6. Test Facility ............................................................................................................................................6 2. Conducted Emission ............................................................................................................................7 2.1. Test Equipment List ...............................................................................................................................7 2.2. Test Setup ...............................................................................................................................................7 2.3. Limits .....................................................................................................................................................7 2.4. Test Procedure ........................................................................................................................................8 2.5. Test Result of Conducted Emission .......................................................................................................9 3. Radiated Emission..............................................................................................................................10 3.1. Test Equipment ....................................................................................................................................10 3.2. Test Setup .............................................................................................................................................10 3.3. Limits ...................................................................................................................................................11 3.4. Test Procedure ......................................................................................................................................12 3.5. Test Result of Radiated Emission ........................................................................................................13 4. Occupied Bandedge............................................................................................................................20 4.1. Test Equipment ....................................................................................................................................20 4.2. Test Setup .............................................................................................................................................20 4.3. Test Condition ......................................................................................................................................21 4.4. Standard Reqirement ............................................................................................................................21 4.5. Test Result of Occupied Bandedge ......................................................................................................22 5. EMI Reduction Method During Compliance Testing .....................................................................24 6. Attachment .........................................................................................................................................25 Attachment 1: EUT Test Photographs Attachment 2: EUT Detailed Photographs Report No. 014H008FI Page : 4 of 27 Version:1.0 1. GENERAL INFORMATION 1.1. EUT Description Product Name : Video Sender Trade Name : PREIME, PBI FCC ID. : PQP-VT2RSP Model No. : VT2RSP, VS1000, VS2000, VS3000 Frequency Range : 2411 MHz to 2473MHz Channel Number : 4 Frequency of each Channel : Channel 1: 2414.75MHz, Channel 2: 2432.75MHz, Channel 3: 2450.75MHz, Channel 4:2468.75MHz Type of Modulation : FM Operator Selection of Operating Frequency : Manual Switch IR Sender : Non-Shielded, 0.8m S-Video Cable : Non-Shielded, 1.8m Adapter : AHEAD Cable Out: Non-Shielded, 1.8m Note: 1. This device is a Video Sender included a 2.4GHz transmitting function, a 433MHz receiving function, an Audio/Video port and an IR-remote output. 2. These tests were conducted on a sample of the equipment for the purpose of demonstrating compliance with Part 15 Subpart C Paragraph 15.249 for non-spread spectrum devices. 3. This device is a composite device in accordance with Part 15 regulations. The function for the receiver was, measured and made a test report that the report number is 014H008, certified under verific…

Text truncated - open the document above for the full version.

Report No.: 014H008FI Page: 1 of 3 Version: 1.0 Attachment 1 : EUT Test Photographs Front View of Conducted Test Back View of Conducted Test Report No.: 014H008FI Page: 2 of 3 Version: 1.0 Front View of Radiated Test Back View of Radiated Test Report No.: 014H008FI Page: 3 of 3 Version: 1.0 Front View of Radiated Test (High Frequency) Back View of Radiated Test (High Frequency)