PQP-WP224PWireless PC Card

Wireless PCMCIA Card User Manual Version : 1.0 Wireless PCMCIA Card 1 Copyright Copyright  2002 by this company. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company. This company makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any software described in this manual is sold or licensed "as is". Should the programs prove defective following their purchase, the buyer (and not this company, its distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. Further, this company reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation to notify any person of such revision or changes. . All brand and product names mentioned in this manual are trademarks and/or registered trademarks of their respective holders. Wireless PCMCIA Card 2 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio technician for help. FCC Caution: To assure continued compliance.(example-use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the Following two conditions: ( 1 ) This device may not cause harmful interference, and ( 2 ) this Device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment. Wireless PCMCIA Card 3 Federal Communication Commission (FCC ) Radiation Exposure Statement This equipment complies with FCC radiation exposure set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, this device and its antenna(s) must not be co-located or operating in conjunction with any other antenna R&TTE Compliance Statement This equipment complies with all the requirements of DIRECTIVE 1999/5/CE OF THE EUROPEAN PARLIAMENT AND THE COUNCIL OF 9 March 1999 on radio equipment and telecommunication terminal Equipment and the mutual recognition of their conformity ( R&TTE) The R&TTE Directive repeals and replaces in the directive 98/13/EEC(Telecommunications Terminal Equipment and Satellite Earth Station Equipment) As of April 8,2000. Safety This equipment is designed with the utmost care for the safety of those who install and use it. However , special attention must be paid to the dangers of electric shock and static electricity when working with electrical equipment. All guidelines of this and of the computer manufacture must therefore be allowed at all times to ensure the safe use of the equipment. EU Countries Not Intended for Use The ETSI version of this device is intended for home and office use in Austria Belgium, Denmark , Finland , France ( with Frequency channel restrictions). Germany ,Greece, Ireland , Italy , Luxembourg .The Netherlands, Portugal , Spain , Sweden and United Kingdom. The ETSI version of this device is also authorized for use in EFTA member states Iceland, Liechtenstein, Norway and Switzerland. Wireless PCMCIA Card 4 EU Countries Not intended for use None. Potential restrictive use France: Only channels 10,11,12 ,and 13 Wireless PCMCIA Card 5 Manual Contents Chapter 1 Introduction.............................................6 Chapter 2 Installation ..............................................7 Chapter 3 Configuring Utility .................................10 3.1 Monitor .................................................................11 3.2 Statistic .................................................................13 3.3 Site Survey ............................................................14 3.4 Encryption .............................................................15 3.5 Advanced ...............................................................16 3.6 Version ..................................................................17 Chapter 4 Technical Specifications.......................18 Chapter 5 Troubleshooting.....................................19 Wireless PCMCIA Card 4 Switzerland. EU Countries Not intended for use None. Potential restrictive use France: Only channels 10,11,12 ,and 13 Wireless PCMCIA Card 5 Manual Contents Chapter 1 Introduction.......…

Text truncated - open the document above for the full version.

Report No.: 02AH014FI Page : 1 of 4 Version:1.0 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo

FCC ID.: PQP-WP224P FCC ID AND DoC Label The FCC ID and DoC Label will be placed on the equipment as shown in the photograph below. Wireless PC Card PESI Model No.: WP224P TESTED TO COMPLY WITH FCC STANDARDS FOR HOME OR OFFICE USE S/N: Made in Taiwan Wireless PC Card Model No.: WP224P F F C C C C I I D D : : P P Q Q P P - - W W P P 2 2 2 2 4 4 P P This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. S/N: Made in Taiwan

Report No.: 02AH014FI Page : 2 of 4 Version:1.0 (3) EUT Photo Report No.: 02AH014FI Page : 3 of 4 Version:1.0 (4) EUT Photo Report No.: 02AH014FI Page : 4 of 4 Version:1.0 (5) EUT Photo

Report No. 02AH014FI Page: 6 of 52 Version:1.0 1.2. Operational Description EUT is a Wireless PC Card with 11 channels. This device provided four kind of transmitting speed 1,2,5.5 and 11Mbps. The device of RF carrier is DQPSK, DB PSK and CCK. The device adapts direct sequence spread spectrum modulation. The Printed antenna was provides diversity function to improve the receiving function. This Wireless PC Card is an IEEE 802.11b Wireless LAN adapter. It allows your computer to connect to a wireless network and to share resources, such as files or printers without being bound to the network wires. Operation in 2.4GHz Direst Sequence Spread Spectrum (DSSS) radio transmission, the Wireless PC Card transfers data at speeds up to 64/128-bit Wired Equivalent Protection (WEP) algorithm is used. In addition, its standard compliance ensures that it can communicate with any 802.11b network.

Report No. 02AH014FI Page: 1 of 52 Version:1.0 Test Report Product Name : Wireless PC Card Model No.: WP224P FCC ID.: PQP-WP224P Applicant : PRIME ELECTRONICS & SATELLITICS INC. Address : 69, Tung-Yuan Rd., Chung-Li Industrial Park, Chung-Li City, Taoyuan, Taiwan. Date of Receipt : Oct. 01, 2002 Date of Test : Oct. 16, 2002 Report No. : 02AH014FI The test results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by NVLAP any agency of the U.S. Government Report No. 02AH014FI Page: 3 of 52 Version:1.0 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION .....................................................................................................5 1.1. EUT Description............................................................................................................................5 1.2. Operational Description ................................................................................................................6 1.3. Tested System Datails....................................................................................................................7 1.4. Configuration of tested System .....................................................................................................8 1.5. EUT Exercise Software .................................................................................................................8 1.6. Test Facility ...................................................................................................................................9 2. Conducted Emission..................................................................................................................10 2.1. Test Equipment............................................................................................................................10 2.2. Test Setup ....................................................................................................................................10 2.3. Limits ..........................................................................................................................................10 2.4. Test Procedure .............................................................................................................................11 2.5. Test Result of Conducted Emission.............................................................................................12 3. Peak Power Output ...................................................................................................................13 3.1. Test Equipment............................................................................................................................13 3.2. Test Setup ....................................................................................................................................13 3.3. Limits ..........................................................................................................................................13 3.4. Test Result of Peak Power Output...............................................................................................14 4. RF Exposure Evaluation ...........................................................................................................15 4.1. Fries Formula ..............................................................................................................................15 4.2. EUT Operation condition ............................................................................................................15 4.3. Test Result of RF Exposure Evaluation.......................................................................................16 5. Radiated Emission .....................................................................................................................17 5.1. Test Equipment............................................................................................................................17 5.2. Test Setup ....................................................................................................................................17 5.3. Limits ..........................................................................................................................................18 5.4. Test Procedure .............................................................................................................................19 5.5. Test Result of Radiated Emission................................................................................................20 6. Band Edge ..................................................................................................................................32 6.1. Test Equipment............................................................................................................................32 6.2. Test Setup ....................................................................................................................................32 6.3. Limits ..........................................................................................................................................33 6.4. Test Procedure .............................................................................................................................33 6.5. Test Result of Band Edge ............................................................................................................34 7. Occupied Bandwidth .................................................................................................................40 7.1. Test Equipment............................................................................................................................40 7.2. Test Setup ..........................................................................................................…

Text truncated - open the document above for the full version.

Report No.: 02AH014FI Page : 1 of 3 Version:1.0 Attachment 1: EUT Test Setup Photographs Front View of Conducted Test Back View of Conducted Test Report No.: 02AH014FI Page : 2 of 3 Version:1.0 Front View of Radiated Test Back View of Radiated Test Report No.: 02AH014FI Page : 3 of 3 Version:1.0 Front View of Radiated Test (Horn)